Having problems with your Whirlpool 24 in. DU1055XTP Built-in Dishwasher ?

Not much water pressure

\015 I have been having problems with my Whirlpool DU1055XTP off and on for the last year or so. The top rack dishes aren't getting cleaned. I changed the water inlet valve, and it seemed to help for a short while. Then I started getting all kinds of white grittiness all over the dishes. I open up the bottom and made sure it was all cleaned out. It seemed to work better for awhile. Now I'm not having enough water pressure agian to wash the top dishes. After inspecting the drain tube coming out of the bottom of the dishwasher, I came across a little round black rubber disk that I had forgotten about. Not sure where this goes or if this could be causing my problems or not. I do have the one rubber flap valve thingie with the round bottom and rectangular top. It is installed and seems to be okay. Help please I'm at my wits end!!!! BTW, we were using gel soaps and have since swithced to powder and have turned up our water heater. Our water here is extremely hard. Help!!! Thanks in advance everyone.\015

Answers :

At this point, your motor that drives the wash pump is beginning to fail. Replacing it will fix your problem with it having water pressure and cleaning properly.\015\012
\015\012As you replace the motor, the impeller should be provided as well.\015\012
\015\012Good Luck!
Hard water is the reason for the spots. There is a new product out at www.dishwasherfilter.com that is made specifically to fix this problem. It filters the water going only into your dishwasher leaving your dishes spot free with every load. It is very affordable and guaranteed to work or your money back. You will love the way your dishes look after the very first load.
Repair Help & Product Troubleshooting for Whirlpool 24 in. DU1055XTP Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Frigidaire built in dishwasher model PLD2855RFC1. Have to wash dishes pretty much spotless prior to using dishwaser. Glasses come out with what appears to be soap residue regardless if powder or liquid. Did not use a gauge but water pressure in rest of house is good, recently replaced water heater, pressure regulator and just replaced the dish washer water source valve. Washer is about 18 months old, has never worked really well.


Hi, \012\012I have an older dishwasher also and recently my wife also complained about it not cleaning right... so me being the man I am tried in vain to clean the things... Bought new spray arms online and ins ... Frigidaire PLD2855RFC Dishwasher

I have a kitchenaid Model KUDW03CTBL2 dishwasher. It is pumping water, but the top sprayer and the one under the top rack just have a little water coming out. Not enough to make them spin. We also noticed the water in the bottom when opened is not as much and it is cool not hot. The dishes on the top rack will not clean, and the bottom is not completely clean. We have checked water pressure and water tempurature through the house, All is operating fine. This dishwasher is only 1 year and 10month


... KitchenAid Dishwashers

I have a Whirlpool dishwasher model number DU1055XTPQ4 that is not cleaning the dishes. When the dishwasher is working, the bottem arm is turning and water comes out the holes. The middle arm has some water coming out, but does not turn. The top arm does nothing. It appears I have a pressure problem. I took out all the arms and cleaned them, along with the plastic tube that feeds them water. They had some build up on them but not much. I have the same result as before. I took off the


... Whirlpool Dishwashers

Water pours out the other end of the pump opposite the pressure hose connection. It has a clear plastic cap with a small **** in it. Looks like water should escape here but way too much water being pumped out.


... Pressure Washers

Hi- I have a Simoniz S1600 pressure washer. Usually when I start it, the motor kicks in to build up pressure. Now it won't kick in no matter what I do. A small stream of water will come out but there is no pressure. There are no reset buttons on the exterior of the machine. Thanks so much.


... Black & Decker Pressure Washers

I have a McCulloch FH160B power washer and it no longer builds up pressure. I haven't used this very much at all. I tore it apart and cleaned everything I could find. When i pull the trigger for the spray nozzle, I get line water pressure. When I release the trigger, the power washer sounds like it starts to build up pressure. When this was working correctly, the pump would shut off when the trigger was released. Any suggestions?


... McCulloch Pressure Washers

My pressure washer leaks water out the back form some kind of valve that has a hole in it. the pressure washer will flow pressure but not as much as it did.


... Briggs & Stratton Pressure Washer Projectpro Spray Nozzle

When I power the Karcher 520M water pours from the handgun - there is now leak until pressure is applied. the pump does not cut out but I don't know if this is a problem with too much pressure causing the leak or too little pressure because of the leak. there does not seem to be a way to dismantle the handgun - is this correct Bill


Not too much pressure, a bad gun.Unfortunately you will have to replace the gun. About $65.00 Canadian ... Karcher 2500 PSI Pressure Washer

Not much water pressure


At this point, your motor that drives the wash pump is beginning to fail. Replacing it will fix your problem with it having water pressure and cleaning properly.\015\012\015\012As you replace the motor, the impeller should be provided as well. ... Whirlpool 24 in. DU1055XTP Built-in Dishwasher

Frigidaire Dishwasher Lights wont come on, hit start button, makes noise, no water then eventually shuts off. Couple weeks ago, had work done to furnace now not much water pressure in house...


