Having problems with your Whirlpool 24 in. DU920QWD Built-in Dishwasher ?

How to access thermo fuse on Whirlpool dishwasher DU920QWDB4


Answers :

Had all screws removed on inside of door, but had to remove front outside panel to access screw with held panel to door.
Repair Help & Product Troubleshooting for Whirlpool 24 in. DU920QWD Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How to access thermo fuse on Whirlpool dishwasher DU920QWDB4


Had all screws removed on inside of door, but had to remove front outside panel to access screw with held panel to door. ... Whirlpool 24 in. DU920QWD Built-in Dishwasher

My Whirlpool GU2400XTP dishwasher keeps blowing the fuse. It sat up for 6months because the control panel went out and I couldn't afford to get a new one. Finally replaced the panel and the thermal fuse blew during the first wash cycle. I tried to put a 15AMP fuse in it's place to check it out before I bought a new thermal fuse and it too blew during the first cycle. Any ideas?


Are you replacing the wires along with the fuse? It is important to change the wires too as they are usually the cause for the fuse blowing. Be sure and get the fuse kit that includes the wires. \015\012\015\012Is your water too hot? Hot ... Whirlpool GU2400XTP Built-in Dishwasher

Does the Whirlpool Gold dishwasher have a fuse?


The fuse is in the control panel on the right hand side after you open the panels 6 screws.The replacement fuse kit comes with a wire harness that must be used to prevent the new fuse from blowing. ... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

I have Whirlpool Quiet Partner III dishwasher, Model number GU2400XTPS3, Serial number FS1820245. I recently had the thermal fuse replaced by an authorized service repair person. My problem is that the dishwasher stops mid-cycle. I noticed that when I try to clean it in the normal cycle, the dishwasher stops with about 46 or 47 minutes remaining, and the green light flashes continuously. I have pressed the Normal and Heated Dry buttons, as well as the Sani Dry and HEated dry buttons to res


... Whirlpool 24 in. ADG7540 Built-in Dishwasher

Whirlpool Gold Quiet Partner Model # GU980SCGQ2 The dishwasher normal light flashes on and off continually. The dishwasher won't stop cycling now, everything seems to work normally other than it won't stop cycling. I've attempted turning off the breaker- no luck. Attempted resetting the dishwasher- no luck. Any assistance would be appreciated. Is this a problem with the control module? The thermal fuse?


... Whirlpool 24 in. GU980SCG Built-in Dishwasher

I have Whirlpool Quiet Partner III dishwasher, Model number GU2400XTPS3, Serial number FS1820245. I recently had the thermal fuse replaced by an authorized service repair person. My problem is that the dishwasher stops mid-cycle. I noticed that when I try to clean it in the normal cycle, the dishwasher stops with about 46 or 47 minutes remaining, and the green light flashes continuously. I have pressed the Normal and Heated Dry buttons, as well as the Sani Dry and HEated dry buttons to reset the


... Whirlpool GU2400XTP Built-in Dishwasher

My whirlpool dishwasher Model No. ADG 450-3 is not heating the water. Can you let me know where the element is or is there a fuse i could replace. Where would I get a diagram of the inside workings of this dishwasher?


... Dishwashers

What does the thermal fuse look like on a Kenmore Elite dishwasher model number 665.16473300? I believe that is the problem. I have the control panel accessible but don't know what the fuse looks like for this model.


... Dishwashers

Whirlpool dishwasher cycle control knob broken ( I think the dishwasher model is 8051219). How do you gain access with intent of replacing the knob ?


... Dishwashers

I have a Whirlpool DU1055XTSS dishwasher that completely stopped working. I took it apart, found the thermal fuse to be bad, ordered a new, then replaced it and it worked for 2 loads. Now the thermal is open again. What could be "taking it out"? Is the thermal fuse strictly a thermal or does it repsond to current? It's 2 years old, i have already replaced the heating element, the main control board, and now the thermal....twice.


Hi.If the thermal fuse is blowing, that means that there is overheating.Common causes for overheating are:Thermostat cutting off too late.Plugged element.Plugged element means that the element sta ... Whirlpool Dishwashers

I have a whirlpool dishwasher model# du943pwkqo. What wires go to the thermal fuse? I lost power to it and took it apart to check the fuse and there are no wires hooked up to it. Does any one have a wiring diagram?


It is a black wire from the door switch.. hope it helps the tech sheet \015\012\015\012http://www.servicematters.com/docs/w ... Dishwashers

Whirlpool GU1500XTKT0 dishwasher has a Rinse only led blinking. No functions are responding on the control panel. Keyswitch resistance check table on Whirlpool Service Technician's Tech Sheet checks good with digital multimeter. Door switches and thermal fuse near control module check good.


