Having problems with your Whirlpool Dishwashers ?

Whirlpool ADG 993 The door will not remain closed


Answers :

Repair Help & Product Troubleshooting for Whirlpool Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Whirlpool ADG 993 The door will not remain closed


... Whirlpool Dishwashers

My whirlpool dishwasher type 280-2 detergent door will not open during wash cycle. Yes the compartment, springs and door are thoroughly clean. Will not open if I just close the door and remains empty. I'm wondering if perhaps I knocked off some random part that makes it open. So please tell me how darn thing opens and perhaps a pic of the parts so I could see if ones missing. Thank you for any help offered for this, its driving me nuts.


... Dishwashers

Hi, I have a Whirlpool ADG 7540, started to run normal cycle, water began to filter through, and then beeping continuously. When door opened, light is on left hand side of controls, on the spray water button. Close door and beeping continues, Please help.


... Dishwashers

Hi i have a whirlpool adg 7554 it wont fill up and beeps everytime u go to start it when closing the door what would be the problem thanku


... Whirlpool 24 in. ADG7952 Built-in Dishwasher

I can't start any new cycles on my whirlpool adg 7960 dishwasher. Everytime I close the door the beeping starts and the cycle returns to 40 with start button flashing.


\015\012Hi,\015\012\015\012The reason for the washer not going into cycles is bad or the heating element itself is bad .I would suggest you start by checking to see if the element gets hot during operation. If no, ohm test the eleme ... Dishwashers

AEG Favorit 80820 dishwasher tablet door opens as soon as switched on and door closed. When you put the power on and select a wash and then close the door the small grey dishwasher tablet inside the door can be heard to open as soon as the door is closed. Normally this door remains closed until asked to opened automatically by the dishwasher at the correct point in the selected wash program.


... AEG 24 in. Favorit 80820 Free-standing Dishwasher

My soap cap remains in the closed position at all times. The clasp mechanism works fine, if I cycle through with the door open I can see and hear the catch release when it should. But the door remains closed at all times. I leave it open to run, and sometimes it's closed when the wash cycle finishes! Is there an easy way to take the cap off and clean it? Or do I need to WD-40 around it?


There is a little spring in there that flips the door open, just take the screws off of the side of the door, you'll see the broken spring by the door, make sure power is off to dishwasher ... GE Nautilus 24" Built-in Dishwasher

Whirlpool ADG993, door fault: Hi, a few weeks ago soemthing broke on the door to my diswasher and it falls open wide with no stopping half way as usual. That was fine as the machine could still work, but now the door won't close. All seems fine until you get all but closed and then the door raises slightly from the bottom right corner, preventing it from closing. It looks like something may be jammed in there which pushes the door up at the last minute. There's a man coming out on Friday,


... Whirlpool Dishwashers

Soap door on my Whirlpool dishwasher model # DU810SWKU0 does not open.I had inner door off to check rinse agent problem.Is there something i did putting inner door back on? If I close soap door and turn timer knob on outside of door the soap door will open after I make two full turns of the knob.If this cant be fixed can I just put soap in the bottom tray that has no door or put soap in both trays and do not close the soap door? Thank You RH.


... Whirlpool 24 in. DU1100XTP Built-in Dishwasher

Door won't stay up or stay closed. The door used to be pulled in so it would stay closed and remain latched. Now it slams downward when you open it and won't remain latched when you want it to run. Some kind of counterweight seems to have disconnected.


I did replace the door latch. I could replace the hinges, which is something I was considering, but the door will still not lock. Can the hinges affect that? It will close. ... Dishwashers

Door catch Door closes but latch inside door panel does not lock in place so door will not remain closed. Appears that plastic part in door catch recess will rotate but is not under any spring pressure and will not lock in place.


Hi.Usually the spring is not sold as a single part.You will need to replace the door lock.Regards. ... Dishwashers

Whirlpool ADG993 Hi -Had several issues with the door similar to those posted, coming away at the hinge, not sitting flush so wont close. New issue - the latch has given way, it sounds like it works but the catch is not holding, the door then falls to the floor. Any suggestions for making the latch hold the door closed? - thanks..


