Having problems with your Whirlpool 24" Black BuiltIn Dishwasher Dishwasher ?

I just bought the whirlpool 24" black installed it ran it ones to check for leaks ran fine open the door now the door wont reclose im clue less


Answers :

Something has to binding the door . Check for proper square and make sure nothing is hindering the hinges.
Repair Help & Product Troubleshooting for Whirlpool 24" Black BuiltIn Dishwasher Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I just bought the whirlpool 24" black installed it ran it ones to check for leaks ran fine open the door now the door wont reclose im clue less


Something has to binding the door . Check for proper square and make sure nothing is hindering the hinges. ... Whirlpool 24" Black BuiltIn Dishwasher Dishwasher

We have a Kenmore portable Dishwasher one and a half years old. It ran fine for about 6 months then we saw a water leak from the lower right hand corner of the door. I cleaned the door gasket. It stop leaking for a while. It started leaking again. Cleaned and rest the door gasket again. It is still leaking. Unit drains fine and all other functions are correct. What is the fix?


... Kenmore Dishwashers

Dishwasher leaking We bought our dishwasher in Sep/07, it was fine for a year, then started leaking out the bottom of the door on the left. We had the seal on the door replaced (didn't work) and then the door gasket replaced. That worked for less than a year, now it is leaking again in the same place. What could be going on? Have already put $400.00 repairs into this machine and am reluctant to put more money in to have it break again the same way. What do you suggest?


This sounds like a hinge problem to start with.\015\012\015\012Test the seal by dragging a strip of paper through it with door closed. Probably that left hinge isn't holding door close enough which was probably the original cause. As se ... KitchenAid Architect? II S SERIES KUDS03FT Stainless Steel Built-in Dishwasher

My Zanussi DS17 slimline dishwasher is leaking from below the door at the front. The inside seals all seem to be fine, but the catchment moulding below the door (which is revealed at the front when the door is opened) is filling up with water, and then overflowing. I can't see where the water is comming from, but it is definitely the water from the washing cycle as it's hot. Any ideas? I haven't dragged the maching out from the wall yet, but I may have to. David R


Hello,\015\012Have a look at the bottom spray arm and check the ends of the arm for splitting as this will cause the water to be directed at the door lower section and leak.Try taking arm out and run for a short while and see if it stops the le ... Dishwashers

My Kenmore dishwasher leaked out through the door and into the kitchen. It appears it is not draining and once the water reaches a certain level, pushes out the door. It did this before and we thought maybe the drain was clogged, but couldn't see anything. Ran it again and was fine but has now done it again. Could this be the control module or the overfill control, or something else?


\012\012Hi,\012Here\012is a tip that I wrote that will help you with your dishwasher not\012draining problem...Dishwasher Problems - ... Kenmore Dishwashers

My whirlpool dishwasher is ocasionally filling back up with water, whether the door is open or closed, and regardless of of control panel being lit. It happens, then leaks out the front. If i run the cancel drain, it will pump out the water just fine. All the other cycles are working just fine, and it leaves no water at the end of of the cleaning cycle. I have found no common occurance for this


Greetings,\012\012 in most instances the water inlet valve is leaking..this is the water valve that brings water into the dishwasher...its possible, the drain water is running back into the d/w from the drain hose not installed prope ... Dishwashers

I have a "Crosley" portable dishwasher, Mod#DC24J6A, Serial # 0176983 1089. Everything about it is fine EXCEPT it started with a slow leak at the front door, which has become a raging kitchen-flooding torrent. I do not see any gasket breaks. Gotta clue?


... Dishwashers

My soap dispenser door wont open. I've change to soft soap, ran cycle back to back but still nothing. what do I check next?


