Having problems with your Whirlpool 24 in. GU2548XTP Built-in Dishwasher ?

I think the dishwasher completed all the cycles, but there is 2" of dirty water in the bottom that didn't drain. When I pushed the drain/cancel button, it comes on and makes a humming noise but does nothing else.


Answers :

Repair Help & Product Troubleshooting for Whirlpool 24 in. GU2548XTP Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I think the dishwasher completed all the cycles, but there is 2" of dirty water in the bottom that didn't drain. When I pushed the drain/cancel button, it comes on and makes a humming noise but does nothing else.


... Whirlpool 24 in. GU2548XTP Built-in Dishwasher

If i switch on my dishwasher, all lights flash on and off red,and it's makes the beeping noise when it does when the wash is finished... no water is coming in either... please help... it does nothing and you cannot press any of the buttons to use a cycle. it is making a humming noise. i have checked the filter in the bottom of it, and have switched it off at the wall and back on again. cheers,


Un plug it remove bottom drawer. look in back left corner of cabnet on bottom, is it wet dry it out and try again ... Fisher and Paykel Dishwashers

I have a Defy Dishwasher DW-12. I push the start button and it makes a sound as if to start and no water comes in - it just hums and the water is on. It has been working fine. - but last night i was woken up with it still buzzing after 5 hours! and nothing happening


... Dishwashers

I have a Tecnik TKD795/3 built in dishwasher. It is now making a gurgling noise as though it is draining water when I try to start the cycle, but the cycle does not start and no lights come on at all. I have tried pressing the outside two buttons to reset, but absolutely nothing happens and the gurgling noise continues until I release the power button. Can you help please?


... Tecnik 24 in. TKD795/3 Built-in Dishwasher

GE triton xl dishwasher has power but will start a cycle. Lights come on when buttons are pushed. When you push start it makes a locking sound but does nothing. I've tried restarting by turning power off for 30 seconds to a minute and still does not help.


... Dishwashers

Whirlpool Quiet Partner II: Was making loud noises while working. Then stopped working and cleaning light blinking only. Did the push buttons thingy - stopped blinking. Now just fills up, makes a humm


... Dishwashers

Kenwood Elite Dishwasher Mod#665.13779 K600 "Normal Wash " light blinks continuously with NO washer action. No other wash modes light up when pressed. Washer does not do anything. However, a couple of times I got it to make a noise as if it was draining, but then nothing happens. Push "Cancel" and it blinks in unison with Normal Wash light. Open door and close it, "Cancel" light goes out and Normal Wash light continues to blink. Have tried various combination of buttons to try to "Reset"


... Kenmore Dishwashers

Inlet/drain light on. i know it drains OK because if i pour water into bottom and close door and turn on i can hear it draining water out. it wont fill. i have cleaned everything and taken base off and cleaned and checked float and all ok. i have tried every combination of holding buttons down and trying to reset but machine just makes low humming noise and after about 5 seconds the red light comes on again.


... Miele 24 in. G646SC Plus Free-Standing Dishwasher

When i push to on button on my tecnik dishwasher it makes a draining noise but does nothing


... Tecnik 24 in. TKD795/3 Built-in Dishwasher

Humming noise i have a GE nautilus GSD2200 model which has not been used more than 4 years that is giving me trouble.  it's making a loud humming noise (the noise comes and goes, comes and goes) which seems to be coming from the motor area at the bottom of the unit.  I stopped it in the middle of the cycle, but the water seems to be stagnant at the bottom.  any suggestion on fixing the problem myself?


I have seen this SOOOOO many times in my 35+ years in the appliance repair industry.......it is very typical....here you are this is an answer I provided someone with the exact problem not to long ago..............This is a t ... GE Nautilus 24" Built-in Dishwasher

Our AEG Favorit 50620 dishwasher won't start. When I push the power button, the power light comes on, but none of the other lights. Pushing the function buttons has no effect. The door is fully closed, and it was working perfectly before. I have tried turning it off and on, unplugging it etc. Nothing works. Interestingly, if you push more than one function button at the same time, some of the function lights come on, but then when you try to start the cycle it still won't work. Help!


... AEG 24 in. Favorit 40650 Free-Standing Dishwasher

I have a KitchenAid Model KUDP01FLBT5. After I push one of the clean buttons, and the start button and close it, nothing happens. The indicator lights for the buttons come on as you push them. When this first started, you would ahve to open and close the door and re-set the buttons (not sure if that button re-setting had anything to do with it) up to 20 or 30 times, and it would eventually come on. Now it won't anymore. Help!


