Having problems with your Whirlpool 24 in. DU1100XTPS Built-in Dishwasher ?

Whirpool Gold Dishwasher not turning on

\015 It's plugged in under the sink and only the clean light will blink. If I push cancel it shows it has 2 minutes remaining on the cycle. The cycle will finish and then go righ back to where it was with the clean light blinking. If I push start I just get 2 flat lines where the minutes should display. Tried unplugging it a few times and even left it unplugged over night. any thoughts?\015

Answers :

Hi,

This machine was made by Whirlpool and the flashing clean light is a common error code for them.
If\015\012the clean light is the one flashing then your dishawasher could have a\015\012heater circuit problem (depending on the age) or this could simply just\015\012be water colder than it is used to getting.
Repeatedly press the Heated Dry and Hi-Temp Wash(scrub) which ever yours has untill all the LED lights come on, press cancel twice and\015\012try the dishwasher again making sure to run the water at the kitchen\015\012sink till it is hot before starting the dishwasher, if this trips and\015\012locks you have a problem with the heating element, or temp sensor.
Press\015\012the heated dry button followed by the normal cycle button, and then\015\012repeat once. You should see all of the lights come on for a second or\015\012two, and then the dishwasher will work again.
If you haven't\015\012already, take a look under the kick plate in front to see if there is a\015\012schematic tucked in there somewhere. Whirlpool has put their\015\012diagnostics for specific models on these.
I don't have the specific repair manual for you model.
So, if the above combination does not work here are two more that have worked for me.
HiTemp Wash + Air Dry + HiTemp Wash + Air Dry in less than 5 sec
or
Hi Temp Scrub/Scour + Air Dry + Hi Temp Scrub/Scour + Air Dry in less than 5 sec



Let me know, if you need further assistance.


Hope i helped you.


Thanks for using ' Fixya ' and have a nice day!!
.If the dishwasher's eletronic control doesn't detect a water temperature increase during the main wash cycle, that symptom can occur.the control will not let the dishwasher start once such a condition is detected.this could be caused by a problem in the heater element, its in-line thermostat, the related wiring or a problem in the electronic control.It is also possible just the washer not spraying properly (possibly from blockage in the filter or problem in the pump), the dishwasher not filling sufficiently or draining prematurely or even a problem in the door latching mechanism's switch(es) could cause it.
once verified the error display may have to be cleared from the control manually. by setting the unit into diagnostic mode by pressing the key sequence 'Heated Dry, Normal, Heated Dry, Normal' and then pressing cancel.
Repair Help & Product Troubleshooting for Whirlpool 24 in. DU1100XTPS Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Whirpool Gold Dishwasher not turning on


Hi,This machine was made by Whirlpool and the flashing clean light is a common error code for them. If\015\012the clean light is the one flashing then your dishawasher could have a\015\012heater circuit problem (depending on the age ... Whirlpool 24 in. DU1100XTPS Built-in Dishwasher

Whirpool Dishwasher ADP5966 Turned dishwasher on. Only light that comes on is normal wash light. Start button is flashing when normal wash light is on. On pressing start button dishwasher does not work


Most likely the door switch is not making proper contact when you shut the door or the Start button is faulty. Needs someone to look in the door panel to fix. ... Whirlpool Dishwashers

Whirlpool Gold Quiet Partner Model # GU980SCGQ2 The dishwasher normal light flashes on and off continually. The dishwasher won't stop cycling now, everything seems to work normally other than it won't stop cycling. I've attempted turning off the breaker- no luck. Attempted resetting the dishwasher- no luck. Any assistance would be appreciated. Is this a problem with the control module? The thermal fuse?


... Whirlpool 24 in. GU980SCG Built-in Dishwasher

Whirpool thermal fuse - Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher


... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

Will not turn on - Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher


Check to make sure the breaker to it isnt tripped ... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

I cannot unlock the controls on the panel - i just bought a house that has the whirlpool gold quiet partner dishwasher and when i press any button nothing happens but says controls locked - i unlock the controls and try to turn on the dishwasher and still happens and says controls locked again. can you help?


Try turning the circuit breaker off for 30 minutes. Then turn back on and see. If it keeps locking you may need new control console. Hope this helps. ... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

My whirlpool gold quiet partner iii lights will not turn on. There is water in the bottom of the dishwasher. I can't turn it on at all. Nothing lights up. What do I do?


Pull control panel, remove control board cover and check the white colored fuse, rectangular, that's mounted to the control board housing.\012\012Rich\012Western Appliance Repair\012 ... Whirlpool GU2400XTP Built-in Dishwasher

Dishwasher will not shut off and has water in the bottom of the tub. Whirlpool Gold, Made in Germany GU120ES1Q. I had a repairman in to check it out yesterday. Now the dishwasher will not turn on at all and the repairman says the two parts that it could be are not available.


... Whirlpool Gold 24 in BuiltIn Dishwasher w Adaptive Wash Cycle 24 in Builtin Dishwasher

How to turn on a gold series whirlpool dishwasher


... Whirlpool Gold Series Dishwasher with Sensor Cycle

Hi i have a whirpool gold dishwasher i always have to reset the panel to use it cause its stuck on clean light always on the code that come up when i reset is 88 1d what is the problem?


