Having problems with your Viking 24 in. Professional Series VUD040 Stainless Steel (Premium) Built-in Dishwasher ?

Will not shut off

\015 My dishwasher will wash and clean like usual but it will not turn off it keeps on running unless I manually turn it off\015

Answers :

Hi this problem is the soil sensor. Basically the dishwasher will continue washing or add time to the wash if it thinks the dishes are still dirty. You will need to replace the soil sensor normally located on or by the drain pump. Mike
Repair Help & Product Troubleshooting for Viking 24 in. Professional Series VUD040 Stainless Steel (Premium) Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Dishwasher malfunction MOST OF THE TIME it shuts itself down before fully filling with water - SOMETIMES it doesn't shut down until the minute the wash pump starts - SOMETIMES it washes for 10 or 20 minutes before shutting down - SOMETIMES it will even run a whole cycle, BUT it doesn't open the soap dispenser door - tried doing a diagnostic run but after it turned on all the lights on the panel it started to fill with water and shut itself down......... HELP


Follow this steps and fix it. God bless youFloat Switch\012\012\012The float switch may be hung up and this can cause the dishwasher to be stuck in a cycle. Check the ... Dishwashers

I have a brand new GE disherwasher GLDA690. When I open it and then shut it the NOrmal Wash button and the machine turns on. There is no way to shut it off unless I hit the reset button and then it drains and shuts down in a minute or so. But anytime I open and shut the door the machine starts. Why? Thanks


... GE GLDA690MWW / GLDA690MBB Built-in Dishwasher

Engine won't shut off! Replaced the shut off switch and it still won't shut off!


All the off switches do is to ground the spark either through  the primary or secondary. Make sure one side of the switch is hooked to a ground and the other to the primary (small wire) of the magneto.  ... Pressure Washers

Hello I hope someone can help me. I have a Siemens Hydrosensor Dishwasher that when I start it up in runs for a while and shuts off. I need to open and close the door several times then it may run for a short while, 15 seconds to a couple minutes and then shut down again. Finally, it will run through the rest of the cycle. The issue generally occurs when the digital timer is between 85 and 78. If I just leave it go once it shuts down it does eventually start up and will complete the washing cycl


It sounds like the door switch is at fault, it will cause the symptoms you stated. ... Dishwashers

Machine runs until manually shutting down, or until auto-shut down. In either case machine will not start back up for sveral minutes. Can I replace, disable, or remove the auto shut down feature. It's bexcome quite a problem. Please help. Mark


Hi and welcome to FixYa, I am Kelly. \015\012 \015\012I note that your question was 3 months ago. I answered a current post today that had your exact same symptoms. Your post was revealed after I answered the curre ... Dewalt DPD3100 Gas Pressure Washer

Hello all, We have an Ikea Whirlpool DWF 416 that is a couple of years old and has never caused any problems. From today the door has stopped shutting properly. The electronics and internal mechanisms seem to be working fine, since when you turn it on the cycle starts - but only if you hold the door shut. Has maybe a catch gone? Any ideas for fixing a door-shutting problem like this? Thanks in advance! Dave


The catch is no longer working. Contact IKEA for the replacement part. I'm sure it's available through EBAY or something, but probably not guaranteed or as reliable. ... Dishwashers

The door would not shut. We checked all around and nothing was blocking the door from shutting. We determined the latch on the door was not releasing. I forced the door shut. The touchpad works...lights come on but unit will not operate. The release handle on the front just wiggles back and forth without effect. Lowes says it is one of three parts...none returnable. Any thoughts on what part and whether this is something average consumer can self fix? Thanks.


Hi,\015\012 Lowes is right regarding the parts needed.\015\012\015\012First check the strike part is ok - that's on the body of the machine not the door.\015\012\015\012Unplug the machine.\015\012\015\012Remo ... Whirlpool DU1055XTS Built-in Dishwasher

I have an Asko 3251 that is about 4 years old. It has been great up until 2 nights ago when it just keeps running when is has completely cycled. You can open the door and it keeps running. You can push the shut off button and the lights on the controls go out but something keeps running. The only way I can shut it off is by shutting off the circuit breaker. The next morning I can turn the breaker back on and it will be off. Does anyone have an idea what is causing this?


... Asko 24 in. D3250 Built-in Dishwasher

The dish washer ran its full cycle but won't shut off. the little pump motor in the very bottom keeps cycling water in the bottom. it won't shut off when you open the door, it won't shut off when you push the power button and the front switches won't respond. the little light on the front of the dish washer is blinking and it has never done that befor normally the lites are always on solid.....


The drain stuck cycle ( I presume you mean drain pump running constantly ) are directly related with overfill scenarios for Asko dishwashers of this ... Asko D3122XL 24 in Builtin Dishwasher

My frigidaire dishwasher will not shut off the water being pumped into the dishwasher. It just keeps pumping in even after the required fill time and will not shut off, eventually I have to turn off the shut off so that it doesn't overflow. The float is working ok. Is this a sensor,circuit board?


