Having problems with your Westinghouse Dishwashers ?

Our Westinghouse dishwasher stopped working at the start of a heavy wash cycle. The light inside is working but the control panel is not. There is no indication of any power on the control panel.Your assistance will be welcomed


Answers :

If there is no power to the control panel it must be a failure of the power supply in the unit.
\015\012First of all ensure that the mains supply comes into the control panel from the power plug to the unit.
\015\012The program controller unit has the power supply within that feed the processor and sections for the program controlling.
\015\012Since most of these program controller units are embedded in epoxy it may be hard to service except to check for a fuse link or a visible component failure as probing into to fault find may be difficult.
\015\012If so the program controller unit must be changed.
\015\012A multimeter must be used to check the voltage to the main unit and the loss of voltage to the microprocessor unit.
Repair Help & Product Troubleshooting for Westinghouse Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Our Westinghouse dishwasher stopped working at the start of a heavy wash cycle. The light inside is working but the control panel is not. There is no indication of any power on the control panel.Your assistance will be welcomed


If there is no power to the control panel it must be a failure of the power supply in the unit.\015\012First of all ensure that the mains supply comes into the control panel from the power plug to the unit. \015\012The program controller ... Westinghouse Dishwashers

We had a power cut. When it was over the dishwasher continued and finished its wash cycle. The lights on the control panel, on/off and wash cycle indicator lights did not work during the remaining part of the cycle and will not work now. The dishwasher is a Hotpoint, mod. LFT 114 UK


... Hotpoint Dishwashers

I have an Electrolux EIDW 6105GB1. The washer fills with water then immediatly drains back out, the lights all flash and the trouble code light under the kick panel indicates the wash pump. It has done this before and I took the pump out and checked it with power direct, then returned it to the main control board plug and it was working and pulsing it's speed as it should. It worked fine for several weeks and now it's doing it again. Is it possible that there's a problem with the water float ins


Hi\015\012\015\012The issue is either with the wash pump that is going bad or\015\012the motor itself that is unable to run. As the washer fills and then drains\015\012immediately so the pressure/float switch should also be checked. Hope ... Electrolux EIDW6105GW 24 in. Built-in Dishwasher

Bosch dishwaher Model # SHX46A does not display indicator lights and does not function in any mode. There is power to the on/off switch that works and power to the control panel. Other wise the unit is dead. The problem occurs consistantly. I have not tried to fix this problem. Please advise. Thanks, Al


Having same problem, power to outlet, but unit is "dead", no lights, won't turn on. Unit is 6 yrs old and don't want to spend $100 for a repair man to tell me there is no hope....anyone else experience this? ... Bosch Dishwashers

Quit working during wash cycle, about 6 liters of water left in bottom, looks like it quit during rinse cycle. There is power to the door switch and door switch works shutting off power when door is opened. However the control panel does not respond to any push button. I have had a problem in the past with moisture from the door vent getting into the control panel area causing the push buttons to become eratic.


The capacitors in the control panel could be bad or have burnt out. Do check all connnections and if necessary, check the continuity of the power to and from the control panel with an ohm/voltmeter. ... Dishwashers

Model KUDS03FSSS2 Power to unit but unit dead. no light indication on control panel. buttons do not work


I have this problem. Acts like the power is unplugged. No panel lights, no error codes. The problem must be the ....NON-RESETTABLE BI-METAL [fuse]or else the door switch. I cannot find either one to measure with my volt-ohm-meter. Any tip ... KitchenAid Dishwashers

I have a mdd8000aws dishwasher. After a power outage (2 days) the power came back on, and the bottom drawer no longer works. It still make the chiming noise when the drawer is opened, but the control panel is not fully lit up and the washer will not start in any mode. The lights seem to flicker for a short moment and then they all stay very lightly lit up. Is this just a bad control panel or is there some other circuit that needs replaced? BTW, the top drawer works perfectly.


... Maytag MDD8000AWS Builtin Dishwasher

We have a kitchen aid dishwasher model # kudso1msso -- quit working and the control panel button lights are out so i assume there is no power to control panel. we have power at the plug every else looks ok. . could the internal fuse at the control panel be blown or the circuit board blown.


Sounds to me like a 'breaker' must be thrown; ... KitchenAid Dishwashers

Dishwasher had all control lights on in the morning; touchpad would not work; cycled power to the dishwasher and now no lights on the control panel will come on


... KitchenAid KUDS35FXSS Dishwasher

Control panel will not light up, the dishwasher was running and now it has stopped mid cycle and will not do anything. I just replaced the control panel (black plastic with buttons, not control circuitry). was running the diswasher and it seemed to be working fine, then stopped. water is standing in tub, I checked the float, I don't think the float is the problem. There is power to the outlet, no tripped breakers. But control panel will not light up.


I have a kitchenaid dishwasher model # KUDC10FXBL1 I went to start it and none of the buttons were working. I have checked the breaker and the wiring and everything seems to be in order. ... KitchenAid 34 in. KUDP01FLSS Stainless Steel Built-in Dishwasher

My LG 24 in LDS 5811 ww quite working in the middle of a cycle. I have power to the machine, but no lights come on, nothing works. I turned off the power and removed the front pannel. The large brown wire and large orange wire that are plugged into the back of the control panel start to smoke. So does the large black wire and the large white wire. Any ideas, is this the heater or is the panel bad?


