Having problems with your Whirlpool Dishwashers ?

I have a whirlpool for Ikea dishwasher that is built in and I put it on the normal 30 minute cycle before I went to bed and 8 hours later it was still going. I opened the door and machine was full of suds. It is like it gets stuck and can't move on to the next part of the cycle. I have checked the filter in the bottom of the machine and checked the salt and rinse aid levels.


Answers :

It could be waiting for the temperature to reach the required level.
\012
\012Sounds like the heater element has died.
Repair Help & Product Troubleshooting for Whirlpool Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a whirlpool for Ikea dishwasher that is built in and I put it on the normal 30 minute cycle before I went to bed and 8 hours later it was still going. I opened the door and machine was full of suds. It is like it gets stuck and can't move on to the next part of the cycle. I have checked the filter in the bottom of the machine and checked the salt and rinse aid levels.


It could be waiting for the temperature to reach the required level.\012\012Sounds like the heater element has died. ... Whirlpool Dishwashers

My bosch dishwasher gets stuck in wash mode. We have to turn the dial to move to the next cycle. When we check inside soap suds are built up on the bottom. We use less than a 1/2 of an Electrasol tablet, no wuick dry ball. We just ran the dishes with no soap and there's still soap on the bottom?


... Dishwashers

The dishwasher does not complete a cycle. It starts the cycle just fine but then it stops after one minute. It seems like it gets stuck and won't move to the next step. I do hear a slight clicking noise similar to a clock ticking, like its trying to move on, but then it stops. It clicks three times. When I open the door the "fine china" light is on even though I set it on "normal". Is there a "re-set" button?


The Control Board is gone, the part is $475.00 Find a new one.... ... Viking Designer Series DFUD041 (Premium) Built-in Dishwasher

We have a IKEA Whirlpool DWF 407 dishwasher that suddenly stopped pumping in water. It's just stuck in a loop where it sounds like the water pump is dryheaving and soon after it starts smelling a bit burnt and smells a bit like a battery. I've checked the overflooding breaker and there's no water down there and I can hear the switch turning on if I move the floater upwards. Also checked so that the water hose up on top of the machine is securely fixed. Any ideas?


... Whirlpool 24 in. ADG6340 Built-in Dishwasher

When cycle starts after about 1 minute bleeping starts and when door opens the machine has changed the programme to the 1st programme (rinse) the light is flashing 7 times then pause then starts again, it sounds like the water is not getting into the machine, we have checked the water pipes for blockage and cleaned the filters?? Model is ADG7440


... Dishwashers

BOSCH Classic Electronic the end light and check water lights wont go off, cant get machine to run cycle


... Bosch Dishwashers

Non-functional I purchased the dishwasher to replace a very old one. I plumbed and wired it exactly according to the installation instructions. When I started the machine to test it all i get is a blinking "wash cycle" light. There is no water moving, no pump noie, nothing. I pulled it back out and double checked everything and it is all in order. Any suggestions?


CHECK FOR A FAULTY WATER INLET SOLENOID ... Frigidaire 24 in. FDB1050REC Stainless Steel Built-in Dishwasher

My Candy CD474 dishwasher seems to get stuck on some of the programme setings. It sounds like it is still working however the dial does not move on. The cycles are also tking longer than expected


... Candy Dishwashers

Hotpoint LFT 114 dishwasher Cycle seems to run OK BUT water cold. No flashing of lights to indicate error, lights appear to behave as normal. Metered the heater element, not open circuit or short circuit. Metered the NTS resistance goes down as temp goes up Dismantled and checked all connections, all seem good. Ran the self test program and it seemed to get stuck in the wash stage, never seemed to move on BUT no error message. Now what, any suggesting please guys??


... Dishwashers

Our dishwasher seems to be stuck in drain mode. My daughter put the wrong kind of soap in it. She accidently put Regular dish washing soap in rather than machine dish washing soap. We've got all the suds out. Seems to drain water just fine. However we cant seem to get it to add water. Does the soap have anything to do with it? Anything I can do from my end? Please Advise. Thanks


Plastic base is full of water. Need to remove whole unit to access bottom and dry it out. ... Bosch 24 in. SHU66C02 / SHU66C06 Built-in Dishwasher

Sometimes the cycle would get stuck (like transmission not working). Now making noise but not taking in water to wash. Machine about 8 years old and used daily. Isi it worth fixing? Sevice call is $140 plus parts and labor. If not what would you buy in its place? SHU3032UC/UC12


... Bosch 24 in. SHU30 Built-in Dishwasher

I have a Frigidaire Ultra Quiet II dishwasher that gets stuck in the 6:00 position (between light wash and drying) during the cycle. It also gets stuck right before the drying cycle. It will proceed with the cycle if I manually move the dial. The heated drying feature is also not working as well. Do you have any suggestions? Thank you for you time, for it is appreciated. Best Regards, Scott G.


