Having problems with your Viking 24 in. Professional Series VUD141 (Ultra-Premium) Built-in Dishwasher ?

NO POWER TO THE MACHINE

\015 I have a 7 year old Viking built-in dishwasher and when i went to turn it on it does nothing. There is water left in the bottom of the dishwasher but there is nn power to the unit. The breaker is fine. Is there some kind of reset button. I have pulled the unit out of the cabinet and can see no apparent problems. Any ideas?\015

Answers :

Hello. I can help you. Since you already checked out the power, skip that step and look at the latch.
\015\012
\015\012\015\012\015\012\015\012\015\012If your dishwasher doesn't work at all, check these:

Power from the house
Door switch
Wiring
Timer or selector switch
\015\012\015\012\015\012\015\012Power from the house\015\012\015\012Is there power getting to the dishwasher? This can be difficult to test, because dishwashers are usually wired directly to an electrical circuit, rather than plugged into the wall. But at least check for a blown fuse or a tripped circuit breaker.

\015\012\015\012\015\012\015\012Door switch\015\012\015\012The door switch is important because, if it's defective, the dishwasher won't work at all. To reach it, you need to remove the control panel cover, or sometimes the interior liner of the door. If it's defective, you need to completely replace it.

\015\012\015\012\015\012\015\012Wiring\015\012\015\012Often the main wiring connection from the house, at the dishwasher, burns and breaks the connection. If that's the problem, the wires must be repaired/replaced as necessary. If that's not the problem, check the wiring to the door switch, the wiring between the door and the lower part of the dishwasher, and the wiring to the timer. Repair any broken, burned, brittle, or defective wiring, using the proper appliance-grade wire and connectors.

\015\012\015\012\015\012\015\012Timer or selector switch\015\012\015\012Although it's uncommon, the timer or the selector switch may be defective. If so, you need to replace the defective part, because neither of these can be repaired.
Hi...

\015\012Good luck !!!

Regards

PCmania

Repair Help & Product Troubleshooting for Viking 24 in. Professional Series VUD141 (Ultra-Premium) Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

The dishwasher stop during the wash cycle. It did finish draining the water from the tub. The machine is not showing a power signs, I check the circuit breaker and the fuse is not tripped. I open and closed the door and the door latch seems to be working fine. There is just no power to the washer. Usually when a machine breaks down, there still is power or buttons that light up on the front of the machine. I looked on the internet and many say that the fuse could be tripped. No where can I find


... Whirlpool DU912 Dishwasher

LDS5811WW - machine will not power on??? When we push the power button, the machine won't turn on - we get nothing. Almost like it's unplugged - it's not, AND Yes there is power to the outlet. Front door leaks occasionally too.


Some newer d/w have a lockout feature to prevent littles from turning it on, often the kiddos accidentally activate the lockout during their explorations. Any chance it's locked?\015\012\015\012Also, I believe this type of unit has an adj ... LG 24 in. LDS 5811 Built-in Dishwasher

Stops part way through programme water still in machine. Now no power to machine. Problem happened yesterday - cleaned filter and pump - power came back. Programme started but then stopped. No power - nothing happens.


Either there is a bad capacitor in the control panel, or the power supply has a faulty capacitor. You will have to get a multi-tester and test each component for resistance and current ... Dishwashers

Our Hoover HD98E Dishwasher stopped working properly today. After a while the machine stops during the power spray cycle and just buzzes as though the pump is powered but not spraying. Is this the pressure pump? It empties Ok cos you can hear the machine emptying...


Its possible that your timer has a bad contack at this spot the machine stops but the drain valves open try advancing the timer one notch to see if it will work if yes relace the timer thanks from gilles ... Hoover 24 in. DT999 Free-Standing Dishwasher

We have a Maytag MDBH945AWW3 dishwasher. It is acting like there is no power getting to the machine (all buttons are unresponsive and no LED's light up), but there is DEFINITELY power getting to the machine. Ideas... or even a test procedure to help diagnose which item might be broken?


