Having problems with your Westinghouse Dishwashers ?

Dishwasher no longer heats up....where can I get a new element please


Answers :

There are a couple different sources we recommend.
\015\012Repairclinic.com
\015\012Partselect.com
\015\012
\015\012Go to both, and enter your model number for replacement parts.
\015\012
\015\012Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question.
Use Google with your model number, there are lots of parts sites.
Repair Help & Product Troubleshooting for Westinghouse Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Dishwasher no longer heats up....where can I get a new element please


There are a couple different sources we recommend.\015\012Repairclinic.com\015\012Partselect.com\015\012\015\012Go to both, and enter your model number for replacement parts.\015\012\015\012Thanks for using FixYa - ... Westinghouse Dishwashers

I have a Chef Classic dishwasher ( model B8913WW) which is no longer heating the water, I assume I need to replace the element but nobody in my area knows where to get parts for this make or model, any ideas please??


If you know how to use a multimeter you can get to the heater connections and check the resistance of the element. it chould be about 26 ohme. Also the over heat protector thermostat should measure zero ohms. Make sure all wires connected to the heat ... Dishwashers

My Omega Eurolux Dishwasher (mode: DW211P/1) won't stop cycling, It sems to get stuck during the wash cycle and continues for hours, until I turn it off. If I turn the dial to rinse it rinses fine. It doesn't seem to heat the water at all, there is no steam when I open the door. I have put a new heating element in, but this doesn't seem to be heating up at all. When I open the door mid wash cycle the element is cold to touch.


... Dishwashers

I have a Euro E7dwss Dishwasher which isn't heating the water and gets stuck on the cycle. Is there a wiring diagram for it somewhere as i am unable to find anything useful on the net. Is there a second heating element somewhere? Please help Cheers Andrew


... Dishwashers

My zanussi dishwasher zsf4123s stopped getting hot,i bought a new heating element but still does not heat up,though im not sure if i fitted it correctly


... Zanussi ZT485 Built-in Dishwasher

Hello, we have a Frigidaire dishwasher Model# FDB1250REC2. There was all kinds of junk down in the lower filter area and when I tried to remove the parts they all came out together and then fell apart. I need to see how the parts go back together, because I thought I had them in there correctly, but when I opened up the dishwasher after running it the water sprayer was laying on the heating element. Could you please help me get it back together right? Thank you


I am having the same problem...were you able to fix it? ... Frigidaire Dishwashers

New dishwasher installed and heating element is not heating and get no hot water. Hose and electrical are connected.


On the bottom of your dish washer you can check if the heating element is getting power, if not you have few thermostat next to it (they might be disconnected from the instalation) or they might burn. check them when the power is off for continuity.. ... Dishwashers

Hotpoint BFI680 Dishwasher blows 13 amp fuse about 30 seconds after wash starts. Should I bother trying to get it repaired or just get a new one. It is 8 years old. I am assuming heating element is broken. Parts alone are 70 euro plus labour.


... Dishwashers

Hi there my dishwasher is a westinghouse sb908 but hte water is not getting hot. Do I need a new mother board to help diagnose the problem or is there a 'heat relay' that has a problem or an 'element'


... Westinghouse Dishwashers

Conia CDW0305W dishwasher. Gets stuck on the cycle and has be clicked along to finish. Doesn't appear to be heating as it first sticks at a point I'd expect hot water wash and dishes come out with grease residue and still wet. I live in the middle of nowhere, to a professional will cost me a fortune. Is this the metal element and can I fix it myself? Please help, I'm sick of hand washing!!


... Dishwashers

I have a Bosch dishwasher she44c05uc/40 It is 3-4 years old. Recently I noticed that the cycle times have gotten much longer. Since then there is a sewer smell in the washer especially when starting a new cycle it comes out of the disposal. I'm wondering if the pump isn't heating the water hot enough. I've also noticed that the dishes aren't getting near as clean as they were before all this started. Especially stuck on food. It used to clean everything now dishes almost need rinsed.


Hello,Welcome to FixYa ... Bosch 24 in. SHE44C02UC / SHE44C06UC / SHE44C07UC Built-in Dishwasher

New World Integrated Dishwasher DW60 E4 flashing and beeping. Managed to get it going for a while with a d/w cleaner, it filled, water heated but then E4 error kept flashing and it stopped, had to scoop water out. Cannot find instruction booklet to check fault. Please advise. Many thanks.


... Dishwashers

Hotpoint Aquarius FDW40 Dishwasher works normally but doesn't heat the water. How do I get to the heating element?


... Hotpoint 24 in. FDW60 Free-standing Dishwasher

I have a whirlpool dishwasher DU915WKSO: when I turn the dishwasher on, the heating element comes on but no water comes into the unit. I recently replaced the garbage disposal and th dishwasher worked fine for a time or two. Since then I have only been able to get water in it once. Like I said, the heating element works but no water in the dishwasher. Thanks for any help.


