Having problems with your Whirlpool 24" Built-In Dishwasher - Black-on-Black ?

I had a draining problem, clogged line, fixed. Does the small in line rubber valve under the dishwasher in the transition piece to the hose have any real need to go back? and which direction it is cupped slightly. Also are there any assembly instructions? I cant seem to get it back quite right, or a white washer has split. not sure which.


Answers :

Repair Help & Product Troubleshooting for Whirlpool 24" Built-In Dishwasher - Black-on-Black

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I had a draining problem, clogged line, fixed. Does the small in line rubber valve under the dishwasher in the transition piece to the hose have any real need to go back? and which direction it is cupped slightly. Also are there any assembly instructions? I cant seem to get it back quite right, or a white washer has split. not sure which.


... Whirlpool 24" Built-In Dishwasher - Black-on-Black

We have a LG direct drive dishwasher (LDF7932ST) that doesn't seem to clean very well. It leaves dried on food bits and a white film on everything especially the cups and mugs. Even on the power scrub cycle with an extra rinse. If the problem is the recirculating pump how do you remove the arm or bottom filter to clean out? I can't seem to locate the instruction book. Thanks for the help Tina


... Dishwashers

My dishwasher seems to go through the cycle but no water is running,you cant hear it. any idea what the problem is? i've check the line and it is on.


Check the drain valve of the machine ... Hotpoint 24 in. HDA3400G Built-in Dishwasher

3 yr old LG TROMM DLE 5977W Dryer-loud rattling noise started about a month ago.If I press on the front of the dryer below the door it stops.Something has come loose that stopped the vibrating noise?How do I take the front off to find out if its something I can check myself. Can't seem to find instructions on line.


Remove the bracket at the top rear of the dryer 6 screws\015\012\015\012Tilt top up and forward to remove\015\012\015\012Remove operator panel by unplugging connectors and removing screws.\015\012\015\012Pull up an ... Dishwashers

Bush dishwasher model wqp12-9348 not draining away fluid and seems to be blocked which is making water leak over floor. Cant find instruction manual to trouble shoot. Think it might be food residue or oil? will salt help?


... Bush Dishwashers

Dishwasher we recently removed our old dishwasher and need to clamp off the water line what size cap do i need cant seem to find one to fit 1/2inch to big 3/8didnt work either hwo do i cap off to prevent leaking


3/8 tubing is the normal size. other than buying a few different sizes from hardware store, (return the ones that dont wrok. not much else that can be done. well excepot call a plumber cause there shloud be a working shut off valve leading to dishwa ... Tappan 18 in. MDR251RE Built-in Dishwasher

I have a General Electric Potscrubber dishwasher. When the cycle is finished, the water does not drain into the sink.I turned the unit upside down to look into the bottom. The motor turns freely. The instruction sheet I found in the bottom of the unit said to remove the filter screen and check the piston valve. I looked at what I thought was the piston valve, but I'm not sure how to check it. The line to the sink seems to be clear. The model of my unit is GSC3230Z03WW. The serial number is AZ627


... GE Dishwashers

No instructions came with the dishwasher and i dont know where the water line goes i cant find it


The water line hooks up underneath the dishwasher, it connects to a water valve, usually blue in color. You'll need to make sure the water line is slid underneath the dishwasher, and then make sure the bottom kick-plate is removed from the dishwasher ... Dishwashers

We have a 2 draw F & P dishwasher but at the end of a cycle the cups in the cup rack do not seem to be clean on the outside. We place the cups face down, the inside seems to get clean O.K. but there is a often a film left on the outside of the cup. What could be cuasing this?


If the problem does not get fixed by increasing the rinse aid quantity setting, and assuming you do not live in a hard water area, I would recommend buying a Finish dishwasher cleaning kit (2 pieces) and run dishwasher on high temperature cycle one d ... Fisher and Paykel 24 in. DD-602 Built-in Dishwasher

I have a hotpoint built in automatic dishwasher model HDA3740G02SA. When my dishwasher runs all the cups on the top shelf seem to have dishwashing soap powder left in the bottom of the cups. I do not over fill the cup where you put the dish washer powder in. It seems like it isn't rinsing the glasses and cups on the top rack of the dishwasher properly. Do you know what the problem would be and how to correct it?