The unit will need a new Wire harness, Pump/motor assy, Main Pcb and inner door liner.\015\012Contact LG @ 1800 243-0000 they may help you out. ... LG 24 in. LDS 5811 Built-in Dishwasher

The buttons on my control panel no longer work. At first, it was just one button, then two. Now none of the buttons work. The model is a Whirlpool Quiet Wash Plus #DU920PFGQ2. Do I just replace the control panel? The dishwasher is receiving power.


... Whirlpool Dishwashers

An electrical panel breaker switch was replaced after the microwave and dishwasher both lost power. The microwave works after replacing the main panel breaker. However the dishwasher will not show any power. Checked the internal circuit board, no burned areas, cannot find an internal GFI reset, what can I do to get power restored to the main control panel or even the unit itself? Rick C


1)check any fuse in the circut board.(blown off)\015\0122)check any loose connection of neutral (or)phase wire to the machine(or)in the switch. ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

Have a GE Quiet Power 3 Dishwasher. Went to reun it and when I closed the door no lights came on to pick a wash cycle. Nothing like it lost power. No buttons work, nothing. Opened door and removed inside door panel. Have power at door latch switch. Actually have power at all 4 connections and doesn't change when engaging switch as if door was closed. Switch does click but no power at front control panel. Whats up. I have my own Handyman/Home Remodeling business and I'm very good at fixing things


If your dishwasher is not running check the following \015\012\015\012You have already taken care of the 1st item.Power Supply The main power supply is the first thing to check. Also remove the toe ki ... Dishwashers

Have power to the control panel but the thing don't work????


I take it nothing lights up at all? In the 665 it is very common for the thermal fuse to go out. It should be on the control panel with 2 wires coming out of it with spade terminals. Disconnect that and see if there is continuity ... Dishwashers

I have a kitchenaid kemc308kss04 power went out to house now no lights on control panel or not does the panel work. Light in me comes on but nothing else works. Checked breakers works. Any idea?


... Dishwashers

Kitchen Aid Dishwasher model # KUDK03CTSS3 The control panel lights are blinking rapidly, several of them. Nothing works, even after powering off and on again. I see there are instructions to reset the control panel on these before calling for service. How do I reset the panel on this model?


... Dishwashers

I have a KitchenAid dishwasher model KUDC10IXWH1 that has no control power. I have already verified that there is 120V at the control board. The unit kept the lights on after the cleaning cycle was done and I couldn't shut them off. I reset the electrical breaker and now nothing works, but the board has power. Please give any advice you might have. I was thinking of replacing the board, but I'm not sure if it is the board or the front control panel. Any way to tell?


... KitchenAid 24-in Built-In Dishwasher White ENERGY STAR KUDC10IXWH

My Maytag mdb5130aww dishwasher stopped working; the only function it does is DRAIN. The panel buttons light up. WASH, RINSE etc all do not work. How do I test if the control panel is sending out power to the water pump? What else can I check?


... Electrolux 24 in. EDW5500DSS Stainless Steel Built-in Dishwasher

Whirlpool DU940 dishwasher. Opened the door and felt that the coil was warm but washer has not been turned on and control panel does not function. Removed power from washer and coil stopped heating but control panel still not working.


... Whirlpool GU2400XTP Built-in Dishwasher

I have a whirlpool quiet partner i dishwasher (model DU1055XTSQ2) that has suddenly stopped working. Control panel has partial functionality. All of the buttons on the control panel have a green LED feedback light when depressed. None of them provide LED feedback anymore except the Hi-Temp Wash, Sani-Rinse, and Heated Dry buttons. So there is power to the dishwasher. Any ideas? Please help Scott


The control board has failed.CLICK HERE to see the parts breakdown. ... Whirlpool DU1055XTSQ Built-in Dishwasher

Hi there . Beko DWD4310 stopped working , no "power on" lights, changed control panel as advised here, still not working, checked on off button with fase tester power getting as far as there. Any suggestions ?


I can see a couple of possibilities as to why the on/off light is not turning on.\015\012\015\012Either the door switch is faulty or the thermal fuse is blown.\015\012I do not have access to a service manual - so cannot provide the ... Beko Dishwashers

I have a Type S9J1S - SE64A630GB dishwasher which is not progressing beyond draining. With power on it seems to be constantly draining. There are no lights displayed on the control panel strip, and I cannot force it to re-set. This suggests to me that it is an electrical control-panel problem. Any assistance gratefully received!


... Siemens 24 in. SE64A630GB Built-In Dishwasher

My Frigidaire fghd2433kf1 starting flashing PF occasionally. I would open and close the door and it would go away. It became more frequent until two days ago when the dishwasher stopped mid cycle and flashed PF. When I opened and closed the door, everything went dead and the dishwasher no longer works. It acts like it has no power coming into it. I checked the breakers and the wires connecting the power into the dishwasher. No luck. I replaced the control panel, but not the control board. It did


... Frigidaire FGHD2433KF Builtin Dishwasher

My Dishwasher is not working, no power on control panel.


... Whirlpool 24 in. DU1100XTP Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1403 seconds