Having problems with your Whirlpool Dishwashers ?

I have a Whirlpool Dishwasher DWH B10 from IKEA. It is integrated in a kitchen unit. It has developed a fault. Have done some online investigation and indicates OWI problem. Can't find reference anywh


Answers :

Repair Help & Product Troubleshooting for Whirlpool Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a Whirlpool Dishwasher DWH B10 from IKEA. It is integrated in a kitchen unit. It has developed a fault. Have done some online investigation and indicates OWI problem. Can't find reference anywh


... Whirlpool Dishwashers

I have a SMEG dishwasher. Can't find the model number on dishwasher or manual. Had two flashing lights and referred to manual - indicates a blocked filter. Cleaned that out, but now when I try to put it on "light" cycle (indicated by wineglass symbol), that light flashes (but no others as would indicate a problem).. All the other cycles work fine. Any ideas? Thank you!


Hi.If only the crystal light is flashing and no other light is on, then that is not an error code. Problem can be a temporary malfunction, or a defective control module or keypad.The delicate (crystal) light flashing with last ... Smeg 24 in. STX2 Built-in Dishwasher

DISHWASHER QUIT WORKING IN ALL WASH CYCLES EXCEPT SHORT WASH CYCLE. YES I HAVE TRIED TO FIX IT. I HAVE REPLACED THE CONTROL MODULE WITH A NEW ONE. ALL WIRING LOOKS CLEAN AND IN GOOD ORDER. NO EVIDENCE OF CORROSION. NOW UNIT WILL NOT WORK AT ALL, BUT "CLEAN LITE INDICATOR' IS FLASHING IN SEQUENCES OF 7. I HAVE FOUND THE SCHEMATIC SHEET BEHIND THE KICK PLATE. AND USING IT I HAVE TRYED TO USE THE DIAGNOSTIC PROGRAM BUT CANNOT FIND ANY PROBLEMS. AFTER DIAGNOSTIC PROGRAM IS COMPLETE THE DI


Hello,\015\012\015\012Welcome to FixYa.\015\012\015\012With the symptom you`ve described ( specifically the clean lite ) this is an error of poor water circulation or a heating fault...many times manifesting in th ... Whirlpool Dishwashers

Normal cycle light blinking, won't turn on MDB7609AWW1. Was told it was micro computer. Replaced it....same problem..Put old micro computer back in.. wife secured all wires and banged the machine and it started working tfor a few Days.. stopped with same old symptoms..I'm sure guru is correct and it is the touchpad, but his facing appears to be glued on,I don't wan't to ruin the front of the console , and I've not been able to find a touchpad part on the schematic or online. Help???


... Maytag MDB7609AW Builtin Dishwasher

We bought model KUDS02FR in Nov. 2005. The last few months we have had a residue on many of our dishes, esp. plates and bowls, when we unload the dishwasher. We've been double-checking the detergent dispenser, Jet Dry, and the way we load the machine. We have rewashed dishes, but it doesn't seem to have solved the problem. I cannot find a trouble-shooting guide in the Consumer Reference Guide, only information on loading and guides to the various racks. We have hard water and use both dispensers


Hi,Check your heating element.. Dishwasher ... KitchenAid Dishwashers

I have a whirlpool dishwasher model adp 5550 condenser. The dishes do not get clean. I have had a repair man out twice and he replaced the soap dispenser on Friday but it still doesn't work. I went to the store today and bought every cleaning things I could find for dishwashers and also started to investigate online myself. I took the arms off and cleaned them, I took the filter out and cleaned it, and then I noticed that the plastic bar that runs from the top, along the back and into the bottom


... Dishwashers

Dishwasher works for 15 seconds then it stops, and indicator says cycle is finished. when i try it again it only fills with water and nothing happens. i'm wondering if it's motor problem or if there's something wrong with the pump. if it's motor, do you know any place online that i can order it? thank you.


