Having problems with your Whirlpool 24 in. GU2548XTP Built-in Dishwasher ?

New problem :door seems to kind of bounce like it

\015 New problem :door seems to kind of bounce like it does not want to stay open. I found black rubber piece on floor beneath door ? I assume this is something to do with the problem, but not sure what to call it and if it is vital to replace this rubber piece. ? whirlpool dishwasher GU2458xtp53\015

Answers :

Repair Help & Product Troubleshooting for Whirlpool 24 in. GU2548XTP Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

New problem :door seems to kind of bounce like it


... Whirlpool 24 in. GU2548XTP Built-in Dishwasher

I have a Maytag DWU8250BAX and the thing leaks like crazy. I just replaced the door gasket, but that is not the problem. When I took a closer look at the door it seems as though the water is getting up and into the door through a space in the bottom of the door. It seems to me like there should be another door seal to fill a gap that sits between the door hinges. If anyone knows if there should be a seal here and then what the part number might be that would be great. Thanks!


There is an airgap under the door..it should spray up and run down the door not spray up under it..look for crack or hole in spray arm..if there is the wrong soap in it it will flood out with lots of bubbles..just have to flush it out. lastly, if you ... Dishwashers

The dishwasher doesn't seem to have nearly enough water in it. The upper sprayer arm doesn't seem to be spinning when running (I open the door and look really quick) and the lower one looks like it barely spins and barely sprays water. The dishes are barely wet and the soap is just laying on the bottom. The water is on, there are no kinks in the supply line. It sounds like it is running, and pumps pumping, but being brand new I am not sure what it should sound like. It certainly doesn't sound li


I would lift the drain pipe higher. approx. 1/2 the height of the dishwasher . also rechack incomming water supply. Make sure no blockages and the like. Try again. ... Bosch Dishwashers

The detergent dispenser [Main Wash] door doesn't stay closed. It seems like there is something wrong with the latch, but we can't what. We've cleaned it, but don't know what else to try. There don't seem to be pieces missing or broken. But no matter what, when we put in the detergent [we use the cubes] the door always just pops open and the detergent ends up falling to the bottom on the dishwasher. The dishes are still getting relatively clean, but we want to solve the problem with the door


... Frigidaire FDB1200RG 24 in. Built-in Dishwasher

Hello all, We have an Ikea Whirlpool DWF 416 that is a couple of years old and has never caused any problems. From today the door has stopped shutting properly. The electronics and internal mechanisms seem to be working fine, since when you turn it on the cycle starts - but only if you hold the door shut. Has maybe a catch gone? Any ideas for fixing a door-shutting problem like this? Thanks in advance! Dave


The catch is no longer working. Contact IKEA for the replacement part. I'm sure it's available through EBAY or something, but probably not guaranteed or as reliable. ... Dishwashers

Smeg DI612CA integrated door springs open, catch won't hold when trying to close door. Have removed before and reset catch. Same problem now seen again. Likely that I need new catch unit, or could problem be electronic?


... Dishwashers

I have a Maytag MDB7600AWB dish washer. I have a door leak, dripping from the right side. I can not see anything that would allow it. It seems like it could be coming from the inside of the door. Also, there is heat and condensation on at the top of the door, above the leak. It could be that steam is coming from the top right and dripping down the door. Could you give me some idea about fixing the problem.


HI,Check for the following troubleshooting steps:Some leaking around-under-from the door on dishwashers can be traced back to a split in the spray arm. If the lower spray arm develops a split in it, the spray arm can turn too ... Maytag 24 in. MDB7600A Jetclean® II Built-in Dishwasher

Dishwasher model DWU9902AAE is leaking at base of door. What is most likely problem? New door gasket?


... Maytag Dishwashers

Hello! I just ordered a new facia panel for our Bosch dishwasher SHU9955UC/U12. It seems like it should be fairly easy to replace it (meaning, myself...). Is it really just a question of unscrewing the screws on the inside of the door, removing the old panel and then replacing the new one? Are there any especially delicate inside mechanisms/parts That should be protected? Many thanks.


