Having problems with your Whirlpool Dishwashers ?

Whirlpool Model # DU8300XX-0. Motor seal is leaking.

\015 Whirlpool Model # DU8300XX-0. Motor seal is leaking. Have removed 3 screws holding motor to plastic impeller housing. Removed gray plastic piece that screws into other end of impeller housing. How do I remove brass bushing and impeller to remove motor ? Thanx. Doug.\015\012\015\012The 8 in the Model # may be a B. ( DUB300XX-0 ) My eyes aren't as young as they used to be. :-)\015

Answers :

Repair Help & Product Troubleshooting for Whirlpool Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Whirlpool Model # DU8300XX-0. Motor seal is leaking.


... Whirlpool Dishwashers

Whirlpool model # DU1055XTPQ4, type 575-0. It is leaking water from the bottom front and it looks like the seals are tight. There are seals along both sides and the top. Is there supposed to be one at the bottom?


... Whirlpool Dishwashers

My Maytag model mdb9600aws motor shaft seal is leaking. How do I remove the seal and replace a new one. I am a novist, but I have taken the motor completely out and replaced the seal / gasket that the motor sits in, but there still is a leak. I am afraid the leak is going to destroy the motor as it has corrosion / salt like stuff about the motor. I have attempted to pry the shaft off with the use of 2 screw drivers. I was thinking since I am going to replace the whole motor shaft seal and chop


You are wise to realize the leak would destroy the motor.Take a close look at the diagram to see everything that gets placed on the motor shaft. That should give you a good idea what can/must be removed from that shaft. ... Maytag MDB9600A Jetclean II Built-in Dishwasher

Whirlpool Model DU915PWPS0. Water leaks from the bottom of door


... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

Smeg dishwasher leaking through the door ive removed the lower door seal but dont know how it should go on happened all of a sudden and there was a desert spoon in the bottom of the dishwasher . im hoping it leaked because it dislodged the seal the seal came out easily from the outside of the dishwaser. can any one tell me how to replace it and which way it is supposed to sit model number sa425 smeg


... Dishwashers

A built in whirlpool dishwasher is leaking around the door seal, right side to be more specific. cleaned the seal, and along the bottom and it still leaks. Is there an adjustment that can be made to tighten the door. I wouldnt think it would be the seal itself do to being less than 2 years old. Thankyou for this service.


Hi,There is no adjustment per say on this door or seal. If water spray directly on the door it can cause this, what I mean by that is if the spray arm, either the upper or lower is stuck and continually sprays in one place it can cause th ... Whirlpool Dishwashers

Model # PLD2850RDC2 has a leak at the bottom of the door. i have replaced the gasket in the vent. Had to remove door cover and seal at bottom of door. Had difficulty replacing bottom seal. How do I replace seal correctly? It is still leaking. Could it be something else?


The side baffels are bad. look on each side on the bottom in the corners and that is were their at just pull them out and get new ones ... Dishwashers

My Maytag Quiet Series 300 (Model #MDBTT79AWW) leaks about cup of water a minute. I've removed everything from inside the dishwasher. It looks like the main seal is replaced from the bottom, possibly necessitating pulling the unit out first. Is it possible to apply some sealant to top of the seal to stop the leak? Thanks, John


... Maytag PDB3600A Built-in Dishwasher

Dishwasher leaks occasionally. Does not leak every time it is used. Leaks from front of unit, usually front left side. I believe it is overfilling and leaking over the front door or splash seal. It is a Maytag model MDB5000AWW.


... Maytag 24 in. MDB5000 Built-in Dishwasher

Leaking lower door seal on kitchenaid dishwasher model KUDM25SHWH


Check door hinge. ... KitchenAid KUDR01TJ Dishwasher

I have Whirlpool ADP 962 dishwasher. The front door is leaking when washer is running. I can feel a rubber seal at the bottom of the door, when I open the door, which seal is wavy and corrugated. How do I replace the seal, and what is replacement part number. Thanks Trevor H


Hi,\012Here is a tip that I wrote about dishwashers and them leaking.Leaking Dishwasherheatman101\012\012\012\012q4w5ifgf ... Whirlpool 24 in. ADP5966 Free-standing Dishwasher

We are having water leak from the bottom of our Roper Dishwasher door. THe model # is RUD5750DG3. I have taken the inside door frame off and found a small white rubber seal had dislodged inside. i placed it back in the only sopt it fits but water is still leaking. I have checked to make sure the water is not leaking from any where else on the dishasher. This occurs when the water inside is spraying and eventually fills up on the bottom. We no longer have our manual as the dishwasher cam


Try to fix the rubber seal which has come out by fixing it through super glue or apoxy seal which will stop the water spill and leakage.\015\012Please give more details of you dwasher ..... the Make and model so that i can send you the manual f ... Dishwashers

Dishwasher leak I have a General Electric Potscrubber Mobile Maid dishwasher (model GSC720?) that hasn't been used in some time, but appears to still work OK. It has a leak from the left hand vent opening in the bottom of the door when operating. The seal around the door appears intact and doesn't leak. Can you suggest a probable cause, and remedy? Thanks, Bob.


