Having problems with your Whirlpool 24 in. DU930PWP Built-in Dishwasher ?

Control Lock light on, won't go off.

\015 Whirlpool quiet partner IV, Control Lock light on, washer will not start. It says "press & hold" right below the control lock light, but no amount of pressing and holding seems to make a difference.\015

Answers :

I need your correct model number to help refer to you owners manuel how to come off control lock press and hold turns it on not off
Repair Help & Product Troubleshooting for Whirlpool 24 in. DU930PWP Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a Kitchen aide dishwasher Model KUDI01ILWH6 that will not turn on..there is a control lock light on and I have tried pushing the cancel button but all that happens is the control lock light flashes 3 times and the dishwasher still wont turn on....Please , how to I disengage the control lock


... KitchenAid Dishwashers

The lock light on my kenmore elite dishwasher #15962990 wont stop blinking. It wont reset to run a cycle. How do I reset the control panel??? HELP!!


Hi\015\012\015\012To reset the control panel press and hold the RINSE ONLY/AIR DRY button for 15 seconds. Hope this helps....please let me know if you need further help.\015\012\015\012Daniel ... Kenmore Dishwashers

Whirlpool dishwasher model DU920PFGGO wont start. "controls locked" light blinks when door is closed.


Hi\015\012\015\012\015\012Thanks for using FixYa. To unlock it press and hold the AIR DRY button for\015\01210-15 seconds. Please accept the solution if the issue is resolved or post a\015\012comment for further a ... Whirlpool Dishwashers

I have a Whirlpool dishwasher model #DU920PFGQ4. The controls locked light is flashing, and when I press the air dry key for 5 seconds it won't unlock, however the cancel/drain light starts flashing. When I press the cancel key the controls lock light will stop flashing, but will resume as soon as I release the cancel key. I have tried disconnecting power for 24 hours, but as soon as I plug it back up it does the same thing. Nothing else on the control panel will work.


... Whirlpool Dishwashers

Kenmore Ultra Wash Dishwasher Model 665.15779 LOCK ON light blinking on control panel, unable to use washer. If buttons were locked, LOCK ON light should be lit continually not flashing. If you press and hold NO HEAT DRY button to disengage lock, nothing happens. If you press the CANCEL button it begins to blink in unison with the LOCK ON light. How can I stop the light from blinking to allow button function again?


... Kenmore Dishwashers

The controls on my GE GLD4600N10WW have on occasion locked up. In the past, I have resolved this by turning the breaker off and back on. It has now locked up, but won't reset. When the breaker is turned back on, the dishwasher control panel lights indicate "Normal Wash" and "Heated Dry" but the controls do not respond. After several minutes the lights simply go dark. It does not respond to any button pushing.


... Dishwashers

Matsui MF160 integrated dishwasher: Had problems for a while now with the buttons on the control panel ie: on button needed to be pressed down hard for it to connect and sometimes the wash cycle programme buttons would just keep flashing between the three of them and then they would settle down, for the past few days the on button light has stayed on and wont go off and now all the lights on the control panel have gone off and the dishwasher wont work at all, we have tried dis-connecting it, che


... Dishwashers

Have Kitchen Aid Dishwasher KUDS01FKSS1 The lights on the control panel wont go out it wont start, sometimes the lights flash,the control lockcomes on after a cycle.


HI. I need to know which lights are flashing? This in very important to know. Kindly look at the control and let me know which lights are flashing. Is it the rinse light,cancel light or all? ... KitchenAid Dishwashers

The control lock light goes on as soon as I press the cycle to start the dishwasher. The dishwasher does not start, presumably because the control lock stays on. I do not know how to disable the control lock function. Pushing and holding the button for 3 seconds does not disable it.


Hello &\015\012Welcome to FixYa\015\012\015\012To unlock the\015\012controls press and hold the HEATED DRY button for 20seconds. If the problme\015\012returns then only option is touch pad replacement. Please get back t ... Maytag Dishwasher

3 sec light on control panel blinks .. dishwasher wont star. None of the other control lights come on. I have reset the breaker in the main panel to attempt to reset any internal breakers with no results. When I attempt to set anuy of the options, the 3sec light blinks then returns to a solid light.


Go to maytag website they have all kinds of help there ... Maytag 24 in. MDBH950AWS Built-in Dishwasher

I have a Fridgidaire dishwasher with a control lock feature that has now decided to lock!! There is nothing in the manual about this. The manual doesn't acknowledge this feature!! Ridiculous! Anyhow, my control lock light is on and I cannot run my dishwasher!!