Make sure the arm on top isnt hitting something, each time you load it each in there and spin it to be sure it moves freely, also make sure your rinse agent container is full of rinse agent. ... Hotpoint 24 in. HDA3740G Built-in Dishwasher

Hotpoint Dishwasher Bought it new 2 weeks ago. Seemed to be working ok. Last night it started leaking out the front door (suds). I disconnected the drain line (tried to blow through line to tub, NO GO) so I started it and ran it into the sink. It seemed to be flowing OK, but there is still about 1/2 inch of water inside washer. Is this OK? Model # HDA3400G02BB


Water will not come on. started 3 months ago being erratic, some time it would work, some time it would not. Now it has gotten solid. Everything runs except water, therefore no wash. ... Dishwashers

Whirlpool Dishwasher detergent door not operating properly. Main wash door opens immediately after starting dishwasher. No pre wash cycle. Loud humming noise coming from bi-metal switch or wax motor attached to the detergent cup assembly. I just replaced detergent cup assembly including the wax motor and I still get a loud vibrating humm from the actuator. model number du1055xtp3


Pdemaio,ngafm at your serviceI believe the loud humming you describe is an electronic problem. And is not worth changing parts randomly and spending unnecessary funds in this fashion!my advice is a hands on experi ... Whirlpool Dishwashers

Hi. I have a 3 year old LG dishwasher. It will not drain. Display shows OE. I completely cleaned the drain assembly inside the DW. I checked the discharge line, it is completely clean. I disconnected the drain line from the air vent assembly at the sink and ran the DW, still will not drain. I disconnected the discharge pump wires and ran current directly, the pump works. I replaced the main control PCB, still will not drain. Please advise. Thanks


Measure the electric resistance of the Drain Motor. (Value should be 20-40 Ohms) If it is out of spec, replace it.\015\012\015\012Please reply with what worked best. Thanks! ... LG 24 in. LDF 7811 Built-in Dishwasher

Magic Chef DU4K is not draining all the water. There's at least a gallon of water standing in the bottom. I have cleaned the air gap assembly and drain line completely. They were even sanitized in hot water. I do not hear the water draining like it use to. When it worked properly you could always hear water draining into the GD. Now I can hear any draining. Again, there is no clogging anywhere in the drain line assembly. Is it a bad pump. I don't know where to go next with this.


... Magic Chef Dishwashers

I have a Bosch SHY66 dishwasher. The detergent cup will not open. The rinse injector stoped working a long time ago. I removed the outer door and the mechanism for the detergent cup and rinse injector is exposed. I see a clear fluid inside. How can I determine if the detergent cup mechanism has failed or if it is a failure of the control signal? How can I remove the detergent cup assembly? I am willing to buy the service manual if you now where to find it. Thank you, Bruce O'Reilly


\015\012Bosch Detergent Dispenser \015\012It's not that bad to change. Remove door panel, remove two timer actuator arms (be careful of springs), pry down tabs on top and sides and push it out. Of course remove upper bas ... Dishwashers

My Kitchen Aid KUDS01DJSS0 seems to have water going to the upper spray arm (I see water coming out of the unit just beneath the upper rack), but the pressure doesn't seem to be high enough to clean the upper rack. No evidence that water is coming out of the spray arm on the very top. Lower rack dishes seem to clean OK. I have already removed the whole upper spray arm assembly and inspected the flapper valves that the middle sprayer goes into. I suspect that it's not making good enough contac


... KitchenAid Dishwashers

My lower rack will not clean bowls or cups and I have to be very careful how I place plates. The serviceman has been out twice and I have run vinegar through multiple times with no improvement. My top rack is working fine. I have tried running it on different settings and we have verified that the lower wash arm seems to be spinning. The temperature seems to be fine. Even glasses placed on the lower rack that weren't very dirty seem to have a scum in them when finished. Any ideas?


