Having problems with your Tappan MDB531RF Dishwasher ?

My new tappan dishwasher came with a blue front door. Is this blue material a protective layer to protect the door finish? If so, how do I remove it to show the real door finish?


Answers :

Itsa protective cover. peal it off
Repair Help & Product Troubleshooting for Tappan MDB531RF Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My new tappan dishwasher came with a blue front door. Is this blue material a protective layer to protect the door finish? If so, how do I remove it to show the real door finish?


Itsa protective cover. peal it off ... Tappan MDB531RF Dishwasher

Bosch she4am Unit starts briefly, then stops about a minute into the operation and lights the CLEAN led. I located the diagnostics code paper, ran the test a few times, and come up with the same code...the CLEAN led lit indicates a door switch problem. I removed the door switch, it's a magnetic hall effect transistor..seems to work but not sure it's showing proper voltages. It reads 8vdc or so across the switch with door open, and about 11.7vdc with door closed. Seems too narrow a range to me


... Dishwashers

I have a GE Quiet Power 3 built in dishwasher. With 1 min. left in a cycle, I opened the door, removed an item, then closed the door again, but it didn't finish the cycle. The machine continued its single beeps to indicate the door was open. Reopened and closed the door. None of the buttons on the control panel respond. Have unplugged and left overnight, plugged back in, beeping continues.


... GE 24 in. GLD6500L Built-in Dishwasher

The dishwasher stop during the wash cycle. It did finish draining the water from the tub. The machine is not showing a power signs, I check the circuit breaker and the fuse is not tripped. I open and closed the door and the door latch seems to be working fine. There is just no power to the washer. Usually when a machine breaks down, there still is power or buttons that light up on the front of the machine. I looked on the internet and many say that the fuse could be tripped. No where can I find


... Whirlpool DU912 Dishwasher

Whirlpool dishwasher model # DU1055KTP34--washer stopped mid-cycle---no power at panel---removed panel and checked door switches--one showed 5 volts and switched other showed line voltage and switched


... Whirlpool 24 in. DU1055XTP Built-in Dishwasher

I just purchased a G.E. dishwasher with a black front panel that is glossy. My daughter used a mister clean sponge to clean it and is now full of scratches, is there anything I can use on it to get them out without having to replace the panel. I also have a G.E. frig with a different finish on it, it has a rough texture it never marks or shows finger prints best refrigerate I have ever owned, and was wondering if I could get that finish on the dishwasher door panel.


Once paint is scratched it is scratched. There are cheap and inexpensive ways to cover that panel with a glossy black, or even stainless or white, or whatever. Go to www.applianceart.com, they have a ton of options to help your dishwasher getting b ... Frigidaire 24 in. FDB1050REC Stainless Steel Built-in Dishwasher

Frigidaire Dishwasher How do I remove the blue protective material from the front of my new dishwasher?


It should just peal off from the edge like a piece of tape. ... Frigidaire 24 in. FDB126RB Built-in Dishwasher

Leaking dishwasher leaks intermittently. I removed the side panels and there is no sign of water in the base of machine. Door seal seams to be intact. What else can I check. Seal that needs replacing? Machine is 18 months old. seams to leak on the right side of the machine. Please advise. many thanks. My dishwasher showed the error code either OE or E1, I think it was more OE. I stuck my hand in the filter in the bottom of the machine and then it was okay but the next time it was used it leake


What sort of soap powder do you use\015\012some soap powders foam a lot in machine causing dishwasher to leak through seals\015\012also check that the machine is square that is the door is closing parallel with cabinet\015\012do no ... Dishwashers

I can't figure out how the detergent timer lever attaches. It fell off before I got the panel of the door so I couldn't see how it was attached. If I had an exploded diagram showing how it attaches, I could finish the job.


May I get the make and model # to help you more ... Dishwashers

FDW70 dishwasher, starts to fill with water, shows pre wash on control panel, then pumps out within about 2-3 minutes, but has vertualy no water in it. Puts up code A10 on control panel, can still hear the pump going even when l open the door. Have replaced a burnt out heater tube with a new genuine unit, also have removed & checked fill valve & this works fine.


Hi,Try this few steps;Turn off the water supply to the dishwasher and remove the hose, turn\015\012on the machine for a couple of minutes in a fill position then turn off\015\012the machine, reconnect the hose, turn the ... Hotpoint 24 in. FDW60 Free-standing Dishwasher

Glasses and others things are not getting clean in the upper rack. A white film remains on the glass and stains are not removed. Also I'm having trouble with the silverware showing rust spots and not getting clean. I use Jet- Dry all the time. We bought it three years ago. The brand is JDB-5 and numbers inside the door are: JDB1270 AWY 36072124 LC MAX LOAD CHG 9. made in Newton, Iowa. We have had trouble with things not getting clean for quite a while, but it has gotten worse. The water is scald


If you have hard water, glasses can look spotted and cloudy even after cleaning. Sometimes changing the dishwasher detergent can help. The easiest solution to clearing up glasses that start to look cloudy is toadd some vinegar to t ... Jenn-Air 24 in. JDB1270AW Built-in Dishwasher

Inlet/Drain light is on. I have cleaned the drain pump and non-return valve, rinsed under water, removes all foriegn objects, turned the drain pump impeller (which turns freely) and carefully replaced the non-return valve and secured it with the locking clamp. I tried turning off the dishwasher and teuned it back on. No warning light shows but as soon as I try the dishwasher on a wash cycle it fails to pump water into the machine and release the washing tablet door. The programme unit makes a no


Is the water inlet turned off by chance? Is there no water at all inside the dishwasher? ... Miele 24 in. G643Vi Plus Built-In Dishwasher

