Having problems with your Whirlpool 24 in. DU1100XTPS Built-in Dishwasher ?

Washer will not start

\015 I have a Whirlpool GU2500 that will not start. The drain cycle will start if the cancel/drain button is pushed. If I push the start/resume button the light above it blinks 3 times and nothing happens. The clean light is also continuosly blinking. I can not afford a service call, any thoughts or suggestions that may help?\015

Answers :

Does the dishwasher plug in under the sink or is it hard-wired? If it plugs in under the sink unplug it and let it stay that way for 5-10 mins and see if that changes anything. If it is hard-wired see if you can figure out which breaker it is on and turn it off for same amount of time. Let me know.
\015\012
\015\012
\015\012Thx
Repair Help & Product Troubleshooting for Whirlpool 24 in. DU1100XTPS Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have whirlpool Dish washer model GU 120 ES (bought in 2001). When we start the dish washer cycle the unit starts for a minute, then the "start indicator" light flashes. As indicated in the instructions, we press the "start button" for five (5) seconds, at this time the washer clears the water out and stops. If you can assist this would be greatly appreciated. Thanks Jeff


I called the service tech.... ... Whirlpool Dishwashers

Home Depot has a lawn mower with the Honda GCV160 Electric start version engine. They also have a pressure washer with the Honda GCV160 engine. I have a disability that makes it difficult to pull the starter rope. I would like to get the electric start on the pressure washer. My local Honda bike shop service center said they use different blocks. Can I get a pressure washer pump mounted to the Honda GCV160 Electric start version engine? If necessary, are there adapter plates that can be purchase


... Karcher 2500 PSI Pressure Washer

I have a Kenmore 665.16039401. The 3 right hand buttons on the keypad; Delay Hours, Cancel/Drain and Start/Resume do not respond and I cannot start the washer. Doing the self-diagnostic test by pressing "Heated Dry - Normal Wash - Heated Dry - Normal Wash" results in all of the LED's lighting and the washer starting a full 20 minute self-test cycle in which all functions seems to work properly. Opening and closing the door during this testing stops and then re-starts the washer appropriately


... Dishwashers

I have a Maytag quiet series 400 dishwasher. I set the required buttons for a wash, inserted the soap in the soap tray but the machine will not start. Previously, when the washer would not start, I opened the door and pushed down on the soap tray and its seemed to fix the problem. Next time I used the machine, again not starting, but by pushing on the soap tray it would not start. Can you suggess what the trouble may be or give me a check list that I may do before starting the washer. This machi


... Maytag Dishwashers

When I press the start/resume control, the dish washer start/resume light blinks 2 to 3 times, then turns-off. then the dish washer beeps several times; however, the dish washer does not start. when turned the breaker switch off and on, and then I press the start/resume control, the dish washer go through a normal wash cycle. The next day when I press the start/resume control, the same thing happens. 2 to 3 blinking lights followed by beeping for several seconds. Dish washer does not start


... KitchenAid KUDC10IXSS Builtin Dishwasher

When it starts i can hear water inter washer, but it does not pump water into the spin jets after a few minutes it makes a peebing sound and the washer, dry, clean buttons starts flashing and it dose


... Samsung DMT300RFS Builtin Dishwasher

Have a Husky Pressure Washer 2200 psi, HU80931. I don't have an owner manual. It has set for about a year. When I started the washer there was very little pressure. Did some cleaning and it was a little better, but now there is no pressure and I am having trouble keeping it started. Can you help? The washer was purchased at Home Depot and it has Briggs and Stratton the the washer too. Thank You, RJ


Look at eReplacementParts.com and the parts diagrams ... Briggs & Stratton Pressure Washers

The washer will not start when the water is turned on; once the water is turned off the washer will crank. Within seconds of starting the washer the water supply is turmed on and the washer stops running.


... Campbell Hausfeld Pressure Washers

The washer cycle stopped without warning, i thought the timer or the timer motor but it is not the timer works fine and so is the motor. but the timer motor runs til the washer motor starts than is the timer stops and the washer is working but not cycling so no rince or drain or soap etc... just pumping water. if you can tell me what might be the problem, thank you. like i said the timer stops when the washer motor start.


... Jackson JPX-300L Dishwasher

2050 PSI Gas Pressure Washer - 20244: my excell pressure washer wont start. pull start t...


... Briggs & Stratton Gas Pressure Washer 20244

I have a Bosch dishwasher, stainless steel front- with buttons on the inside top( same as display, and the washing cycle won't start. Water seems to be running into the washer, as I can hear it, but the cycle never starts. Recently, I had clogged garbage disposer issue that has been resolved. The dish washer drains into the disposer, and I had free standing water left behind in the washer for 2days during this time.. Could this be the issue? Can you help me figure out this problem? Thanks!!


... Bosch 23 in. SHU 8805 Built-in Dishwasher

Hi i recently started to have issue with my dishwasher. The issue is that the washer stops in the middle of the washing cycle. More specific, once i start, it stops about 20 second latter. Once i push the door of the washer it start to work again for another few seconds any ideas?


