Having problems with your Whirlpool 24 in. DU1055XTP Built-in Dishwasher ?

''Clean'' light is blinking, ''Cancel'' does not reset the cycle.

\015 I have killed the power in an attempt to reset the machine. However, the ''Clean'' light returns to blinking when power is restored. Pushing the ''Start'' button causes the start light to blink three times, then the ''Clean'' light starts blinking again. How do I reset the dishwasher so that I can run it through the wash cycle??\015

Answers :

If the clean light flashes 7 times, pauses, then repeats...

When\015\012the dishwasher doesn't sense a water temperature increase, it stops working and locks the functions (clean light flashes 7 times, all\015\012buttons are non responsive). It does this as a safety in case the\015\012element is broken and feeding electrical current into the water.

To resolve this you will have to reset the console. Do this by closing the door and press these buttons in sequence...

-high temp wash
-heated dry
-high temp wash
-heated dry

...all\015\012the lights will turn on briefly and the machine will start a diagnostic\015\012cycle. You can press cancel or let the diagnostic cyle finish (1-2\015\012minutes).
You should now be able to run the dishwasher as normal.

If\015\012the issue returns, you could have a problem with the heating circuit\015\012(ie. element, thermostat or wiring).
It rarely happens but it could\015\012also be the door switch not engaging properly when the door is closed\015\012(slightly bend the door latch down making sure it doesn't hit the door\015\012when you close it).\015\012\015\012\015\012\015\012\015\012\015\012

Good luck!
Hi r2strelioff,
Does the machine need cleaning? Most dishwashers require a cleaning routine usually with dishwasher salt to be followed when the 'Clean' light comes on. There may be a separate compartment inside, near the back.

Regards,
Mark.

Repair Help & Product Troubleshooting for Whirlpool 24 in. DU1055XTP Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

''Clean'' light is blinking, ''Cancel'' does not reset the cycle.


If the clean light flashes 7 times, pauses, then repeats...When\015\012the dishwasher doesn't sense a water temperature increase, it stops working and locks the functions (clean light flashes 7 times, all\015\012buttons are non responsive ... Whirlpool 24 in. DU1055XTP Built-in Dishwasher

It won't start. The clean light is blinking but it won't reset to start a new cleaning cycle. the cancel function work and it will drain the basin but that is all.


Hello & Welcome to FixYaFlashing clean light is reset by pressing two buttons in sequence 3-4 times, to reset your kenmore press these buttons in sequence:High temp wash-heated dry-high temp wash-heat ... Dishwashers

Hi...my dishwasher 'clean' light continues to blink. I can hit cancel and it sounds like the cancel cycle is running. After that the light keeps blinking and I can not start the machine. If you hit start the light goes on, then stops, and the clean light flashes again. Any clues? Thanks!


Sounds like the control board or panel is shot. What is the model number of the unit, and serial number? ... Dishwashers

Kenmore Dishwasher Model 665.11643300 Cycle will not run. Normal Wash light blinking Cancel light will also blink (but can be cancelled by holding button down) I tried shutting down the power and resetting at the breaker. I tried other buttons like Air Dry, etc to see if there was some sort of sequence Note* last cycle ran was rinse cycle many months ago - house has been vacant and dishwasher has not been in use.


I will look a bit further in detail about your dishwasher problem. I am assuming you have checked the inlet water tap to the dishwasher is turned on. ... Dishwashers

The green clean lights blinks constantly, It will not allow me to cancel and when I try to start a new cycle the start light blinks a couple of times then the clean light starts again, but nothing happens.


... Whirlpool 24 in. GU2548XTP Built-in Dishwasher

Kitchenaid model KUDIO1ILBL6 The lights for Heavy Cycle ,Normal Cycle and Cancel blinking at the sametime constantly. The tech sheet is missing and the unit is appox. 5years old.have shut power down for 5 minutes .When power turn back on only the Heavy Cycle light blinks costantly. Have Ohmed out the door switches and check adjustment OK. Checked board strips and plugs for good clean and tight connections OK. Thanks


Hi, You need to reset the unit by pushing the buttons. Push the heated wash/heated dry a few times. All the lights will light up and the dishwasher will continue its . Let ... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

I have a Sears Kenmore Elite Ultra dishwasher 665.1315 model. For the last 3 weeks, it keeps having the clean light blinking 6 times pause then 1 blink and pause and repeats cycle again. I have turned off the breaker...I have reset by pressing the heated dry and normal wash until all lights are flashing. It then completes some type of cycle and looks ok. When I opened the door, steam came out and all was hot inside. However, once I try any new wash cycle, it seems to wash but after 1-2 hours and


Call sears service and tell them you need service there is a service flash and will be no charge ... Kenmore 24 in. 15932 Built-in Dishwasher

I have kenmore 665-16032401 clean light blinking and cannot reset cycle. Power was out for several hours, happened during wash cycle possibly, when came back on the light is blinking and cannot clear it or resume anything.


... Kenmore 24 in. 16032 Built-in Dishwasher

I have a Whirlpool DU1048 that started out with a blinking clean light. I reset the dishwasher by pressing the heated dry and normal buttons twice. That worked the clean light stopped blinking. The problem now is the dishwasher seem to be stuck in the wash cycle. I finally have to turn it off after over an hour washing. Is this possibly a heating element problem? is that user replaceable?