If your keypad tests, door switches, and thermal fuse are all good, the only test left is to make sure you are getting 120 volts at your control board. Test for 120 volts at terminals p8 and p7, and at p2-6 and p7. You will have to activate the doo ... Dishwashers

We recently purchased a Whirlpool ADP 4736 dishwasher, and just last night while it was working the fuse just blew, and we heard a popping sound at the back of the washer. We tried to replace the fuse, but the same problem. rnAlso, there a lot of water has collected at the bottom of the washer, although the dishes have been cleaned and dry. What could be the problem and the solution for this. All the instructions are in Polish and made in Poland. Please advise?? Many thanks Percy'


... Whirlpool 33 in. ADP6830 Free-Standing Dishwasher

Whirlpool dishwasher (Kenmore elite) lights on control panel do not come on. Have replaced control electronic board, fuse is good. Dishwasher does not run


... Whirlpool GU1100XTLB / GU1100XTLQ / GU1100XTLT Built-in Dishwasher

I have a Whirlpool DU1055XTSS dishwasher that completely stopped working. I took it apart, found the thermal fuse to be bad, ordered a new, then replaced it and it worked for 2 loads. Now the thermal is open again. What could be "taking it out"? Is the thermal fuse strictly a thermal or does it repsond to current? thanks


Water is getting on the wiring somewhere, take it apart right after a cycle and see if you have a door leak, or the motor is going bad ... Whirlpool DU1055XTS Built-in Dishwasher

Whirlpool dishwasher Model#GU3200XTPS0 No power to unit, Control panel does not have power check the circuit and outlet, are OK. is there any fuse inside the unit? is circuit board has any fuse?


... Whirlpool 24 in. GU2500 XTP Built-in Dishwasher

Whirlpool DU1055XTSS dishwasher is totally dead as if it were unplugged. No response from front lights. Only 3 years old. Another post for an different Whirlpool model says it's the thermal fuse, but I cant find that part for this model.


Hi,If you have power going to the dishwasher, meaning the breaker, switches, wiring and fuses in the home are okay, the most common cause for your symptoms is the thermal fuse. The thermal fuse is a small disk shaped device th ... Whirlpool DU1055XTS Built-in Dishwasher

Whirlpool Dishwaser Model #DU8000XX5. Dishwasher won't do anything. Almost as if not getting any power. Was told to check thermal fuse. Noticed some burning around suspected fuse. Ordered new one, but new one doesn't look like old one. Old has 4 connections, new one only has 2. What gives?


... Dishwashers

Whirlpool dishwasher model DU1055XTSQ2 will not run. Only half of lights on control panel working. Probably need to replace control panel. Do I need to replace the bi-metal fuse also. What does the bi-metal fuse do, how would I know if bi-metal is bad, what are symptoms.


... Whirlpool Dishwashers

I have a Whirlpool dishwasher, model DU943 that's under 7 years old. I went to use it last night and it won't power on. I tried selecting all of the cycles, but the dishwasher never came on. I looked through the troubleshooting tips in my manual (like checking the circuit breaker for a tripped fuse, which was fine) and I still have a problem. what else can I try? thanks.


Hello- This unit has a thermal fuse inside the door panel on the control. This part is replaceable. If it is bad, replace.- and would suggest not using heated dry as this is most common cause of fuse failure. Let me know if this info helps- have more ... Whirlpool Dishwashers

I have a Kenmore Elite Dishwasher Model 665.13773K600. It seems to have no power to the touch pad (top) control panel. I have already checked the circuit breaker and the power to the dishwasher. A friend said that it may perhaps be the thermo fuse cut out that needs to be replaced. 1) Is this true? 2) How can I remove the 1" thick control panel touch pad after removing the six screws- it seems to be stuck, and I don't want to break the plastic touchpad.


... Kenmore Dishwashers

Whirlpool Dishwasher No Power: GU1200XT dishwasher thermal fuse in power up circuit blew & was replaced about two months ago. It has blown again. Both times it was after wash was finished but water was left in tub. Would appreciate suggestions on what may be causing the hi temp condition and how to verify.


I have a similar problem with my whirpool diswashre GU2500XTPB1. I check thermal fuse (on the board. It is OK (continuty). Right door switch _ OK, Left door switch _ weaker a bit). It still not work) I do not know what to check? ... Whirlpool 24 in. GU1200XT Built-in Dishwasher

Thermo fuse keeps blowing on my dishwasher - Dishwashers


... Dishwashers

Replacing thermal fuse on whirlpool oven - Whirlpool WDT910SAYE Gold Series Dishwasher with PowerScour Option - B


... Whirlpool WDT910SAYE Gold Series Dishwasher with PowerScour Option - B

Whirlpool Dishwasher ADP 536 stopped washing, the safety fuse dropped, dishwasher restarted, detergent stays at the bottom, water is fed in and out, but no washing, may be spray motor pump?


... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1961 seconds