... Dishwashers

Dish Washer, Electrolux Home Products, Model FDB2510LCC0, Serial NO: 7H34962223 Machine does not drain or add water. The machine has been worked for a couple of years. I checked the following: 1. Overfill Protector not stuck 2. Motor turns on and the machine cycles correctly 3. Since the machine has been running correctly the unit is hooked up correctly: hoses, garbage disposal, knockout plug. Again everything has worked and the motor does cycle and the machine will perform the different cycles


... Electrolux 23 in. ESI602 Free-standing Dishwasher

Water gets into the machine OK, but it gets stuck on the rinse cycle and continues until I stop it. The tablet does not get dissolved because it doesn't get past the rinse cycle. Please help! Christy


This does sound like a problem with the "anti-flood" device that does detect water (leak / spill) at the base of the washer. This device is a protection device that consists of a polystirene float and a micro swithch. Once a water leak od spill is de ... Dishwashers

Whirlpool dishwasher DU1015XTXBO Stopped working during cycle, acts like don't getting any power. Checked the plugin and it works. No lights or anything coming on the dishwasher. Its like it just


... Whirlpool Dishwashers

BF41 Dishwasher with a leak stuck in mid cycle Hi, I have a 'general domestic Appliance Ltd' BF41 (95+G709394) dishwasher which recently started leaking at the door. After replacing the seal the problem seemed to ease, then recently the problem started all over again and the leaking got worse. A couple of day ago I couldn't stop it leaking and now it's stuck in mid cycle and even though the water is washing inside the machine it never gets hot inside or finishes the cycle. Ive tried stopping and


... Dishwashers

De3861fw Hi, the machine stays on the same cycle time(cycle wash 5-84min; cycle wash 6-93min) The machine is on and sounds like it is running, but no water is entering, have checked the obviuos of water being turned on and also draining properly, but to no availe. Please help! Cheers


... Beko Dishwashers

Bosch dishwasher, Model SMU 7056, UC 09, FD 7309. My older unit has operated flawlessly for years. Two days ago it started to "stall" in one cycle and not progress to the next, e.g., stayed in the wash cycle and would not move on to rinse. In addition the heat generated in the machine was way below normal. A repairman told me that if the water doesn't get hot enough, the unit will not move on to the next cycle. I always use the "Regular Wash" option, but tried other options such as 'Economy


... Bosch Dishwashers

Dishwasher stuck on rinse cycle. Have three yo son who plays with buttons, but I've been unable to get washer to finish (rinse went for three hrs prior to me realizing it was still running). Tried the front panel buttons w/o effect other than able to turn unit off, but it resumes in rinse cycle. Turned power off to machine from circuit breaker ( w/ machine off) then restarted and still in rinse cycle. How do I reset?


... Miele G892SC SS Dishwasher

Machine leaves a layer of suds after any programmed cycles. Tech tried changing the combi unit; tried adj rinse cycles. But still get suds when washing is finished. Need help.


... Miele CVA2660 Dishwasher

I have a Kenmore Model # 587.1430590. It's stuck in the drain part of the cycle and I can't get it out. I've checked to be sure that the float isn't obstructed or stuck and I've tested the float switch to ensure that it is working properly. What should I check next?


Stuck in the drain would not have any thing to do with the float . the the float and it's sw only controls the power to the fill valve . i would think that in the start of any cycle it will drain first then advance to ... Kenmore Dishwashers

Whirlpool mo 110753790 It gets stuck in the wash cycle & will not move unless you move the dial. This happens while the heat light is on & light will not go off which causes the dial to be stuck. Once you advance the dial, the light goes off.


Timer behind dial is defective if it will not advance on it's own. Either continue to advance past the defective section of replace it. ... Dishwashers

I have a cda cw 496 dishwasher, the water is draining and filling up to the machine, but the rotating arms are not getting the flow of water and not moving. I have checked the machine for blockages, checked the pipes etc and wonder whether it is an electronic programmer problem. PLease help


Sounds like the circulation pump. I had the same problem on my CW496. The original circulation pump was pretty cheap and nasty and although it was still working had lost a lot of power and was struggling to turn the rotating arms. The dishes were sti ... Dishwashers

Dishwasher problems I have a counter top dishwasher and it's not cleaning things like it used to i think its clogged but i cant get to the drain because it is in the bottom i tried draino but it didn't work i also tried unscewing the bottom but i cant get that part out i think there is somthing stuck in there.


First thing to check water hose that connect at back of machine. pull the screen out and clean it. use a pliers. I run my under water then use a q-tip if its clog to clean the rest.\015\012\015\012Then pour a cup of vingar in machine and ... Danby 22 in. DDW396 Free-standing Dishwasher

Dishwasher wont fill with water. just before it stopped filling i was turning the dial (a lot) between the wash cycles back and forth to attempt to get it to fill and drain (I didn't let it go through a cycle). We also removed the hose from the machine as it had split and replaced it and we had the machine tilted on it's side. the dial still clicks round but it sounds like the pump is going and it doesn't seem to be filling with water. Help


Hi. I suspect that the timer mechanism will be the culprit here, but i recommended to inspect and test the water inlet valve, before replacing the timer. The valve is a known problem area, as well. Follow the valve inspection procedure below, careful ... Fisher DS603W / DS603B / DS603I Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2052 seconds