There is some mechanical problem.Check water flow. Free rotation of spray arms. Refer user guide. ... Dishwashers

Wont start I've had the washer for many years with minimal problem. Yesterday when I closed the door no light went on and the washer would not start.  After 20 minutes or so it suddenly went on and worked fine.  I thought that it might have not completed its last cycle. Today, however, I had the same problem and it's been over an hour and still hasn't started. (I checked the circuit breaker and it's fine)


Give it a firm push over the door latch once you've closed the door..it might be the door switch not activating. oops.... first and formost isolate from power for 5-10mins and try ... Bosch 24 in. SHU43 Built-in Dishwasher

I have a craftsman 4.5hp quantum xte pressure washer 1800psi/4.5hp/2.0gpm mod 580.761800. I have to start the washer before I turn the water on and just today started with if I let go of the trigger on the wand the washer stalls. Can you advise as to what the problem is and how to solve? Thanks ****


The pressure relief valve(bypass) is most likely stuck or clogged. take the relief valve off and check for broken or jammed parts..there should be a bypass hose that goes around the pressure valve ... Briggs & Stratton Pressure Washers

Model number 66515632000 Kenmore Ultra wash with quite guard about 8 years old Washer stopped near end of rinse cylce, dishes look clean, water in washer did not drain and looks clean. All attempts to restart washer, or hit drain etc result in attempt to start and then it stops. sounds like trying to start a car with a very weak battery.


Unfortunately it sounds like you have one of two possibilities. A) You have something like a piece of glass or food ect. that has worked its way down into your pump and is tying up the impeller or pump as its trying to start. -To op ... Dishwashers

My Bosch Dishwasher does not drain all the water out of the dish washer after the finishing cycle...I usually start the washer and then push the drain cycle and it starts to pump for about 10 seconds and stops and starts and pumps again for 10 seconds and stops and then pumps for about 25 seconds and stops....doing this manual drain twice empties the dishwasher of the excess water....what may the problem be?


... Bosch 24 in. SHE43C05UC Stainless Steel Free-Standing Dishwasher

Briggs and Stratton pressure washer will not start. I have a 6.75 hp pressure washer that is only a year old. when I pull cord it turns over but does not start. I changed plug and checked it, I have spark when pulling. I have 40-50 psi of compression when pulling also. gas was drained and is brand new. it was working fine last time it was used. I have tried starting it without the water line or spray wand hooked up and no difference. After about 10 or 15 pulls, can smell gas when I am trying to


Hello dave, the problem is compression to low,you need 60 to 130 lbs to run engine,check for blown head gasket,or bad rings,or a stuck open valve,hope this helps,, ... Briggs & Stratton Pressure Washers

How do i turn on the water for my washer?I just moved in to my place, tried to start the washer but it started spinning before any water came in. I think the water must be switched off. There are two taps opening pipes going into the washer, a blue and a white one. Should I try opening one of these?


Yes open both of them they are the feed lines for the washer ... Dishwashers

Started washer, heard 'pop', water started coming out of bottom


Thats not good. Sounds like the seal blew out. Inside the unit there are seals that seal up the parts where they are bolted together. Also there is the pressure connection that could have blown out as well. To determine which is the problem you will ... Karcher K 593 M Electric Pressure Washer

I have DeWalt3750 psi pressure washer, its been long time since I used it, now that I wanted to use it, I can not start it. I already changed the oil and filled it up with new oil but still can not start, What is wrong with the washer? thank you


Here is the long answer with everything we learned while using a power washer twice a day for years::This assumes you did not turn power washer over or on its side to drain oil, or dirty oil will flow into carburetor requiring complete carburet ... Dewalt 3800 PSI Pressure Washer

The control is set for regular wash. When Start/Reset is pushed, the washer does not start. There is 1 HR in the display. I have waited the hour+ and the washer does not start and I have been unable to reprogram the unit....cannot locate manual. Can you help?


The user manual is available at this site. I suppose the PDW9800 series should apply to your model.\015\012\015\012See page 5 f ... GE 24 in. Profile PDW9880JSS Built-in Dishwasher

My Honda 2600 psi power washer will not pull to start. It was running great then I allowed the neighbor to borrow it. He ran the washer till it was out of gas and proceeded to refuel and at this point it would no longer start. The pull cord is out about 4-6 inches out and I am concerned about taking the casing off myself. Fearing that it may throw more off on the unit. If i take the casing off are there any spring loaded parts that will dismount? What should I do? Spark Plug? Turn


You should be fine to take the recoil off, there shouldn't be anything that shoots out at you. You might want to check the oil level on the engine, many of the Honda engines won't start unless there is enough oil in them. If your oil level is fine, c ... Honda Pressure Washer PSI 3000

I accidentially sprayed water on the pressure washer motor and got it wet and the pressure washer stopped and won't start up. Will it start back up after things dry out or is the motor broke?


Yes it most likely will, BUT you need to dry OFF ALL electrical items well.\015\012\015\012Check also that you haven't dislodged anything from the system.\015\012\015\012If it still will not go, you may need to use WD40 or similar water d ... Pressure Washers

My Delonghi Dishwasher keeps turning off. The dishwasher is turned on at the power point. The water is turned on. Okay When I press the POWER botton on the front it wont stay on. I have to keep my finger on the POWER button and then press the START button for washer to work. If I do this it will then pump out any water in the bottom and start to work. ***BUT when you take your finger of the POWER button the washer just turns off and stops working. Do you have any idea what could be the problem p


Yes, the power button is faulty. by pressing the power button forcefully, you are in effect allowing the contacts to close. Replace it. ... Dishwashers

Just bought a new Briggs Stratton 6 75 pressure washer. i put in a half a tank of gas in the tank and it started up. i ran the pressure washer until it was out of gas. put more gas in now it will not start.


Assuming you tried choking it when you tried to start it, verifiy its getting gas,if not tap lightly on the bowl of carburator. if it is getting gas, check for spark ... Briggs Stratton 020273 Elite Series Portable Gas Pressure Washer
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1028 seconds