Having problems with your Viking 24 in. Professional Series VUD141 (Ultra-Premium) Built-in Dishwasher ?

Left Knob Settings

\015 Hi all. Just moved to a house with the Viking 040 or 141 (not sure which). There is no documentation and the letters on the knob settings (mainly the left one) are worn. Could anyone enlighten me as to what these settings are? A Photo, or perhaps even manual? THANKS!\015

Answers :

On our model VUD141, the knob has a mark and the cycles are printed on the front panel. It is labeled as follows (starting from straight up and going clockwise):
\015\012OFF - Heated Dry - No Heat Dry Sani Cycles 165 deg F - Power Heat Selection - No Heat Dry - Heated Dry
Repair Help & Product Troubleshooting for Viking 24 in. Professional Series VUD141 (Ultra-Premium) Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Left Knob Settings


On our model VUD141, the knob has a mark and the cycles are printed on the front panel. It is labeled as follows (starting from straight up and going clockwise):\015\012OFF - Heated Dry - No Heat Dry Sani Cycles 165 deg F - Power Heat Se ... Viking 24 in. Professional Series VUD141 (Ultra-Premium) Built-in Dishwasher

Left Knob Settings


Goto northerparts.com and search your model.they may have a manual.try samsmanuals.com also. ... Viking 24 in. Professional Series VUD040 Stainless Steel (Premium) Built-in Dishwasher

Karcher K6.95. Twin shampoo containers Wherever I set the control knob, left bottle, right bottle, or off, Shampoo is still taken from BOTH containers. Any ideas please ???


... Pressure Washers

We have a Whirlpool dishwasher model ADG7550. It runs ok for a few minutes then it switches to the rinse setting (i.e. the furthermost left light of the temperature lights, i.e. lights from the left, 'rinse', '40degs', '50degs', '65degs', '70degs'. We may set it to start at e.g. 65degs, it does so ok for a few minutes then it switches to the 'rinse' light and starts to beep every few seconds. There are 11 beeps.


HI, There are two areas of concern here. This will be an issue with either the element, or control sector. I suggest to start with the element inspection. This will requir you use a multimeter, if possible. You will need to varify proepr element func ... Dishwashers

Asko D1706 Dishwasher will no longer respond to control knob, turning knob clockwise has no effect on cycle nor will this turn dishwasher off! Dishwasher appears to be stuck in some part of cycle but will no longer wash dishes, door must be left open or will not turn off!


I also had this problem.\015\012Support person couldn't tell me if the pump was supposed to run even when setting the control knob to 'off' (bar before (1)).\015\012After draining the pan, the control knob functioned normally. So apparently any power ... Asko D1706 Built-in Dishwasher

Have moved into a house with a Bompani Antilla BO 02014 model dishwasher. There is a control knob on the right hand side with settings and it seems like it controls the time the dishwasher is on (similar to top load washing machines). I do not know which settings to use or what they mean. Can you help? Thanks Terry


... Dishwashers

Cannot start my Comet pressure washer...water runs thru fine. Had set choke to open (push to left) and start to left.


Hi: Some things to check: Is the gas old or contaminated with water. Change it if you are unsure. Are you getting a spark? To check this: BE CAREFUL. Remove the plug. Plug it back into its wire. Hold it WITH INSULATED PLIERS so the tip is close ... Comet Pressure Washers

Model #363.14232100 dishwasher. When you turn the switch to on, it will not come on. If you keep turning the knob slowly you can hear the dishwasher trying to start up,but it doesn't. Keep turning the knob and its the same thing, sounds like it will start, but it doesn't. It did fill with water, but once it was opened it didn't start up where it left off. The lock switch was in position, and still nothing. Now I have water in the bottom but can't get the thing to come on. Any suggestions? Help!


... Kenmore 24 in. 16539 Built-in Dishwasher

I have a technika diswasher,not sure of the model, is approx 3 years old and has a big dial on the left hand side with 7 wash functuions and the power button is smaller and is on the RHS. I cant remember how to reset the wash settings. I thought that by pushing in the large dial this set the wash cycle but a technician told be that you have to hold your finger on the start/pause button until the green light flashes, and turn the dishwasher off then back on. Can you please give me a step by ste


I have the same model. You just turn the dial to the setting you want, push the dial back in, turn the (right) power button on then turn the smaller start button on. I use different cycles all of the time depending on whats in the load and this works ... Dishwashers

Have been given an aeg oko favorit 4060 dishwasher and do not have a manual for the different knob settings and want to know the settings and what they mean


... AEG Dishwashers

I have a problem with a bosch dishwasher i put in a kitchen 10 years ago. knob on left side buttons on right , stainless steel interior. i dont think client has ever used it. he must have put in new disposal but did not clear knock out. he went to use it with regular dish liquid.it started to leak and foam. he left me a note to look at it. 10 hrs later its still running and water is everywhere. i disconect from disposal and pump water into bucket but now can not get water to go in to it. tried b


First check that the valve under the sink is turned on sorry have to put this part in next thing to check would be the inlet water valve and assure that you do have power going to the valve if you dont then you would look at the float switch as the p ... Bosch Dishwashers

Model GSD3620Z02BB - The normal cycle will not engage when the knob is turned. The short cycle will engage (sound like it is working) but the soap is left in the reservoir and about 2 inches of water is left in the bottom. Thank you for your help.


