Having problems with your Whirlpool 24 in. GU940SCG Built-in Dishwasher ?

The drain cycle stop working. Everything else is ok. I check the hose and strainer for clog, nothing there.


Answers :

Repair Help & Product Troubleshooting for Whirlpool 24 in. GU940SCG Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

The drain cycle stop working. Everything else is ok. I check the hose and strainer for clog, nothing there.


... Whirlpool 24 in. GU940SCG Built-in Dishwasher

Hello , we have a blanco BFDWC65 dishwasher supplied to us by our builder , The dishwaser fills with water ok then once in cycle it starts (with all operating lights ) then stops , it continues to start then stop for the rest of the cycle , Quiet some time later it finished and then drained the water ok , now it struggles to get to the end of the cycle. have checked all filters , water pressure and for clogged hoses , everything is ok in that department. Any help would be apprieciated


I would suspect the control board in this type of behaviour. As the machine is new I advise no interference, but to open a claim under warranty. You would have all the warranty papers for this unit, or should have received them from your builder. The ... Dishwashers

Dishwasher not draining @ end of cycle - drains throughout cycle, but not the final rinse. I checked hose, pump, filter - nothing is clogged. Any Ideas?


... Jenn-Air JDB1105AWS Stainless Steel Dishwasher

Neff s5443x1gb/07 drain pump starts at beginning of any cycle then stops. when due to fill with water nothing happens and the end light is flashing. there are no blockages. is there ant way to check the supply hose which is in one with the valve or could it be something expensive?


... Neff 24 in. S5443X2 Built-in Dishwasher

- the dishes and glassware on the top rack are not coming out clean - I checked the course strainer to see if it is being blocked but don't see any thing there - I also took out the spray arm that sprays up into the top rack and ran water through it with a hose - it also appears to be free of clogs. - I don't see the spray arm spinning when I open the door during the wash cycle - - lastly, it may be unrelated, but the dishes are not coming out of the washer as hot as they used to be any i


... KitchenAid 24 in. KUDI01DL - Multiple Color Built-in Dishwasher

Hi! We just installed our LG LDF8812WW built in dishwasher. We ran our first cycle and after the wash cycle the dishwasher displayed error code OE. I read that it meant there is a problem with the drainage, and to check the hose if it is kinked. Well, the hose is not kinked and we have no idea why it would have a problem with the draining. We have the hose set up per the installation instructions. How can we check to for something clogged? Any suggestions?


I actually own an LG LDF8812 myself, except mine is stainless steel, not white. So be it. :-)\015\012\015\012Anyway, it sounds like you have just unboxed the unit and it is brand new, not just new to you. I am also ... LG LDF8812 Stainless Steel Built-in Dishwasher

Avanti dishwasher stopped working. I have checked breakers-the dishwasher lights do come on-it will not cycle. When it first stopped working, the motor was working, but the dial would not move. I tried to cycle it to drain the water, but then nothing more happened.


... Avanti 18 in. DW19PSS Platinium Built-in Dishwasher

Kitchen Aid dishwasher Model# KUDP01FLSS. 2 problems #1 Won't run unless you press in on the door and hold it for a few minutes then it runs through cycle normally. Problem #2 It won't drain water out at the end of the cycle when I open the door there is water laying in the bottom of the tub. I have checked the drain hose for clogging and it appears normal. I am able to remove the hose from the disposal and suck the water out of the tub using a shop vac this indicates to me that the drain is ope


... Dishwashers

I have a MDB4630AWS1 series dishwasher that is only a couple of weeks old. Suddenly, it now starts the wash cycle but then the Cancel/Drain light turns red, and it drains and stops the cycle. Check for items blocking the sprayers and looked for anything clogging the interior. It does this with all the settings. Seems to work for a few minutes, but then it just drains and stops. Any help would be greatly appreciated.


... Maytag MDB4630AWS Dishwasher

My dishwasher siemens se25a266gb purchased in 2003 will fill with water go through a wash cycle but does not pump out the water i have cleaned out the filters, checked the exit hose and all seems ok the only way to get the water out is bale out by hand. after this it will run through a wash cycle then stop and not pump out. how would i get to the pump and check it? any help appreicated regards Alan


\012Hi,\012Here is a tip that I wrote that will help you with your dishwasher not draining problem...Dishwasher Problems - ... Siemens 24 in. SE25A266 ExtraKlasse Free-standing Dishwasher

Bosch shv55mo3gb Keeps stopping during cycle, when open door the little tap light is on meaning trouble with water, checked supply vavle is on, checked filters and no kinks in hose, if i turn the water supply valve on and off then sometimes you can here the water flow through and it will work again, onlt 13 months old??


Use this link then click on insruction manual download type in the model number remember 0 is a number.I know that sounds condesending but i forgot. I used the manual with the ending aus.\015\012\015\012 ... Bosch 24 in. SHV55M03GB Built-In Dishwasher

Defy Dishmaid DW12 stopped mid cycle and does not respond I checked for any moisture underneath the machine by opening the back and side panels. the only response that I do see is when the door is open the light burns but when it's closed, it is dead. By turning the program/ cycle knob nothing happens.