Hi\015\012\015\012Thanks for using FixYa. To\015\012resolve this you will have to reset the console. Do this by closing the door\015\012and press these buttons in sequence...\015\012\015\012 ... KitchenAid 24 in. KUDP01FL Built-in Dishwasher

I have a KitchenAid Dishwasher KUDIO1iLBS2 and none of the lights come on and if I press any of the buttons nothing happens. The unit is getting power to it as I shocked myself. I did ordered and replaced the control board and still nothing is happening. Any suggestions or ideas? Is there a reset button or is there a possible fuse that is out that would make the lights not come on? Please help.


... KitchenAid Dishwashers

I have a Kenmore 665.13742k603 dishwasher and it will not drain. If I push the cancel button (drain), it makes a noise but it does not drain. I usually hear a water trickling sound when I push drai


... Dishwashers

I have a Frigidaire FDB956rbc0 model. When the start/cancel button is pushed nothing happens. There is power and other buttons cause lights above what is pressed come on. Delay wash works but when it starts the washing light flashes. I have run a test on the cycles by pushing start/cancel and power dry button during power failure mode. all cycle run properly. Any thoughts?


... Frigidaire Dishwashers

Hi i have a smeg df 410 sdx 450 wide dishwasher that is coming up to three years old ,the fault it has developed is that it wont switch on ,press the button and nothing happens,no lights or the normal beep.240v is getting to the button and when the button is pushed on 240v comes out the other side and goes to the various pcb's but the appliance wont do any thing,can you please give me some ideas.


... Dishwashers

Maytag dishwasher mdb7601 will not run- light doesn't come on and nothing happens when you push the buttons. Earlier it would work but if you pushed the light cycle button the longer cycle would light up and it would run. Then the time running light did not light up.


... Maytag MDB7100AWB Dishwasher

The motor is making a loud humming noise when turning on, water comes out, then stops, and the fan shuts off, then motor keeps making the humming souond? Does the motor need to be replaced?


... GE Dishwasher Mechanism Assembly - WD26X10045

Our frigidaire model FDR252RBS1 makes a noise like it is running but the spray arm does not sound like it is actually washing. It makes the humming noise clear thru the cycle and nothing happens, wat


... Dishwashers

I have a whirlpool quiet partner II and it seems that it keeps draining and making a ratteling noise while doing so. If I push the cancel/drain button it will make the same noise


Your pump is out need a new pump ... Dishwashers

Whirlpool Quiet Wash Plus dishwasher Model DU920PFGZ3. Worked fine until I replaced the insinkerator and forgot to punch the drain plug leaving water standing on the bottom of the machine. I punched the drain opening, and pushed the cancel/drain cycle button. It drained fine but since no water comes from the spray arms. I have removed the arm all the way down..NOTHING!! Some research indicated it could be the water inlet valve. When the buttons are pushed, it cycles but no spray or water.


... Dishwashers

Lights on Dishwasher light up but nothing happens. When I reset power it lights up the high temp and sanitize button light up and LED displays PF. After I open the door they stop flashing. the far left five buttons light up when I push them and a corresponding number displays on the LED screen. the only lights that do not come on are the Delay button and power button. Don't know if they are working or just don't light up. No matter what lights up the unit does not turn on....:( ? help can't fin


Pf is power failure\015\012 your loosing voltage to the unit \015\012it may just be the door switch or it could be in the control\015\012 try starting the unit but keep your hand on the unit pushing the door in place,, its not a g ... Electrolux 24 in. EDW5500DSS Stainless Steel Built-in Dishwasher

My hoover hds 55m dishwasher wont start a cycle when you push the start button the led comes on but then nothing happens .


... Whirlpool Dishwashers

When the water should be filling or rinsing the machine is making a horrible, loud, noise and no water is coming out. The solutions I looked at for no water don't mention this noise - they mention a slight hum. This noise is as loud as a TV turned up almost all the way! This happened during a cycle - the wash ran fine and it got to the rinse and started this.


Hi,If the noise lasts beyond 2 minutes at a time (which it sounds like it does) then you have a motor problem. I am suspecting that the main seal has leaked onto the motor and is causing water to get into the motor. ... Maytag 24 in. MDB4100 Built-in Dishwasher

Asko D3530. Program LED does not come on. Also nothing happens when I push Set, Menu or Start. Tried button on the left (cirle with a I, looks like a reset button?). Checked plug, GFI and circuit breaker switch. Still no power and no light no response from various buttons.


Hello,\015\012\015\012Welcome to FixYa.\015\012\015\012It sounds like you've got a bad power switch or a wire at the power switch or as you described it... (circle with a I, looks like a reset button?) ... Asko 24 in. D3530FI Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0969 seconds