Having problems with your Whirlpool Dishwashers ?

Whirlpool Dishwater, model #DU945PWQ0: Replaced door switch, still won't start


Answers :

Repair Help & Product Troubleshooting for Whirlpool Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Whirlpool Dishwater, model #DU945PWQ0: Replaced door switch, still won't start


... Whirlpool Dishwashers

Whirlpool Dishwasher detergent door not operating properly. Main wash door opens immediately after starting dishwasher. No pre wash cycle. Loud humming noise coming from bi-metal switch or wax motor attached to the detergent cup assembly. I just replaced detergent cup assembly including the wax motor and I still get a loud vibrating humm from the actuator. model number du1055xtp3


Pdemaio,ngafm at your serviceI believe the loud humming you describe is an electronic problem. And is not worth changing parts randomly and spending unnecessary funds in this fashion!my advice is a hands on experi ... Whirlpool Dishwashers

I have a whirlpool dish washer model#du1100xtpq3 type 575-0 it has a green lite under sanitizer that flashes seven times and won't let it start i have been told by ask a repairman payed 28.00 told me it was a heat element 30.00 installed didn't change was told it was a door switch amother 32.00 installed still no change any ideals?


Seven flashes indicates an F7 fault code!\015\012\015\012 ... Whirlpool 24 in. DU1100XTP Built-in Dishwasher

I have a GE dishwasher model number GLD55OOLOOWW. It was starting a start cycle and i opened the door to put more dishes in and my finger must have hit a button on the door and now two lights flash off and on and it wont reset itself. It has been on for several hours and still blinking and beeping every so often and unplugging it does not help. Any suggestions how to solve this problem. Thank you.


Try pressing the cancel button ... Dishwashers

Bosch Dishwasher model : SHV4313GB/17 The machine won't switch off and the pump is still trying to drain water ( there is no water left in machine ) The cycle seems to have finished as it has made the beep sound as if it has finished. The dishwasher is still working even when you open the main door. Have tried to reset it but to no avail. Even after turning it off at the mains it still starts up again as if in mid cycle ! HELP PLEASE


I have a SHV. My sink drain backed up, and the water accumulating in the sink then migrated to the dishwasher, through the drain pipe, causing the dishwasher to fill up and, it turned out, overflow a little. When I turned on the dishwasher, the wat ... Dishwashers

My Whirlpool Duet, model WFW8400TWO2, powers up but then shuts off when I hit Start. There are no error codes displayed. I replaced the CCU and ohmed the door switches, the pressure switches, all okay. This failure happend about a year and a half ago but I wasn't around to see what was replaced under warranty. Any ideas?


... Dishwashers

I have a model pld4375rfc3 that want start. Wont do anything when you mash the buttons, the rinse Only light is on. tried the jumper from black to black and white to white for the door switch but/ Dishwasher now has a code dc flashing, also it does not have a heated dry


... Frigidaire Dishwashers

Whirlpool dishwasher model DU920PFGGO wont start. "controls locked" light blinks when door is closed.


Hi\015\012\015\012\015\012Thanks for using FixYa. To unlock it press and hold the AIR DRY button for\015\01210-15 seconds. Please accept the solution if the issue is resolved or post a\015\012comment for further a ... Whirlpool Dishwashers

My 3 yr old Whirlpool Dishwasher model #du1055xtss2 wont come on or respond at all is this a control board issue or door switch or something else, help.. what do I do?


... Whirlpool Dishwashers

Whirlpool dishwasher model DUB700XB has quit cycling. Fills with water but will not start wash cycle. Making intermittent humming noise unless the door is open to disengage the switch, even when on stop. No LEDs lighting when rotating the dial through the various cycles. Unit is old and wondering if it's better to buy a new one rather than fix this and have something else go wrong in the not to distant future. Thanks in advance


... Dishwashers

Maytag Model MDB7160AWW S/N 10337613WQ Symptons: Fills with water OK, shuts off water OK, does not start any cycle, or drain. After a power off/power on reset, problem remains. Flashes CLEAN & LIGHT WASH. My understanding is this is an error condition for low motor current, which makes sense as the motor never starts. I know both door switches are good (I checked them with a DVM) and both engage when the door is closed. Tripping the water float switch opens the valve and water fills the tub


... Dishwashers

Hi. Got a dishwasher from IKEA - Whirlpool DWH B00. It wont run anymore, 2 years old. It just wont start up, it starts to give a beep, and the solution is to press the <|> button for 2 sec, then restart it. But it still wont start. I've cleaned all filters, checked for water on board underneath, and given it some salt - no luck. Any ideas?


