Having problems with your Whirlpool Dishwashers ?

Model ADP 4665 WHM purchaswed 2007. Small pool of water at end of cycle coming from l/h side of door. Seal is split at three regular intervals. Is this how should seal should be? Can I instal a new seal myself if it is fact damaged?


Answers :

Repair Help & Product Troubleshooting for Whirlpool Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Model ADP 4665 WHM purchaswed 2007. Small pool of water at end of cycle coming from l/h side of door. Seal is split at three regular intervals. Is this how should seal should be? Can I instal a new seal myself if it is fact damaged?


... Whirlpool Dishwashers

My glasses are covered in small grainy specs after the wash cycle. THey wash off easily, but that's not good, regardless. I used econo setting & thought changing to regular wash would help, but it didn't. I use Cascade with Dawn (lemon scent, which I purchased by mistake after hearing lemon might damage silver) and a rinse aid. Help. Oh, the model is SHU66C05UC/43, and the machine is maybe three years old. Thanks. Riffi OBrien


There are many probable causes of failure .A dishwasher's water inlet valve is its most common part to fail. When \015\012your dishes are not being fully cleaned, quite oft ... Bosch 24 in. SHU66C05 Stainless Steel Built-in Dishwasher

We have a MDB4651AWW dishwasher. It is very loud, we have the bottom front panel that seals the dishwasher at the floor but cannot figure out how to install it. One way it does not fit, the other way it won't let the door open and close properly. The noise is terrible and it has been that way for three years. We don't believe there is anything wrong with the dishwasher, figure the bottom panel will deaden the sound. can you show us how it goes?


... Maytag Dishwashers

Removing and installing seal kit in Comet pump


... Comet GXD2527G Pressure Washer Pump

I have a Bosch dish washer model SHX 43 M 0 ZUC / 48 FD 8709 00169 The dish washer is about 1 1/4 years old and was installed by a plumber as part of a Home Depot kitchen remodel. The problem is draining. The quick wash does not drain at the end of the wash. The regular wash sometimes drain and sometimes does not. The auto wash does drain. The lack of draining does not cause problems with the regular wash cycle. I checked the drain hose re the instruction manual and it is correctly installed.


Usually a brush with a flexible shaft will do the trick...\015\012\015\012Like this venturi tube cleaner (available where gas grills are sold)\015\012\015\012 ... Bosch Dishwashers

Have a GLD6500L00CC dishwasher. after the completion of any cycle there is a lot of water standing in bottom.It is understood that there should be a little water to keep the seal lubricated but the level is as high as the brackets supporting the heating element. The manual refers to running the discharge hose high referring to the installation instructions. The installer did not leave any install instructions only the Operating manual. There is no air gap installed. Where do you go to get a pa


The drain line may be partially clogged. You will find manuals here:http://www.geappliances.com/ ... GE Dishwashers

I have a Dishlex Global 450 dishwasher and have a faulty seal to replace. The original door seal had a foot on each side and the replacement I received has 45 degree cuts and no foot. Also the bottom seal replacement appears to be a screw-in type where the original was slipped behind a fold in the door. I have been assured by the supplier that I have received the correct replacement parts. Could you confirm the these parts are in fact correct and if they are which way should the seal lip an


Hello Tony. I am as concerned as you are that this is not the correct replacement part. The key to getting the right part is the model number which is on your machine, if you know where to look. Do this, go to this link to properly locate your mod ... Dishwashers

I have a Bosch dishwasher model SHE4AP02UC/06, serial number FD901102579 that has been used twice since installation. When I select the Regular Wash cycle, the Regular Wash LED and the Active LED come on. The machine washes the dishes and then when it stops making noise. At that point the Active LED goes off and the Clean LED comes on with the Regular Wash LED. These LED's do not go off. There is no signal saying that the dishwasher is finished. Is this the way it is supposed to be operating or


Ya id say until u open the door after it has washed ... Bosch Dishwashers

Have recently found our Frigidaire PLD2850 leakingat bottom right area. Unit seems to be leaking at corner where seals meet. Can't find anything and have installed new seals to no avail. anyone have any ideas? thanks.


Take a blow dryer on high all around the seal until very warm . close door tight and latch allow to set several hours tryer again good luck ... Frigidaire 24 in. PLD2850 Built-in Dishwasher

Hi I went away on holiday and my dishwasher AEG 50800 was in perfect order. When I came back after three weeks it does not work. It was not in use while I was away so I don't get how come it is not working now .It does start up but its like the pump is just not kicking in. Ihear water running but the blades dont move and nothing seems to get washed, any ideas. Or is a new expensive pump my only option? My Husband seems to think a seal might have gone. Can a seal go while not in use? Thanks


It's worth looking under the machine. There is an overflow area with a float switch which sometimes fills up and it stops it working ... AEG Dishwashers

Hi, We have a Frigidaire dishwasher machine 1500 series with fully electronic control. It is a new unit, has been installed nearly 4 months ago. The other day, when I went to take the dishes out of it, I notice that the rubber gasket that seals the door had come off somehow. Along with it I saw, sitting on the bottom, two pieces that looked like part of the seal, but I didn't know where they came from. I put the rubber gasket back on, but now the pieces and now the dishwasher will leak when runn


... Frigidaire Dishwashers

How do I reinstall the pump seal? I have old KitchenAid KDS-16 dishwasher. The drain impeller failed and I purchased a new kit. Disassembled the pump. Installed the new pump seal but it does not hold water.