Where exactly is the power getting to? ... Maytag Jetclean II MDBH945AWS Stainless Steel Built-in Dishwasher

I have no power to the control panel on front of the machine, I have checked and there is power getting to the machine.


... Jenn-Air 24 in. JDB8910 Built-in Dishwasher

FDW60 Hello, I have a Hotpoint FDW60 dishwasher. It seems to have the usual quality issues but the actual problem is different to most I see on here. The machine has only been used about 20 times, but yesterday the following happened, I loaded and selected intencive program, when I pressed start the machine made a shriek/chipping sound, it seemed to run for about 5 seconds then stopped with the power and prewash lights flashing erraticly for about 3 seconds then was totaly dead, no power light o


Tom,\015\012If your dishwasher is still under warranty, best thing will be to contact Hotpoint's service center for repair the problem. ... Hotpoint 24 in. FDW60 Free-standing Dishwasher

Kranzle Pressure washer...seems to be no power to the machine..checked switch and all connections all fine but no power to the machine


Could be that the fuse in the plug needs replacing.Does the machine make any noise? Does it buzz/hum when you try to turn it on? - If yes, a starting capacitor is required. ... Electric Kranzle Professional 1600 PSI Pressure Washer

Ariston LSI 41 dish washer had intermitant problem of green light not coming on when main power switch turned on and machine not working, the circuit had beed repair before. I played around and got the machine to go through a full circle once then would not go again. So I have put a new circuit board with switch etc. still the switch panel light dose not come on, i found bad connection in connector which comes from small plug on circuit board, (two red wires )I have checked for power to board. W


... Ariston Technologies Dishwashers

I have a LG model LD-14AT3 dishwasher that will not start when you push the power button.There is power to the machine. Does the machine have its own fuse or reset button.


... LG Dishwashers

KitchenAid KUDL03IVWHO Machine seems to stop after the initial water fill. There is power to the machine, the door latch circuity is working, all the buttons on the control pad light up. After selecting any of the wash cycles and pressing start, the washing light illuminates and the machine fills normally to the point where the fill valve stops the inflow of water. At this point the machine stalls, it does not start the cleaning process. I can press cancel and the machine drains normally. I e


Hi,\015\012\015\012You have got to the correct resolution. This is a circuit or most commonly called the board problem. Please find the bellow mentioned link which will help you to get one compatible for your washer.\015\012\0 ... Dishwashers

Hi, The machine will not complete a cycle. I think it may have started when the power was turned off at the mains during a cycle. Symptoms are : - You can turn machine on, select a program, press start button, close door, machine appears to begin cycle as normal, water seems to load, then 2 minutes later drains, and 1 minute or so after that the machine beeps 3 times to indicate cycle is finished. Dishwasher tablet door never opens, dishes not cleaned. Have tried : - cleaning filters; - turn


It is likely the dishwasher is locked in some diagnostic program.\015\012If you provide the dishwasher model no. then I can try to find out the keys you need to press to get it out from it. ... Whirlpool Dishwashers

What makes swing on bobcat 337 slow?filters news oil new and full has good breakout power but everything seems to be slower that other machines i have run or owed my case cx 50 would eat this machine alive the bobcat isnt mine but run for a township i work for. very disappointing machine. has 2500 hrs on it any ideas bad pump or valves it


... Pressure Washers

I have a kenmore 665.13719k601, i used the delay switch and now i found water in the bottom of the machine. the cycle most have stopped while i was away. when i returned there was water sitting in the bottom of the machine. The water is clean... I can not drain due to no access to power on the machine. I checked the breaker but it was on, so i reset it anyway... nothing.. any idea's


... Kenmore 13719 / 13712 Built-in Dishwasher

I have a Bosch SHU5315 dishwasher that doesn't turn on. I checked power getting to the machine, reset power at circuit breaker box and door lock appears to be working. Is this the power supply or computer brain motherboard?