... Whirlpool Dishwashers

Door interlock appears faulty on my whirlpool awm 321 . It wont allow program start when door closes . Needs a lot of coaxing , banging with palm of hand , knee etc .Door itself appears fine , catch looks ok , finishes and runs ok once we finaly get it started .Hve tried pressing the interlock slider in with a pencil , but cannot succeed in pushing the contacts into place and starting the program . HELP PLEASE


Only solution is to replace the interlock - it is just held in by 2 screws ... Dishwashers

I have a fridgidaire dishwasher model # FDB 1450chc2 andon the control panel the red lights are flashing and washer wont start ?? when I open the door the lights go out but when I close the door and push start the washing lights start to blink but doesnt start to work ?? Need help thanks [email protected] Brian


... Frigidaire 24 in. PLD2850 Built-in Dishwasher

Model KUDS30FXSSO, Unit attempts to start. Blue light on the front of the door comes on indicating the cycle is starting. Pump runs a few seconds as normal. Then the maching sounds like it trying to start the next step three or four times. The blue light goes out. The washing cycle then switches to cancel/drain, ( I opened the door to see which control lights were on.) runs the drain pump then stops. The green light on the front panel does not come on indicating the cycle was completed.


... KitchenAid 24 in. KUDP01FL Built-in Dishwasher

Flashing lights My GE model # GHDA455L00CS Quiet Power a dishwasher's lights are flashing when I start it, will not reset or in-take water. I've tried unplugging it and restarting. Nothing. Tried removing door door screws and press down door latch. Still nothing. HELP!!!!!!! IT WILL NOT PROGRAM. IT HAS A FLASHING LIGHT. WE HAVE BOUGHT EVERYTHING BUT STILL DOES THE SAME THING


It mite be the circut board problem..just  re-soldered a few of the pins in it and things will be back in working order. ... GE Profile PDW8400J Built-in Dishwasher

Wont start The lights on my dishwasher are on but it wont start. COuld this be a door switch problem? In the past I have given it a gentle nudge and it's started ok but that knack seems to have gone.


... Hoover Dishwashers

Model #363.14232100 dishwasher. When you turn the switch to on, it will not come on. If you keep turning the knob slowly you can hear the dishwasher trying to start up,but it doesn't. Keep turning the knob and its the same thing, sounds like it will start, but it doesn't. It did fill with water, but once it was opened it didn't start up where it left off. The lock switch was in position, and still nothing. Now I have water in the bottom but can't get the thing to come on. Any suggestions? Help!


... Kenmore 24 in. 16539 Built-in Dishwasher

I have a 4 year old Maytag MDBH945AWW and the panel lights come on and I can select cycles... but the dishwasher wont start. I tried holding the start cancel button, tried turning the breaker off for a couple of hours, took the inner panel off the door and checked the latch, but its still wont start. Any other suggestions? If it needs a new control panel its probably better to just get a new similar dishwasher for $300, correct?


What you need to do is read for continuity and power across the door latch switch. (2 white wires) AND 2 Black wires Both wires must read continuty at the control panel connectors to the power source terminals for the unit to start. Since the co ... Maytag MDBH945AWW / MDBH945AWQ / MDBH945AWB Built-in Dishwasher

Myy kitchenaid dishwasher model kudi01flss doesn't start even though the lights on the panel light up so I opened up the door to look at the latch and found a broken plastic piece that appears to be part of the latch. Could this be why the machine doesn't start. The funny this is the door still seems to snap closed even with this broken piece but what I'm thinking is that this piece activates some sort of electrical connection that turns the machine on when the door is closed. Any thoughts on th


... KitchenAid KUDC25CH Dishwasher

Won't start-replaced door switch. Still won't start


... Maytag MDBH955AWS Stainless Steel 24 in. Built-in Dishwasher

My maytag dishwasher model PDB2600AWX wont start and wont latch properly unless you push hard on the door I cant tell if the latch over the tub is bad or the latch in the door is bad or both


The latch on the door is held by two screws loosen these adjust and then tighten, until you get it right, good luck. ... Dishwashers

I have a Whirlpool DUL300XTLQ3 Queit Partner III. The cleaning blades stopped moving-started it-waited awhile-opened it-the blades were in the same position. Took the bottom blade+filter cover off. Then I held down the metal piece on the case and switched on the micro switch on the door to see it running with the door open. The water shot straight up about 4-5" that's it. This does not seem to be enough pressure for the water to get all the way up to the top spinner. Am I looking at a new pump


If there is not enough water, the dishes would not get cleaned. Thiscould be caused by a partially closed water shut-off valve (locatedunder the sink), or a faulty dishwasher water valve (located at thebottom of the dishwasher, behind the kick panel, ... Whirlpool Dishwashers

I have a De Dietrich DVF102J dishwasher when I close the door the start button goes out so it won't start the cycle have replaced the door switch but its still the same any ideas what it could be?


... De Dietrich 24 in. DVF120J Built-in Dishwasher

There is electricity since all the light in the panel looks fine. But it would not start after you press start. I make sure the door is closed correctly. Is there a defect in this model for door switches? thank you very much in advance! My cell pone is 206-979-3149. Lori Jin


... Maytag Jetclean II MDBH945AWS Stainless Steel Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2002 seconds