Having problems with your Whirlpool 24 in. ADP6940 Dishwasher ?

F2 error leaking water from front bottom of unit


Answers :

Repair Help & Product Troubleshooting for Whirlpool 24 in. ADP6940 Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

F2 error leaking water from front bottom of unit


... Whirlpool 24 in. ADP6940 Dishwasher

Smeg e2 error (water level tripped). Filter is clean and no rubbish below filter on inside of dishwasher. I have taken the front panel off but am not sure where the float device is located - I am wondering if it is just to the left of what looks like a solenoid. There is no water in the base of the unit in the front panel so would rule out any leaks. Reset program and turned off power at socket but still not using hot water. Possible PCB issue ? Any advice appreciated. Smeg DI612C Dishwasher.


... Dishwashers

I have a Frigidaire dishwasher that is beginning to leak from the bottom. After taking off the lower front floor panel and looking under the unit, then pouring a bowl of water into the washer the water drips through unit onto the floor. What do you recommend? This is still an attractive dishwasher.


... Frigidaire 24 in. FDB1050REC Stainless Steel Built-in Dishwasher

Removed rear toe-plate to detect leak. Leak caused by broken drain hose. Hose replaced. To do this the unit was tipped forward onto its front door to allow access to the base area. Water allowed to drain out the front base area. Unit re-assembled but now does not switch on. Water connected. Base-plate dry. No water was detected at upper-front control panel. Power is connected and reaching unit ( multi-meter test ). Tipping the unit forward seems to be the cause. Is there any fuse,


The micro switches are frequently replaced on the door handle and they don't need to ever get wet. A lot of amp draw burns those switches up while they are dry. If they were wet and power was applied then they got fried my friend. The good news is th ... Dishwashers

After dishwasher was in cycle, I returned to kitchen and found puddle of water on the floor in front of it, water leaked down to basement. Haven't used since. Tried starting a cycle, but afraid to allow water to collect at bottom of unit.


The symptoms you describe, sounds like it could be caused by a worn door seal. Over time, these seals compress to the point where they no longer seal correctly, or food particles and grime get caught between the door and seal and leave small air gaps ... KitchenAid 24 in. KUDP02FRSS Stainless Steel Built-in Dishwasher

My Haier dishwasher is leaking badly from the bottom of the unit. I took the back off and checked the connections; all are tight. It looks like the water is dripping from the inside of the unit near the front right corner of the unit. Any recommendations?


... Haier 17 in. HDT18PA Built-In Dishwasher

I removed the panal on the right side as you are facing the front of the machine. there is a float unit on that side near the bottom that water goes thru, it has two electric plugs that also attach to it. this unit is leaking - what is it called, what's the part number, & where can i buy it


I believe the part you're refering to is the float container; here's a copy of the owners manual:\015\012\015\012http://www ... Equator 23 in. WB72 / BB72 Built-in Dishwasher

Our Fisher & Paykel single dish drawer unit (6 months old) is leaking limited water from its base down the front of bottom drawer below the unit's base onto the kitchen floor. One inspection by a technician failed to find any rectifiable problem. Unhappy, Wicks Road North Ryde


One drawer leaks can cause this problem. If you don't fix it. One day it will turn on the pumps from both units without any one touching them since the floor sensor at the bottom housing detects water and it will run for ever until you unplug the pow ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Hobart commercial under the counter diswasher LXIC Model Number 130016. DELIME light comes on every day at startup. Machine will immediatly run (in DELIME mode I think) for about 5-10 min and then get E4 error. We unplug power to the unit let it set, replug it back in after 3-4 cycles of this, it will eventually work perfect for the entire day. I have replaced the Sensor that is on bottom front of the unit in the water trough. ( I replace the sensor to the right if you are looking at the un


Q have your run a descaler . to rid the machine of its deposits . in order for the machine to run properly the parts and pump / screens must be clean . / descaling for deliming . dishwasher and icemakers is comm ... Hobart LXIC-6 Dishwasher

Dishwasher leaking Our dishwasher all of a sudden started leaking. I've taken the front panel off the door and can see exactly where. It's not a hole or anything...it's at the front, left edge of the basin, the bottom left corner at the front. It seems that right after it fills with water, it starts to leak once water is moving around inside and washing cycle starts. It is as if big waves are being pushed to the front left corner and over the lip of the basin. I don't think the water level is to


Just an idea...if i'm understanding you correctly,could the door seal be creased there or folded over by use and age to permit this to happen? cause you said nothing is missing ... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

Leaking from underneath. Water appears from under basboard to the right of dishwasher, not from directly in front. Only seems to leak during rinse cycle and has just started recently. Removed front panels and noticed the bottom of cabinets on both sides have water damage as if water has been leaking for some time. Never have seen any water until now. GE model GSD500X-66WB. Came with house, approx. 15 yrs old.[


Hi,\012Here is a tip that I wrote about dishwashers and them leaking.Leaking Dishwasherheatman101\012\012\012,fhjsuj ... GE 24 in. GSD500X Built-in Dishwasher

Water leaks fron the front bottom of the door when washing dishes.The unit is in only 13 months old.


... Frigidaire 24 in. FDB635RF Built-in Dishwasher

I have a Whirlpool Gold GU3600XTSY0 Model. There is slow water leak from the right side bottom front of the dishwasher. It looks like the water is leaking from a sensor on the bottom. The sensor has a pin protruding that can push up and down...almost like an on/off switch. I am wondering if there is any way to fix this. Water is leaking on my hardwood floors.....


