Having problems with your Whirlpool Dishwashers ?

Replacing timer on whirlpool dul100pkq0 dishwasher

\015 Removed old timer, but a plastic part called a "follower" fell out, don't know how to install this part\015

Answers :

Repair Help & Product Troubleshooting for Whirlpool Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Replacing timer on whirlpool dul100pkq0 dishwasher


... Whirlpool Dishwashers

How do you replace a timer in a whirlpool Quite partner Gold dishwasher Model # GU3200XTP00 Seriel Numner F50505022


... Dishwashers

Whirlpool MBD121RF dishwasher. Fills and drains but does not wash (spray water - as far as I can tell). Nothing seems blocked. Both pump and timer are expensive to replace and the unit is 15 years old.


... Kelvinator MDB121RF Dishwasher

GSD500X-73WB Dishwasher: Automatic timer has stopped working. It is still possible, though, to work the dishwasher manually by turning the dial. How much will it cost to replace the timer? I guess that it is the whole control unit including the timer that would need replacing.


... GE 24 in. GSD500X Built-in Dishwasher

I have a problem that appears to be a bad motor on a Whirlpool dishwasher. The motor costs $300 and the dishwasher is about 6 years old...Does it make sense to replace the motor or just replace the whirlpool diswasher (18 in unit = $600 new)...your thoughts?


Hello, W/D here.I try to work replacement vs. repair like this:If the cost of repair is greater than 50% of replacement, I always go for the replacement. My reasoning is that the remainder of the appliance is more likely to develop fault ... Dishwashers

I am working on a d8 dishwasher and found the cycle timer (49 sec/ 11 sec) faulty. Ordered a replacement timer from russell food equipment. The new timer is different mounting and timer motor specs. Can you tell me if this timer is the proper replacement. New part number cpn14480


... Dishwashers

Whirlpool dishwasher - how do i remove timer ??


When I looked up a Whirlpool 2000 dishwasher, it shows an electronic timer. For a mechanical timer, see last paragraph.\015\012First, turn off the breaker for the dishwasher. Then you'll need to remove the Phillips screws around the inside of t ... Dishwashers

Whirlpool dishwasher will not drain. All hoses are clear. I replaced the air gap too. The dishwasher will drain into a bucket when I detatch the hose from the air gap, but not into the drain/disposal when I replace it.


Http://www.partselect.com/repair.aspx?appliance=dishwasher&part=water-wont-drain\015\012\015\012\015\012\015\ ... Whirlpool GU2400XTP Built-in Dishwasher

My GE dishwasher timer gets stuck and doesn't move. I replaced the solenoid already as the water wouldn't drain. Would replacing the timer fix the problem for good?


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. Timers usually won’t go bad however,\015\012if every other part of the dishwasher seems to b ... Dishwashers

Our Whirlpool dishwasher, DU1145XTPBA, has almost quit cleaning the dishes. It started with dishes on the top rack. My husband was told by rep to replace the top unit. That did not help at all. Now the bottom dishes are almost as dirty and gritty as the top rack. This dishwasher is too new to have to be replaced and we've already spent $50 on the top rack. Is there anything else to check at this point?


Hi, \012I have an older dishwasher also and recently mywife also complained about it not cleaning right... so me being the man I amtried in vain to clean the things... Bought new spray arms online and installedthem in minutes...now the thing works li ... Whirlpool 24 in. DU1100XTP Built-in Dishwasher

My dishwasher, a Whirlpool DWF B10, is not cleaning properly. When the cycle has finished, there is always a block of undissolved dishwasher tablet/powder left behind. My guess is that the seal to the powder door has gone and allowing the tablet to get wet too early and part dissolve before the door opens - is this likely to be right? If so, can I get a replacement seal or do I have to replace the whole powder & rinse aid containers ??


... Whirlpool Dishwashers

I have a not quite 2 year old Kenmore dishwasher model #665.1322.(I believe built by Whirlpool) The motor has burnt out. That seems ridiculous to me when there is just my husband & I using it and I've had dishwashers in the past that have lasted 10 - 15 years. Anyways - we have no warranty so we thought we would try to replace th motor - but I can't find anything online. We live in south western Ontario - any suggestions of where we could find a replacement motor?


I have recently had the same problem with the same model. Do you think there's a connection? I'm going to report this to Consumer Reports. ... Kenmore Dishwashers

Have Bosch dishwasher model SHU3035UC/U12 Timer sticks in wash or rinse mode. Can timer be replaced and if so what is the cost? Do you have a diagram available to assist me with the replacement?