Ok collected the data for this model.its the problem of water level sensor.it needs to be replaced to solve this issue.it is to be done by a technician as it requires bit of soldering too.its not a type of do it yourself job.thanks.\015\012\015 ... Dishwashers

Water remains in Whirpool Gold Quiet Partner dishwasher


Sounds like an issue with the drain pump, disconnecting the drain hose fromm the trap and run the unit, pointing the disconnected drain hose into a bucket. You should get a fairly strong stream of water until most of the unit has drained, if not you ... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

Hi. My dishwasher won't let me move the latch into the locked position. When I turn the knob past the start cycle I hear a klunk noise. When looking at the latch it is obvious that there is a gold color piece of metal on top of and in front of the silver latch blocking it from moving sideways. Is this something I can fix on my own, or need a repairman or time for a new washer? The washer will be 5 years old in October. Thank you, KIm Martinez


... GE Nautilus 24" Built-in Dishwasher

Dishwasher has power but is not turning on? I have a Whirlpool Gold Quiet Partner IV Model # Gu1500XTKS0 Seriel # FM1115468 Type # 575-0 2.7 amp 60HZ 120 Volts


... Whirlpool Dishwashers

My whirlpool gold dishwasher won't turn on, has power to unit


... Dishwashers

I'm trying to install a new mount in my whirpool dishwasher. The spray arm does not turn freely and is hitting the dish basket.


The screw types rarely give problems - so I'm presuming it's the clip type with plastic prongs.\015\012\015\012First make sure the replacement part is the same as the old. It should press - fit with a click when in position.\015\012 ... Dishwashers

My whirlpool gold dishwasher gu2475xtvy does not turn on. i checked the power and thats fine please help Bob


Note that washers have an anti flood device that once triggered shuts off the inlet water and turns the pump out motor on only. This anti flood device detects any water on the base of the washer due to leaks or in some cases a blocked pipes. The devi ... Dishwashers

Whirpool dishwasher gold quiet partner 3 is leaving a heavy film and waste on dishes is there a filter to be cleaned?


The problem is hard water. There is a new product out called the dishwasher filtration system. It filters the water before it enters your dishwasher. It works amazing and has a money back guarantee. You will love the ... Whirlpool Dishwashers

Our whirlpool gold dishwasher will not turn on/drain since it's last wash. It does not appear to be the breaker. Any advice?


Wash timer ... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

I have a GU1500XTLB1, type-575-0 Whirlpool Gold dishwasher. For the last couple of weeks I've been getting the control lock on. I got the manual out, I hold the air dry button and it clears. My problem is now when I turn the machine on dosen't matter which cycle I hit (pots and pans, normal, or quick wash) it runs for about 5 minutes and it goes into a mode with the timer having lines going horizontal with the air dry button lit up and rinse button lit up. It sounds like it starts the cycle


Hi,There are Few Tricks to Reset this. Follow the below Tricks :-1. Try holding down heated dry key for 5 secs. I believe that is the control lock/unlock button on your model. IF not, look for the lock symbol and follow same i ... Whirlpool Dishwashers

Manual for whirpool gold quite partner - Dishwashers


May I get the model # to help you more. ... Dishwashers

IDL750 - Fuse trips when turned on. HELP! We had some electricians here to install a new electrical socket for a new fridge. They put the new socket in the same wiring as for my existing dishwasher!! The first time I tried to start the dishwasher cycle with the new fridge plugged in, the circuit box fuse tripped. Now, even with the fridge turned off, the dishwasher makes the fuse trip when turned on. Is there a fuse inside the dishwasher that has blown and needs to be replaced? or a ground brea


Hi.The first step is understanding if the problem is the socket or the appliance. Find an extension long enough to reach a different socket. Move the appliance to reach the power cord, and connect the dishwasher to a different power sock ... Indesit 24 in. IDL700 Built-In Dishwasher

Dishwasher GSD2030F03WWSA735136B Model Series number;Piece fell off inside front panel, making it impossible to turn on dishwasher at all..so I took off front panel screws, opened dishwasher and saw white plastic piece but can't find where it goes but it must have something to do with turning the knob to start dishwasher because the knob won't turn now..so it must attach inside somehow but I can't figure out where it goes...help!!


I think you need to get a new knob, write down the model number and make and take the pieces to your local domestic appliance supplier, there might be something similar in stock. Now I do mean the kind of small supplier that understands this kind of ... Dishwashers

My Maytag dishwasher goes for long stretches when it won't turn on even though I push the proper buttons. The buttons won't light either. It turns on by itself after a couple of weeks of sitting idle. Some of the lights may blink on the start panel while the dishwasher doesn't work, but only on occasion will it fully operate. I have turned off the power and turned it back on, hoping to reset the computer part of the dishwasher. It didn't work.


The Control Touch Panels like to fail on may brands - especially Maytag. They are sensitive to humidity - and a lot have the vents out the front - right by the control panel.Please reply using "continue with this expert ... Maytag Dishwashers

Bosch Integra 500 dishwasher turns on and starts wash cycle, turns off after 90 seconds and then there is no power on the button panel at all. The dishwasher is full of water. Now the unit will not turn on or off. There is power to the outlet the dishwasher is plugged into.


Your controlboard is no good. find out if its a recall unit go to thermador.com which is the company that owns bosch and they can tell you the price if you have to oreder it or if its free for part and you pay labor to install ... Bosch Integra® 500 SHX46A0 Dishwasher

I have a Whirlpool dishwasher (model DU890SWKQO). I turned it on and for a few minutes only the motor was running, no water. I opened the dishwasher to stop it and turn it off, then on again. When I opened it, the was an odor (burning or heat smell) and it was foggy (steam or smoke, not sure which) inside. I am assuming I did not turn the dial correctly so it only 'clicked' on the motor. Concerned now that the dishwasher is broken or concerned that it's not safe to use. Was the steam/smoke


... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1768 seconds