Having problems with your Whirlpool Dishwashers ?

Dishwasher has been idle for 6 months, let water in the washer but washing did not take place. Mod#DU810SWPQ0


Answers :

Going to buy a new dishwasher, but thanks anyway.
Repair Help & Product Troubleshooting for Whirlpool Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Dishwasher has been idle for 6 months, let water in the washer but washing did not take place. Mod#DU810SWPQ0


Going to buy a new dishwasher, but thanks anyway. ... Whirlpool Dishwashers

We have been using this model since Sept. 2007.When new, it worked very well. It has over time, performed less then we would expect. Not only do we have to scrub dishes by hand before placing them into washer,they some times require hand washing after being washed by machine. Not only are they dirty, the glasses are covered with a cloudy white film. We have not done any maintenance or service to this dish washer. Does this washer require some sort of service or attention. Please advise. Thanks


... Jenn-Air 24 in. JDB1250 Built-in Dishwasher

My dishwasher is a Fridigdaire FDB510LCS1, approximately five years old. The timer/knob stops advancing at about 7 o'clock, somewhere in the wash cycle. But the washer keeps running. I marked the place where it stops and, on additional tests, it stops in exactly the same place. I can advance the knob slightly past this location and the washer continues through to the end of the cycle.


Hi\015\012\015\012This is due to a faulty timer on your dishwasher. You would need to replace it to resolve this issue. You can buy the timer for your dishwasher from this link---\015\012\015\012 ... Frigidaire 24 in. FDB510LC Free-standing Dishwasher

My 2008 frigidaire 24" dishwasher model #FDB1050REC is not washing during the cycle. I have run the test cycle and the tub is filling up and draining but no washing is taking place during the wash cycle. The dishwasher has an electronic control board and therfore no mechanical timer. I put test leads to check for voltage on the power leads to the main washing pump, which I have already replaced with a new one, and I'm only registering a low voltage of around 10 or 11 VAC. With the cycle off I'm


If you have replace the motor and this did not fix your problem then yes replace the control board ... Dishwashers

Have a 665-16293201 dishwasher with electronic controls and smart sensor. Approx 10 years old in great shape. it just started having a problem - it takes a long time for the sensing to be completed at the start of a wash and then the washer will start and display a time - like 92 minutes - turn the sensing light off, then start to wash and count down. when it gets to 86 minutes, it starts to sense again and will continue washing while displaying 86 and with the sensing light on. It will keep


... Kenmore 24 in. 16293 Built-in Dishwasher

After wash cycles are completed there is about 1/2 gallon of water remaining in the bottom of the washer. I checked the drain that exits into a disposal and that is clear. All around the bottom of the washer base is clean and I can find no obstruction. Nothing in the owners manual gives me a clue as what else to do. I don't want to start taking things apart unless I have to.


Hi and welcome to FixYa. I am Kelly. Most dishwashers are connected to the sink / garbage disposal via an Air Gap. The Air Gap gets debris inside it that blocks the drain passages. Check out this video on how to clean it: ... Maytag 24 in. MDBH950AW Built-in Dishwasher

When ever i start my Hotpoint DWF 35 dish washer the numeric display has started showing a very long cycle time, it seems to be adding about 60 mins on what the cycle normally takes. It still seems to wash ok but takes forever to complete.


... Hotpoint 24 in. DWF35 Built-in Dishwasher

Our Whilpool GU1200XT "Quiet Partner III", (Apr. 9, 2003) ran very quietly until about 18-24 months ago when a frying pan lid, that had been washed many times, had lost about 1/2 of it's paint when it came out of the washer. We thought that the paint would soon get ground up & disappear, but we are still plagued with the niose during the wash cycle. Can we take this thing apart ourselves & fix it and if so, how?


... Whirlpool 24 in. GU1200XT Built-in Dishwasher

My siemens dishwasher has the water tap indicator light on when washing starts. i have cleaned the water filter and the spray arm but the light doesnt go off and the washing doesnt take place. Instead i can just see water coming into the drain in intervals. what do i do?


... Siemens Dishwashers

Frigidaire FDB520RHB Dishwashers : We bought this dishwasher about 3 months ago. Today I ran the washer before I left to do errands and when I returned, I believe the washer had finished its cycle. But about an hour later, I noticed it had started up on its own? It then proceeded to run for almost 3 hours before my husband canceled the cycle. We were kind of waiting to see if it would stop on its own, which is why we let it go so long. I think it usually takes about 1 1/2-2 hours to wash. Could


Try to run the dishwasher on a short cycle like rinse and see if it finishes the cycle.It is likely the heater or hot water temperature is not reaching the desired level and this could cause the extended wash cycle. Feel water temperature ins ... Dishwashers

Lg adora model no.ghda696pss serial no.sr800098c dishwasher takes in water but no washer arms are going round and the soap container does not open at the end of the cycle the dishwasher empties and heats the utencils which have not been washed.


