Having problems with your Whirlpool 24 in. GU3200XTP Built-in Dishwasher ?

Lihgt huming from motor not washing

\015 Light huming from motor not washing\015

Answers :

The starting capacitor may be bad but more likely the motor is stuck with a bone fragement or it is a bad motor.
Repair Help & Product Troubleshooting for Whirlpool 24 in. GU3200XTP Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Lihgt huming from motor not washing


The starting capacitor may be bad but more likely the motor is stuck with a bone fragement or it is a bad motor. ... Whirlpool 24 in. GU3200XTP Built-in Dishwasher

The dishwasher will fill with water but when it trys to start the wash cycle it just makes a huming noise like you would hear when an electric motor is frozen. you can cancel and and it will drain with no problems. i checked the chopper and it spins freey and it appears that the shaft driving the chopper is not frozen. just curious what parts i need to purchase. thanks very much. richard lester


... KitchenAid KUDS01FKSS Dishwasher

Wash pump motor removal to clear wash pump of a large object.we have washer out of cabinet on it back on the floor. Need to remove wash pump motor to access wash pump to clear a large object from the pump rotors.


... Whirlpool GU2300XTS 24 in Builtin Dishwasher

MAYTAG MDB7600AWQ DIAGNOSTIC CHECK USING CONTROL BOARD AUTO AND MANUAL, ARE GIVING ME A HIGH CURRENT WASH MOTOR DIAGNOSIS.(NORMAL WASH FLASHING) THE BOARD ITSELF CHECKS OUT OK. ALL FUNCTIONS WORK AS THEY SHOULD.WASHER FILLS THEN ATTEMPTS TO RUN FOR (ABOUT 3 SECONDS) IT WILL DO THIS 3 TIMES THEN BOARD GOES BLANK. ALSO, THE WASHER WILL FILL WITH THE DOOR OPEN??? BUT WON'T ATTEMPT TO WASH. REPLACE WASH MOTOR?? THANKS lYNN


I would agree.. Here is a site for you to copy and paste in your address bar that I think will be helpful:http://home.howstuffworks.com/how-to-repair-a-washing-machine.htm/printable ... Maytag Dishwashers

Hi experts - My dishwasher won't drain properly. There's several inches of standing water in the bottom of the unit. During the drain phases of the wash, the motor underneath doesn't spin and a buzzing is coming out of the motor relay. During the wash and rinse phases, the motor runs fine and all appears well. Any thoughts? Thanks!


Either the water outtake or the pump are clogged - you will have to remove it to see where's the problem. ... Frigidaire 24 in. FDB679GF Built-in Dishwasher

I have a Kenmore diswasher model 587 1525. I can hear the water filling and rinsing, but during the wash cycle I do not hear the motor. At the end of the wash cycle and when I open the door I see the detergent tablet is sitting on the floor. The dishes are not cleaned. Does this mean that the motor has failed or is it the control card. I can hear some clicking noise while the motor should be running. Maybe solenoids cycling.


... Kenmore 24 in. 15252 / 15254 / 15259 Built-in Dishwasher

The motor continues to run with the diswasher powered off. In addition it will no longer enter wash mode. It can be powered on and wash mode can be selected, but nothing happens except the motor continues to run. Cycling the power feed off and back on does not solve the problem.


Hello John,\015\012\015\012The simple answer (without looking at the wiring diagram) is the float switch. The simple answer (after looking at the wiring diagram) is the float switch. I've posted the wiring diagram for this washer to Flick ... LG 24 in. LDS 5811 Built-in Dishwasher

My sound conditioned Whirlpool dishwasher is real old. It fills up completely with water. It looks like it will overflow, so I stop it. I thought it always started washing from the start. Do they always fill completely up with water, then start washing. I never noticed. I am afraid the water will overflow. Can it? Last time I ran this, it had a real loud motor. I used to hear the motor running from the start, but now I don't, just water filling up to what looks like overflow if I let it. I baile