... Bosch SHU9955UC Built-in Dishwasher

FDW60 dishwasher Hi My dishwasher is about 15 months old and the problem I have is that it seems to stay on pump and the Ecco45 light is flashing.  A repair company looked at the machine and said that the motor looked like it was leaking and water was getting in the bottom setting off the micro-switch.  He contacted Hotpoint who fitted a new motor today at a cost of £89.85.  Went to use dishwasher tonight and we still have the same problem.  The dishwasher started the washing programme for about


I've just (as of 10 minutes ago) had the same problem. I followed the advice given elsewhere in this forum and removed the bottom cover - water running out so needed a big towel to mop it up. I stood the machine upright and restarted it - no problem! ... Hotpoint 24 in. FDW60 Free-standing Dishwasher

I have a Bosch SHU43C05UC diswasher. Last night, I put it on before going to bed as usual. I was awakened a couple of hours later to a loud grinding sound (like a pump being run dry), and found the noise coming from the dishwasher. The display read "0" time remaining, so I opened the door and the dishes seemed clean, so I left it shut off. Tonight I have been trying to troubleshoot the problem. The dishwasher will turn on, but it will not seem to fill with water. I have verified that the


Ok well before you can do anything you must obtain a service manual, link below.\015\012\015\012http://allrepairmanuals.com/bosch ... Dishwashers

We have a FGHD2433KB1 model dishwasher. Among other problems that I have seen here (detergent door not opening, dishes not clean at the end) our biggest problem is that the dishes are never dry at the end. They are actually dripping wet. It doesn't seem like it is venting during the drying cycle. Any help would be welcome. thanks


Hi,\012I have an older dishwasher also and recently my wife alsocomplained about it not cleaning right... so me being the man I am tried in vainto clean the things... \012Bought new spray arms online and installed them inminutes...now the thing works ... Frigidaire FDB956RB Built-in Dishwasher

Have the same problem as other with the maytag quiet series 300 model MDBS561AWB dishwasher. Two of the buttons on the front light up, but dishwasher will not start. Don't know if CBoard or the buttons or the ribbon cable is the problem. Took the door apart and couldn't find any condensation....Looks like maytag has done it again......could use some help with the cost of replacing all those parts. Will help me decide if better to buy new dishwasher.....preferrably not a maytag or whirlpool, or a


... Dishwashers

The dishes are not clean when we run the wash cycle. It looks like the water flow from the top sprayer is NOT working. The door, when we open it, has undesolved soap stuck in globs on the top of the door. The top dishes are not clean and some of the botom dishes are not clean. We've run some clear washes to see if we can find the problem. The water flow looks suspect. Is it in the electronics or in the water mechanics. I called the repair guy who ususally comes out and says buy a new one! The re


Hi, \012I have an older dishwasher also and recently my wife alsocomplained about it not cleaning right... so me being the man I am tried invain to clean the things... Bought new spray arms online and installed them inminutes...now the thing works li ... LG 24 in. LDS 5811 Built-in Dishwasher

Kudl03fvsso dishwasher Was working fine, now dead no lights ,nothing. Has power, checked thermo fuse in door and door switch both ok seems like this is a common problem. any suggestions?


... KitchenAid Dishwashers

The control panel on my Maytag MDBH970AW is unresponsive, and the latch is stuck in the "open" position (the plastic piece stays pushed in to the handle and won't come down). I've checked that the unit is getting power from the house. Last time I had this exact problem (when it was under warranty), they had to replace the control panel, the latch, and it seemed like most of the door. What should I do?


