Having problems with your Tricity Bendix 23 in. DH092 Free-standing Dishwasher ?

Noisy fan assisted oven, cooks ok, as soon as it heats up it makes a continous vibrating whirring noise,drives me nuts, doesnt stop till turned off. didnt use to make this noise.


Answers :

Repair Help & Product Troubleshooting for Tricity Bendix 23 in. DH092 Free-standing Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Noisy fan assisted oven, cooks ok, as soon as it heats up it makes a continous vibrating whirring noise,drives me nuts, doesnt stop till turned off. didnt use to make this noise.


... Tricity Bendix 23 in. DH092 Free-standing Dishwasher

Maytag mdb9150 dishwasher stopped at some point last night--found it this morning with flashing lights--I think "clean" and "heated dry", not sure.  I used "drain/off" to make sure there was mechanical noise--there was, so I don't think the machine is dead.  Purchased on 2001 with 5 year warranty, so out of luck there.  I tried turning off the electricity to the unit for a few hours; nothing improved.  When you start it (or think you have!) it makes noises for about a minute that sound promising


Check pump and solonoids click/work, if no mechanical noise, could be the circuit board, but they can be expensive. :(\015\012if the solenoids click, and allows water in, then the pump might be jammed, with grit, clean and reinstall... good luc ... Maytag 24 in. MDB9150A Built-in Dishwasher

I have a LG intello dishwasher 2050SH Turned it on yesterday and did a rinse. This was the first use for 4 months in our second home. It was very cold. The rinse stopped some way through and an error message displayed (cannot remember). Tried to run again and now the dsiplay is locked. It turns on with usual sound, but none of the buttons work. They make a noise when pressed but nothing on the dsipay changes. I suspect that the outlet was frozen and that I should not have tried again - too im


Hi\015\012\015\012To\015\012unlock the lock in your LG Dishwasher, with the door open press the SPRAY &\015\012RINSE buttons simultaneously for 15 seconds. Hope this helps...please post back fo ... Dishwashers

Cda cw 494 - dishwasher makes beeping noises and stops halfway through cycle . will restart if turned off but will not complete . doesnt seem to be filling properly .now and then does complete cycle and works fine .cheked water supply - ok.


Greetings,\015\012 usually, open and close door..then start counting the flashes. these will give you your fault code. The code then tells us where to go from there. off hand, i would say you have a heater problem.. Either, the water is not ... Whirlpool Dishwashers

Hi threr I have the following problem with my Haier DW12-EFM dishwasher: The dishwasher seems to operate properly for the first several minutes untill program selector knob stops betwin position 2 and 3. After I turn it manually it keeps on turning and than it stops again after I turn it again it operates till the end of the program but the dishes are not clean enough to be used. I also noticed that the heater does not operate (water is cold). Do you know wht the problem might be. Reg


... Haier 24 in. ESD100 Built-in Dishwasher

I have just moved into a home with the DS-603i and used it for the first time. I put it on the first load and seemed to go for way to long. so i opened it up and t washed the first load ok, but continued to make noises. It would make these noises even when draw opened. Turn on & off at power and it doesn't change the noises. The light on inside indicates rince, which i think is a F1 error code according to the manual online. Any tips on how to fix this?


The F1 error code indicated a leak problem. The noise that you hear is from the pump motor. There is a leak due to the top lid not sealed properly, so the water is shooting out during the wash cycle. It did not seal tightly because there are 2 actuat ... Fisher and Paykel 24 in. DS-603 Built-in Dishwasher

Hi i have a bosch model no sgs53e02au australia 2 weeks ago put a wash through over night woke up in morning noticed still making noise opened up the door of dw still making noise sort of brrrrr noise constant not stopping unless press botton off would turn off still had water in bottom rang company they told me to clean filter which i did found glass particules took water out with sponge clean it rang back they told me to get a piticuler tool size 20 to unscrew and pull out pump sat there unscr


... Bosch Dishwashers

We recently purchased a new pump for our frigidaire gld4355rf dishwasher. The old one started making grinding noises. When we moved the dishwasher it had leaked due to a failure of an interior seal. Our new pump is now making the same grinding noise but it is not constant. When my husband adjusted the pump by using his hand when he got into a certain position the noise stops. We keep the screens clean. Is there an issue with the pump in this model?


... Frigidaire GLD4355RF Dishwasher

I have a slimline CDA dishwasher, when i turn it on it makes a noise like it is draining but doesnt start. My son put it on in my absence. i dont know what he did but when i came to it it was full of suds and making a draining noise.


... CDA Dishwashers

Humming noise i have a GE nautilus GSD2200 model which has not been used more than 4 years that is giving me trouble.  it's making a loud humming noise (the noise comes and goes, comes and goes) which seems to be coming from the motor area at the bottom of the unit.  I stopped it in the middle of the cycle, but the water seems to be stagnant at the bottom.  any suggestion on fixing the problem myself?


I have seen this SOOOOO many times in my 35+ years in the appliance repair industry.......it is very typical....here you are this is an answer I provided someone with the exact problem not to long ago..............This is a t ... GE Nautilus 24" Built-in Dishwasher

I have a Rebadged Siemens dishwasher model no. SE6TIE1GB / 13 TKD 795 / 2. When turning on, the dishwasher makes the "normal" noise of washing but after less than a minute it stops and refuses to wash anything. Ive tried pressing the reset button but no help. Worth mentioning, the night prior to that, I switched on the dishwasher before sleeping and when waking up at 5am, it was still washing so I manually turned it off and opened the door to find some water at the bottom of the tray.


... Siemens Dishwashers

The motor is making a loud humming noise when turning on, water comes out, then stops, and the fan shuts off, then motor keeps making the humming souond? Does the motor need to be replaced?


