Having problems with your Whirlpool Dishwashers ?

My ADP6000IX has error code 1. Manuel says inlet longer time and cuase may be fauctes is not opened. Can not find what a faucets is in the manual to fix it


Answers :

Where the water comes in to the machine is a solonoid type shutoff valve. This may be malfunctioning. You may need to remove the kick plate at bottom of machine. You will see where the water supply comes in and connetcs directly to it. When machine demands water, solenoid is energized to release flow. There is usually a basket filter inside the connection, just like on a washing machine hookup, it's possible the filter is clogged with minerals or other debris.
\012Shut off the water from the other end, should be a hand crank shut off, remove the supply hose from the solonoid and check to see if clogged. If not, the solonoid it's self may be bad and not opening fully or at all. In which case it will need replacing.
Hi.

The faucet refers to the water hose at the back of the dishwasher. Check if there is water getting to the dishwasher.
Ensure that there is pressure, and that the hose is not kinked or blocked.

If the problem does not depend on water source and inlet hose, then either inlet valve or water level switch may be faulty.

Here parts.
Repair Help & Product Troubleshooting for Whirlpool Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My ADP6000IX has error code 1. Manuel says inlet longer time and cuase may be fauctes is not opened. Can not find what a faucets is in the manual to fix it


Where the water comes in to the machine is a solonoid type shutoff valve. This may be malfunctioning. You may need to remove the kick plate at bottom of machine. You will see where the water supply comes in and connetcs directly to it. When machine ... Whirlpool Dishwashers

I have a Blanco Dishwasher Model BFDWC65X. It appears that the thermostat may be faulty as the water gets extremely hot on cycle 3 which is supposed to operate at 45 degrees centigrade. When I open the door mid-cycle, clouds of steam emerge and the whole dishwasher smells hot - almost a burning smell. I have found an online source for a replacement thermostat, but would like to know how difficult a job it will be to replace the thermostat. Also where can I find a manual that details where the th


... Dishwashers

Linea dishwasher stops cycle mid through and only continues when you manually turn the dial. How do we fix this? Have read it may have something to do with the thermostat, but was unable to find it.


... Dishwashers

The soap compartment remains closed so the tablet is not completely used - i need to open it manually after completion and clean it out May I fix the problem or do I replace the part?


... Bosch 24 in. SGS43C02 Classixx Built-in Dishwasher

I have the GE 206c1513p001 Potscrubber and recently found a black seal or rubber band in the dishwasher. Since then, it has been making a continuous clicking noise when it is run and does not clean the dishes thoroughly. I am trying to find a manual or something that may tell me where this seal belongs so that I can fix this issue. The bottom of the dishwasher is also not draining completely. Please help! Thanks!


I have the exact same problem!!! Found 2 loose rubber bands, the bottom doesn't drain completely, and the dishes are left either dirty with a white film on them. Please help! ... GE Dishwashers

Where can I find craftsman pressure washer 1500psi operator's manual I am not able to locate a manual for a Sears 1500 psi pressure washer. Do you know where I may be able to find one?


... RTO 1500 Psi High Pressure Washer,very High Quality

Kitchen Aid Dishwasher KUDS03ST We built our house and had this dishwasher sitting in the box for almost 2 yrs before finally using it. After finally installing it I find that occasionally the door to the soap does not open for washing as I find out when the dishes are supposed to be clean and I open the door to hear the soap then pop out of the dispenser. How do I fix this problem?


I have seen a lot of dishwashers that have this problem if they have a flip open lid for the soap .. often its caused by the top adjustable tray blocking the soap door from opening .. i put a camera inside to figure out what was happening ..in some ... KitchenAid Architect? II U SERIES KUDS03ST Stainless Steel Built-in Dishwasher

I believe there are counter weights on the main door that allow you to open the door a few inches. Mine will only open the the full [down] open position. What typically goes wrong and how do I fix it? Also there is a streak of sopa leading from the rinse aid fill location. Where do I look to find parts. One of the plastic spacers on the handle broke.