Sometimes the wax motor to open the flap goes bad,\015\012 the motor is inside the door be tween the panals\015\012 open the door up\015\012imsending a link that will show you where and what i talk about\015\012 you will wa ... Maytag 24 in. MDB3700 Built-in Dishwasher

I have a Viking dishwasher made by Asko. It is less than 6 months old. Today I had a problem with my disposal (water not draining through it and leaking under the sink) and ran the dishwasher, which cleaned/dried the dishes fine. BUT, since the water was not properly draining from the disposal, apparently the dishwasher was not draining properly either. A repairman came to fix the disposal before I knew about the dishwasher issue. Now, the dishwasher won't turn off "draining mode" - button pu


... Viking DFUD042 Built-in Dishwasher

I have washed and rewashed my dishes with no soap and my glasses have a horrible white film and any of my plastics now have white film almost as if the soap is not rinsing off. I have resorted to hand washing and some of the glasses seem to be etched with this white residue....difficult to remove. Please help! I have read possible heating element problems but I just ran the dishes thru a wash cycle with no soap and when I opened the door the heating element seems to be functioning fine -- all


Hi,The scum, film and white residue problems have started since the reduction of phosphates in dishwasher detergents.Here is a tip that will help you to solve the problem of films, residue, and scum in your ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

Indesit dishwasher door wont close , and keep dclosed, the catch doen1t seem to work anymore , dishwasher working fine , water leaking from below because not closing properly , have had dishwasher for 2 yrs no problems as yet .Wondered if this was a common fault thanks


On a D61 I managed to solve this without dismantling the door!If you look carefully in the hole where the white catch fits you can see the shaft it rocks on. I put a small screwdriver in here and levered it forwards. It didn't want to stay so I ... Indesit 24 in. D63 Free-standing Dishwasher

I have a Bosch Exxcel dishwasher which runs the drain pump constantly even with the door open and despite there being now water in the machine at the cycle wont start. I have checked the warer amtrix and the ffed hose to the sump for blockages. The float switch operates OK but when the water drains down the float drops and the water is pumped in, then the float rises and water leaks out and the drain pump kicks in again and no more ater will come in unless you push the float down. Inside the bas


I am not sure about this model but most models run a drain cycle for a set period at the start of a wash cycle and then move on to normal filling and cycle of machine provided the various switches are at the low level it will carry on to its set cycl ... Bosch 24 in. SGS47E02 Exxcel Free-standing Dishwasher

Maytag MDBtt60awb will not start. Power definitely at dishwasher as panel lights are on, however "start" button does nothing. Dishwasher is less than 2 years old. The panel buttons eventually turn off. I've cycled the power to the unit with no response. The door is definitely latched. Unit ran fine a few days ago.


Most likely you have a bad motor when replacing the motor ihave found it is cheaper to get the pump with the motor attached where as they charge you more money for just the motor or the pump seprately try allbrands appliance parts they seem to be che ... Maytag 24 in. MDB5600A Jetclean II Built-in Dishwasher

I have a Fisher and Paykel Nautilus DW920 dishwasher. However, the door to the detergent dispenser does not open reliably every load -- usually I have to open the dishwasher door about 20 minutes into the load and open the soap dispenser myself. The catch on the dispenser will have released, but the dispenser door will not have sprung open. I am not sure exactly what the problem is -- the soap dispenser door simply seems a bit stiff in its holster. Given a little nudge, it springs open fine. I h


... Dishwashers

Close the Maytag dishwasher, cycle starts, but I noticed a leak! Dishwasher door can be opened by putting your fingers on the edge and pulling it open. Tried it again, door clicked, thought it was ok but still could open door with fingers. Emptied the washer, door locked. Put in a few dishes, same problem


Your problem appear to me like it come from your upper basket .\015\012pleas try 1st to ensure the basket goes inside\015\012untill the end it is important..\015\012 thank you ... GE Dishwashers

Maytag Dishwasher Quiet Series 300 Door Leak: Model No. MDB8600AWG: The door leaks both from just beneath the touch pad at the top of the door, leaving a streak down the center face of the door (minor annoyance) as well as from the bottom left and right corners, more of a concern. I have cleaned both door gaskets and tried to reseat the inside door panel, to no avail. There appears to be a way to adjust the door travel (the door sags almost completely to the floor when opened), but I have yet to


... Dishwashers

Heller Dishwasher DWH16 has completed cycle and the door wont open. I put it on again wishful thinking and it still wont open. Can you please advise.


