Having problems with your Westinghouse Dishwashers ?

Have a WDF901, the Ready light blinks six times after running for short while on the heavy cycle, has worked fine for over 12 months so far.


Answers :

Repair Help & Product Troubleshooting for Westinghouse Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Have a WDF901, the Ready light blinks six times after running for short while on the heavy cycle, has worked fine for over 12 months so far.


... Westinghouse Dishwashers

I have a Kenmore model 665. It is having an intermittent problem. It goes through the fill cycle, and then stops. Timer does not progress either. Then, at some random moment, it will come back on and finish the entire cycle. This could even be a day or two later. Sometimes it seems a nearby thump will set it off, other times no one is anywhere near it when it comes back on. This happened for a month or so off and on 6 months ago, and then it worked fine for 6 months. Now it's back to it.


Its possible its a door switch thats causing this or the main wire is loose..be careful as you do have 115 volts. i'd turn off power and check where power comes into d/.w and make sure the wire nuts are tight.. the next step is a little more difficul ... Dishwashers

I have a Miele G868 dishwasher. It is 15 yrs old. 8 months ago the soap dispenser wouldn't close, so I got another dispenser from Miele and replaced it myself. Everything worked fine until 3 months later, when the soap dispenser did not open. After 3 restarts, it began to function as it should. Now 5 months later, the soap dispenser is not opening at all. Here are my observations: 1. Economy wash cycle should run 35 minutes but only runs 13 now. 2. Water in machine is not hot, even though I run


... Miele Dishwashers

New SHE4AM16UC, professionally installed eight months ago. Worked fine with very light usage until now. Dishwasher starts normally but stops and signals "clean" after less than five minutes on any cycle. One inch of water in bottom that (I think) drains when a new cycle starts. Soap tablets are not ejected from compartment. Bosch authorized repairman says he now has two client dishwashers with identical symptoms and is asking Bosch support for ideas (he's changed pump, control unit, and float sw


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. If the clean light flashes, pauses, and then repeats.\015\012When the dishwasher doesn't sense a water t ... Bosch SHE4AM16UC 24 in. Built-in Dishwasher

Dishwasher Repair I have a Frigidaire dishwasher that came with the house. The house and washer are probably about seven years old. It woked fine for the first few months but now, when I turn it on to wash it fills with water but then it will not go into wash cycle (i.e. there is no water sent into the dish compartment). It will go through every cycle by filling and emptying through wash and rinse but no water goes into the dish compartment. Is there a pump that is perhaps not working? How is th


Ebers, you have a seperate wash and drain motor on this model. When you remove the bottom panel the drain pump will be on the right and the circulation (wash) pump will be in the rear. You are going to have to verify that you have power getting to t ... Frigidaire 24 in. FDB421RF Built-in Dishwasher

Hi, I have a 10yr old Neff s5543 built-in dishwasher, it is has been working fine but recently has stopped fully draining. I have removed it from the housing and checked all pipe work is unblocked and not kinked, have also blown back down drain tube to free any blockages from drain pipe, have also removed pump cover and checked around impellor for any foreign bodies etc. Everything seems clean and free. I ran a complete heavy cycle (empty dishwasher) and allowed drain pipe to drain into a


Hello there and thank you for choosing fixyaOk there are acouple of things that can be checked on this along with what you have already checkedDrain solenoid\015\012 \015\012 \015\012 \015\ ... Neff 24 in. S5543X2 Built-in Dishwasher

INDESIT IDL505 DISHWASHER(2nd hand working fine for 3 months) started to notice some light/slight streaking, misting especially glasses(annoying but not to much of a problem) then about two weeks later heavy streaking,glasses totally misted completely did have a brief problem with water inlet solenoid but checked it and its working properly (only malfunctioned once) i refilled the salt container and put on a simple wash and found that it used about half the salt in the container,changed the hard


Maybe the machine got a leaked inside.. ... Dishwashers

Water fill solenoid receives only 10 volts on normal cycle-not enough juice to open solenoid. Dishwasher does not fill. Dishwasher works fine on short cycle because on that setting the control panel sends 120V to the fill solenoid. Is there a ciricuit board or fuse I can replace?