Most of my exprience has been that there is a pully/spring arrangement for the door tension. You'll have to pull your D/W out far enough to see and adjust.\015\012Regards, --W/D-- ... LG Dishwashers

I have a GE Potscrubber 1230 Dishwasher, and the soap cup will not open duing the cycle, so that the wash cycle will not complete, but runs indefinitely until I open it, open the soap cup manually, and then run the cycle again. Is this an easy fix?


There is a wax switch in the cup that has failed.Replacing the cup is your only fix.Reply with the model # and I can help you locate a replacement.Thanks!! ... Dishwashers

I have an electrolux wt30 m/n LS6 dishwasher, trying to find a wiring schematic so I can try and rewire it to operate on 220v 1 phase, presently it's wired for 220V/3 trying to find a site that may offer a parts and repair manual w/ schematic would appreciate some help in resolving this problem


... Electrolux Dishwashers

Hi my Candy dishwasher model CDI 1012/2 is filling with water then after a few minutes if bleeps and the error code meaning according to the manual is "Longer inlet time. possible cause Faucets is not open" The tap is fully open and the dishwasher is now full of dirty water. Could you please suggest an alternative cause?


... Candy Dishwashers

Indesit d41 dishwasher overfilling, pressure switch seems ok(checked with multimeter) ,when pressure switch is manually operated the electro fill valve remains open. only time fill vave shuts is when power is off or door is open. can someone please help as i cant find wiring diagram or service guide online


Possible faulty pressure switch or a faulty drain pump ... Indesit 18 in. D41 Slim-Line Free-standing Dishwasher

I have Frigidaire FDB956RBC1 diswasher. I have to turn off the water to fix the faucet. When I turned the water back on, water did not go to the diswasher when I used it. The diswasher runs normal except with no water going into it. The water runs find at the facet. There is separate water supply underneath the sink for the faucet and the diswasher. I wonder if there is a mechanism with the dishwasher that stop the water from going into the dishwasher after the water supply been turn off. I did


FRIDG... EXPERT HERE \012\012\012Welcome to fixya\012\012Hello\012\012 \012\012 ... Frigidaire FDB956RB Built-in Dishwasher

I have a GE Profile Triton XL Dishwasher PDW 7880P00SS for the past 1.5 years. The manual detergent dispenser always has 50-75% of the detergent left over like the door didn't open sufficiently regardless of what soap I use (liquid, powder, etc.). Currently using Finish powerball tabs. I've seen some posts about a possible poor design of the racks blocking the door from opening, but wondering if there are any solutions out there (dispenser mechanical fix, just dropping a tablet in botto


... GE 24 in. Profile PDW9880JSS Built-in Dishwasher

Error Code E1 means longer inlet time. possible causes faucet is not opened, or water intake is restricted, or water pressure is too low, according to the BRADA portable dishwasher model EP9242AWW What does that mean and how do I fix it? I have shut the water faucet off and the error message still shows.


... Dishwashers

It went thru the whole cycle and when I opened it up - there was water still left in the bottom - hit the cancel/drain button and nothing happened. Unhooked the drain line to the drain pipe under the sink and no water came out. How do I find out if it is the pump ? If I take it out - what do I need to look for and what trouble shoot things do I need to know. I live about one hour from the nearest town - so I would like to find out the problem - before I call a repairman and maybe fix it myse


... Kenmore 24 in. 17462 / 17464 / 17469 Built-in Dishwasher

Detergent dispenser My dishwasher is a Maytag jetclean series 01, model # VU304, serial # 218223 . The dish degertent dispenser won't flip open. I am not sure when it is supposed to do so during the wash, so I go ahead and flip it open manually during the final wash (when I remember to do so). Hope this is an easy [email protected] Thanks loads


... Maytag MDB9600A Jetclean II Built-in Dishwasher

I just bought a used Kenmore portable dishwasher with Model #587 1749581. I'd like to find an owner's manual and parts list for this...in particular the hose adapters to fit onto a kitchen faucet. Can't seem to find such. Do you know how old this dishwasher is and if parts are available?


