Having problems with your Whirlpool 24 in. GU2500 XTP Built-in Dishwasher ?

My GU2500XTPSO would not start. The panel wouldn't light up. My husband ordered and replaced the thermal fuse but the new fuse burned out immediately. Can you help? It will not start or light up. Should I look at another problem causing the thermal fuse to burn out?


Answers :

Repair Help & Product Troubleshooting for Whirlpool 24 in. GU2500 XTP Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My GU2500XTPSO would not start. The panel wouldn't light up. My husband ordered and replaced the thermal fuse but the new fuse burned out immediately. Can you help? It will not start or light up. Should I look at another problem causing the thermal fuse to burn out?


... Whirlpool 24 in. GU2500 XTP Built-in Dishwasher

See below This is a post that I just copied to this space "I have a whirlpool Quiet Partner II, Model GU2400XTB1, that just suddenly will not start, as if the power was cut. Circuit breaker is fine. from the little Internet research I've done it looks as thou it could be a thermal fuse problem. How easy are these to replace, assuming that's what it is?" Mine is quiet partner III ... there is power to the connection box at the dishwasher it self (checked w/ light tester) ... but there is no power


Have you tryed leaving the power cord out of the socket for an hour or so sometimes they don't lose the memory until they have been left disconnected for a while ... Whirlpool GU2400XTP Built-in Dishwasher

Dishwasher will not start, no lights come on. There is also standing water at the bottom. Can you help point me in the right direction? Went to start the dishwasher and none of the controls on the panel are working or lighting up. I checked the fuse box and all fuses are good.


... Frigidaire 24 in. GLD2350RC Energy Star® Built-in Dishwasher

I have a kitchen aid dishwasher that is stuck on the clean cycle. It will drain water, but no water seems to be getting into the washer. If i push the start button, cycle will not start. The clean light is the only light that will stay on. the other lights will go on, but they eventually go off without starting the cycle. Is this the thermal fuse???


... KitchenAid Dishwashers

Ariston dishwasher i have an ariston built in dishwasher. It wont start washing cycle, and has 2 flashing lights from the left (total 4 lights)...can anyone help. i cant find the model number on the machine. The lights looking like sprinkiling water..i have filled the salt, and rise etc but still it wont come on please help


I have a brand new ariston ll-64 and the wash cycle won't start and two flashing lights ... Ariston Technologies L63 Free-Standing Dishwasher

I can't get the igniter to start on north start pressure washer #157224. Fuses ok, indicator light in heat switch does not illuminate. Blower works, fuel dripping out. Cleaned fuel tank and pump and filter too! Tried jumpering past the thermostat didn't help either. Also, swapped pump and heat switches on main panel. No help!


... Pressure Washers

Power off I have an ASKO D3100 Dishwasher, which is a few years old now. It stopped working a while ago where the power went off and stayed off (no lights anywhere). I've checked the power point and it's okay. I've flipped the dishwasher over to look inside and I can't see a fuse or anything that looks helpful. Can someone help me troubleshoot this one?


Howdy. I suspect a power surge went through your machine and fried its itsy bitsy brain.Its time for a new one unless you have a good supplier and serviceman who will replace the control unit. Get an estimate with a closed top cost before you agree. ... Asko 24 in. D3112 Free-Standing Dishwasher

Kenmore elite 13852 will not show any lights. looks like no power but checked breakers in basement and everything looks good. Is this a bad door switch or is there a bad internal fuse? Thanks for any help!


INTERNAL FUSE,but most of them dont have a fuse and it is the controll panel...check with volt detector that you get power to the control panel if you do ..then its the panel if you dont , its the conection to your macine. good luck ... Kenmore 13859 / 13854 / 13852 Dishwasher

KUD102CRWH1 The dishwasher does not start after a cycle. I have to reset the breaker in order to get it to run. The green led light flashes twice when I press start and I also replace the thermal fuse. Any assistance would be greatly appreciated. Unit is approximately 4 years old and not sure if there are any recalls on this. Thanks


... KitchenAid Dishwashers

I have an H62 Hobart commercial dishwasher. I had it on fill to start it up. There was a loud pop while it was filling and now it has stopped. The power light is still on but the dishwasher will no longer fill. Where should I start looking for the problem. Would it be a fuse that popped?


... Dishwashers

Cycle interrruption Recently, about 20 minutes into the wash cycle, the unit shuts down and the lights start blinking - usually "Pots & Pans" & "Quick Rinse" simultaneously. No other buttons respond and I cannot get it to finish the cycle. Only shutting down the unit at the fuse box eliminates the lights. I've checked for blockages and nothing found. Manual does not offer any help or suggestions. Any ideas??


Relace control board. ... Kenmore 24 in. 16032 Built-in Dishwasher

Have the same problem as other with the maytag quiet series 300 model MDBS561AWB dishwasher. Two of the buttons on the front light up, but dishwasher will not start. Don't know if CBoard or the buttons or the ribbon cable is the problem. Took the door apart and couldn't find any condensation....Looks like maytag has done it again......could use some help with the cost of replacing all those parts. Will help me decide if better to buy new dishwasher.....preferrably not a maytag or whirlpool, or a


... Dishwashers

I have a jenn-air dishwasher jdb-5. The light panel only comes on if I press the time-delay button. I cannot start it and none of the other lights come on. Please help. It is not the outlet nor a blown fuse.


