Having problems with your Viking 24 in. Professional Series VUD141 (Ultra-Premium) Built-in Dishwasher ?

One of the kids used the dish soap instead of dishwasher, there is water on the bottom and none of the lights are on... I looked at the fuse box but that was fine


Answers :

You may have, installed on the dishwasher, an "excessive soap, foreign object or flood sensor" on your dishwasher that shuts it down if there are excessive suds (as with a high sudsing detergent), etc.
\015\012
\015\012 Dishwasher detergent is considered a low sudsing detergent and specially formulated for dishwashers. Perhaps you can "wet vacuum" the suds and water from the bottom of the tub and then see if you can reset the appliance per your owner's manual. If not in the manual, try shutting off the electrical supply to the diswasher via the wall switch (if applicable), plug, etc. while it is considered in the "on" position. If still no operation, contact an appliance service company.
It probebly suds up and leaked out the front. when the sensor detects water under the machine it will shut down. you need to remove the bottom pannel then use a shop vac to clean the water or a fan to evaporate it. it may suds up again after it starts. remember cold water wil not suds. so you may need to dump pales of cold water into it then pump it out. good luck!
\015\012Eric
Repair Help & Product Troubleshooting for Viking 24 in. Professional Series VUD141 (Ultra-Premium) Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

One of the kids used the dish soap instead of dishwasher, there is water on the bottom and none of the lights are on... I looked at the fuse box but that was fine


You may have, installed on the dishwasher, an "excessive soap, foreign object or flood sensor" on your dishwasher that shuts it down if there are excessive suds (as with a high sudsing detergent), etc. \015\012\015\012 Dishwasher detergen ... Viking 24 in. Professional Series VUD141 (Ultra-Premium) Built-in Dishwasher

Dishwasher will not start, no lights come on. There is also standing water at the bottom. Can you help point me in the right direction? Went to start the dishwasher and none of the controls on the panel are working or lighting up. I checked the fuse box and all fuses are good.


... Frigidaire 24 in. GLD2350RC Energy Star® Built-in Dishwasher

Help! My Whirlpool Quiet Partner II isn't working at all. Water was standing in bottom at end of last 2 cycles, but on the last cycle, I came home to clean looking dishes, standing water, and a machine that won't turn on at all- no lights on any buttons- nothing works. I've tried the reset codes published here and elsewhere, but there are no lights on any buttons at all. The circuit breaker is fine. I have 3 young kids and can't function long without my dishwasher!


There is a fuse in the control panel what your model# i can get you the part number its easy to replace it. ... Dishwashers

Our GE Profile (Quiet Power 6) dishwasher is having trouble cleaning our dishes. The top shelf rarely gets cleaned and the bottom is questionable. It used to work fine. We always use Cascade powder detergent on a normal wash cycle. We have hard water. Any advice would be appreciated. I took apart the washer looking for an obstruction but none existed.


The obstruction can be external to the unit. Check the drain at EACH connection working backward from the sink connection all the way to the motor pump outlet hole. Do not forget to dis-assemble the Air-Gap (if installed) and to check the inside of ... GE 24 in. Profile PDW9880JSS Built-in Dishwasher

Hi, I have a KitchenAidDishwasher (Model KUDP01FL). It's worked well for a few years. Yesterday, when we went to turn it on, none of the lights on the buttons were on. WE can't turn it on at all. The fuse box looks fine, nothing is tripped. Any ideas?


Kill the power to the unit. Pull the control panel down to access the control board located on the right hand side of the panel. There will be 2 wires coming in to a white plastic clip on fuse located on the side of the control board. It will have a ... Dishwashers

We have a built in GE dishwasher. It has worked fine for about 4 years but now the glasses in the top rack will not come clean. I have cleaned all the holes where the water comes out but I think the sprayer that is beneath the top rack (the one that is attached to the bottom of the top rack) is not rotating. We had someone out to take a look at it and they said it was fine. It isn't fine as it is not cleaning the dishes. Is there a reason that the bottom sprayer is not turning?