... Frigidaire Dishwashers

GE quietpower 3 dishwasher repeatedly shuts down after 2 minutes of running.I open the door,shut the door and push the start button,It starts and then shuts down after about 2 minutes of running,every time.


Please provide the full model number of the dishwasher.\015\012Also does the behaviour change if you change the program you are choosing. Try the short cycle like rinse program. Are any of the lights flashing or staying on?\015\012\ ... Dishwashers

My Maytag Performa dishwasher PDBL390AWW fills with water and then runs for about 30 seconds and shuts off. It starts up again for 30 more seconds then shuts off. when i hit the off button it drains and then shuts off. what is wrong???


... Maytag 24 in. MDB5600A Jetclean II Built-in Dishwasher

Dewalt 4200 pressure washer shuts down after a few munites checked oils seems to heat up and makes a strange noise and shuts down bought new and only about 8 hrs of use confused?? anything will help h


... Dewalt Pressure Washer. 4200 PSI 4.0 GPM Pro Triplex Pump Gas

Craftsman power washer model no 580-752800. the powerwasher runs fine but just shuts off for no apparant reason. after a moment i can start again. will run and pump perfectly and then just shuts off.


... Pressure Washers

Timer seems to be stuck in between the short wash and the rinse exactly 1/2 way. It then just keeps washing untill you shut it off. You know after three hours you shut it off.


Turned the Dishwasher on then it stopped, so we hit Cancel Drain won't drain or follow thru to the wash cycle? ... Maytag Dishwasher

Washer won't start tried everything , I could think of changed spark plug tried new gas , Two things that bother me are . if i take out the spark plug and put my thumb over the spark plug hole theres no pressure and the wire that comes from the coil to shut off the pw it has continunity from the coil to the pin that sticks up to shut off the pw but it also has continuity from the coil to all parts of motor.


... Pressure Washers

Cycle was coming to end, pump will not shut off. I manually shut off the DW and restarted it, pump came back on, now is running and I cant restart a new cycle, pump stays on even with door open.


Ther is poss water in plastic base or float is stuck. ... Bosch Evolution 800 SHE68M05UC Stainless Steel Dishwasher

Hobart lxih everytime i add soap i get a service code e4 and the machine stops shut the machine off and it restarts just fine add soap and shuts down i use a powered saop made for under the counter dishwashers even when i run a delime agent thru the machine it the does the same what to do thanks for help david


E4 indicates water level has not reached top water sensor. Check for proper flow-water pressure to machine (15-25psi) and clean sensor in wash tank ... Hobart 24 in. LXIH-3 Built-in Dishwasher

MODEL PLD2855RFC3 SERIAL TH82763321 A person has to push or slam shut with force. My wife can not close dishwasher.We had it about a year. It's getting harder and harder to close so will lock shut


Ceck if the door gasket PS1148262\015\012 , part 3 on diagram below is worn, deta ... Frigidaire 24 in. PLD2850 Built-in Dishwasher

Engine starts runs good for 2 or 3 min the quites, will start right back up and run for 3 or 3 minutes, then shut off, will restart and run for 4 or 5 min then shut off.,


... Pressure Washers

I replaced the coil set, but that was not the problem. The ignitor will light the gas flame and it will blow for about 2 minutes, then the gas shuts off. Since replacing the coils, I have not tried the dryer with wet clothes inside. Is this gas shut off normal or do I need another part?


The gas flame will cycle on and off in response to the thermostat. Two minutes sounds about right for the dryer to warm up to temperature. The gas will shut off until the temperature cools down and then should cycle on again. Let the dryer run (ei ... Dishwashers

I have a kenmore quite guard 2 and it shuts down completely after about 1 or 2 ( compete power shut down) and then after about 4 to 5 min all the lights on the key pad keeps blinking.


... Kenmore 17342 / 17349 Built-in Dishwasher

Kenmore elite clean lite is flashing won't shut off.unit won't work modle #66516912001 serial#fk4402228.it flashes 7 times over and over.i shut off all power turn back on still flashes .i replaced electric board in door panel new button panel


I have a service bulliten on this if you will email me at [email protected] ill send it to you its too big for here ... Dishwashers

Have Whirlpool dishwasher Gold Series, Model GU9805CGB1 which stops part way through wash cycle with the led indicator blinks on the normal cycle.....if we ope nthe door and shut ...it continues until part way through rinse cycle...stops again....led indicator blinks again.....we open the door & shut and it continues....but then continues to run through the normal wash cycle continuously.....until we open the door again.....what's wrong???


Sounds like the door is losing contact with the door switch, first thing i would check is the door strike.Metal strike plate located on the tub itself that the door latch catches as it closes. its a spring metal striker, i would try bending it down ... Dishwashers

Shark pressure washer with honda 5.0hp motor when in use spraying with good pressure it the pressure shuts off and motor sounds like its about to shove a rod through the cases shut it off restart it andd the same thing occurs all fluid levels good pump and motor. water pressure from hose bib good. may b low water pres. for short time due to possible kink in hose reel not sure


What type pump oil to usefor karcher 2400 psi ... Honda Pressure Washers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0358 seconds