A new control panel is the only solution.as its the problem of short circuit on the control pannel board due to which its blinking lights as you touch particular buttons.as replacing the pannel will solve your problem.\015\012 ... Dishwashers

I have a MDB4630AWS1 series dishwasher that is only a couple of weeks old. Suddenly, it now starts the wash cycle but then the Cancel/Drain light turns red, and it drains and stops the cycle. Check for items blocking the sprayers and looked for anything clogging the interior. It does this with all the settings. Seems to work for a few minutes, but then it just drains and stops. Any help would be greatly appreciated.


... Maytag MDB4630AWS Dishwasher

My kitchenaid dishwasher quit working, the hi temp scrub and heat dry buttons light up but nothing else does. The dishwasher makes no sounds and doesn't even try to turn on so I tried bypassing the thermal fuse, safety latch, and replaced the motherboard so to speak and still nothing so PLEASE HELP!?!


... Dishwashers

Whirlpool ADP6000WH No Power up We started a cycle , then all of a Sudden it shut off completely.... No error code at all and no lights or Display. No fuses in the House were thrown and i've tested the power point on the wall and all is ok. Just no response when pressing the Power Button on the Dishwasher??? Please Help :)


... Dishwashers

We have a Bosch dishwasher SHX46A06 UC/21. It continually runs. We couldn't find a diagnostic test for our model, but we did for another model. We held down the power scrub and regular wash cycles then turned it on and pressed them again. The delicate/econo light started blinking. Looking at some of the blogs, most often it seems to be the heater or the control panel - does this diagnostic test help to pinpoint what could be wrong? Also, where can we find a good manual for our model - we're havi


Here is a link to the service manual http://cgi.ebay.com/Bosch-Dishwasher-Service-Repair-Manual-/250480379703. \015\012 ... Bosch 24 in. SHX46A02 / SHX46A06 Built-in Dishwasher

No power to dishwaser, won't start. I checked fusebox, not the problem. I want to know if there is a fuse somewhere in the dishwasher, I looked and could not see anything, also manual is no help.


You could try checking the door latch/switch. if it is burnt and not engaging, the machine may not start and will appear to have no power. i don't know the color of the machine, the letters after the LC will help with this, however maybe this brea ... Frigidaire 24 in. FDB510LC Free-standing Dishwasher

Model KUDI24SEWH2 - the dishwasher was operating, I opened the door to add another dish. When I closed the door, there was a small click and nothing happened. The lights indicated to me there was rinsing and drying going on, but in reality, nothing happened.rn We were told it might be the thermal fuse, but have just check that and it is fine. It will fill, just not pump or drain. Any help?


... KitchenAid Dishwashers

Something was stuck in the latch, which made the machine not start. I removed item, however, the lights come on, the heat comes on, bot no water or the rest of the cycle begins...help.. I have held down start/cancel and the heat dry buttons. I have unplugged the power for three minutes... I have taken the front covers off, looked through the latch mechanism but found no other issues. There is a little water left in the basin, so I checked to see if there was a clog, by blowing air into th


Hi,Sorry for the delayed response. Your problem dated 30th Sep 2009 was reposted today on FixYa. I am sure by now some other expert must have responded to your question and solved your problem.If this is not the ca ... Frigidaire 24 in. FDB1050REC Stainless Steel Built-in Dishwasher

I have a Kleenmaid dishwasher model DW20W and it all of a sudden won't start. The door shuts ok, the power is on and the start light is on. The salt light is also on so we replaced the salt but that didn't help. The cycle seems is stuck on the universal 65 degrees mode and I cant move it forward or backward from that mode. Ive switched it on and off and pressed all the buttons. It won't start. Help?


... Dishwashers

Maytag model MDB4651AWW3 recently the lights for normal cycle do not light and wouldnt start unless you got lucky. Now it wont start all together and when start is pressed you can faintly see light on the start and wash indicators. Please Help!


HiIf you have already tried leaving it unplugged for a while then the issue is with the control board that has gone bad and should be replaced to solve this issue. You can also try to blow some compressed air on the electronic control and ... Maytag 24 in. MDB4651A Built-in Dishwasher

I have a fridgidaire dishwasher model # FDB 1450chc2 andon the control panel the red lights are flashing and washer wont start ?? when I open the door the lights go out but when I close the door and push start the washing lights start to blink but doesnt start to work ?? Need help thanks [email protected] Brian


... Frigidaire 24 in. PLD2850 Built-in Dishwasher

My kitchen aid dishwasher will not start I replaced the interface control board thinking that was the obvious problem. When you go to set the dishwasher to start some of the settings don't always light up then when you push the start button the lights will flash then start but it's not flashing and won't start. I get lucky once in a while and get it to flash then start. I don't know where else to look. I don't want to start replacing parts one at a time till I get lucky. My model # is KUDIO1F


Check all cables especially the ribbon cables from the user interface to the electronic control assembly as steam from dishwashings will create small amounts of corrosion and inhibit signals to and from these 2 components,unplug each,inspect,and reco ... KitchenAid Dishwashers

KitchenAid Dishwasher (KUDP01FL) - unable to remove two wires from thermal fuse box. Help


... KitchenAid 24 in. KUDP01FL Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1559 seconds