Having problems with your Whirlpool 24 in. DU1055XTPS Stainless Steel Built-in Dishwasher ?

Du1055xtsd2 whirlpool dishwasher runs but doesn't fill with water doesnt cycle


Answers :

A few things could be wrong.
\012
\012It can't cycle without water. be sure you have water at the valve under the dishwasher. You should be able to see it by dropping the front plate under the DW.
\012
\012If you have water pressure, then check for voltage (120) at the valve with the timer calling for water. ( start of cycle).
\012
\012If you have voltage and pressure, replace the valve.
\012
\012If you don't have voltage, it could be the little switch inside the DW. It pulls up and down. The level switch could be bad.
\012
\012If that doesn't do it, it may be the timer or the door lock interface.
\012
\012Good luck.
Repair Help & Product Troubleshooting for Whirlpool 24 in. DU1055XTPS Stainless Steel Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Du1055xtsd2 whirlpool dishwasher runs but doesn't fill with water doesnt cycle


A few things could be wrong. \012\012It can't cycle without water. be sure you have water at the valve under the dishwasher. You should be able to see it by dropping the front plate under the DW.\012\012If you have water press ... Whirlpool 24 in. DU1055XTPS Stainless Steel Built-in Dishwasher

My Whirlpool dishwasher isn't filling with water. It runs the cycle but obviously doesnt wash.


The water valve is bad or the board check to see if 110 volts is comeing to the valve with a volt meter ... Whirlpool Dishwashers

GU2700 Whirlpool - Does NOT FILL 2 Gallons on INITAL FILL - unit has new parts FILL VALVE IS NEW OVER FILL SWITCH IS NEW while filling if you reach under the unit and push the over fill float up it turns off the fill cycle - if you let go - unit keeps filling - but does not add the correct 2 gallons - water is not even close to the heating element - does not have enough water to come out of the TOP SPRAY Arm


... Whirlpool Dishwashers

Item: Whirlpool Ultra Dishwasher Age: 3 yrs Problem: Not enough water to effectively wash the dishes. State: When the dishwasher is started, the fill valve opens as normal. Only about 1/2 the amount of water is let in when the pump turns on and the washing cycle begins. Opening the door shows that the water level does not reach the bottom of the float. When I close the door, the wash cycle begins again but stops after a few seconds. This is when the water begins to fill again. This time, the wat


Larry,The float is generally for overflow conditions and will interrupt power to the fill valve solenoid. If you are not filling completely in the time allowed by the timer, it is most likely a flow restriction in the water ... Whirlpool GU2400XTP Built-in Dishwasher

Jackson jp-24b purchased this machine used, cant figure out how to work it. I flip the auto cycle on, and then the power switch. The fill light turns green and i assume water is filling up in the machine. In the meantime there are two small red external hoses that hot water comes and i currently just have those hanging in the sink. At the same time, nothing is happening during the wash cycle, the wash gauge doesnt even move only the rinse gauge. Also when i try to drain it nothing happends (begi


It needs a new drain relay box 120 volt the drain is stuck open the jp 24 were not very good machines the red lines are drain lines if you plug up the drian lines at fillup the machine will wash but now it will never drain a new drain box is not c ... Jackson JP-24B Built-in Dishwasher

I have the Whirlpool Quiet Partner 1 the wash cycle starts and about 20 Min.'s into it the clean light starts flashing or the the start light, one or the other each time and it wont dry the dish's anymore we have already replaced the panel once and it has always popped when it is filling with water or changing cycles. HELP!!!! I hate washing dish's and I am beginning to hate all Whirlpool Appliances.


If the clean light blinks 7 times thats you heating circuit. Test the heater with an ohm meeting to see if it has open. If so order the heater kit and it comes with the control board. ... Whirlpool GU2400XTP Built-in Dishwasher

My whirlpool GU2300XTSS0 dishwasher does not cycle between wash/rinse/dry cycles. It fills, washes, drains and refills in the same cycle. What can I do to solve or check for solutions to this?


Hello,\015\012\015\012This means the software in the control board is corrupt. YOu would need to try a power cycle, if that does not work, replace the control board to fix the issue. You could purchase the control board from the link below. Typ ... Whirlpool GU2300XTSS Stainless Steel 24 in Builtin Dishwasher

Whirlpool dishwasher model DUB700XB has quit cycling. Fills with water but will not start wash cycle. Making intermittent humming noise unless the door is open to disengage the switch, even when on stop. No LEDs lighting when rotating the dial through the various cycles. Unit is old and wondering if it's better to buy a new one rather than fix this and have something else go wrong in the not to distant future. Thanks in advance


... Dishwashers

Yes I have a whirlpool DU1345XTVB1 dishwasher. Just got in July. After each wash cycle the dishes are not dry. I have been using Finish gelpacs w/jetdry & also have a off brand drying agent in reservior to help dry dishes. The water temperature is set pretty hot & washer is draining good. I have tried checking wash cycle a few minutes into 1st cycle to see if water is in filling & heating. Didn't know if maybe heating element going out or thermostat not working? Thank you for your time.


<span style="FONT-FAMILY: 'Trebuchet MS'; FONT-SIZE: 10pt; mso-ansi-language: EN" lang="EN">Hi,<br />Check your heating element.. </span><br />\015\012<span style="FONT-FAMILY: 'Trebuchet MS'; FONT-SIZE: 10pt; mso-ansi-lang ... Whirlpool 24 in. DU1050SS Built-in Dishwasher

Dishwasher (Whirlpool Model DU930PWQ0) won't pump out. Problem occurred after door was opened during a cycle. Then the pump-out function ceased to work. Washer fills and pumps correctly during the wash cycle. Any suggestions? My guess is that the electronic control may be faulty and it is not opening the solenoid valve for the drain cycle. The other option I have thought of is that the solenoid valve may be faulty and is not responding to the signal from the controller. The dishwasher is n


... Whirlpool DU930 Built-in Dishwasher

Hi, have a whirlpool portable dishwasher WBC25003. I don't think it's filling with enough water. Can you tell me how much water should be in it once the fill cycle has been completed?