Hi, \012I have an older dishwasher also and recently my wife alsocomplained about it not cleaning right... so me being the man I am tried invain to clean the things... Bought new spray arms online and installed them inminutes...now the thing works li ... Dishwashers

Karcher 2400 pressure washer with honda engine. my problem is that i've installed a new rebuild kit in the pressure pump assembly, and now, when i reinstall the assembly back on the engine, i cant even pull start the engine over. its too tight! when i loosen back on the pump assembly, i'm able to pull the engine over. what have i installed wrong from the rebuild kit??


The pump is correctly oiled and lined up on the camshaft, correct? ... Karcher 2500 PSI Pressure Washer

Assembly I recently purchased a pressure washer from Home Depot. It is rated at 3100 psi. It is a comet pump with a honda gas engine. The assembly instructions recommended that I remove the plug on the top of the pump and replace it with a vented plug that was provided. However, none of the other enclosed manuls talk about the vented plug. Am I reading the assembly insturctions correctly. Should there be a vented plug ?


HI your machine would have been delivered with a blanking plug in the pump. You will need to remove this and fit a vented pump or your pump will build up too much pressure inside. ... Comet BXD2527 Pressure Washer Pump

Our dishwasher seems to be stuck in drain mode. My daughter put the wrong kind of soap in it. She accidently put Regular dish washing soap in rather than machine dish washing soap. We've got all the suds out. Seems to drain water just fine. However we cant seem to get it to add water. Does the soap have anything to do with it? Anything I can do from my end? Please Advise. Thanks


Plastic base is full of water. Need to remove whole unit to access bottom and dry it out. ... Bosch 24 in. SHU66C02 / SHU66C06 Built-in Dishwasher

Have a whirlpool G2P DWI / 1 WH integrated dishwasher - when put on [70C] it seems to work ok and washes dishes but then after what seems to be the full cycle it just beeps continuosly - when opened the start button is flashing and the green light is on under the pre-rinse symbol. There are two bar codes down the side: 8542 347 15810 and 33 0451 014488. It's been in for about 3 years and have had no problems with it. Can't find instruction manual.


... Whirlpool Dishwashers

My Whiripool gold (Model Number)gu1200xtkso Does not drain - Everything else works fine but when the cycle is over the water is still Present. I dont know how to unscrew anything. I cant seem to find what to take off.. seems in possible to even check help....


... Dishwashers

My dishwasher won't fill with water. I've checked the float assembly inside the washer and it seems to work fine. I've been looking for the float switch and water inlet valve inside the bottom panel in order to 'test' them, but can't seem to easily find them.


If hot or both cold and hot fill try to switch the pipes \015\012if not filling it may be a problem with program and or filter blocked \015\012check also the pump\015\012did you check the water is on as sometimes people forget to sw ... Dishwashers

Dryer will not heat when started. All other functions seem to be operating. There seems to be a cycling sound as if it is trying to ignite, but unsure. The vent is clear, the gas line is free of kinks and unobstructed. I have tried different heat selections and nothing has worked. It is about 2 years old. Model # WGD5600SQ0


Http://www.dryerpartsonline.com/686590-Gas-Dryer-Ignitor_p_275.html\015\012\015\012When they fail they won't let the gas flo ... Dishwashers

The dishwasher doesn't seem to have nearly enough water in it. The upper sprayer arm doesn't seem to be spinning when running (I open the door and look really quick) and the lower one looks like it barely spins and barely sprays water. The dishes are barely wet and the soap is just laying on the bottom. The water is on, there are no kinks in the supply line. It sounds like it is running, and pumps pumping, but being brand new I am not sure what it should sound like. It certainly doesn't sound li


I would lift the drain pipe higher. approx. 1/2 the height of the dishwasher . also rechack incomming water supply. Make sure no blockages and the like. Try again. ... Bosch Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0604 seconds