The pump and motor comes as one unit. Motor does not come seperate. Pump parts can be sold seperately ... Moyer Diebel 401HT Dishwasher

The soap in my "smart dispenser" appears to have turned partially into a gelatin surrounded by liquid. Our dishes do not seem clean lately, and I just realized that the red light (to indicate that the soap level is low) has not come on in some time. What is wrong? The above problem refers to my GE Profile Dishwasher with the model # of PDW9980N20SS I have only ever used the same soap which is Cascade Complete liquid dishwasher detergent, as recommended in the owner's manual. The only ot


I have the same problem. It isn't because of a long vacation, so if its still under warranty, call them out before they try to charge you an arm and a leg!\015\012\015\012 I called GE, they told me that it was Cascade's fault because they ... GE Dishwashers

Hi there. I have a Matsui MF145 slimline dishwasher and having a problem. When I press the on/off button I would usually then press the program indicator button (usually the first indicator - pans) and close the door and the dishwasher would start. Currently i press the on/off button and try to press the program indicator button and the on/off button flashes and there is a continuos beeping sound....and nothing more happens. Do you know what the problem is?


Try to clean the unit, ofetn when the machine is dirty, some sensors are fooled thinking there's some problem. be sure there's no jam on mechanical parts. ... Dishwashers

F 13 problem indicated on miele g2420 optima dishwasher


Its on the end of the water intake line - ussually under the sink - connected to the hot water line. ... Miele 24 in. Incognito G843SCVi Built-In Dishwasher

Electrolux ESL 43010 dishwasher - intermittent beep during operation - but cannot find problem


... Dishwashers

Optical water indicator (Turbidity Sensor) failure - FA error code


... Dishwashers

Problem is washer stops with indication of water problem


Yes there is a sensor.Servicing the Water Level Control SwitchThis\015\012is another control panel switch, usually located next to the\015\012temperature switch. There is a small hose connected to this switch, and ... Asko 24 in. D3250 Built-in Dishwasher

I have a KUDP02FRSS. Two problems: after completing the entire cycle, I open the door to find each time water staying unremoved at the bottom. My other problem is, I need to really push ******* the door to get the machine start working. What are your solutions for these two problems?


... Dishwashers

Like sand Not getting the dishes clean it seems like sand and other stuf in the glasses :( cant find any extra filters , have clean the regular ones in the bottom of the machine. Please can someone help me find a solution or find a manual online.


Clean out both top and bottom spray arms\015\012Deep Diver ... Bosch 24 in. SHU5305UC Built-in Dishwasher

FDW60 Fault Hi, I have exactly the same problem. My dishwasher starts and washes ok but appears to get very hot during the drying phase and then the two lights fast and eco flash warning of a heater problem. I suspect either the heater, thermostat or control PCB. As the rest of the cycle seems of and the water gets hot then I'm assuming the heater and thermostat are OK. When the dishwasher attempts to dry is when the problem starts. Did anyone find out what there fault was? Thanks


Hold down the start key and you will re- set the D/W. Please Rate This !!! Thank YOU !!! ... Hotpoint 24 in. FDW60 Free-standing Dishwasher

Hi, I have a Miele G681 dish washer with an intake/drain light problem. I've read all posts about similar problems I could find both on this forum and others but I'm afraid I still can't figure my problem out. The intake/drain light starts blinking mid way into the dishwashing process. The dish washer fills up, rinses, drains, water is hot, everything seems to function just fine. Some time after the tablet drops from its door mounted container, and the time estimate reaches 46 minutes r


... Dishwashers

After interrupting a wash cycle by opening the door, the "start" button indicator will not light when the start button is depressed. (Neither will the "delayed start" indicator work.) The dishwasher will not resume any operation. All other control indicators light when selected. Removing and restoring power to the unit does not clear the problem. The unit is a Jenn-Air model JDB1100AWB.