That is your overflow water switch, that tube goes up to the washer, that switch is defective..water from the machine will come thru that hole ... Dishwashers

Water Leak at bottom of unit


Hi there,\015\012\015\012leaks a quite frustrating once they happen but there aren't that many places that you can have a leak. i would recommend looking at the drain pump and ensuring all seals are ok. after that focus on the door itse ... Bosch 24 in. SHY56A05 Stainless Steel Built-In Dishwasher

I cleaned the sump but when you run the washer it leaks water out the bottom of unit


... LG LDF6810ST Stainless Steel Built-in Dishwasher

Leaks water from bottom of door. Error code E7 ?


I found this and it also may have to do with the door seals...how old is the unit...if door seals get old and stiff..(not soft and pliable) they sometimes leak...after usage the heat and moisture may cause them to swell and or become soft thereby sea ... Hobart 24 in. LXIH-3 Built-in Dishwasher

Leaking water from underneath the front door. Water seems to be leaking through the bottom plastic seal. and sprays against the inside bottom of the door then drips onto the floor. Help


Hi,Leaks under the door can stem from a variety of causes. If your\015\012dishwasher is very old, the tub itself may have become corroded and may\015\012have holes. Inspect your tub; if you see such damage, use an epoxy\015\012patch kit t ... Dishwashers

SHX46B I have a 4 year old Dishwasher that filled up with clean water on it's own and leaked on the floor. There appears to ba a float switch switch on the very bottom of the unit that runs the pump if this happens. It won't stop until I remove the water caught in the plastic base on the very bottom of the unit. Drain is clear and this machine has worked fine until now. I'm thinking it may be a bad or leaky fill valve but how can I check?


... Bosch 24 in. SHU66C02 / SHU66C06 Built-in Dishwasher

My trusty Bosch s510 Dishwasher which has been going strong for about 17 years (at least) has just decided not to empty itself. I noticed the bottom was full of water after a wash. I emptied all the water out by hand and presuming there is a blockage in the drain tried using a plunger to unblock it. I have since put it through another cycle and half way through water started leaking out of the front. At the end of the cycle the bottom of the dishwasher was again full of hot 'soapy' water. If th


Same problem, so went out and bought a new bosch. Problem with the S510 was cured by lubricating the pump out motor bearings with a squirt of WD 40. If you don't know which pump, follow outlet hose to pump outlet.Les ... Bosch Dishwashers

Leaks my dishwasher was working great .. and then it started to leak at the bottom of the door when it would cycle into the wash mode .. I cleaned out the bottom trap and put the unit back . and now it will not cycle at all .. and there is water in the bottom of the as if it is not draining .. any ideas


Hello Emmitt White - Try unplugging the dishwasher or flipping the household circuit breaker off first. Wait approximately ten minutes and turn the unit back on. If the issue persists, it could possibly be a few things: faulty door switch, drain p ... Frigidaire Professional Series 24 in. Built-In Dishwasher Dishwasher

Hello, I have a Frigidaire Dishwasher, model FDB750RCC1. It will not fully drain. There is water in the bottom of the unit after the cycle is complete. As it is not full of water or leaking out of the unit when I open the door I am suspecting it is the pump that has broken? (the water must be draining to the overflow point and then stopping as there is nothing pumping it) Any thoughts or ideas for me anyone? Am I on the right track?


... Frigidaire 24 in. FDB750RCC Stainless Steel Built-in Dishwasher

Maytag jetclean dishwasher leaks: Water leaks underneath. I don't see the source of the leak but see water running out on the left side about midway back on the bottom. Could it be related to the little plug inside the unit on the left side halfway up?


... Dishwashers

I have a LG Dishwasher LD 14AW3 it fills and runs for about 30 min. It then appears that when it tries to rinse it cannot get water and flashes "1E". I disconnected the unit and when I moved it out of its position water was leaking from the bottom of the unit. after cleaning out the inside filter & the hard water filter I re-connected and found it worked. I ran a dishwasher cleaner through it at high temp. After a few loads the problem has come back. It is now located in MY garage waiting for me


Found a leaking component that was causing the foam float located and attached to the inlet valve to shut down the water inlet and the water inlet Solenoid was also sticking. I found out this simply by tapping it while it was trying to get water for ... LG Dishwashers

I have a Kenmore Model 665.15955792 dishwasher. Water is leaking out the bottom of the door. I changed the door seal and the defusers but it continued. I took off the front of the door and I see the water filling into the base of the machine. When the dishwasher starts the cleam cycle, water is pushed up into the small square holes in the bottom of the door and then splashes up over the lip of the door and out onto the floor. It has never done this before, just started recently. I have had the d


... Kenmore Dishwashers

I have a Karcher K3.48M electric pressure washer which used to shut off when you weren't using the cleaning wand. This no longer happens and there is alot of water running out of the bottom of the unit. (This didn't used ot be the case) I expect a leak somewhere inside the unit, but I'm wondering even more if there is a pressure switch which has failed that cased the leak. In other words, if I find and repair the leak and there is a failed pressure switch, it will likely only break again. I can'


Hi you will have a 8 digit number on a silver plate on the machine with a number like 1.141-470.0\015\012Then go to www.karcher.com then on the left click on Europe, then you ... Karcher PSI Electric Pressure Washer
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1095 seconds