With dishwasher empty and disconnected, find the screws around the area of the "vent",you may need to open it from the bottom. There will be a hose that has either ruptured or just needs the clamp tightened with a screw driver. I think that the hose ... Dishwashers

Water leak My model is a GU2400XTPB1 The tub of diswasher has small hole where a screw is mounted on bottom of dishwasher. Leak is severe during cycle. I have tried epoxy but it will only hold up for a few washes. Will anyhing seal the leak and hold up? The dishwasher is only 2 years old..


Mine also started leaking. Element also too hot. Mine has a 20 year warrenty on the tub (which I was NOT aware of) Repairman came today and the whole tub unit and element will be fixed for free! Look in your whirlpool instruction book to see if your ... Whirlpool 24 in. DU1100XTP Built-in Dishwasher

I have a Whirlpool DU9000XR-9 dishwasher that was leaking. No leaks were coming from the bottom of the tub or any connections, etc. I replaced the door seal where it closes on the tub. There is still a leak on the bottom of the door. Can you point me to a possible issue(s).


... Whirlpool Dishwashers

I have a Whirlpool Gold GU3600XTSY0 Model. There is slow water leak from the right side bottom front of the dishwasher. It looks like the water is leaking from a sensor on the bottom. The sensor has a pin protruding that can push up and down...almost like an on/off switch. I am wondering if there is any way to fix this. Water is leaking on my hardwood floors.....


That is your overflow water switch, that tube goes up to the washer, that switch is defective..water from the machine will come thru that hole ... Dishwashers

I have a kitchen aid superba model no. kuds25shbs1. when running water leaks out the bottem of the door. Is the seal probably bad and can it be replaced. How?


... KitchenAid Dishwashers

Looks like my dishwasher is leaking. Found the leak downstairs of my house. Is there a bottom seal in the dishwasher that needs replacing? I have model # FDB510LSC0.


... Frigidaire Dishwashers

I have the two drawer model dish-drawer system. In the past the top seal leaked and since has been replaced with a new seal. Worked well for several years after but then the top drawer quit running. So we started to use the bottom drawer. That was fine for awhile althought it would pump waste water into the top drawer. Now neither drawer will work. The bottom drawer starts up and shuts down. I pulled the lower drawer and it is dry.


If your model has got an LCD display are you able to record what shows up on the display when the bottom drawer shuts down. If no display then are you able to note down the LEDs which are on inside the top of the drawer lid. It is likely there is no ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Leaking at bottom of front door with suds and water coming out. Cannot find the model number. Seals on door (3 sides) are fine. Cannot see a seal for under the door.


Hi,\012Here is a tip that I wrote about dishwashers and them leaking.Leaking Dishwasherheatman101\012\012dafhrw ... Hotpoint 24 in. HDA3400G Built-in Dishwasher

Our Hotpoint Aquarius Dishwasher BF11, built into the kitchen units is leaking steam from the door ( and starting to cause the wooden floor to bend ). Can I get a door seal for this model ? It's probably 11 years old, being in the house when we bought it. And, is fitting a door seal a simple job for an amateur ??? !! Thanks


... Hotpoint Dishwashers

Have a leaky gate valve shaft seal that I want to replace myself (part # WD8X181). It only leaks when in the drain cycle. Repair manuals are not available for this model. How much disassembly is involved to replace this seal? Do I need to gain access to the shaft from inside the housing pump assembly (drain sump)?


... GE Dishwashers

Leaking dishwasher I have replaced the rubber grommet around the soap dispenser latch and have double checked it for leaks.It is not leaking and I suspect that was never my problem.The water is coming from the lower right hinge area.I do not qualify for the maytag recall.I have never used the rinse aid dispenser but find it peculiar that there is no rubber washer in sight.Could I have a bad door seal? Maytag Model #DWU7402AAB


Hi there, dishwasher leaking might be due to either of these causes, check these:Main tub sealNote… If the main motor of your dishwasher is mounted vertically, beneath the center bottom of the dishwasher, the foll ... Maytag 24 in. DWU7402 Built-in Dishwasher

My Whirlpool Gold Model #GU980SCG52 is leaking on the outside of the Water inlet. The hose is attached on top, but the water is leaking out of the opening on the front side under the hose.


HI. this is a inlet assembly issue. The water inlet valve can be identified by the water hoses connected to it. One hose will lead from the valve to the pump/motor assembly in the center of the dishwasher. Check that the hoses are securely connected ... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

I have a Whirlpool Dishwasher model number DU8400XB-1 it has leaked at the bottom left side for a while and now all the way across. I removed the inside of the door and saw that the splatter shield had come loose. I put it make in place but still have leaking. any advice


Drum maybe the problem ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1217 seconds