You may have tilted the seal when installing so take it apart again and make sure it is all the way down in its bed and it streight to the shaft . and looks centered then reinstall all other parts and try again .. mm h ... KitchenAid Dishwashers

There is water leaking between the left and right seals on our Frigidaire dishwasher FBD700BFC2. The dishwasher is level and was installed by the builder two years ago. The seals are intact, and water only leaks during the wash and rinse cycles. What else should be checked or done to prevent the water from coming out of the dishwasher.


Sorry to read about your problem, I hope this helps you out.its time for new seals...I tried to help you. Please help me and Rate/Vote on my response, thanks and good luck ... Frigidaire FDB700BFC Built-in Dishwasher

Hobart Kitchen Aid dishwasher KDS-58. This washer is a champ. Recently it started leaking water from the lower left corner of the door, while the washer is in the wash mode. I replaced the lower seal, below the door, the seal is installed correctly. Not sure what to do next?


... Dishwashers

I have a three-year-old Sears Kenmore Elite dishwasher. I find that despite the fact that we scrape and rinse our dishes before loading the machine, after each three months of use (two loads a day) or so, I have to take the machine apart (spray tower, racks, bottom impeller, bottom screen housing, food grinder cover) and clean-out the food grinder area, for it fills-up with sludge. The sludge restricts the water flow and there isn't enough flow to turn the impellers via that steering jets.


Have you tried different detergents? Some detergents after getting wet and going through the wash cycle with the debris from the wash turns into a grease substance that grimes up in some dishwashers. Try running the machine with hot water this someti ... Dishwashers

Dishwasher is 8yrs old. We have lived in our home for the last three years and for the past 2 1/2 has given us great service. Now for thew past 3-4 months our dishes and untinsails have a heavy residue on them at the end of a completed cycle. We have had a new piston assy , timer, and rinse aid dispenser install. We have tried advertised cleansers to no avail. Since the last two items have been installed, we have tried twice to no avail.


Hi,The scum, film and white\012residue problems have started since the reduction of\012phosphates in dishwasher detergents.Here is a tip that\012will help you to solve the problem of films, residue, and scu ... GE Nautilus 24" Built-in Dishwasher

Installing a seal kit to kenmore dishwasher, model


... Kenmore 18 in. 14432 / 14439 Built-in Dishwasher

I installed according to guide, but dishwasher will not fill with water. Pump sounds much too loud to be normal. Wiring was checked three times for correct connections. Water supply was checked twice for water getting through, no leaks and water supply on. Drain hose is connected correctly and is connected to house drain.


You state the water supply is on.\015\012Have you loosened the compression nut at the dishwasher ell to see if you have pressure to the water inlet to the dishwasher?\015\012Remember the dishwasher will always run a little to make sure an ... Whirlpool GU2400XTP Built-in Dishwasher

This dishwasher is older than most living people in this business. It works great except it is a 208 three phase unit. It is in St.Peter's church in New York Mills, MN. We bought it used during our remodel project in 1994 for a price of $800.00. That was our mistake. We had a converter installed to accomadate the 3 phase power supply. So we have this converter running 24 hours a day using up electricity and we use the dishwasher four times per year. I am wondering if we could replace the motor o


This unit is a dinosaur. The 3-phase converter had to cost twice as much as the unit. Best solution - turn the power off to the 3 phase converter when not in use.Better best solution - find a newer unit that will be repairable should it n ... Hobart AM14-253 Free-standing Dishwasher

I have a bosch SHU8815UC dishwasher. It was already installed when i moved into my apartment - so I'm unsure of the age. The dishwasher isn't functioning. When I open the door, the "Clean" light and the PowerScrub button are red. When i close the door, the light go off but nothing happens. One time I closed the door, it started to rev up but would shut off and beep three times after about 1 min. No water comes out. Any ideas? Thanks! June


... Dishwashers

Dear experts, i just installed a new disposal and i forgot to knock out the plug for the dishwasher. i ran the dishwasher and of course it didn't drain. i knocked out the plug and i tried it again and it still won't drain. what kind of damage did i do. hopefully there's a safety switch to protect the pump. it's an old unit. the model no. is DW730W. Thank you. jeff


You should see a red button on the bottom it is a system reset\015\012 look at the drain hose ensure it is clear\015\012and has good flow ... Jenn-Air 24 in. DW731 Built-in Dishwasher

Need instructions on how to install LG dishwasher door seal


... LG Dishwashers

The inner door seal keeps popping out and is now stretched out and ripping. Need a new one and advice on installation please.


Over time, these seals compress to the point where they no longer seal correctly, or food particles and grime get caught between the door and seal and leave small air gaps.The silverware tray (if located along the left or right side) can ... KitchenAid KUDS24SE Built-in Dishwasher

This is a "ventless" system. Our dishes aren't drying in any cycle. There are two door gaskets on this model, one was installed by me under the countertop. I was sure to make as complete a seal as possible, since I did not see a vent on the door itself. What can I do to fix this problem?


If your dishes are not drying properly, you most likely will have a defective heating element. You can remove the element on a General Electric appliance, (or any other make and model) and replace it, by following these simple steps: 1. Your heating ... Dishwashers

How do you pop the vent out of the inside of the door without damaging the plastic vent or the seal?


Br, should be a slot in it, put a flat blade screwdriver in it and it should turn about a quarter and pop out...Catriver. ... KitchenAid 24 in. KUDS25 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0641 seconds