It is possible that by opening the door mid cycle, the door switch mechanism has got disengaged. Refer item 11 in ... Jenn-Air 24 in. JDB1100AWS Built-in Dishwasher

Can't get pressure from homelite hp3127s gas pressure washer after using only 1 season. can't find manual to find problem. is there a switch i'm missing?


No,it's probably a bad valve body or the pump itself broke. Homelite isn't the best quality machine. ... Pressure Washers

SEARS/WHIRLPOOL DISHWASHER Model 665.16014401. The CLEAN light keeps blinking and washer will not run. Op. instructions say to check the heater circuit. Heater element tests at 12.9 Ohms and thermo unit at 55 K ohm and the unit I beleave looks like overtemp cut out is less than 1 ohm. these look like good #s to me so I suspect the controller p/n 8564544. When I look up the number online I find it has been replaced with 8564546, but the only picture I can find of it looks like the connections are


... Kenmore Dishwashers

I have a Zanussi dishwasher model IT 5614. When I turn the dishwasher on, the indicator light is already stuck at "BIO 50" and won't move, and the dishwasher won't start when the door is closed. This just happened today. The indicator light for dishwasher salt was also on, so I added dishwasher salt and that light went off, but the machine is still stuck. The instruction book says that when this happens, technical assistance is needed. What exactly is the problem, and is it anything I can


It has been suggested to switch the machine on/off a couple of times and the flashing light will not reappear. Until this light goes off the dishwasher will not start. All the filters should be cleaned free of any leftover food particles. What i mean ... Dishwashers

Is it common for Kitchenaid dishwashers to have water pooling inside them? It's almost like the valve for water coming in isn't shutting all the way...in the middle of the day, we'll find water inside the dishwasher...it drips out the front when you open the door...but when you turn it on, it doesn't have any problem draining the system...mysteriously, we find water in the bottom...what's up?


There is a rubber flapper valve that keeps water from running back into your dishwasher. It's a $5.00 part, but it's a bear to get to,\015\012\015\012You have to pull the drain pump to access this flapper.\015\012\015\012Also ... KitchenAid 24 in. KUDP02FRSS Stainless Steel Built-in Dishwasher

Bosch SHU43C My Bosch SHU43C is stuck with the drain pump running. I ran the self-test and it gave me the fault code 4 wich indicates a filling fault. The washer is empty and all wash cycles display the correct number of minutes for the cycle. It counts down to 0, but the pump continues to run. Does this indicate a stuck float, or is the problem with the control board? Where is the float located? Are diagrams/pictures available on-line anywhere? I've done some searching, but haven't found any. R


My SHU43C is just over 3 years old. I had a similar problem recently. First, there were a few floods. Then, the Bosch only drained non-stop. Even when I used the Cancel Drain buttons the drain pump would run without stopping. When I ... Bosch 24 in. SHU43 Built-in Dishwasher

Leaking This is a problem that I have when the dishwasher is in drying mode. I will find a 5X5 and sometimes smaller, size water spot under the dishwasher after the dishwasher has stopped. I was told it was the vent were the steam comes out and I had that replaced. It still leaks, then they told me to replace the rubber around the door, still leaks now they order a whole new plastic interior door. Please if you have any ideas what could be causing the problem, please let me know. Thank you


\015\012open the bottom panel 2-4 screw\015\012take a flashlight and turn the machine on\015\012see where it come from\015\012if you need take the unit out a bit f ... Jenn-Air JDB4000AWS Stainless Steel Dishwasher

I have a Kenmore Quietguard dishwasher, only a few years old, and it won't drain. I pulled it out and checked the drain hose, could not find a clog. I took the basket and sprayer out, couldn't find any clogs there. It seems to be making a little bit of a different noise but does still clean the dishes. Does the motor pump the water out and could that be the problem?


I have a Kenmore Quietguard portable that won't stay connected to my kitchen sink faucet. Checked all I can and continues to spray the wall and me without staying attached securely to the faucet adapter. Help!! Any ideas? ... Kenmore 24 in. 15162 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1042 seconds