... Whirlpool DU1055XTS Built-in Dishwasher

We have a Kenwood KDW8ST2A dishwasher. We used to get the error code E3 (when still under warranty) and were told not to use dishwasher tablets as it generated too much foam. The problem has been intermittent but now we get the E3 error every time, no matter what program we run, or how little detergent we put in. I've a feeling its not heating up properly, is there any way to check the heating element? Is it worth attempting a repair?


... Kenwood KDW243A Builtin Dishwasher

Kenmore Dishwasher Model 665.15912001 Heating element doesn't seem to be heating. Wash cycles are loooooong and the drying cycle doesn't exist. Easy fix or buy a new dishwasher? I haven't tested anything yet. Should I start with the thermostat or the element itself?


Hi. i would test the element first. this will be the likely issue.First, open the doorand look into the tub and locate the heating element (if it is covered, remove the lower dish rack and cover). The heating element has two termina ... Dishwashers

Westinghouse Dishwasher Model SB907W5*08 the dishes are not getting cleaned & it appears that it is not heating as i bought a bottle of dishwasher cleaner & the dishwasher is supposed to heat up enough to dissolve the lid off the cleaner to let the fluid out. after putting the cleaner through a cycle the cleaner lid was still there. i think this must mean that the heating element is broken? this is out of warranty & can't remember how much it cost us so don't know whether better off gettin


Hi\015\012If you are observing that the dishes are not clean, then you'll need to follow certain steps to be sure where exactly the issue. First thing to check for is the detergent cup and spray arms. Check if the dishwasher's spray arms are w ... Westinghouse 24 in. MDP531 RF Free-standing Dishwasher

Maytag MDBH970AWS Heating element won't turn off. Dishwasher heating element won't turn off. Have to shut off the breaker to make it cool down. Heating element gets hot as soon as you flip the breaker back on


The heater relay is located on the control board, a faulty relay or a faulty control board would cause the problem you have described. The fix is to replace the control board. Parts for your unit should be available from most appliance parts retail ... Maytag 24 in. MDBH970AWS Built-in Dishwasher

HEATING ELEMENT IT SEEMS THAT THE HEATING ELEMENT IS NOT HEATING. THIS CAUSES THE DISHWASHER TO RUN LONGER AND THE DISHES ARE NOT CLEANING PROPERLY. I WAS WONDERING HOW TO TROUBLE-SHOOT AND FIX THIS PROBLEM.


Hi\015\012\015\012follow the manual:\015\012http://www.kitchenaid.com/assets/pdfs/product/ZUSECARE/8574093.pdf\015\012\015\012if it dosent work then as you mentioned the heating unit is bad\015\012you can replace it by yourself by buying it and insal ... KitchenAid 24 in. KUDI01IL - Multiple Color Free-Standing Dishwasher

The heating element stopped heating in my Maytag dishwasher, Model DWU8860BAE. I put in a new heating element, but it doesn't heat.rnWhat might be the problem? What should I do?


... Maytag Dishwashers

I need to change the heating element in my Kenmore Elite Built in Dishwasher and don't know how to get the old heating element out


Disconnect\015\012 the power source to your dishwasher before you conduct this or any \015\012other test. Either unplug the unit from the wall outlet, remove the \015\012appropriate fuse from the fuse box, or flip the appropriate breaker in \015\012t ... Kenmore Dishwashers

Small Burn spots on interior tub below heating element. These spots have small cracks in center of them, and leak right through the bottom of the tub, dripping water all over under the dishwasher. Nothing has falling into the bottom of the tub, and nothing has touched the heating element. What in the world could be causing this to happen? Kenmore Ultra Wash Quiet Guard 4 Mod.# 665.1603* Purchased new from Sears 2006


Hi,\015\012\015\012The heat from the element when the dishwasher is in the "drying" mode has caused the bottom to stress crack and become open so it leaks...\015\012Ultimately this will cause you to have to replace the dishwasher... ... Kenmore Dishwashers

Idl350 dishwasher fitted a new element but it wont heat the water


Check that there is a circuit through the thermostat(over temp thermostat) or there may be a faulty heat sensor on the control board. ... Dishwashers

Frigidaire dishwasher FDB126RBS1 Heating element does not get hot


... Frigidaire Dishwashers

Installing new heating element in Bosch dishwasher


In order to replace te heater in that unit, it must be remove from cabinet, and taken apart, it is very labor intensive, in order to access the heater, youll need to remove eh lower plastic pan from D/W. in order to get that removed, ... Bosch 24 in. SHU53 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2429 seconds