Having problems with your Whirlpool 24 in. GU1200XT Built-in Dishwasher ?

Just installed a new dishwasher. First run smelled like burning rubber. What could this be?


Answers :

Repair Help & Product Troubleshooting for Whirlpool 24 in. GU1200XT Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Just installed a new dishwasher. First run smelled like burning rubber. What could this be?


... Whirlpool 24 in. GU1200XT Built-in Dishwasher

I removed an old dishwasher and replaced it with this GE 24" Profile GSD533ODO1WW unit. It seems to run through the cycles like it should but it doesn't seem to run any water for some reason. I hooked up a new water line to it and turned it on. There where no leaks that I could see. Is there any installation manual that you could send me to make sure that I didn't miss anything or is there anything that you can tell me that I should look for? Thanks, Jesse


... Dishwashers

I have a electrolux EIDW6105 dishwasher,since new,after a load of dishes are done,by the end of the day,the inside of the dishwasher smells so bad,like rotting food,it is almost unbearable to smell.I had a service tech come and check it out,he said the washer was not installed correctly,was not level,I made the change,same problem,then he said I would need to use DISHWASHER MAGIC once a week,same resault,then he called electrolux tech support and they told him that it was nomal and I should run


... Electrolux 23 in. ESI602X Built-in Dishwasher

The water is pumped out after the rinse cycle then it continues to run and make an unusual noise but nothing happens. The noise is almost a grinding sound. There is also a smell like some part may be hot or the wiring may be hot. I can reset the dishwasher and re-run the cycle up until that same point and it does the same thing again. I have had a repairman out twice in the last six months. The first time he could find nothing wrong because the problem was intermittent and he couldn't see anythi


Timer \015\012\015\012or\015\012\015\012 ... Bosch Dishwashers

Dishwasher Stinks Our dishwasher has recently begun to smell like burning rubber when it is running. Still washes the dishes fine, and we pulled it out several times but can find no smoking, smoldering, etc to pinpoint the problem area. Fumes give me a headache. Can anyone help?


Is your dishwasher less than a year old? if so you need to call bosch and have all the gaskets replaced. they tried a new chemical to make the gasket but now have found that after the dry cycle the gaskets put off a strange odor like your discribing. ... Bosch 24 in. SHX99A15UC Stainless Steel Dishwasher

I have a Smeg dishwasher SA660 EB. Still like new . Hardley used but have problems with the timer switch not progressing past 5 and also had the thermostat replaced as a loud bang heard and the machine did not work. Since warranty on repair run out it sounds like water is leaking around the thermostat through onto electrics as loud bang noise heard again . I found the thermostat just pushes up into the rubber seal in the bottom of the dishwasher. I have taken out the rubber seal as this also loo


... Smeg Dishwashers

TV static I just installed a new dishwasher. When it is running, it causes static lines on the TV. Prior to the new dish washer, I did not have this problem. It is wired correctley, and not on the same circuit. As I stated I did not have this problem until the new dishwasher. I called the service people for the dishwasher, and they stated they could not help me. Have you got any ideas, or do they make some type of filter I can put on the line to the TV.


There should be a suppressor fitted to the mains terminal block on most dishwashers. if this is not the case you will have to get hold of one you plug in. regards ... Dishwashers

I have an Inglis dishwasher.Serial number-FC3312512,Model number-IBU37002 or it could be IBU37062.I do not know how old the dishwasher is, as I justed moved in to my house this October,and the dishwasher came with the house.Last night I reset the options on the dishwasher,and had the cycle running on heavy duty.About 1 hour after the dishwasher was running this very bad smelling--like smoke- steaming odour was coming out of the door vent of the dishwasher.The smoke alarm went off in my house,and


... Dishwashers

Good Morning, I don't need any help except to get rid of my lg dishwasher because it is the worst dishwasher I have ever had!!! I have had it fixed once(new motor ,new soap tray,new board) and it still does not work good and still smell like it is burning up. I have not been as unhappy with anything in my life. WISH I HAD NOT HEARD OF LG AND WASTED A LOT OF MONEY!!!!!!!!!


Hi,You might be interested in this.....http://www.contacthelp.com/directory/Shopping/Electronics/LG?ListingID=386heatman101 ... LG Dishwashers

Dishwasher fix water does not go through the spray,. the upper hand an lower hand are clean , the pump does operate to empty the dishwasher . I do smell like some burning smell when I turn the dishwaher on, the water start running for 1 minute or 2 than stop shortly and doesn t reach the arm then the dishwasher becomes hot inside . Thank you


Something has gotten passed the screen and is jamming your pump impeller pull lower spray arm pull screen and see if you can find what is jamming the impeller and remove it drain pump is separate ... Maytag MDB7100AWB Dishwasher

I am trying to replace the GUIDE RAIL BRACKET ASM on my GE dishwasher (model no. GSM1800JWW). How do I either: (a) remove the old brackets, and then install the new ones; or (b) remove the rollers from my new brackets, so that I could slip these rollers onto the old brackets still in the dishwasher, saving the trouble of removing the old brackets in the first place? Either solution would be acceptable, but right now I can't figure out how to do either one without breaking something. Thank you v


Be ready for both . because if they break you can still replace it. but (a) is to me the better choice. let me know how you made out and send me a 4 thumbs post if it works out ... Dishwashers

Error code E24 on a new Bosch dishwasher that was just installed. This is the first time I tried to run the dishwasher after installation.


