Having problems with your Whirlpool Dishwashers ?

Whirlpool dishwasher stopped in mid cycle still had water in the bottom and will not operate. No lights will come on


Answers :

I know this may sound like the obvious but have you checked the electrical circuit breaker to see if it is tripped? If you have and the breaker is not tripped the next most likely problem is the timer. A new timer along with a good tutorial on replacement can be found at http://www.repairclinic.com . Just enter your model and any other information asked for at the home page search engine, find your parts and order. Replacement videos are available on the site.
\015\012
\015\012Thanks for using FixYa and for the great rating.
\015\012
\015\012hardrocko
Repair Help & Product Troubleshooting for Whirlpool Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Water inlet I have a miele dishwasher and water keeps collecting in the bottom tray which in turn makes the water inlet light come on and stops the dishwasher from working. i have drained the water out of the bottom tray which makes everything work again but how can i stop this from happening as it seems to happen on a weekly basis. thanks


It sounds like there is either a kink in your drain hose or your garbage disposal is blocked up where the dishwasher drain is connected ... Dishwashers

Whirlpool dishwasher stopped in mid cycle still had water in the bottom and will not operate. No lights will come on


I know this may sound like the obvious but have you checked the electrical circuit breaker to see if it is tripped? If you have and the breaker is not tripped the next most likely problem is the timer. A new timer along with a good tutorial on repla ... Whirlpool Dishwashers

My Frigidaire Dishwasher FDB1050RES2 gets stuck in a rinse cycle. The light on the front will be lit "clean" but the bottom of the washer is full of water. Opening the door does not turn off the "clean" light. For me to get it to run, I have to unplug it, plug it back in, push the start button until the ?washing? light comes on. I then push the start button once more and the dishwasher will begin to drain. I open the door as soon as I hear the water stop draining into the sink drain. This


By the descrition you are giving you will need to replace the main control board.Part number 154568401.you may also need to check the float switch.The part will run about 110.00 dollars from a local parts store ... Frigidaire 24 in. FDB1050RE Built-in Dishwasher

My whirlpool adp 553 dishwasher stopped mid-cycle with water in bottom, no power light. Power light goes on if door is opened. Can you please help me?


... Whirlpool 24 in. DU948PWPQ Built-in Dishwasher

Diplomat dishwasher ADP8112 - stopped mid cycle, full of water, no lights on. Thought on/off switch faulty so fitted a new on. Now when you switch it on, lights 4 and 5 flash, then there's a beep and then flashing lights stop and lights 3 and 5 come on and stay on. Any ideas as to how to fix, please?


... Dishwashers

Bosch dishwasher I have a month old Bosch dishwasher. It was stopped mid cycle. I drained the water at the bottom, but the active light keeps flashing, and when I press the start,reset button, then turn it off, it does the same thing when I turn it back on. active light keeps flashing and the wash light is on. It won't even lock the door. How do I fix this because there is no Bosch dealers here to help with the problem.


... Hotpoint 23 in. BF41 Built-in Dishwasher

I have a kitchenaid dishwasher model KUDS01FKSS0 which is not running. For the past 2-3 months it occasionally stopped mid cycle with water still at the bottom of dishwasher but eventually resumed working. Now it just doesn't run any more and there is water presently in the dishwasher tub). The user interface part (keypad) seems to be working. I can press the keys and the corresponding LED would light up. However after I close the door, nothing happens. There is also no noise what so ever. Any i


THE MOTOR SHOULD MAKE NOISE IF ON, CHECK THE MOTOR OR TIMER. ... KitchenAid KUDS01FKSS Dishwasher

I have a kitchenaid dishwasher model KUDS01FKSS0 which is not running. For the past 2-3 months it occasionally stopped mid cycle with water still at the bottom of dishwasher but eventually resumed working. Now it just doesn't run any more(and there is no water presently in the dishwasher tub). The user interface part (keypad) seems to be working. I can press the keys and the corresponding LED would light up. However after I close the door, nothing happens. There is also no noise what so ever. A


... KitchenAid KUDS01FKSS Dishwasher

My whirlpool dishwasher just stopped working the middle of the cycle with water still in the bottom and now nothing lights up or comes on and the water is just sitting in the bottom. Any suggestions?


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for using FixYa. If the cycle doesn't\015\012complete, then the first thing that should be checked is the Timer and then the\015 ... Whirlpool 24 in. GU3200XTP Built-in Dishwasher

Dishwasher is less than a year old. Once in a while it will stop about 10 minutes into the cycle, then the display lights will blink. Sometimes it will stop and the lights wont blink so we will come back later thinking it is done only to open it up and there is water sitting in the bottom. Doesnt happen all the time but sometimes and yesterday happened about 10 times finally gave up. I can cancel and restart the cycle but the same thing happens.


I would most likely guess a faulty latch....it will cancel the cycle, thinking that the door has opened, and the lights will flash. After a certain amount of time, it might "time out" and reset and the lights would stop flashing. Unfortunately it's ... Frigidaire 24 in. PLD2850 Built-in Dishwasher

My Electrolux ICON dishwasher stopped working in the middle of a wash cycle. there is water left in the bottom and none of the lights come on when I puch them.