Find your main stop cock in your household for cold water supply and make sure it is fully open(anti clockwise).If this makes a difference to rest of house, then your washers pressure should be fine too.If still same problem, check your washers fill ... Frigidaire 24 in. PLD2850 Built-in Dishwasher

AT FIRST WITH JUST THE WATER ON (PUMP OFF) I SQUEEZE THE WAND AND WATER COMES OUT ABOUT 3 FT. THEN WHEN I START THE PUMP AND SQUEZE THE WAND ONE STRONG SQUIRT COMES OUT THEN GOES BACK TO ABOUT 4 FT. NOT MUCH PRESSURE. CHECKED THE CHECK VALVES, AND THE 3 PISTONS THEY ALL WORK. PUMP NO.AXD 3020


Hi, W/D here.Leave the water on, and hold the trigger down for about 5 minutes to get all of the air out of the system. Letting off of the trigger occasionally and then opening it up will help displace any air in the chambers. While still hol ... Comet Axd3020g Pressure Washer Pump 27 Gpm 2000 Psi

Have NEFF built-in dishwasher Typev S9WIF Enr - S5543X1GB/17: FD - 8203 670150. The problem is that the detergent tablets - FINISH ALL -IN - ONE Power Ball are not dissolving, although they have been "wetted". The water pressure is set to maximum, and the spray arms rotate freely. Live in the far north of Scotland so is not a hard water area. Any suggestings as to the cause would be much appreciated. Regards


Thanks for providing the full product code for your dishwasher. This helped identify its user manual very easily form the Neff website.\015\012\015\012Question - have you been using Finsh all-in-one power ball with this unit belore? ... Neff Dishwashers

Have a honda gvc 160 power washer. It works ok for a while then loses all pressure. It seems as though when it is not running and the water is attached there is not as much water coming through. Is there a screen somewhere that might be plugged?


Sounds like the machine is not getting enough water.\015\012Please check your water pressure to the machine and also the water inlet filter in case its a little dirty. ... Campbell Hausfeld PW2102 Gas Pressure Washer

Have a Karcher kb4040 that continues to run constantly even when the trigger isnt pressed. Also water flows out of the detergant hose when im not pressing the trigger. Pressure seems down slighlty, not much. This happened after i ran water out of trigger gun with no lance attached, machine switched on. Seems to leak from trigger handle aswell. Many thanks in advance


This is two things. One is the back flow check valve to the soap line is leaking. The other is the pressure switch on the output side of the pump. ... Pressure Washers

Motor starts, stops, starts, stops etc never running completely. not putting out much water pressure. not building pressure??


Is you nozzle plugged? That is what this sounds like. ... Karcher PSI Electric Pressure Washer

Wont put out much pressure and burner wont work, and there is grey water coming out of the pump on the top. like it has oiland water mixed together.this is a northstar 240 electric steamer


... Northstar Electric Wet Steam & Hot Water Pressure Washer 2000 Psi, 1.5 Gpm, 120 Volt

Get E17 error which bosch tells me is due to too much water pressure. Have reduced pressure by closing off inlet tap as recommended but now can't seem to RESET the dishwasher. Held down START button for over 3 sec, but nothing happens.


... Dishwashers

EXWGV2121 I am not getting any water at all from the outlet hose. I replaced the manifold and no valves are sticking or seals bad. Don't know much about gas pressure washers


... Pressure Washers

The power washer turns on and everything but the water does not come out with much pressure. What seems to be the problem


... Craftsman 2500 PSI Briggs Stratton Powered Pressure Washer

Dishwasher filling up and over flowing. switch to turn on pump comes on late or when I manually put pressure on drain. Have hard water and found much scale. could sensor/float scale cause this? Thinking about filling with white vinegar and letting sit so I don't have to take apart. Thoughts?


Take a packet of unsweetened lemonade any brand and run it through a cycle. This will clean all the scale and calcium from the pump and spray arm to improve the circulation of water in the machine. ... Asko Dishwashers

Cant start the unit ,there is to much pressure on the pull chord when water is hooked up.


I have also had this issue if you squeez the triger on the the gun while you pull the start you will be ok, I know this is ghetto but otherwise a quick fix lol ... Northstar Professional Series Pressure Washer 4000 PSI

I'm trying to find out how much oil should be in the water pump of a honda pressure washer model xr2750-1


It's an ex-cell pressure washer with a honda motor.engine oil capicity: 0.61 qts(.58L)view owner manual here:http://www.excellpressurewasher.com/documents/pdf/a12338-e.pdf ... Honda Pressure Washers

Not very much water pressure inside washer - KitchenAid 24 in. KUDI02IR Built-in Dishwasher


The majority of problems with low pressure is there is a filter screen where the hose connects to the washer unit. \012Disconnect the hoses and look there.\012Check that first and make sure both of those screens are clean. If they are clean, then th ... KitchenAid 24 in. KUDI02IR Built-in Dishwasher

I have an 1200 psi electric pressure washer and the pump turns on but does not shot out very much water at all..Not sure what the brand is due to it being bought by a customer who asked me to help him


... Pressure Washers

Karcher professional hds 655 steam cleaner not much water pressure


If there is nothing wrong with the machine but you have lost power over the years you have been working it. It could be that the machine needs a new pump kit or/and change the pressure nozzle.smaller issues could be that the pump isnt turned to h ... Karcher Pressure Washers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1315 seconds