... Whirlpool 24 in. GU2500 XTP Built-in Dishwasher

Whirlpool Dishwasher detergent door not operating properly. Main wash door opens immediately after starting dishwasher. No pre wash cycle. Loud humming noise coming from bi-metal switch or wax motor attached to the detergent cup assembly. I just replaced detergent cup assembly including the wax motor and I still get a loud vibrating humm from the actuator. model number du1055xtp3


Pdemaio,ngafm at your serviceI believe the loud humming you describe is an electronic problem. And is not worth changing parts randomly and spending unnecessary funds in this fashion!my advice is a hands on experi ... Whirlpool Dishwashers

Dishwasher will drain but not wash, is this a motor issue or control board. I guess my real question is does the pump motor, wash and drain as well???


Your dishwasher s probably clogged take apart an clean this happens to me all the time my wife thinks its a garbage diposal its not ... Whirlpool Dishwashers

E3 error I have a Fisher and Paykel DW60cdx2 dishwasher which was tripping the safety switch as the drain hose was leaking and was shorting the wash pump motor out which I replaced and now on start up I I did notice the wash pump motor had a solenoid on the side where my original did not otherwise all else is identical.


... Fisher and Paykel Dishwashers

Dishwasher motor sounds like its struggeling to run. oR LIKE it's bogging down during washing cycles any and all cycles. there is water going into the washer but when washing it sounds like there is no water moving around creating the motor to work harder ........sounding like its gonna stop at any second. frigidaire d/w model#= FDB510LCS3 SERIAL==TH74378818


Try pouring water from the front. The pump has got air traps inside. This will ease your problem.Also check whether the spray arm turns freely without any obstacles. ... Frigidaire 24 in. FDB510LC Free-standing Dishwasher

Makes rumbling noise during wash cycle. I've pulled the pump and found no debris. It's been making this noise for about a year now. No problems with our dishes getting washed. Do you think the bearings inside the motor may be bad? If so, would I need to replace the motor and pump assembly?


... GE 24 in. GLD5560LSS Stainless Steel Built-in Dishwasher

ASKO 1885 Built-in Dishwasher: The water sump fills normally, but the wash cycle does not start. Althought the timer seems to work, the wash cycle motor won't start up in any wash or rinse selection. The spray arms do not spin - no water is being pumped. At the end of the wash cycle time, the water will empty out of the sump. Thank you. TB


Hi, Welcome to FixYa. Based on your description and provided the dishwasher is indeed 1) an Asko 1885 and 2) filling ... Asko 24 in. 1885 Built-in Dishwasher

I have GE Madellion 870 Washing machine I guess I have motor problem motor stopr after smoke Now Motor spins for few second then stops after 15~ 20 minutes, it will run again for few seconds if my motor burnrd then why it still runs for few seconds


Hello ashankhan,huuum,happy to assist you!You said,I have GE Madellion 870 Washing machineI guess I have motor problemmotor stops after smokeNow Motor spins for few second then stopsafter 15~ 20 minute ... Dishwashers

I was trying to wash dishes and i noticed that the motor wasn't running but water was filling up the unit. I smelled something burning, and i shut it off and took off the cover and i felt the motor and it was very hot to touch. I assume the motor is frozen. How do I change the motor? Is my diagnostic accurate?


Hi.From your description it sounds like the pump motor has blown and must be replaced.Before replacement the motor can be tested by jumping eac of its wires to energize it directly, for safety reasons the operation must be done by a ... Dishwashers

No Water Coming Into SHU43C05UC/12 Bosch Dishwasher: We have a Bosch Dishwasher, model number SHU43C05UC/12. It has been working for more than 4 years, but yesterday I notice that although I hear a motor sound, there is no water in the dishwasher. The LED display on the panel seems to be working all right. I ran a diagnostic pressing and holding Power Scrub and regular wash button then pressing the on/off button. Got C1 at start then P0 and the Regular wash and Quick wash flashing on/off. How c


... Dishwashers

Bosch Shu43C02UC dishwasher fills with water but the washing won't start. As the filling nears complete, a double clicking noise occurs to start the washing motor but nothing happens. The time continues to countdown but the machine is silent. When I open and close the door, the click click noise is heard but the machine is silent. I can cancel the cycle and drain the water but none of the washing or rinse cycles will activate but the timer works. The soap door even opens if the timer is left to