... Electrolux 24 in. EDW5505EPS Stainless Steel Built-in Dishwasher

My Whirlpool Dishwasher ADP931 has stopped working. It stopped in the middle of the cycle with 2 to 3 inches of water on the floor of the compartment. I mopped out the water and tried to restart the dishwasher. The green "on" light now comes on when I press the start button. but nothing happens (no motor comes on,no water enters).Repeating the above action several times does not help the washer to restart even though the other function lights will come on when the knob is turned. saturn1914


Hi,Whenever you see such symptoms, Time for you to investigate it properly. Check the below guide :-\015\012\015\012\015\012\015\012\015\012Power from the house\015\012\015\012Is\015\012there power getting to the dishwa ... Dishwashers

|Can't seem to get any response or panel lights from my built in Kenmore Ultra Wash Quietguard 4. I stopped the machine mid cycle, started it again, I do believe it started but when I checked a bit later no indicator lights at all, and still has water in bottom of dishwasher???


Hi \015\012\015\012Thanks for using FixYa. The issue seems to be with water not draining. To\015\012start with check all\015\012the hoses for blockages, after you have checked the drain hose and can't locate\015\012t ... Kenmore Dishwashers

I have a Bosch SHU 3030 dishwasher that made a loud clicking noise and then stopped mid cycle. There was water at the bottom of the washer that I scooped out. I checked the filter and cleaned out any debris. There appears to be no power to the dishwasher. I spin the control dial and nothing happens; no lights, no sounds. The circuit was not flipped.


Pull the bottom kick panel and check the connections on the lower right, where the electric wires come in. Trip the breaker first, to be safe. ... KitchenAid 24 in. KUDI01TJ - Multiple Color Built-in Dishwasher

My 1yo slimline hotpoint dishwasher LST216 has developed a fault when trying to run the 'normal wash': washing stops after a couple of mins, the lights start flashing and the alarm comes on as soon as the water is being drawn into the machine. When I open the door I can hear a whirling/grating motor noise coming from the bottom of the machine. I have cleaned all filters and have run other programmes to check overall functionality and they all work as expected most of the time. I cannot unders


... Hotpoint Dishwashers

I have a Dishlex Global 300 dishwasher that stopped working mid-cycle. I had to sponge out all the water. Now none of the buttons do anything and none of the lights come on. When I turn it on at the power outlet it gives a single beep, but I cant get it to do anything else. I've opened it up and there is no water or dampness anywhere inside. Any ideas?


It is your control board inside your dishwasher. ... Dishwashers

Kenmore dishwasher model #665.16039401 no lights, no power, breaker is not tripped? Any suggestions? There is some water in the bottom of the dishwasher, like it stopped mid cycle?


... Kenmore 24 in. 16039 Built-in Dishwasher

My Bosch dishwasher SGS46E26GB/90 makes a knocking noise when started. the timer does not advance and the check water light comes on.There is water in the bottom (up to the bottom of the door) . If I reset the DW the water drains ok. If I mess with the buttons E3 shows on the display the 'quick' light stays on and the eco light flashes. I've checked the filter where the water hose is fastens to the rear. I've cleaned the filters at the bottom of the DW and cleaned out the pump area under them.


... Dishwashers

Have a Whirlpool Quite Partner II DU1145XTPBA 1 1/2 old just stop working no lights will come on at all. There is standing water in the bottom. We have replaced the thermal fuse and still nothing. What else can we do this dishwasher is not even 2 years old.


Re-verify the thermal fuse.If the new wire that came with the fuse was not used the fuse will blow again.Check the door switch for continuity.The power to all parts goes through the door switch first.Open the wire terminal box ... Dishwashers

My KUD101TJBL0 dishwasher stopped with water in the bottom and will not start. There are no lights blinking. We have checked and there is power coming to the unit. We have tried a reset and it didn't help.


... Dishwashers

No power dishwasher stop working in middle of cycle. water still in the bottom no power,lights nothing .there is power coming from panel


Check the thermal fuse located on electronic control 2 inch square fuse problalby no continuity through it, Replacemant comes with wires attached and instructions for installation ... KitchenAid KUDR01TJ Dishwasher

We have a Bosch dishwasher. The manual says for models SHV46C13, SHX43C0 so I guess it is one of those. It stopped working and when I opened it there was a bunch of cloudy soapy water on the bottom. The power was not coming on at that point. I have noticed that lately when I go to push the on button, the light will go on and when I shut it it doesn't start. After a couple times of turning it off and on it will run normally. This has only happened a couple times though....


... Bosch Dishwashers

Dishwasher stopped in mid cycle. door found open water in tub shut door and tried to re start. no lights come on. unit shows no signs of being on. circuit and switch checked OK connection in front behind kickboard checked OK


Check the main fuse box breaker ... Whirlpool Dishwashers

Candy CDI1012 Integrated dishwasher. When I turn on the dishwasher and start it - for some reason it can not go the whole way through the cycle. When I open the door the - programme light is flashing and water is still in the bottom of the dishwasher - ie mid cycle. The water will only drain if I put it into another program to drain away - but as the dishwasher was mid cycle - the dishes are not clean


Hello mm1973,It could be because of bad door latch switches / blown thermal fuse / blown or oversensitive control board. In all these scenarios, a dismantling of the machine is required. If you have no prior experience, I'd recommend get ... Dishwashers

White knight dishwasher dw1260WA will not power up. The light doesn't come on either. Machine was in the middle of a programme but stopped with water left in it. at that time the light was working but even the light doesn't come on now. I also removed all the excess water out of the machine...I've also checked the fuse and it is fine. Any suggestions?


... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2682 seconds