... Dishwashers

My dishwasher's clean light will not stop blinking and it will not allow me to start a new cycle. I have canceled the cycle unplugged it and let it sit but the light is still blinking


Your\015\012dishwasher will do this as a safety in case the element is broken and\015\012feeding electrical current into the water. Sometimes just a false\015\012reading.Reset your console by pressing: ... Whirlpool 24 in. DU1055XTPS Stainless Steel Built-in Dishwasher

Whirlpool gold, about 2 years old. the "clean" light is flashing. When I hit cancel, a 2 minute dry(?) cycle runs. The clean light resumes blinking. It will not start a new cycle


Looked in the manual and called a repairman ... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

I have a Whirlpool Gold Quit Partner III, model GU1100XTLB1. When I run the normal cycle it functions well until near the end. At that time the unit stops and the pots&pans indicator light blinks. If I hold the cancel button in the unit drains then refills and the light starts to link again. I don't know how to reset this unit because I only have air dry. If I leave the power off for a day I can get the unit to reset. If not, it just fills back up with water and the pots&pans starts blinking aga


... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

My Kenmore Dishwasher 665.16359301 quit working. I flipped off the breaker then back on again. The cancel light comes on and it sounds like its going to drain but theres no water in it. After about 20 seconds it stops and the normal wash cycle light starts blinking. Thats it. I did the reset procedure and it started to work then went back to the normal wash light blinking.


... Kenmore Dishwashers

I got a GLD4400N00WW dishwasher, The normal and headed dry lights blink. I already replaced the touch pad. Once your reset the d/w and shut the door the lights will come on and you can start the cycle. Once you press the cancel button the lights blink and thats it....


... GE Profile PDW8400J Built-in Dishwasher

I have a whirlpool model KuDSO1FL and the clean light blinks and won't start after the cycle has been selected and the start button is pressed. I have tried canceling the cycle but it won't work. The dishwasher was working yesterday and today it drained once we cancelled the cycle and then pressed start but that is all that we could get done. I don't know what the problem is.


Your appliance's clean light blinking will require a service call. It could be several things indicating a problem that are not serviceable by the home owner. You can try turning the power off at the breaker box, then turn it back on and see if this ... Dishwashers

Kenmore Elite model 565.13429K701 will not run. Clean light blinks several times after any cycle is attempted. Cancel just blinks and won't work. Last cycle never ran to completion.


... Kenmore Dishwashers

I have a blinking cancel light on model GU1200xtlt1 and will not start in any cycle. Also if I push another button it flashes rinse button and cancel button. Before this it ran in Sani Clean over and over again and I could not change the cycle. I emptied out a bit of water from the bottom because it did not drain also and the water was not smelling too good.


... Whirlpool Dishwashers

Kenmore model 665.16049400 clean sensor blinking machine will not reset to start new load of dishes.have tried the cancel button. if i choose a cylce and hit start it just sits there with the clean sensor light blinking


... Kenmore Dishwashers

I have a KitchenAid KUDp02FRSS1 dishwasher and it will not respond to any buttons being pushed. The Normal, Light China and Cancel lights continue to blink. I have tried reseting the circuit breaker to power cycle the machine but when I turn the power back on it just continues to blink.


... Dishwashers

Whirlpool GU2300 built in Dishwasher. It rather suddenly began shutting off in mid-cycle. If I cancel or open it, getting it to finish the cycle or even drain takes many tries.Once started, the cycle might take several hours with long pauses during the cycle. When it puases, none of the lights are on at all. If the cycle is disturbed, the normal wash light blinks, and if I hit cancel, the cancel light and the normal wash light blink.


... Whirlpool Dishwashers

Kitchenaid dishwasher - green light blinking on clean cycle.


... KitchenAid Dishwashers

Will not go through a compleate cycle and then the clean light comes on and blinks 7 steady blinks and stops the blinks again and i cant start the dishwasher unless i reset the dishwasher and then it does the same thing


Hi angelbme1,\015\012\015\012I'm Harvey the Master Plumber.\015\012\015\012Your problem is: will not go through a compleate cycle and then the clean light comes on and blinks 7 steady blinks and stops the blinks again and i c ... Dishwashers

Kitchenaid kudp02cr Dishwasher has a blinking drying light during wash cycle, when we cancel it shows the washing light on soild. We have tried resetting the panal, but it isn't stopping. WHat do we need to do and is something wrong with the system.


... KitchenAid 24 in. KUDP02CR Built-in Dishwasher

Whirkpool quiet partner 3 dishwasher status stuck on clean. If I press cancel it goes into a 2 minute drain cycle, but there is no water in it. It will no reset or start....just blinks clean.


If you have a heated dry option and normal wash option push those buttons back and forth three times all the lights will come on reseting the board..\015\012push cans. and your done\015\012if this happens again that means you have a bad h ... Whirlpool Dishwashers

I have a kenmore elite dishwasher, right now it seems to be stuck on the clean cycle the green light blinks on clean,, i pressed start and nothing happens i also press cancelle and nothing happens is there away to reset this or would something be broke


Hi,\015\012\015\012You can also pres "normal wash" and "heated dry" buttons back and forth till all lignts comes on, and it will reset the dishwasher and work normal again..\015\012\015\012But if you get this problem frequent ... Kenmore Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1642 seconds