Hi,\012\012\012\012\012I\012have an older dishwasher also and recently my wife also complained\012about it not cleaning right... so me being the man I am tried in vain\012to clean the things... Bought new ... Maytag Dishwasher

We live on an island in the Caribbean and we have a LG dishwasher (model LDF 8812) that has worked fine for a year, but has recently stopped washing effectively. At first, the top part dishes were coming out still soiled from food. Now the bottom part dishes are coming out soiled as well. We checked both the Owner's Manual and the Service Manual and none of the troubleshooting suggestions appear to be relevant to our problem. The water here is very hard, and the water pressure is low and fluctua


You really need to replace the O ring . Could cause leaks and low wash pressure without it.You may also try running a solution of WHITE vinegar and water through the machine every six months as it helps desolve any lime scale (which is going to ... LG LDF8812 Stainless Steel Built-in Dishwasher

I have an Ariston LS245 dishwasher, have just had the pump replaced, as it had shorted out, due to water in the bottom tray where the water detection float is, also a new drain hose fitted. Have just run a wash and after running a while, presumably to the end of the rinse, wash and dry cycle, then one of the cycle phase lights, the one for 'soak' blinks constantly. I switched the machine off and had a look to see if a wash had been done, the dishes look clean. In the book it says that if one


... Ariston Technologies Dishwashers

My dishwasher is a swan sdw7030w, water is going in and out the machine but no water is getting through to man part wher dishes are, am putting it on and it's jumping from my choosen cycle to economy while beeping, the salt light and starish looking 1 are both on as well, can anyone help me? It was working fine n old house, could it possibly be my water pressure as I can't think of anything else as a woman. Please help me.


... Dishwashers

My dishwasher is a swan sdw7030w, water is going in and out the machine but no water is getting through to man part wher dishes are, am putting it on and it's jumping from my choosen cycle to economy while beeping, the salt light and starish looking 1 are both on as well, can anyone help me? It was working fine n old house, could it possibly be my water pressure as I can't think of anything else as a woman. Please help me.


... Dishwashers

We went to run our dishwasher and lights are out....nothing works......house fuse fine. Been told to look for fuse box inside of dishwasher panel but cannot identify.


If the circuit breaker is good then you need to check the main power line to the unit and make sure everything is connected properly. ... KitchenAid Dishwashers

The dishwasher stop during the wash cycle. It did finish draining the water from the tub. The machine is not showing a power signs, I check the circuit breaker and the fuse is not tripped. I open and closed the door and the door latch seems to be working fine. There is just no power to the washer. Usually when a machine breaks down, there still is power or buttons that light up on the front of the machine. I looked on the internet and many say that the fuse could be tripped. No where can I find


... Whirlpool DU912 Dishwasher

Dishwasher drain is hooked to a food disposer and until recently the unit worked fine. Last week following a cycle a couple of inches of water did not drain out. All food is removed from dishes, silverware, etc. prior to loading and the food trap in the bottom is completely clear. I ran the unit empty through a Lightwash cycle and afterwards the water level (that which didn't drain out) looked to be the same as before. The dishwasher is run 2-3 times weekly whereas the food disposal is


Hi, The I don't think the problem is with the loop and the 32" above the floor.If the dish washer was removed from one house to another, did *********** ever have a dish washer in the house before that he replaced this one with? The reason I am aski ... Dishwashers

New dishwasher (Beko 2542F slimline model). Put it on for 1st time last night -when I got up this morning, the cycle which should have taken just over 2 hours hadn't finished. There's soapy water in the bottom of the machine which hasn't drained and the "wash" light is still on. Looks like the dishes are clean but hasn't moved onto the rinse/dry part. Followed instruction in manual to drain it (hold start stop button till lights flash and should drain in 45 sec) but nothing happened.


... Beko Dishwashers

My top dishdrawer is dead it is a dd601 the seals are deflated bottom one works fine looks like it died near end of wash as there is water in it and the dishes look kinda clean


Hi \015\012Please refer to the link below as it is the service manual. Run diagnostics as instructed. This should help.\015\012Mat\015\012htt ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

The top drawer started getting very loud - maybe the water pump? Now it looks as if no water is getting into the drawer so dishes remain dirty. The bottom works fine, and is not loud when running.