On most control locks, the function is enabled/disabled by holding down the lock button for 3 to 5 seconds. Try pressing the button closest to the little lock symbol for 5 seconds. ... Dishwashers

Lock Control I don't have a manual for my dishwasher. The Lock button is on (top of dishwasher). I have pushed that top button for 3 seconds. The button on the top and the "L" then both blink. The button on the top then stays on and the "L" light goes off. Since I can't get the lock light to go off - - my dishwasher won't tun on. Thank you very much.


First try unplugging the washer from powerpoint for 30secs..this may disable lock.if not, some washers will still work on lock if you hold the buttons you need. for 5seconds. eg try starting washer as normal but hold the button for 5secs....(Ps you m ... Jenn-Air 24 in. JDB1050AW Free-standing Dishwasher

Control panel buttons don't work. Seem to be stuck in the "Lock On" mode. Can't turn off, and dishwasher won't run. When you open the door all lights go off, but as soon as you relatch the door, the "Lock On" light comes on, although sometimes it can be another light. In any case, it won't run.


... Kenmore Dishwashers

KitchenAid kuds30ixss control lock light is always on (lock is NOT enabled)


... KitchenAid KUDS30FXSS Builtin Dishwasher

Lock light wont go off dishwasher wont turn on


Http://shared.whirlpoolcorp.com/assets/pdfs/literature/Use%20and%20Care%20Guide%20-%206-920374.pdf\ ... Jenn-Air 24 in. JDB1100AWS Built-in Dishwasher

Dishwasher wont let u select a cycle...all buttons seem locked...ive unplugged it for 5 seconds or so and then plugged it back in and the normal wash button light comes on and the heated dry button light comes on, but it wont start and it doesnt respond when buttons are pushed...please help. thanks


... GE GLD4560NSS Stainless Steel Built-in Dishwasher

I have a Whirlpool Quiet Partner 2 dishwasher from Lowe's model DV 1055XTVS. The "clean" light flashes three times in a row over and over and the "lock" light is one. None of the controls will work. I unplugged it and that did not clear the problem. How do I unlock/reset the controls?


I have a whirlpool quiet partner 2, its brand new. It leaves a filmy residue on my plastic ware. I use the finish detergent as well as the rinse and no luck. Whats the problem.???????? ... Dishwashers

Programming lights are lighting up when i turn machine on but wont set on a programme. Also the door wont lock in to place?


... Maytag 24 in. MDB8751A Jetclean II Built-in Dishwasher

I have a GE dishwasher with front control panel and at first the wash and dry lights stayed on and it was beeping every 30 sec. when I turned the breaker off for the required 30 sec. the lights started flashing and it is still beeping. The control panel seems to be frozen as it is not working and wont do anything.. everything was working fine before this. I bought it at Home Depot on 3/14/07 and had it installed by a licened electricion. Help


Call ge @ 800-386-1215 for service ... Dishwashers

Came home and dishwasher was stil running from the morning. Opened the door and all the lights on the control panel were lit up and unresponsive. cut power to unit for 1 min and now the controls don;t light or respond to anything . They are not locked and there is power to the unit any ideas ?


Hi\015\012\015\012\015\012Thanks for using FixYa. From what you have described it seems that the control panel has gone bad and needs to be replaced however, if you want more information then please do revert with the manufac ... Dishwashers

The lock on light wont go off. We can not start the dishwasher. We have tried holding the noheat option for several seconds and have turned off the circuit box for several minutes and neither one made the lock on light stay off.


That is the correct button to push to turn the control lock off. You can try to reset the control by removing power for two minutes. If the dishwasher is doing the same thing, most likely the touch pad has a shorted button or a bad connection on the ... Kenmore Dishwashers

My Whirlpool Quiet Partner 111 dishwasher Model # GU2500XTPS7 control panel won't respond. There are 4 lights on, the normal wash light, heat/dry light, the lock light, and the start/resume light is blinking. I have held the heat/dry button for 5 sec. trying to unlock it and nothing happens.


Disconnect your circuit breaker for 20 minutes and then reset. It should reset your dishwasher. ... Whirlpool Dishwashers

Control Lock light on, won't go off.


I need your correct model number to help refer to you owners manuel how to come off control lock press and hold turns it on not off ... Whirlpool 24 in. DU930PWP Built-in Dishwasher

Control lock light is on and dishwasher doesn't start


There is a Control Lock which locks all the control buttons, so the dishwasher cannot be started. It is enabled by pressing and holding the lock button for about 3 seconds. To disable, press and hold the lock button until the light goes out. A ... Dishwashers

GE gld5708vbb flashing lights locked controls


It is possible that since the neutral was bad it could have made a surge on the power and caused the processor controller to fail. It is also important that this must be confirmed to be corrected by checking with a larger load like a heater being swi ... GE 24 In. Black Built-In Dishwasher - GLD5708VBB
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1102 seconds