... Bosch 24 in. SHX99A15UC Stainless Steel Dishwasher

Hi, We have a Frigidaire dishwasher machine 1500 series with fully electronic control. It is a new unit, has been installed nearly 4 months ago. The other day, when I went to take the dishes out of it, I notice that the rubber gasket that seals the door had come off somehow. Along with it I saw, sitting on the bottom, two pieces that looked like part of the seal, but I didn't know where they came from. I put the rubber gasket back on, but now the pieces and now the dishwasher will leak when runn


... Frigidaire Dishwashers

I purchased a Bosch dishwasher SHU43C02uc/22 about 4 years ago. Recently during the last 2 washes, the machine has been giving off a smell like hot rubber during the wash cycle. It otherwise runs perfectly (dishes are clean, drains okay, etc). I have done just the routine maintenance like checking for large pieces of food but have found nothing so far. Any suggestions as to where I should look for where the smell might be coming from?


... Bosch 24 in. SHU66C02 / SHU66C06 Built-in Dishwasher

Rubber smell or a burning eletric smell. burning rubber smell from my dishwasher


... Whirlpool Dishwashers

Bosch dishwasher smells burning rubber


... Bosch Dishwashers

Brand new dishwasher, installed last week. When it is done there is quite a lot of water standing in the bottom of the tub. It has only been run 2 times since installed and both times several inches of water were left standing. Is this something we could check or do I need to have the installer come back, which will probably take a week at least. Oh-KitchenAid #KUDC031VWH


First was a new garbage disposal also installed? There is a knockout on the garbage disposal where the drain hose connects to.\015\012If that is not the problem make sure it has the correct high loop or also called air gap. If that is not right ... KitchenAid KUDC03IVWH Builtin Dishwasher

Re; Smeg DWD612CSS dishwasher. Please help. On setting our dishwasher to operate overnight, we were awoken by a loud bang only to find a strong rubber burning smell and the trip had blown. After investigating we found that the part no DWF 409 interface filter required replacing which we have done. Now however the dishwasher runs to the middle of its cycle and stops. The troubleshooting page of the manual tells us code E3 applies i.e.first 2 phase lights are lit and states "The appliance is not


I would first look for anything that may be stuck anywhere in the machine that may be causing it to come up with an error. Possibly something that was in the dishwasher is making it think it can pump out the water even though it is draining.\01 ... Dishwashers

This dishwasher is older than most living people in this business. It works great except it is a 208 three phase unit. It is in St.Peter's church in New York Mills, MN. We bought it used during our remodel project in 1994 for a price of $800.00. That was our mistake. We had a converter installed to accomadate the 3 phase power supply. So we have this converter running 24 hours a day using up electricity and we use the dishwasher four times per year. I am wondering if we could replace the motor o


This unit is a dinosaur. The 3-phase converter had to cost twice as much as the unit. Best solution - turn the power off to the 3 phase converter when not in use.Better best solution - find a newer unit that will be repairable should it n ... Hobart AM14-253 Free-standing Dishwasher

My Bosch dishwasher has had a problem since we had it installed. It smells like garbage after sitting for a few hours. This problem is there whether it has been run or not. Water is always standing in the large drain tube under the "filter" and it doesn't look clean. I contacted Bosch by phone as soon as this was discovered - in a matter of days after purchase - and was told by a rather haughty service person to leave the dishwasher door open. Not a practical suggestion even if it didn't sm


Was the drain tube that hooks into the sink drain passed over the partition between the sink area and washer area or through a low-level hole. If through a low-level hole, try rerouting the tube over the partition. This forms a 'trap area' to isolate ... Bosch 24 in. SHU43 Built-in Dishwasher

Miele G893 i cant find where to put the salt on our new house's miele 893 dishwasher. the previous owner left salt for us, and the dishwasher smells horrible (like stale water) when you try to run it without salt. (only tried that once though)


You should have a dispenser on the door to add salt,regardless get c.l.r. calcium lime rust remover from a supermarket,lowes,home depot.put a cup in the unit ,run for 15 minutes and then put a cup in again.let the unit complete its cycle.if you still ... Miele Touchtronic G892 Built-in Dishwasher

Whirlpool dishwasher. Just had new whirlpool dishwasher installed, worked fine first couple of times,but now seems like its not getting water at the start.checked valve&its turned on .whats the problem?


Reach inside your d/w and jiggle the mushroom shaped float switch located on floor of d/w. should move freely up and down if its stuck up(or something lodged under it your unit wont fill with water ... Whirlpool GU2400XTP Built-in Dishwasher

My Hobart dishwasher just quite running. They said they smelt a burn smell a little before this happened. They also mentioned that it sounded like it was running a little rougher then usual. Any ideas?


Could be something has gone into the pump and jammed it, I have seen this when the filters are not in place properly, last one I saw a bottle top was in the pump. ... Hobart AM14-253 Free-standing Dishwasher

My Bosch dishwasher is taking hours (at least 3 - maybe more) to complete a cycle. There is gummy, yucky stuff building up inside - sorta pinkish brownish. Could the water not be hot enough? A couple of months ago we installed an on-demand hot water heater and I wonder if that could have anythig to do with it. I've tried running the hot water in the sink first but that doesn't help. Any ideas


If your on demand heater is one of the small ones that mounts under the sink, it will not flow enough water to fill your dishwasher. the dishwasher is waiting for the water level to fill before it starts washing. your bosch will heat its own wat ... Bosch SHX46A07UC Built-in Dishwasher

I just bought a simpson silenco 850 dishwasher & my son picked it up & took it to the property to install it .He said the waste pipe hose was missing the rubber end with the silver clip to hook on .Do I need to buy a new hose or could I find another rubber piece to slip over & re-attach the clip? Thanks


... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2112 seconds