Have you checked the inlet water temperature is at the correct level for the dishwasher.\015\012\015\012Please provide the full model no. of your dishwasher -- Shu43C02UC /??\015\012\015\012I think the problem is linked to th ... Bosch 24 in. SHU43 Built-in Dishwasher

When I press the start button, Bosch dishwasher (model SHY56A 05UC) just keep running the motor pumping the water out of dishwasher, irrespective of: 1) the wash cycle it is on, 2) whether the door is closed or open, 3) whether I cancel drain cycle, as told by Bosch Cust Svc in following steps: - "Cancel Drain" by pressing 'Quick Wash' and 'Regular Wash' buttons together for a minute until it shows 0* - Shut power off for a minute and wait for a minute - Restart on Quick Cycle. Paid


What is happenig i believe and has happened to me 2 times is that the water level float that is on the left side of dishwasher is stuck.\015\012\015\012Either remove side panel and flick lever or pull dishwasher out and tap lower portion ... Bosch SHY56A02 / SHY56A06 Built-in Dishwasher

I have a Hotpoint Aquarius FDW 20 dishwasher. Prewash and Wash lights were flashing, machine had stopped and water was at the bottom of the machine. What does this indicate? After removing some debris from the water drainage pump, then reassembling the machine, I now get the pre-wash LED flashing and a motor operating, but no futher progress into the wash cycle. What does this mean?


Dishwasher always full of water at the end of cycle ... Hotpoint 24 in. FDW60 Free-standing Dishwasher

Bosch SHU43 My Bosch SHU43C dishwasher stopped washing, turns out the impella came free from the motor, I repairded impella and put it back together and now the dishwasher washes great however now it is stuck in a wash rinse drain cycle. Display counts down but the unit never stops running when it reaches 0. Also, the water level is higher than normal and I there is a kind of thumping sound repeatedly every 15 seconds " use to make that sound only once at the start of a cycle before the impella


Sounds like the control module is out -- cost about $100 (I am on my third). I got a "lifetime" warranty when buying my second one. If you are handy, you can replace it yourself. You can call Bosch to confirm this (I did). It mounts inside the door. ... Bosch 24 in. SHU53 Built-in Dishwasher

LG LDF8812ST dishwasher not washing: reports LE error code. Fills and drains ok. Impeller is clear, removed inside housing - no obstructions. Synchronous motor works. Tested main motor - appears to be good. Motor is not locked, looks to be in excellent condition. No shorts to ground, continuity across three main pins - not sure what the other 4 are for. My guess would be the PCB, but not sure how to test this. How do I determine if the PCB is bad?


... LG LDF9810ST Built-in Dishwasher

My KitchenAid dishwasher (model KUD101TJWH0) suddenly is making noise from the motor area while inputing water into the unit, whether in the rinse or washing cycles but makes no noise in the draining cycles. I have pulled the unit out while still connected, cleaned any debris from the filter screen below the lower water spokes and can hear the noise very plainly by the motor but I know how sound can travel with the piping. Is the sound only coming from the electric drive motor attached to the


... KitchenAid Dishwashers

Bosch shu8806 Hello, I aquired a shu8806 recently and it doesn't work. It has power and water. I push wash cycle, indicator light comes on, shut door and nothing happens.  So the door switch seemed like a good place to start. Since I am an electrician I thought I would give it a shot. When plugged in, the wire from the motor is 120V but when jumpered to the neutral(common on the door switch), motor doesn't operate. Although, I have heard the motor turn over momentarialy when trying to run unit e


The pump may be clogged, or the motor start capacitor may be bad or some units have a fill switch wired inline with the motor so it won't start unless the unit is full ... Bosch 23 in. SHU 8805 Built-in Dishwasher

Maytag dishwasher model MDB6800AWB. On Wash Cycle the water is not going to the wash arms, resulting in dishes not being washed. Water inlet and drain work, water is heated, The motor is new.


... Maytag Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1044 seconds