Be sure lock at door is not loose switch at door if not closed wont come on ck door close switch ... Bosch 24 in. SHU5305UC Built-in Dishwasher

After dishwasher was started, and water stared to enter the machine, it was unlatched and left with the lever in the open position for some time. The control dial had automatically moved 5/6 degrees clockwise and left there. Now the machine does not want to start no matter what I do. Power is to the machine, latch is moved to the right, but nothing happens. What's next. Thanks for any help you can give.


Hi,\015\012 \015\012After the water stops coming in do you hear a humming noise? If so the motor may be stuck. Unlock the door to disconnect power from motor then turn the motor by hand a few times (should ... Dishwashers

Whirlpool ADG6962: The power light is flashing. When I push the power light and hold for a second, the machine seems to start it's drain cycle, but then stops and the power light continues to flash.


... Whirlpool Dishwashers

Hobart lxih everytime i add soap i get a service code e4 and the machine stops shut the machine off and it restarts just fine add soap and shuts down i use a powered saop made for under the counter dishwashers even when i run a delime agent thru the machine it the does the same what to do thanks for help david


E4 indicates water level has not reached top water sensor. Check for proper flow-water pressure to machine (15-25psi) and clean sensor in wash tank ... Hobart 24 in. LXIH-3 Built-in Dishwasher

Neff dishwasher will not switch on , checked fuses etc and positive that power is going to the machine but will not switch on,is there any safety feature such as blockage or otherwise stopping machine from switching on, red lights not coming on, machine 4 years old and very little use? can u help


Just went through this myself. It could be a latch switch. Open the door undo the screws that holds on the inside door panel remove the latch. The 2 black boxes with wires attached are the switches. Take them out (use your camera so you know how to p ... Neff 24 in. S4443 Built-in Dishwasher

Pump problems we have a mobile car wash service that we use in the winter months we have a 300 gal tank and several power washers.we use 3 diffrent machines [email protected] gal 2500 [email protected] and a3000psi @3.0 gal i;m having a lot of pump problems with all of these machines.a friend that he thinks that the hose that the machines feed of is to small 3/4'' he suggests i use a1 1/2 hose as close to the machine before adapting to the 3/4'' fitting right now it;s about12'' long away from the tank.any info wo


Are you only using gravity to feed the machines. The law of gravity is that, for every foot of elevation you will get 2 PSI ( pounds per square inch) of pressure. You can figure out the minimum volume that the manufacture requires and make sure that ... Comet GXD2527G Pressure Washer Pump

Kitchen Aid Superba Selectra 21 Mod.: KUDS21SS1 MS S/N: FE 84757436 After whole house power outage, dishwasher began constant high pitch beep or whine. Machine controls unresponsive; display shows F. Cycling power has no effect {except noise stops and display goes off when powered down - of course). Any troubleshooting and parts availability advice would be greatly appreciated!


... KitchenAid Dishwashers

Samsung Triflow SW65ASP2 washing machine has no power


... Dishwashers

Power cord pulled out of machine


... Viking VDB325SS Dishwasher

Bosch Dishwasher I have a Bosch Dishwasher that is a little over a year old. Loaded it up and ran it last night. Got up this morning to unload it, and load it again. Got it all set and went to start it but there is no power. The circut breaker looks fine. But no power to the machine. Not sure what is going on, or what needs to be done. Thanks....


... Bosch SHU3306UC Built-in Dishwasher

No Power Hi. My dishwasher wont start. I loaded it and cannot get any lights to light up on it. There is no power to it at all it seems. I tried flipping the breaker but there is still nothing. The door locks, so that shouldnt be the issue. Is there a way to reset the machine? What should I do?


I have the exact same problem with my Kenmore Type 575-0. It was working one daym it went into dry storage for a year and then when I took it out of storage it would not work. Ive already tested the thermal fuse and there is nothing wrong with that. ... Whirlpool 24 in. DU1100XTP Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0546 seconds