... Maytag 24 in. MDBH970AWS Built-in Dishwasher

WHEM I START MY IGNIS DISHWASHER IT STARTS TO FILL THEN FROM THE RIGHT HAND CORNER CLEAN WATER STARTS TO LEAK OUT . I LOOKED AT THE DOOR SEALS AND THEY SEEM FINE I HAVE ALSO PUT IN A NEW FLOAT SWITCH AND STILL THE SAME PROBLEM ! COULD IT BE THE INLET VALVE ? HELP THANKS MANDY


It sounds like it overfilling,it may be a preesure switch problem.if you turn the dishwasher off the valve should stop if it doesnt then its the valvle.you may have to try cleaning the sunp under the filter.it may be clogged with sludge stopping the ... Dishwashers

Me and my partner just bought a new house and yesterday we tried the dishwasher for the first time. I'm not sure which model we have, but it is a white Westinghouse Dishwasher with 5 wash options. The problem we have is that there seems to be water leaking from the bottom of the dishwasher at the front (sort of where the door is attached to the dishwasher). Do you know what we can do about this?


If the dishwasher has been setting for a long time the seals in the pump could of dryed out. Go ahead and run the dishwasher again and it could seal itself back up if not..... you will need to call a repairman to replace the seals. Or buy a new di ... Westinghouse Dishwashers

We have a ASKO D3450, and it have worked perfectly well for 8 years. Today we have a problem with it. It look like the children-secure is activated becouse the AUTO-lamp is lightning. We try to turn it off, by turn off the power, hold the two keybuttons and turn it on again, press program; and then the AUTO-light should be turned off, but this dosent happend. When we close the door, the machine start to wash, but it seems that no program is activated, and the soap chamber does not open at all.


You have lost the control board.... ... Asko 24 in. D3450 Dishwasher

Whirlpool dishwasher. Just had new whirlpool dishwasher installed, worked fine first couple of times,but now seems like its not getting water at the start.checked valve&its turned on .whats the problem?


Reach inside your d/w and jiggle the mushroom shaped float switch located on floor of d/w. should move freely up and down if its stuck up(or something lodged under it your unit wont fill with water ... Whirlpool GU2400XTP Built-in Dishwasher

My Kenmore model 665.16022401 has the problem w/ the clean light flashing. I tried the bottom combo of hi temp wash, heated dry, high temp wash, heated dry and it re-set my dishwasher but then after I tried to run a new load it doesn't seem like it finishes all the way through because there is still soap left in the soap dispenser and the dishes arn't all clean, plus the green clean light begins flashing again. Don't know what to do.


... Kenmore 24 in. 16022 Built-in Dishwasher

I have a kitchenaid dishwasher model kuds24se with a problem. I MUST hit cancel before I hit start. Note that it doesn't matter how long it's been since the last cycle. It could be a few minutes or a day or more. I have to hit start to get a complete wash cycle. If I don't hit cancel, the washer goes through some sort of cycle and stops. It seems like a normal cycle but of course it is not because I don't hear any water and, upon completion, when I open the door there is heat but the soap dispen


... KitchenAid KUDS24SE Built-in Dishwasher

2 weeks ago, I had a plumber come and put in a new garbage diposer and since then somewhat old/dirty water seems to be sitting at the bottom after all cycles are done. I calle dhim back and he says that there is no problem in the plumbing but more with the pump. I even use the wt/dry vac and removed water and ran it but still comes back with water at the bottom. also the dishes smell like soap. Help!!!


The plumber did not make an air gap in the dishwasher drain hose when he reattached it to the new disposal. Look under your sink, does the hose (attached to the disposal) go down and through the cabinet? If so, that is definitely the issue. Simple ... GE 24 in. Profile PDW7800 Built-in Dishwasher

Dish detergent cakes and sticks, used new detergent, cascade, cleaned water jets on both the top and bottom, seems like the door sticks and does not open, just a guess, dishwasher is 11 months old


... Kenmore 24 in. 17842 Free-standing Dishwasher

I have a Kenmore Quietguard portable dishwasher which does its job excellently. My problem is that I can't seem to find a proper spigot attachment in a standard hardware store, like Rona, that hooks up to it satisfactorily, or at all. On the faucet I had before I had to wrap the joint tightly with a big dishcloth or it would squirt all over the place. I have a new faucet now, and so far the dishwasher's faucet attachment won't even stay on when the water's running. I'm wonder where I can get th


... Kenmore 17259 Free-standing Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1491 seconds