You should be able to go to the Kenmore web sit and down load a manual. If there is a manual you can get it on line. Try google put the model number right in the search. ... Dishwashers

I have just moved into a home with the DS-603i and used it for the first time. I put it on the first load and seemed to go for way to long. so i opened it up and t washed the first load ok, but continued to make noises. It would make these noises even when draw opened. Turn on & off at power and it doesn't change the noises. The light on inside indicates rince, which i think is a F1 error code according to the manual online. Any tips on how to fix this?


The F1 error code indicated a leak problem. The noise that you hear is from the pump motor. There is a leak due to the top lid not sealed properly, so the water is shooting out during the wash cycle. It did not seal tightly because there are 2 actuat ... Fisher and Paykel 24 in. DS-603 Built-in Dishwasher

Westoint Dishwasher I have looked in the manual under troubleshooting tips, but didn't find anything on the problem. The dishwasher goes into cycle,but during the wash cycle it stops,makes alarm and the wash and rinse ligts come on. And now I can't even find the product on this site.Westpoint Dishwasher WQP12-9240. Thankyou My dishwasher is stopping at stage 2 of the programme after beeping once. Quite often the detergent flap doesn't open. Am at my wits end and threatening to leave home!!!! Th


Hi again,\015\012\015\012That should be OK. Just get in touch with your sales rep or his boss. Somebody there will be able to look up the record of the purchase. If they ask for model & serial numbers, you have them. You will find ... Dishwashers

I have a kitchen aid dishwasher model number KUD101TJBLO. I have had the thermal fuse replaced numerous times. It may run two weeks ir it may rub two cycles then the fuse blows. My serviceman has given up on finding a solution.He has replaced the control board and the door switch. However it continues blowing the fuse. I read on the internet that you need to replace the entire wiring kit that comes with the fuse but my repairman says this will not fix the problem and refused to replace the kit.


Hi\015\012\015\012\015\012Thanks for using FixYa. Please check for the short on the wires near the heating element. Also check the resistance of the heating element, it should not be more than 1.6 K ohms. Also ma ... KitchenAid Dishwashers

Customer bought house with a Viking Dishwasher already there. He has no user manuals or documentation with the model number listed. None of the stickers on the side of the door have a Viking model number. This unit is a Quiet Clean System with Auto Water Heating and is (he thinks) about two years old. How can I find out what the model # might be or better yet how do I find out the part # to fix the main control board / interface. It just keeps blinking.


Check the back of the unit for a tag.... otherwise - removing the clock... it should have a part number on it.\015\012\015\012Thanks! ... Dishwashers

I have a Maytag quiet series 400 dishwasher. I set the required buttons for a wash, inserted the soap in the soap tray but the machine will not start. Previously, when the washer would not start, I opened the door and pushed down on the soap tray and its seemed to fix the problem. Next time I used the machine, again not starting, but by pushing on the soap tray it would not start. Can you suggess what the trouble may be or give me a check list that I may do before starting the washer. This machi


... Maytag Dishwashers

I have a Philco dishwasher Svelta DWN17 which works well but has lost its spring or counterweight for the door. The door now drops open when not locked for washing. I am having difficulty finding a servicing firm for this machine and would try to fix it myself if I could find a part and get some details on how to go about it. Can you help, please? Alan Wright


... Dishwashers

Drying problem Hi Our 3-day old LG dishwasher is not able to dry our dishes. After the cycle is finished 2 hours later, I open the door to find that water is everywhere. As if the washer is skipping the dry sequence completely. The "vent" on the inside of the door doesn't seem to have an outlet--why is this a vent if nothing can escape? The owner's manual says to use a rinse aid to help drying. I don't believe in using band-aid's; something else is wrong. Any help/advice is appreciated. Thanks,


Hi,\015\012\015\012As I had the same problem, I worked on my machine and found out the heater unit was not working (it is a brand new machine ! - remark : as I moved overseas, LG did not cover it with their warranty).\015\012\015\012But b ... LG LDF6810ST Stainless Steel Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1330 seconds