Dear friend,\015\012\015\012\015\012\015\012\015\012\015\012\015\012\015\012\015\012ngfam at you service!\015\012\015\012If its new your warranty is for 12 months!If the dishwasher is 10 years or older its not worth inve ... Dishwashers

Kitchen circut was accidently turned off. Now whirlpool gold disher will not work(unit was not running and the door was not closed all the way when circuit was turned off, All circuit breakers are on) There are no lights on display when door is closed completely, and it appears to have no power. Worked fine prior, what could it be? The unit has not been removed from under the counter yet. Is there a fuse or circuit breaker on the unit? If so where is it located? Other troubleshooting ideas


Hello- Turn power off. Remove kick panel and cover for power wires. Check connections. If these are ok, most likely suspect is a fuse at the control. This is a little harder to get to. Remove inside door panel screws. Unplug wires and remove panel. F ... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

Our Kitchenaid dishwasher model # KUDP021R will not start. We close door, select wash and press start. The control lock light at the top which is lit flashes a few times and then stays lit. Dishwasher remains silent. An aside which may be helpful is that the door has always seemed to be not quite straight...as though it had to warp a tiny bit to close and lock.


The problem you have already identified could be the door switch is not closing when you shut the door. Please confirm your dishwasher is KUDP02I (i and not 1).\015\012\015\012One way to check is find out the door switch on the door panel ... KitchenAid Dishwashers

Whirlpool dishwasher gu2700 soap door doesn't open. At the end of the Cycle, the door is still closed and the detergent has not dissolved. Any help is appreciated.


... Whirlpool GU2700XTSB / GU2700XTSQ / GU2700XTST Built-in Dishwasher

My dishwasher door doesn't close properly. It has a panel on the outside and this seems to weigh down the door so it drops. I want to know if the door can be replaced. The model number is ACG9544 (at least I think so, some of the numbers are difficult to see! It could be ADG954 A, or ADG) Can you help?


Take the lower pannel off the bottom and look to see if you have a broken spring.you can order a new one on the sears website. ... Whirlpool Dishwashers

Hi Just bought and installed a Bush wkp12-9348 integrated dishwasher. There seems to be a problem with the door. When I open the door the spring seems very tight and tries to close. I am unable to unload the dishwasher as the door will not remain down. Can anyone help or advise what I can do? Thanks


... Dishwashers

Whirlpool quiet partner 2 Water leaks from the bottom of the door, alot of water, we can watch it pour out. The door is closed all the way. I dont see a gasket along the bottom of the door where it would hit the frame of the washer,


\012Hello, Thank You for using FixYa. I will be helping you today.There is no seal for the bottom it is an air gap. If there is a damaged lower spray arm or crack in it water will come over that edge. Check the spray arm for damage. Open the do ... Whirlpool GU2400XTP Built-in Dishwasher

Squeaky door My whirlpool gold quiet partner 3 squeaks whenever the door is opened or closed slowly. If I move it quickly, there's no noise. I sprayed some WD-40 on the door hinges, but no difference. Appreciate any suggestions...


Wd will not work order and replace the door link assembly installe all parts in the bag, youll be fine easy repair part number 8194001 ... Whirlpool GU2400XTP Built-in Dishwasher

Soap dipenser My whirlpool built-in dishwasher model DU930PWPB0 serial # FR4104078. The door to the soap dispenser will not open. I have been washing the dishes with the door open all the time. When I close it(door) it won't pop open when it should. to dispense the soap in the wash cycle.


Try this... Wipe out the soap dish with white vinegar and a soft cloth.. make sure you get everything off the edges of the door and look for any nicks, blemishes or deformation of the dispenser door to make sure it is not mechanically binding up when ... Whirlpool 24 in. DU930PWP Built-in Dishwasher

I purchased a whirlpool dishwasher GU2475xtvy2 with interior controls on top of the door. Might seem like a silly question, however, do I have to install with the door & controls controls out from under the countertop? or do I install with controls hidden, and make selections before closing door? Doesn't address this in the installation manual. Thanks


Hi,It is up to you as to where you fasten the dishwasher at...if you push it back too far then you will have to do the setting before you close it which is no problem... but if you want it out a bit then you can do that and you will have a hip ... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

Door interlock appears faulty on my whirlpool awm 321 . It wont allow program start when door closes . Needs a lot of coaxing , banging with palm of hand , knee etc .Door itself appears fine , catch looks ok , finishes and runs ok once we finaly get it started .Hve tried pressing the interlock slider in with a pencil , but cannot succeed in pushing the contacts into place and starting the program . HELP PLEASE


Only solution is to replace the interlock - it is just held in by 2 screws ... Dishwashers

Door catch does not engage when door is closed. The programme still works even though the catch does not engage. I have changed the door catch and the micro switch but the catch remains in the same position


... Dishwashers

Ariston LI 45 door will not remain closed and will


Strip the door and re-set the switch. Ensure the metal part of the catch on the machines main body is not distorted ... Ariston Technologies Dishwashers

I over filled my Whirlpool dishwasher with jet dry and it leaks every time the door is closed whether it 's running or not , What can I do to stop this


... Whirlpool Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0680 seconds