Having problems with your Whirlpool 24 in. GU1200XT Built-in Dishwasher ?

LOUD HUMMING AFTER WATER FILLS AT START OF CYCLE

\015 When I start the wash cycle the water fills ok but then there is a loud humming/buzzing coming from dishwasher. Any ideas where it is coming from?\015

Answers :

Sounds like you have something in the sump/motor. I could lead you through it on a chat session but too much just to type. Let me know if you would like me to do so.
Repair Help & Product Troubleshooting for Whirlpool 24 in. GU1200XT Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a bosch SHU6802UC dish washer. Recently the cycles were getting very long (3+ hours) and now when you press power/start, the unit turns on and you can hear the rather loud hum (pump?) of the cycle starting but it does not do anything else, just continues the loud hum. No cycle, does not fill with water, nothing. I ran the diaognostic and it immediately came up "7" on the display. Any thoughts or direction would be greatly appreciated. FYI, I did thuroughly clean it which made no di


There are a few possibities...if you remove the lid and take the two t20 screw off the left side panel at the front you could check the pressure chamber and its hose are not blocked. Use the link and go to page 4, part 263834 and 361113. You ca ... Dishwashers

When the water should be filling or rinsing the machine is making a horrible, loud, noise and no water is coming out. The solutions I looked at for no water don't mention this noise - they mention a slight hum. This noise is as loud as a TV turned up almost all the way! This happened during a cycle - the wash ran fine and it got to the rinse and started this.


Hi,If the noise lasts beyond 2 minutes at a time (which it sounds like it does) then you have a motor problem. I am suspecting that the main seal has leaked onto the motor and is causing water to get into the motor. ... Maytag 24 in. MDB4100 Built-in Dishwasher

LOUD HUMMING AFTER WATER FILLS AT START OF CYCLE


Sounds like you have something in the sump/motor. I could lead you through it on a chat session but too much just to type. Let me know if you would like me to do so. ... Whirlpool 24 in. GU1200XT Built-in Dishwasher

Dishwasher was making a loud hum. I turned it off and started it this morning. Seemed to be working fine, but after about 5 minutes it started making the same loud hum. The first time it seemed to be between cycles with no water, this time there water moving as normal except for the loud hum.


... Jenn-Air 24 in. JDB1100AWS Built-in Dishwasher

Hum in Kitchen Aid Dishwasher Model 8531529. Stated last night. No hum when filling or draining - only during the wash cycle. Can still hear the water spinning inside during the wash cycle, but hum is loud. The water does fill & drain completely/correctly. Any ideas? Might this be an easy fix? or a likely repair man call? Thanks!!


Hi\015\012\015\012The hum sound that you hear is from the motor that is not\015\012working or is about to go out, the motor should be replaced. Hope this\015\012helps...please post back for further assistance.\015\012\015\012Dani ... KitchenAid Dishwashers

I have the Kitchen aid KUDS01DL dishwasher. It was working fine until last week. When starting a cycle, the washer fills with water. Once filled, the motor makes a humming noise and does not circulate the water. I end up stopping the cycle and the discharge pump empties the water. I took apart and cleaned the basin this morning. I did find some random garbage but it did not seem blocked. Do you have any ideas?


... KitchenAid 24 in. KUDS01DLSS Built-in Dishwasher

CI am having a problem getting our Miele G575 dishwasher to run through a wash cycle. It definitely has power, the water is on and there is no water in the bottom of the dishwasher. When you turn the dial to start a cycle, it hums but doesn't fill with water and doesn't progress through any cycle. We have tried all positions of the dial and have had no luck? Any ideas??


You said it does not progress...meaning the dial does not eventually move? it may be waiting on a water level sensor to be tripped. The dishwasher is just not filling. The water valve solenoid may be stuck or defective. or a wire may have come of ... Dishwashers

My Defy Dishmaid Silent makes a loud knocking noise when i start the wash cycle, it fills with water but dose not wash.When i start the wash cycle it sounds like it is washing with the added knocking noise but at the end of the cycle the salt has been released but nothing has been washed.A few weeks ago it would run the rinse cycle but now it will not wash on any of the cycles.Please advise.


... Dishwashers

Maytag dishwasher Model MDBF550AWB--Start4 water cycle, fills. When wash cycle is to begin, water shuts off, wash cycle does not start. Soap does not open. Low hum.


... Maytag Dishwashers

My dishwasher will fill with water but when it goes into the wash cycle it makes a noise that is like a grinding or loud hum and it will not go into the wash cycle but it will pump the water out of the dishwasher when you cancel the cycle


Take apart the spray arm assembly at the bottom on the inside. When you get all the way to the bottom and access the spray motor, simply turn the impeller a few times. Put back together and try it now ... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

I have an LG 1415M dishwasher and it is making an extremely loud noise. It's that loud when it gets to a certain part of the cycle that it is deafening. It starts to fill with water and then I presume when it starts to wash it makes this grinding loud noise. We have cleaned the filters as recommended in manual.