... Whirlpool 24 in. DU850SW - Multiple Color Free-standing Dishwasher

My whirlpool dishwasher is ocasionally filling back up with water, whether the door is open or closed, and regardless of of control panel being lit. It happens, then leaks out the front. If i run the cancel drain, it will pump out the water just fine. All the other cycles are working just fine, and it leaves no water at the end of of the cleaning cycle. I have found no common occurance for this


Greetings,\012\012 in most instances the water inlet valve is leaking..this is the water valve that brings water into the dishwasher...its possible, the drain water is running back into the d/w from the drain hose not installed prope ... Dishwashers

I have a neff dishwasher that is maybe 5 years old. im pretty sure there is nothing wrong with it as it was working perfectly fine before i had a plumbing problem a few days ago. after the plumbing problem was fixed the dishwasher doesnt seem to want to fill any longer. it sounds like it wants to work but its just not filling and going thru the cycle. does it just need to be reset or something? im not sure of the model number as ive misplaced the directions for it. could you please help? by the


Look for the connection from the valve to the inlet of diswasher. Check the hot water valve to be on. It is probably closed when anyone working on the plumping. Good luck. ... Neff 24 in. S5443X2 Built-in Dishwasher

Frigidaire dishwasher model fghd2433kb1 fills with water but then doesnt start wash cycle makes intermittant humm sound like trying unsussessfully to go into wash cycle


... Frigidaire Dishwashers

Have a Whirlpool Dishwasher 6ADP 5540. Starts cycle - fills water then about a minute into it the start buttons flashes 6 times and will not continue on. Very rarely, the cycle does continue on. Have turned off at the main switch. But still have this problem. Look forward to your reply. Cheers, Jodie


Hi Jodie,\015\012\015\012An F6 fault code - indicated by the green light flashing in sequence next to the start button - is indicative of a water inlet problem. \015\012\015\012First of all check that the water tap the dishwah ... Whirlpool 24 in. ADP6940 Dishwasher

Whirlpool dishwasher du930pwsq0 doesnt cycle - Whirlpool DU930PWS Built-in Dishwasher


... Whirlpool DU930PWS Built-in Dishwasher

Cda cw 494 - dishwasher makes beeping noises and stops halfway through cycle . will restart if turned off but will not complete . doesnt seem to be filling properly .now and then does complete cycle and works fine .cheked water supply - ok.


Greetings,\015\012 usually, open and close door..then start counting the flashes. these will give you your fault code. The code then tells us where to go from there. off hand, i would say you have a heater problem.. Either, the water is not ... Whirlpool Dishwashers

My whirlpool dishwasher starts the cycle but then just stops 2mins into cycle. If fills with water and then just when I think it is gearing up to heat the water it stops.. Can you help me?


Micro-controller is behaving erratic. You have to check with another set of PCBs ... Whirlpool 24 in. DU1100XTP Built-in Dishwasher

My dishwasher fills with water then doesnt switch to the next cycle and keeps filling and overflows.


THE PROBLEM MOST LIKELY WILL BE WITH THE FILL CHAMBER, CHECK TO MAKE SURE THATS ITS NOT RESTRICTED,SOME TIME THEY REDUCE WITH LIME SCALE, GIVING A FALES READING THAT THE MACHINE IS FULL,THEN RESTARTS THE FILL PROGRAME AGAIN ONCE THE AIR PRESSURE REDU ... Danby 22 in. DDW396 Free-standing Dishwasher

I have a Whirlpool adp 5656 and the green light on the front is flashing and it wont go into a wash cycle. The common answer to this is to switch the machine from cycle to heat mode and it will reset however this machine doesnt have those facilities, can you help.


You seem to have the question and the answer but I think this is more than a reset. you will have to observe when the fault happens to arrive at the solution.\012Check if the inlet flow is good there is no dirt inthe filter, the water levvel pr ... Dishwashers

I have a whirlpool gold gu2500xtps7 and it fills up with water but the cycle doesn't start. It sounds like the motor or pump to start cycle just hums


... Stainless Steel Whirlpool Gold 24 in BuiltIn Dishwasher w Adaptive Wash Cycle Dishwasher

We have a Whirlpool ADP962 Dishwasher that will not fill. I replaced the inlet hose as I thought the solenoid was faulty. It's gone a step further and now sounds like it fills (continuously) however it soon drains without any water entering the dishwashing compartment (this remains dry). I believe this issue was caused by running it through a cycle without the water mains turned on. Any ideas?


Hi.When you say inlet hose I think you are referring to the inlet valve, which has a built in solenoid. The inlet hose is only the rubber hose connected to valve and faucet.Rather than the hose the problem is likely overfill d ... Whirlpool 24 in. DP840D Free-standing Dishwasher

Have a whirlpool washer and it would not stop filling so I turned off the water facets and bailed out the water and then ran rest of water out on spin cycle. I unplugged washer and turn hoses back on and water still came in could it be the "fill valve". thanks sharon


... Whirlpool DU805DWG Dishwasher

Whirlpool DU840SWLU0 doesn't fill with water on rinse cycle


... Whirlpool Dishwashers

Tub not doesnt fill with water but does dry. goes thru cycles


Make sure you get water to the dishwasher. Check to see if the water shut-off valve (located under the sink) is open. If you get water to the dishwasher, but there is still no water inside during the fill cycle, the problem might be with a faulty wat ... Kenmore 24 in. 16032 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1054 seconds