... Maytag Dishwashers

Kenmore 587 I have a Kenmore 587.1414 that is only 2 years old. I can hear it filling with water and then after a while it will drain, but does nothing in between. After the cycle has ran completely, I can open it and the dishers have never got wet and the soap door is open but the soap has just ran down the side of the door. What could be wrong? Motor gone out?


I think you are right. That would be the most obvious answer. Some motors are warrantied for 2 years or longer. ... Kenmore 16602 / 16604 / 16609 Built-in Dishwasher

I have a frigidaire FDB1050REC0 dishwasher that is working fine most of the time. Sometimes about 40 percent of the time, when we open the main door after it is finished with a normal cycle, we find a big clump of detergent left in the main detergent compartment and the detergent door is open. It is like the detergent is getting wet with the detergent door closed and then when it is supposed to open, the detergent is wet and clumps. We switched to liquid detergent and the same thing is happening


... Frigidaire Dishwashers

Whirlpool ADG993, door fault: Hi, a few weeks ago soemthing broke on the door to my diswasher and it falls open wide with no stopping half way as usual. That was fine as the machine could still work, but now the door won't close. All seems fine until you get all but closed and then the door raises slightly from the bottom right corner, preventing it from closing. It looks like something may be jammed in there which pushes the door up at the last minute. There's a man coming out on Friday,


... Whirlpool Dishwashers

I have a fisher and paykel single door dishwasher model dw918 td. The other day its door spring collapsed and the door had a free fall. The dishwasher operated fine. But we have accidentally opened the door and let it free fall under its weight a few times. Last night the dishwasher began its cycle and stopped after 10 minutes - no beep, no alarm, display was fine. it just stopped. I opned and closed door a few times. Pressing the start/stop button only resulted in a beep but no action. I let


... Fisher and Paykel Dishwashers

Hey Everyone! Ok try this one! I have been working on a KUDS25 Kitchenaid Dishwasher. It was leaking like a siv from the bottom. I replaced both top and bottom plastic bearings and also tightend all the screws at the bottom. Leak Gone, I thought. It now has small leaks down both sides. I have since been told by the owner that he took the door apart himself. I pulled out the dishwasher from the cabinet and ran it. I could see the leaks at the top on both sides of the door latch. I cou


Hello davidgalb. You can install a new gasket to seal the door again. That old seal is not flexible any more. That said, for my time and money I recommend a replacement dishwasher, this one has definitely seen better days. Joe ... Dishwashers

Have the Kenmore Limited Edition dishwasher, model # 665.15892100. When dishwasher is running, you can hear the soap container flip open. However, @ end of washer's completion, and main door is opened, the soap is still in the container. Some has leaked out, but the majority is still in the container. Dishes are still dirty, so it appears that either there is no water to disperse the soap, or does the door really open? Any ideas?


Check the wash arms to see if food has not cloged the holes stopping water getting through\015\012if these are clean the machine may not have enough water entering machine\015\012also check how you stack machine ... Dishwashers

When my dishwasher completes its cycle, there is powdered detergent left in the dispenser and the dishes aren't as clean as they use to be. This started happening after I ran a HI TEMP WASH with a SANI RINSE cycle. I'm thinking that either the detergent dispenser door is opening late or the water is not getting hot enough. To check the dispenser door, I left the door open and just poured powder into the dispenser compartment. This did not improve the cleaning.


Hi\015\012 \015\012Dishwashers use Bi-Metal strip to allow the dispenser to open/close. This strip when heat up causes the soap door spring to open up the dispenser. If this strip is not heated doesn't allo ... Kenmore 16372 / 16374 / 16379 Built-in Dishwasher

Dishwasher leak I have a General Electric Potscrubber Mobile Maid dishwasher (model GSC720?) that hasn't been used in some time, but appears to still work OK. It has a leak from the left hand vent opening in the bottom of the door when operating. The seal around the door appears intact and doesn't leak. Can you suggest a probable cause, and remedy? Thanks, Bob.


With dishwasher empty and disconnected, find the screws around the area of the "vent",you may need to open it from the bottom. There will be a hose that has either ruptured or just needs the clamp tightened with a screw driver. I think that the hose ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1540 seconds