Hi.Ensure that there is water getting inside the machine. If there is no water, then the water level switch or the water valve may be defective. The door lock switch must also be tested.If there is no water getting into the ap ... LG Dishwashers

My gas power washer will not start. I filled the gas, checked the oil, set the choke, made sure it was on, changed the spark plug, checked the air filter, and drained any water. When I pull the cord to start I don't even get a putter. Anything else I can try or do I need to take it to a service place.


Will it run if you pour a small amount of gas in the carb? If so, it's a fuel supply problem. Most likely a stuck closed float needle. ... Honda Maxus Pressure Washer MX5222

I have a Bosch (SHU5302UC/U12). The washer often takes 2 or more hours to run. Sometimes it gets stuck for a long time part way through (e.g. just sits at "43"). Other times, it gets stuck at 1 and won't stop on its own. The latest thing is 2 dots have appeared on the display that I've never seen before. For example, instead of "43", it reads "4.3." Eventually it gets to "C.L." but does not stop running. Also, its been making very strange noises during part of the wash cycle.


... Bosch 24 in. SHU43 Built-in Dishwasher

The dish washer is taking ages to wash and it not clean ing dishes well


Ok so \015\012If your dishwasher has worked fine in the past but, suddenly, your\015\012dishes aren't clean after the dishwasher completes all cycles:\015\012\015\012\015\0121) Che ... Dishwashers

I need to know what kind of oil the pressure washer takes, I noticed it has a place for oil on the engine and another neat the pump. The product is a honda pressure wave 220 PSI Model NO 2225cwh-2


... Honda Maxus Prosumer MX5223 Pressure Washer

Smeg dish washer mod. dw1612c pumps out water as normal takes in water but does not pump through jets to wash


Could be a problem with the pressure switch which will need to be replaced.\015\012The part is available from ... Dishwashers

Our Kenmore dishwasher 665.1726 doesnt seem to be cleaning as well. LAst time this happened a serviceperson cleaned out a filter where food debris had clogged the water flow. We were able to take off the bottom wash arm but couldn't figure out how to get the filter off (there are 4 screws holding it in place and one is under the plastic arm that caries water to the sprayer.


I had the same problem!\015\012\015\012The arm WILL come off....you have to pull the screen off. ... Kenmore 24 in. 15689 Built-in Dishwasher

Tricity Bendix DH090 water valve closes too early. Insufficient water causes program to stop before first heating cycle. If I switch off, open the machine & pour an extra pint of water in, shut the door & switch on again the wash takes place and completes perfectly to specification. OK so the problem seems to be that level detector No 1 switches off the water inlet valve early and level detector No 2 (apparently) halts the cycle since it detects insufficient water in the machine. I cannot see t


... Tricity Bendix 18 in. DH090 Free-standing Dishwasher

I have a G2500BH power washer. I was washing my truck and moved to another place and squeezed the triger and only a trickle of water came out of the nozzle. Do you know what the problem might be. Charles


Yes, There is a blockage either behind the spray tip or inside the trigger of the pull trigger.You should be able to service both parts. ... Karcher 2500 PSI Pressure Washer

Door will close but not lock in place preventing me starting a wash cycle on the dish washer


Check to see if your dish racks are in properly or take them out and then try the door. ... Dishwashers

Whirlpool DU900,09,10,11,15,20,30,DUL100 Hi, I'm not sure what exact model mine is, but those are the models listed on the manual. I opened the washer and the whole upper part of the wash tower was laying on the dishes! I took everything out, and began trying to think logically, and re-assemble the thing; nothing appears to be broken. page 17 of the manual is the only place that even shows this set up, but it's just a part description. As I am looking at the picture, I realize that the spray tow


... Whirlpool 24 in. DU920PW Built-In Dishwasher

How long should it take for a normal wash and heated dry on a whirlpool dish washer. Is 3 hours normal?


TOO LONG- 1.5 / 2 HOURS IS NORMAL\015\012\015\012CHECK YOUR FILL TIMES SHOULD BE NO MORE THAN 5 MINUTES PER FILL\015\012\015\012PUT THE DRAIN HOSE INTO THE SINK OR A BUCKET TO MAKE SURE IT IS CLEAR\015\012\015\012 ... Dishwashers

Sometimes the cycle would get stuck (like transmission not working). Now making noise but not taking in water to wash. Machine about 8 years old and used daily. Isi it worth fixing? Sevice call is $140 plus parts and labor. If not what would you buy in its place? SHU3032UC/UC12


... Bosch 24 in. SHU30 Built-in Dishwasher

Washer [dish] does not start to wash ,it only take in water ?


Circulation pump may be stuck/siezed. More info required, for a more accurate diagnosis. ... Miele Premier-Plus Built-in Dishwasher

Water sounds like its comming to dishwasher after awhile dial turns(timer) disher wsher goes in to dishcharge pumping out water but inside of dish washer seems dry like no wash cycle took place


Look inside the dishwasher for large plastic mushroom-shaped thing in the bottom.\015\012This is a float.\015\012Sometimes a knife or fork or something else gets in the bottom of the dishwasher and won't let the float go down. When the float is up li ... Asko D1706 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1296 seconds