... LG Dishwashers

FDB750RCC1 When I start the DW, the motor hums loud then soft then loud then soft...if I advance the dial some sections of the cycle nothing will be running and others the motor is on, but no water is getting into the unit. I just replaced the inlet valve and solenoid and that didn't change anything. I can see water in the recirculating pipe running up the unit, but it will just try to make it up and fall back down. Not sure how to proceed...my thoughts would lead me to the main motor, but


Can you hear the water solenoid click when it calls for water? If so, check that the water source valve is on and water comes out of the valve. Check the entry hose for kinks. Remove everything under the lower arm down to the deck keeping track ... Frigidaire 24 in. FDB750RCC Stainless Steel Built-in Dishwasher

So, it was working fine for 4 years. Then last week it started getting louder after the initial fill cycle. Now, all it does is fill the bottom with water, clicks (where the motor used to kick in), then just hums. Nothing happens, but when I hit the cancel button, it empties the water from the bottom. Any ideas?


Your spray pump motor has become blocked or ceased - do you have the tools and skill to dis-assemble the machine? ... Whirlpool GU2455XTS Built-in Dishwasher

SMEG pL312 Dishwasher started cycle, partially filled with water then stopped working. Attempts to reset and start cycle again are met with humming sound and no action.


... Dishwashers

I have a whirlpool gold gu2500xtps7 and it fills up with water but the cycle doesn't start. It sounds like the motor or pump to start cycle just hums


... Stainless Steel Whirlpool Gold 24 in BuiltIn Dishwasher w Adaptive Wash Cycle Dishwasher

Loud humming noise when dishwasher is filling with water


Sounds like it could be furring in your water piping. may need a plumber to check it out. ... Dishwashers

Whirlpool dishwasher model DUB700XB has quit cycling. Fills with water but will not start wash cycle. Making intermittent humming noise unless the door is open to disengage the switch, even when on stop. No LEDs lighting when rotating the dial through the various cycles. Unit is old and wondering if it's better to buy a new one rather than fix this and have something else go wrong in the not to distant future. Thanks in advance


... Dishwashers

Machine starts fills Ok but when it clicks on to start the wash pump, nothing happens, I can hear a faint hum. When cancelling wash and starting new wash it pumps out ok too. After rinse cycle it indicates a completed wash, but no water has been pumped through washer arms.


Sounds like your main circulation pump is not working, if it is humming when it is supposed to start, sounds like it is getiing power, so probably not the control circuits, can you measure voltage to pump?if you are getting 120 there, probably pu ... Asko D1876 Dishwasher

Dishwasher hums I have a 2003 Kenmore Elite Ultra Wash Dishwasher model #665.17469300. I started the wash today. The water came in the unit and started washing then I heard it stop and it just started making a humming noise. I was afraid it was going to overheat or something so I cancelled the washed and it drained out. I started the unit up on a different cycle and the water came in the unit but did not wash it just hummed so I cancelled and drained it again. I did that on all cycles and the sa


... Kenmore Dishwashers

My Kenmore Ultra Guard Delux, model 665.13832K601, was very loud during wash cycle, now it fills with water, hums, then empties water. Is this the grinder clogged up?


... Whirlpool GU3600XTSY Stainless Steel Dishwasher

I press start the water fills fine as soon as it start running i get a loud humming/ vibration and nothing happens?


Sounds like the motor is bad.after it fills the motor should start,has it been leaking under the bottom of d.w.rmove the bottom front panel and see if there's any water stains,usually the motor will leak before it finally dies. ... Frigidaire Dishwashers

I have a maytag washer (model -dependable care) and when we start the wash the motor just hums, the water does not fill, if we move the timer switch to rinse the motor engages and the unit works entire the end of the cycle, this is the same for all cycles


Check your fill tubes remove the hoses and see if the filters are plugged, you are not hearing the motor humming. You are hearing the watervalve humming, the motor will not start until the tube is full of water. ... Maytag MDB6650A Built-in Dishwasher

I have a Kenmore Ultra Wash Plus, Model # from door flange is 110753791. Washer fills with water, will not cyle through. Just a humming sound from the cycle timer dial but will not engage and start washing. I cannot drain the water by pressing ''cancel''


THIS SOUNDS LIKE A BAD MOTOR ... Dishwashers

I have a Bosch SHU43C06UC/14. A few weeks ago it was making a loud terrible noise during the entire cycle. We figured it was on its last leg but it was still cleaning the dishes properly. Then with no explaination the noise stopped and the machine sounded normal again. Today when I started the machine it makes the normal sound when starting, but it acts like it is stuck at the beginning and does not fill with water. The timer also does not count down.


... Bosch 24 in. SHU43 Built-in Dishwasher

I have a Bosch SHU43C06UC/14. A few weeks ago it was making a loud terrible noise during the entire cycle. We figured it was on its last leg but it was still cleaning the dishes properly. Then with no explaination the noise stopped and the machine sounded normal again. Today when I started the machine it makes the normal sound when starting but it acts like it is stuck at the beginning and does not fill with water. The timer also does not count down.


... Bosch 24 in. SHU43 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1825 seconds