It's most likely the timer set the timer to when it is gonna fill to a normal wash hook up a volt meter when it is in its fill stage make sure it is putting out 120 volts ... GE Nautilus 24" Built-in Dishwasher

I purchased my Kenmore Elite dishwasher, model # 8542514, in 2003 & replaced the control board in 2006. Recently, I accidently opened the dishwasher during a wash cycle, but it continued working once I closed it. It seemed to work fine for a few more weeks. Now, however, I get nothing--no lights....just doesn't start up. I tried pressing all the code solutions listed on this site, but no luck so far. It seems to me that the control board/panel should last more than 3-4 years.


... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

No lights Nothing, seems dead 6 months old working fine until yesterday Stopped it in the middle of cycle and would not resyart Tried breaker panel Power source fine Cleaned filters Tried reset


... Asko D5233XXL 24 in Builtin Dishwasher

Dishwasher works fine except that after the drying cycle, water slowly builds up in the bottom of the dishwasher. It did this a few years ago for several months, but then it stopped doing it altogether. I did nothing to fix it. Now it's started doing it again. I run the dial around to a point where it drains, let the water drain and then turn it back to off before the drying cycle begins.


Hello,\015\012\015\012This would mean that the dishwashers water valve has failed. This is a simple repair to make yourself. The lower access panel would need to be removed, four screws. You can purchase the part from the link below.\015\012 ... GE Dishwashers

Asko diswasher D3122 - white, built in. For the past 6 months, the dishes are coming out white. I have had the dishwasher for a number of years and never a problem. I had changed to Cascade Complete so I thought that was it, so I switched back to the regular type of Cascade and still have the problem. I tried adding vinegar to the wash cycle and this helped initially but no longer works. I should not have to add vinegar to every load if it worked fine before. A new problem is that in the la


Hi,There have been alot of complaints recently about this...it seems as though the detergent companies have reduce the amount of phosphates in the detergent and that has caused the dishwasher to build up minerals in the dishwasher... then the w ... Asko Dishwashers

Norge branded Jackson dishwasher Model GDU450V fills with water and then drains immediately when wash/rinse cycle begins. First cycle works heavy, normal or short. All wiring and connections look good, timer has been replaced. Suspect problem maybe in door interlocks but a mouse ate most of the wiring diagram. Help!


Hi,\015\012\015\012I'm not sure if you've considered the problem may actually be mechanical and not electrical or where you are in the diagnosis process. So I'll through my hat into the ring on this one since I've seen many many symptom's ... Dishwashers

My Maytag dishwasher is 9 years old-- Model number MDB7100AWW, serial number 27754072ZQ It has worked fine until about a month ago, when I began noticing a kind of "scum" on the silverware and some of the dishes after completing a wash cycle. The top rack will squeak and have some resistance when pulled out, whereas before it always came out smoothly. I have always used powdered Cascade. I've tried using less, thinking I might be putting too much in. Then I got a rinse agent. These thin


We had the same problrms, and then the machine wouldn't even clean anything, we took apart the lower spinner and cleaned the plastic filters and now it works like new ... Maytag Dishwashers

Code F2 I just replaced the door switch on an inoperable DD-602. My top drawer was working fine, but my bottom one has been offline for a while (door switch failed and I never got around to fixing it since I had the top). Well, my top finally failed too so I replaced both switches. Looks like everything is good on the top, but my bottom is erroring with an F2 code now. Kindof makes a thumping noise as it starts the cycle -- maybe 3-5 short thumps and then a 10 second delay, repeats. Any ideas? C


F2= \015\012The motor has not\015\012been sensed rotating\015\012\003 Foreign object has jammed the rotor\015\012\003 The rotor has failed\015\012\003 The hall sensor has failed\015\012\003 The electronic controller has ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

I have a Whirlpool ADF951, it has power to it and was working fine, the power light is on and the green light to the far right of the cycle lights is flashing, I can only get any response if I hold the start button in for about 10-15 seconds, The machine stops the light flashing and makes the noise like it is starting , that goes for about 20 secs then returns to the flashing light stage, any idea's please