Exact same peoblem. Did you guys have any luck? ... Dishwashers

We have a Haier DW12-PFE2-U dishwasher thats 2 years old. The cycle stopped yesterday leaving an amount of water in the bottom and all of the program lights are illuminated with a recurring beeping sound happening. It says in the booklet that the drain hose is too high or bended. But its not. The display does show the time when a cycle is selcted but nothing happens. The dishwasher turns on and off normally. Can this problem be rectified? thanks!


Refer userr guide on page 21. It reads...\015\012\015\012When all the programme indicators " J" blink.\015\012Have you checked whether:\015\012the door is closed properly.\015\012\015\012 ... Dishwashers

Asko dishwasher- about 1 year old. Dishes are clean but very wet at the end of cycle. The bottom tub is filled with water (looks clean and warm). The dishwasher is leaking and water on tile kitchen floor. I checked for a float device inside and do not see one. What do you think problem is? How can I check hoses to see if clogged- do I need to pull washer out? Is that hard?


... Asko 24 in. 1895 Built-in Dishwasher

Hello. i have a kenmore model 363.1522100 serial vf308860r dishwasher. recently with the last 3 cycles there has been about 4 gallons of water at the bottom of the tub. There is no air gap. I cleaned the drains(there were no clogs). I checked the pump and it turns. All hoses are clear of clogs. Any suggestions?


... Kenmore Dishwashers

Siemens dishwasher model SE24A232/43 When going thorugh the cycle it sudddenly stops - all lights go off. Sometimes it recovers (several minutes or several hours), sometimes it is neccessary to wait, open/close door and restart (sometimes it responds to this and sometimes not). Eventually after several such trials it completes the cycle. Control system was suspected, sent for check and repair but nothing wrong found with it. The "all lights off" symptom makes me suspect it is some kind of a


... Siemens 18 in. SF24A262 ExtraKlasse Free-standing Dishwasher

Dishwasher will not drain there is a bunch of water in the bottom. Tried running it through the cycle to make it drain out but still nothing just water in the bottom. Checked the sink and garbarge disposal to see if anything was blocking it or clogging it up but got nothing. Any suggestions?


Most likely a bad drain valve solenoid.\015\012It is attached to the side of the motor.\015\012The GE solenoids tend to burn out. ... GE Dishwashers

Maytag MDB6600AWW Unit is approx 3 years old it was finishing a load and stopped part way through sticking on heated dry. I don't know if it was there in the cycle or if the diagnostics on the board sent the message there. The light now will not shut off or move from the heated dry. I have disconnected 120 volts, removed the panel to check wiring, removed board and reassembled nothing resets the heated dry light and nothing works. I have gone through manual function test, sales floor demo test,


Have you tried pushing heated wash, heated dry, heated wash then heated dry? Sometimes this will reset it. ... Maytag 24 in. MDB6600A Jetclean II Built-in Dishwasher

Neff 4456 water resevoir not filling. Checked float switch and all OK. Checked water supply and all OK. Filled resevoir manually from top of resevoir and program cycle starts but stops when rinse is required.Have stripped down and cleaned switch with float switches as I have had that problem before getting clogged. Any ideas


... Neff 24 in. S4456 Built-in Dishwasher

Wash cycle stopped with water in the bottom. Seems like there is no power. Can't get lights on cycles buttons to turn on. Power button does nothing. Checked circuit breakers. All are on. Lights and outlets around dishwasher area are working.


Check the wiring in the units junction box. Its located at the bottom right corner. You will likely find melted connectors. If so, you need to cut the wires back and replace these connectors. Make sure you turn the power off before doing any of this ... Bosch 24 in. SHX46A05UC Built-In Dishwasher

My dishwasher just stopped working in the middle of the wash cycle. It seems to have no power to it. I have checked all the circuit breakers and reset them all and still nothing. Any ideas?


Your hard wiring maybe bad, or a wire nut came off call electritian or someone who knows electricity ... Whirlpool 24 in. GU980SCG Built-in Dishwasher

Water not draining after wash cycle. Pressed cancel button to start draining per manual, but nothing happens, although sounds like motor is humming. Drain hole in sink appears clear, but haven't checked the hose. What's my next step? Mine is model kudko2cr


Hi,Checkout this tip that I wrote about that problem...http://www.fixya.com/support/r4225828-dishwasher_repair_problem_detergen ... KitchenAid 24 in. KUDI02IRBS Stainless Steel Built-in Dishwasher

My dishwasher stopped working during the wash cycle now i have no lights on the front panel. i checked the breaker but nothing wrong


... Kenmore 15762 Dishwasher

Siemens auto 3 in 1 dishwasher stopped working. lights are on. Machine is humming for a while, but no water enters the machine. Water tap is turned on, filters are clean, no bends in the hose. timer is counting down as during normal washing cycle, but nothing happens


... Siemens 24 in. SE25A266 ExtraKlasse Free-standing Dishwasher

I have a maytag mdb6100 dishwasher with 2 problems. (1) the water does not drain and (2) food is left on the dishes after the wash cycle. I have checked the hose and there are no kinks or clogs.


... Maytag 24 in. MDB8600AW Jetclean II Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1214 seconds