Yes it is likely the pump rotor is seized. I am assuming the water goes in to the drawer but does not get moved around by the washer arm. This i ... Fisher and Paykel 23 in. DD-603 Built-in Dishwasher

I have a GE monogram zbd5900 that continues to drain, won't shut off. The drain pump just runs. None of the lights on the control panel will come on, tried pressing and holding buttons to clear, nothing. Turned off and on circuit breaker (even left it off overnight) and did not change. Drain is not blocked, pulled the unit out and put water in the bottom and it pumped the water out just fine. any thoughts?


See if you can access the tech sheet, should be on the right side of the underside of the unit after you remove the toe panel, or perhaps in the console. Almost sounds like a stuck key pad but the tech sheet might shed more information on this malf ... Dishwashers

My du943 dishwasher will not power on....it looks like it lost power after the dishes were washed and before the water drained. The fuse is not blown, the power box underneath the unit appears ok, and I checked the thermal fuse after reading other posts with the same problem. What to do from here?


... Whirlpool 24 in. DU930PWP Built-in Dishwasher

My kitchaid KUDS02 dishwasher is leaking water under the door all day evan if it's not running. I looked under ther bottom panel it's dripping 1 drop per second. Seems fine in cleaning dishes but somewhere there is leak. Any help where to start looking is appreciated


... Dishwashers

I have a Kenmore UltraWash QuietGuard Model # 16632. Yesterday after 8+ years of problem free operations, it stopped working. When I went to unload it, the dishes were completely dry, the inside of the unit was still warm but there was about 1.5" of water in the bottom of the machine. None of the front panel light or buttons work any longer and I have verified that there is power to the unit. Help?


... Kenmore 16632 Built-in Dishwasher

Have SHU43C and have had no problems with it. We usually run it on the Quick Wash cycle, but ran it on the Regular Wash cycle yesterday because the glasses seemed to be coming out spotty. After it ran, there were no lights on the display like there usually are. The washer had run and the dishes were clean, but it has not drained completely. There is still about an inch of water in the bottom, despite removing and checking both the Large Object Trap and Fine Filter (neither which were clogged


The drain pump needs to be replaced or cleared of obstruction. ... Bosch 24 in. SHU43 Built-in Dishwasher

Dishwasher is not working. after the wash there is water still in the bottom of the washer and it looks like there is no power going to it and the fuse is fine


Re:"dishwasher is not working. after the wash there is water still in the bottom"You have had a drain problem.Disconnect appliance from power.Remove water from inside the tub using a cloth or a sponge.Check the drain wel ... Whirlpool Dishwashers

ASKO D1706 This dishwasher was working well then it tripped out the fusebox and keeps on doing so. The on light is on when connected but when you shut the door it trips the fuse box on the house. The wiring looks ok, there is no water leaks in it. Any ideas


I agree with marine0612, It depends on when it blows the fuse box. ... Asko D1706 Built-in Dishwasher

See below This is a post that I just copied to this space "I have a whirlpool Quiet Partner II, Model GU2400XTB1, that just suddenly will not start, as if the power was cut. Circuit breaker is fine. from the little Internet research I've done it looks as thou it could be a thermal fuse problem. How easy are these to replace, assuming that's what it is?" Mine is quiet partner III ... there is power to the connection box at the dishwasher it self (checked w/ light tester) ... but there is no power


Have you tryed leaving the power cord out of the socket for an hour or so sometimes they don't lose the memory until they have been left disconnected for a while ... Whirlpool GU2400XTP Built-in Dishwasher

Whirlpool gu2500xtps6. The dishwasher was working perfectly but one of these days, for no apparent reason, it wouldn't show any sign of life. None of the LEDs on the front panel light up. It does not respond to any button being pressed. Looks like something electrical but all my circuit breakers are fine. Is there any fuse or something simple that I could replace myself?


... Whirlpool 24 in. GU2500 XTP Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1636 seconds