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. If the light flashes, pauses, and then repeats. When\015\012the dishwasher doesn't sense a water tempera ... Dishwashers

My Bosch dishwasher, model SHX46A05UC/30 has been working fine. I ran it once today on the Power Scrub Plus cycle (always use this one). Shortly after unloading the dishwasher I needed to run it again with more dishes. Within a few minutes of running the dishwasher I heard loud, almost grinding noises. Nothing appears to be stuck. Any ideas on what to do? This dishwasher has always been quiet up until today.


... Bosch 24 in. SHX36L05UC Stainless Steel Built-in Dishwasher

Samsung 9E Error - Low Water Level. Dishwasher has worked fine (10 months old). Confirmed adequate water supply/availability. When opening the dish washer after error, the inside has no standing water. I can hear the dish washer initially fill. This happens later in the cycle (maybe 10 mins in) Should I replace the fill switch/sensor. Is there any info available on how to fix it my self. Appreciate your help!


... Dishwashers

Bought a Whirlpool Energy Star-rated DU1055XTVS0 four months ago. Have had intermittent problems with the water not running during the cycle. Have read instructions, done the trouble-shooting, etc. Even when the water runs, very often the dishwasher tablets don't totally dissolve. (And the tablets work better than liquid and Jet Dry -- I've had etching problems using that combo.) Very disappointed with this product so far.


... Dishwashers

Kenmore ultra dishwasher loud noise coming from it when in wash or rinse cycle aside from loud noise machine works fine this has been going on for months.


Hi,\015\012\015\012Remove the pump cover and the inlet protector and check for a broken glass or any other foreign objects inside.Or Remove the chopper assembly and check if it's not broken. If there is nothing wrong then the motor assemb ... Dishwashers

Have a KUDS24SEAL5 superba and no lights come on after pressing any of the buttons. Power to machine is good. Several months ago it would not start properly by pressing 'start'. Would go directly to 'drain' cycle. Then found that if we pressed 'rinse' before 'start' it worked fine. Now, almost a year later...no lights, no one home...any thoughts?


I had a KUDP02CRB and there is a hidden transition connector on the front panel under a black plastic cover that was pulled out a little. It connects the flex cable from the controller board to flex circuit of the panel. I just pushed it back in al ... KitchenAid Dishwashers

We discovered broken glass dish in bottom of dishwasher with some pieces below the bottom pump area. Shortly after the washer is making a louder noise during operation time. The water pump is quite when filling but after fill the noise comes during the wash time. The heat element works fine. What can be done to quite the wash cycle????


Sounds like you have broken glass in the wash pump you will have to remove pump from sump and clear also check the drain pump.good luck let me know how it goes ... KitchenAid KUDK03ITBK Built-in Dishwasher

G.E. GSD5130 When the dishwasher is pumping out the water a small amount comes in the rotating sprayer head. At the end of the cycle the dishwasher still has water in the bottom. The amount of water varies from just a little to over an inch. I replaced the spring loaded check valve a couple of months earlier and everything worked fine until now. What should I check? Thankyou.


Mike, I just ran into the same problem. I found a second check valve located in the outlet hose of the ELECTRIC drain motor. This motor is located at the right rear underside of d/w and is used only for backflush of the filter. When the unit goes th ... GE GSD5130 Dishwasher

Model FDB4315LFC2 Serial TH80658596 It is only 20 months old but Does not load with water. I have checked water line into white valve and water is flowing, but it does not come into the dishwasher. If I manually put water in the bottom of the dishwasher it works fine through the cycle until it is time to pump in more water. There is a sound but no water comes through the valve.


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. As you have already checked the water line for clogs/obstructions and the water is flowing but wont fill ... Frigidaire Dishwashers

New - 3 months 665.1389 Kenmore dishwasher worked fine until today. end of cycle - water in bottom no directions in use guide how to clean drain or ?? No large items have been allowed on the dishes. don't have any helps in the guide about repair


... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1617 seconds