Hey all, my dishlex dx302 wont heat the water thereforgiving a **** clean. Have searched this topic for a solution and after removing circuit board from front door i found that the board doesnt seem to have dried out like the pics show in some instance any other ideas


Hi,Check your heating element.. Dishwasher ... Dishwashers

My Frigidaire dishwasher keeps showing the Er uo codo on the display. It used to would finish a load even though it would stop for a while when the error message came up, but now it will not run at all when the error message comes up. I read on this site that the Er uo has to do with the vent. I pulled the dishwasher out and removed the vent. I turned the dishwasher on and the vent opened and closed about three times when the cycle started, then it stopped and the error message came up. Is


Hi. This code is in reference to the vent assembly. This may also be a control fault, as well. To isolate the culprit, you will need to make sure that the vent assembly is not blocked. If it is blocked, it must be replaced. Restricted air flow will c ... Dishwashers

Hello! I just ordered a new facia panel for our Bosch dishwasher SHU9955UC/U12. It seems like it should be fairly easy to replace it (meaning, myself...). Is it really just a question of unscrewing the screws on the inside of the door, removing the old panel and then replacing the new one? Are there any especially delicate inside mechanisms/parts That should be protected? Many thanks.


... Bosch SHU9955UC Built-in Dishwasher

Mbd7600awq How do I replace the front door panel? I have pulled the unit out enough & removed door springs. It appears that door can be removed (flats on pivots may allow it) but door bracket hits bracket on the unit. Help! What is the secret?


... Maytag Dishwashers

Hi. I have an LG LDF7810 dishwasher. I did a deep clean and ended up taking out a bunch of grease from the seal between the door-bottom and the tub. I even removed the door to get at the grease I thought was trapped back there. Since then it has been leaking water, sometimes a drip and a couple of times a few ounces have gushed out at the end of a fill cycle. Did I remove some factory grease designed to seal the door bottom? If so, what should I replace it with? If not, what else could the


It is possible that while you removed off the grease the water seal/oil seal was also damaged. Once the seal is taken out it can loose the sealing strength which can make it possible to leak.\015\012Hence it will be good to remove the seal and ... LG 24 in. LDF7810 Built-in Dishwasher

The cabinet handle that is on the wood cabinet door cover is loose, I need to remove the cabinet door, tighten the knob and replace the door


... Miele G2183SCSF Builtin Dishwasher

How do I remove the WET AGENT DISPENSER from the door of the dishwasher. I have it opened but can't figure out what attaches it to the door or how to remove it.


Remove wet agent dispenser assembly\015\012click on this link directly \015\012 ... Dishwashers

Front panel My dishwasher wouldn't drain. I read I had to remove the front panel under the door and get to the hose to look for a blockage. I screwed out two screws on the side of the dishwasher and removed the white front panel just under the door. But then there is another metal panel and I can't loosen it. Is it just stuck or is there soem way of doing this? Elmi


Did you knock out the plug on the disposal before you hooked up the drain hose ? ... Bosch 24 in. SHE44C02UC / SHE44C06UC / SHE44C07UC Built-in Dishwasher

How do i replace door cable do i remove dishwasher from undercounter , do i remove door


Hello, \015\012 \015\012Welcome to FixYa.The unit does need to be pulled out, slightly. ... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

Ariston Dishwasher and Finish tablets? HI I HAVE ARISTON LS603 DISHWASHER . THE ROOM IS SMALL FOR THE NEW TABLET FINISH MAX ALL IN ONE ! DETERGENT DOOR NEEDS TO BE FORCED TO CLOSE WHEN USING THE TABLETS. THE ROOM THERE ONLY NEEDS 2 mm WIDER FOR THE DOOR TO CLOSE SATISFACTORLY I WONDER IF THERE IS ANY MODIFICATION FOR THE TABLET COMPARTMENT ? THANK YOU MOBARAK ZAYED Your name: MOBARAK ZAYED


Put the cleaner tablet in with the forks and knifes.It will work perfectly. ... Ariston Technologies LL65 Built-in Dishwasher

Water spills out of the dryer vent when i open the d/w door after a cycle. Why is this and what can I do? If I have to remove the door, specifically, what screws do i remove? Thank you. Maureen


Hello,\015\012\015\012welcome to Fixya. \015\012\015\012The issue is likely just the blower and housing drain hose blocked with "dirt" from time & use.\015\012\015\012First things first...**turn off th ... Miele G892SC SS Dishwasher

Model KUDS30FXSSO, Unit attempts to start. Blue light on the front of the door comes on indicating the cycle is starting. Pump runs a few seconds as normal. Then the maching sounds like it trying to start the next step three or four times. The blue light goes out. The washing cycle then switches to cancel/drain, ( I opened the door to see which control lights were on.) runs the drain pump then stops. The green light on the front panel does not come on indicating the cycle was completed.


... KitchenAid 24 in. KUDP01FL Built-in Dishwasher

Bosch Dishwasher I have a stainless steel Bosch dishwasher, I made the "mistake" to try to see if I could fix the jammed handle from the door. Unfortunately, (did not realize the top panel comes off without opening the entire door). I removed the screws from the door frame (Inside panel), and the door springs/latched got loose. I would like to put it back together, but I dont have any diagrams on the door to make sure all parts are in place to put the door back together. I have been havin


Hi ED,\015\012\015\012It sounds like a real problem here. If the springs are still in one piece, my best guess is to to remove the springs from the door. Then attach the springs to the dishwasher body first, then reattach the spring to the door. Not ... Bosch 24 in. SGS43C12 Classixx Free-Standing Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0817 seconds