Sounds like the selector switch has gone bad. The machine is not fully cycling thru and draining because the selector isn't proceeding like it should. \015\012\015\012This typically happens if the selector dial is spun real hard repeatedly ove ... Maytag Dishwasher

Brand new high end electrolux dishwasher perfomring horribly - likely due to hard water issue. Cloudy glass and resident left on dishes. Have the rinse agent set at max and hot water is at 150F...is the only solution a water softener??


Dishwashers have a water softener incorporated but this needs salt to regenerate. have you put salt in? ... Dishwashers

Blanco BFDW4X Dishwasher - dial will run any of 3 cycles down right side, and then click back to start position, but will not automatically run the rinse down left side of dial, have to turn the knob manually. Also looking for a manual for this.. Susan [email protected]


... Dishwashers

Our Bosch and our Electrolux stainless steel dishwashers fail to dry. Dishes must be towel dried and the inside of the dishwasher stays wet and must be towel dried and left open to thoroughly dry. I can't seem to find a setting to dry the dishes. Help Please


Hi,Check your heating element.. \012A bad heating element causes many problems in dishwashers…Dishwasher Problems The Heating Element not Working ... Dishwashers

I have a brand new Whirlpool dishwasher #DU810SWPU4 - Model #. No instruction manual was left with me, so I want to be sure I'm using it correctly. When I run it and set the drying cycle to Heat - after it shuts off and I open it up, there is still water on the door and on some of the dishes. Is this correct? Jane Walker


... Whirlpool Dishwashers

I have a jeen-air model JDB6900 and the diswasher will not start. I can turn the knob to any setting and it will not start??


... Jenn-Air 24 in. JDB6900 Built-in Dishwasher

The knob on my Inglis IPU25363 dishwasher is getting very hard the turn to a setting Any idea what the problem is? It is only 14 months old. Thanks.


... Dishwashers

My Whirlpool ADP6565 dishwasher stops before the rinse cycle. The start button then flashes and the rinse light on the cycle selelector knob is lit up. if I hold the start button in the water pumps out and then stops. I have to manualy set it to rinse to rinse the dishes.


You may have a blocked faulty, pressure sensor, or the hose is not flowing freely? Check that out.\015\012\015\012Below please find a service and repair manual, if you use the troubleshooting steps you maybe able to isolate your issue, and affe ... Dishwashers

Poor drying, mold building up in the tub. The condensing drying system is not working well. I pulled the unit out and removed a panel on the left side (facing washer). Saw that the plastic box that appears to be set up for moist air removal and vents to the tub had considerable mold in it at the top of one of the passage ways. Looked like it might be blocking air flow. Could this be a cause of poor drying? Can this unit be removed and cleaned? Also soap isn't dissolving. Bad board controllin


Hi.Poor drying is often caused by a faulty moisture sensor. If there is mold covering the sensor housing , that can be cause for the problem. Regarding the door detergent drawer problem, that is often caused by a defective doo ... LG LDF6810ST Stainless Steel Built-in Dishwasher

Hotpoint wf310 set wash,it starts then after about 20 seconds the on/of light and the lights to the far left flash


You will have to check the error code number which you get as per the blinks.\015\012f01 light 4, motor triac f02 light 3 motor, jammed/ tacho f03 lights 3&4 Ntc fault f04 ... Dishwashers

Have a frigidaire dishwasher (model- PLD4375RFC0)about 2 years old. Set to run as we left to go out of town- when we came back all lights flashing including error- found a child's plastic bowl that had fallen to the bottom and had a melted spot as it was next to the heating element. Called support and were told to master restart- shut the power off for 15 minutes. Did and now flashing "27". Cannot find a code for that and neither could support without sending out a repairman. Any advice before


... Frigidaire Dishwashers

Kenmore dishwasher model# 110753613 - Lights are on to indicate cycle settings but won't start. It is supposed to start when door is closed but but it doesn't start nor does the cycle knob move through the cycles..


... Kenmore 15939 Built-in Dishwasher

Cant figure out how to start the wash cycle. There is no knob or anything to lock it, and when i try setting it to start it wont. I live in an apartment and i believe it is an old dishwasher.


Make sure there is solid "click" when you close the door. It may be that the latch is out of adjustment, missing a piece, bent..There should be a door latch release on the front panel. The door latch is also where the safety switch is located ... Whirlpool GU2400XTP Built-in Dishwasher

My Kenmore model 665.16022401 has the problem w/ the clean light flashing. I tried the bottom combo of hi temp wash, heated dry, high temp wash, heated dry and it re-set my dishwasher but then after I tried to run a new load it doesn't seem like it finishes all the way through because there is still soap left in the soap dispenser and the dishes arn't all clean, plus the green clean light begins flashing again. Don't know what to do.


... Kenmore 24 in. 16022 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0332 seconds