... GE Dishwasher Mechanism Assembly - WD26X10045

I have a maytag dishwasher (model # dwu491oaax - not sure if the 4th lettr from end is a "zero" or letter). It has never been a problem before, but hadn't been used in awhile. The light in the front is not on, and when I close the door and turn the knob, it makes the same "clicking" noise it used to, but the machine does not come on. Any ideas? is there a reset button somewhere?


... Maytag Dishwashers

Drain pump makes draining noise but does not drain water from the wasmachine. It drains water correctly when we use the switch for drain or when we use the switch for spinning. The pump does not stop running. What is wrong?


You will find this link useful. also read commentts and replies following it.\015\012http://www.squidoo.com/Bosch_Dishwasher_Drainage_Prob ... Bosch 24 in. SHE44C05UC Stainless Steel Built-in Dishwasher

I have a Candy Range 4 CDS 68 dishwasher. when you turn it on in any programme it makes a noise, all the lights flash and it beeps. There are no leaks, i have turned the mains power off and on. it appears to have drained correctly. When last used it completed the programme correctly. Hope you can help Peter


... Candy Dishwashers

My Maytag Jetclean Dishwasher Model # MDB4010AWB Serial # 16163916uk is stoping midcycle, it doesnt make any noise or anything just stops. Water left sitting in bottom and have to open door then close to start again , stops again after a few minutes


Possibly a bad door switch losing contact, only after opening nad closing is it making contact again. part number for door swtiches and holder 99002254 retails for a about $25 ... Maytag Dishwashers

My dishwasher has got loads of water in the bottom, I ladelled it out and removed the filters etc but couldnt find out how to remove the final one, it looks like I need a star shaped screwdriver?, tried a posi drive but this didnt work. when I switch it on it fills and makes the right noises for a bit and then stops and does a kind of ticking noise intermittantly.


... Neff 24 in. S5453X1 Built-in Dishwasher

Kenmore Ultra Wash water supply started making loud noise while water is entering washer. If you turn on sink faucet at the same time the noise will stop.


It sounds like the solenoid valves which let in the water are not fully opening and causing chatter -- probably corroded . Turning the washer-water supply faucets down (to the left) will probably stop it, but the solenoid valves need to be checked. ... Kenmore Dishwashers

Turn machine on makes the normal noise when it starts but noise then goes off and machine doesnt fill with water


... Siemens 18 in. SF25A061 Slim-Line Built-in Dishwasher

Bosch SHU43 My Bosch SHU43C dishwasher stopped washing, turns out the impella came free from the motor, I repairded impella and put it back together and now the dishwasher washes great however now it is stuck in a wash rinse drain cycle. Display counts down but the unit never stops running when it reaches 0. Also, the water level is higher than normal and I there is a kind of thumping sound repeatedly every 15 seconds " use to make that sound only once at the start of a cycle before the impella


Sounds like the control module is out -- cost about $100 (I am on my third). I got a "lifetime" warranty when buying my second one. If you are handy, you can replace it yourself. You can call Bosch to confirm this (I did). It mounts inside the door. ... Bosch 24 in. SHU53 Built-in Dishwasher

My ariston lsv 66 dishwasher will not start washing cycle. It makes the pumping noise as it normally does at the start of the cycle and some water enters the bottom of the machine but then it stops. I have checked to make sure that there are no leaks so the problem is with the filling up of the machine. I live in a hard water area and haven't used anything to help reduce the limescale so expect this to be playing a part. I have tried all the washing cycles but the same thing happens. Any advic


HERE I AM I LIKE THIS JOBE\015\012 PLEASE CHECK THE WATER INLET FILTER I FEEL FROM YOUR DESCRIBE IS IT\015\012 YOU NEED TO CLEAN IT BY ASMALL BRUSH >\015\012 THANKS ... Dishwashers

European Bosch SKT 5002/02. Was disconnected by our plumber to install new cabinets. Not used during winter, as it is never used in winters. Fills with water, makes no noises but does nothing else. Have been told on-line to try to turn the motor (blades, I suppose) but it looks like the whole unit is behind galvanized panels and I don't want to do what I shouldn't......


Hi.Re:"Have been told on-line to try to turn the motor (blades, I suppose)" Someone has probably told you to energize the impeller pump motor directly by jumping its contacts to find out if the motor is working. That is a deli ... Bosch 22 in. SKT5108 Free-standing Dishwasher

I have DW60BI dishwasher that has stopped working. Doesnt pump water, only makes the noise that indicates it has finished.


... Dishwashers

Hi I have a mdb6601awb maytag dishwasher. Sometimes when it starts the wash cycle it will make a loud squelling noise. Then if you pull on the handle and stop it, the machine will start and sometimes the noise will be gone. Or you may have to do this 3 or 4 times before it will stop making the squelling noise. I do notice when I pull up on the handle to stop the machine it makes some clicking noises and then the noise goes away. Thank You for any help you may be able to give me!!!


I don't have a solution however I have the same problem with that same model. ... Maytag 24 in. MDB6601AWS Stainless Steel Dishwasher

I just bought a used LG LDS 5811ST stainless steel built in dishwasher. The previous owner said he bought it 4 years ago. It's in great shape but doesn't work. It powers up but the water is not pumping into the dishwasher. The previous owner said that he thought it was the pump. He said he took it apart once and cleaned a bunch of crud out of some hoses and it worked for a while then started making funny noise and stopped. When i got it home i powered it up and connected water hose. It seems to


Rom the Service Manual:"1E INLET ERROR Not reached to the normal water level in spite of 10 min. water supply.The Hall sensor is OK?Check the frequency of Inlet Water by the Test Mode." ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1406 seconds