... Dishwashers

Replacing drainage hose on Whirlpool dishwasher?


Just follow the hose to the other end, it goes under the dishwasher and it usually just clamped to the drain pump. Should be able to buy a replacement hose at repair clinic dot com. Installation is the reverse of removal, just pay attention to how th ... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

Beko d3422 Dishwasher not working, timer does not turn, works if manuall turned. Replaced timer but still same issue.


... Beko Dishwashers

I have a whirlpool dishwasher DU915WKSO: when I turn the dishwasher on, the heating element comes on but no water comes into the unit. I recently replaced the garbage disposal and th dishwasher worked fine for a time or two. Since then I have only been able to get water in it once. Like I said, the heating element works but no water in the dishwasher. Thanks for any help.


... Whirlpool DU1055XTS Built-in Dishwasher

My SHE4402UC/36 dishwasher malfunctioned all the lights were flashing and the machine was trying to drain. The guy came out and replace the control board. The dishwasher now read 199 on all cycles except the rinse and hold, the santitized light does not come when its done. The repair guy told me the count down timers were flakey on the the Bosch dishwashers and it would learn my dishwashing patterns in time. So 6 cycles later the dishes are still damp at the end of the cycle-the length of the cy


Well its not baloney but it is cheesey. normally changing the module is the cure but it has to be programmed correctly. bosch has a recall so check it out and see because the recall is free and the tech is suppose to know how to program it. go to the ... Bosch 24 in. SHE44C02UC / SHE44C06UC / SHE44C07UC Built-in Dishwasher

Whirlpool dishwasher The dishwasher works off and on. Every few days it stops going on altogether...only the cancel button goes on and the the dishwasher's timer says 2 minutes. Sometimes the air dry button works,but none of the other buttons work. The problem has been when the repair person comes out, it all of a sudden starts to work and so he can't diagnose the problem. I spoke with someone who said it sounds like with the touch pad or computer control board is bad. You don't seem to list my


THE TECH WHO CAME TO FIX MY DISHWASHER FROM Y=THIS EXACT PROBLEM TOLD ME THAT IT IS CAUSED BY THE WATER THAT TAKES TOO MUCH TIME TO GET WARM, SO YOU HAVE TO MAKE SURE THE WATER IS NOT GOING TO BE COLD BEFORE YOU TURN THE DISHWASHER ON. AS TO FIXING I ... Whirlpool 24 in. DU1100XTP Built-in Dishwasher

I have Whirlpool Quiet Partner III dishwasher, Model number GU2400XTPS3, Serial number FS1820245. I recently had the thermal fuse replaced by an authorized service repair person. My problem is that the dishwasher stops mid-cycle. I noticed that when I try to clean it in the normal cycle, the dishwasher stops with about 46 or 47 minutes remaining, and the green light flashes continuously. I have pressed the Normal and Heated Dry buttons, as well as the Sani Dry and HEated dry buttons to res


... Whirlpool 24 in. ADG7540 Built-in Dishwasher

I have Whirlpool Quiet Partner III dishwasher, Model number GU2400XTPS3, Serial number FS1820245. I recently had the thermal fuse replaced by an authorized service repair person. My problem is that the dishwasher stops mid-cycle. I noticed that when I try to clean it in the normal cycle, the dishwasher stops with about 46 or 47 minutes remaining, and the green light flashes continuously. I have pressed the Normal and Heated Dry buttons, as well as the Sani Dry and HEated dry buttons to reset the


... Whirlpool GU2400XTP Built-in Dishwasher

Bent leg We had tile installed and so we have to be able to adjust the legs by approx 1/2 in. to pull the dishwasher out. The timer went out and so we were going to replace the dishwasher, but the new one won't fit in our cabinet. So, while trying to put the Bosch back in, I guess the back leg hung up on something and bent ... can't screw it in, can't screw it out, dishwasher is out of level as it is. Questions as follows: 1) how important is it to have it level? 2) any suggestions on wh


It's hard to say what to do about the leg without seeing it. You should at least try to get something under it to get it level as possible. If not perfect, it is better to have it tilted slightly back than foreward. ... Bosch 24 in. SMU40 Built-in Dishwasher

Hotpoint HDA3400g dishwasher is not running. I have checked to make sure it has power. Took the washer apart, checked that it had power through the door switch to the timer control, all is well. Still not running or getting water into the dishwasher. Any ideas besides replacing the water inlet valve? Will this dishwasher cycle through if it does not have water?


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for using FixYa. Please check for the following if your dishwasher\015\012is not working-- ... Hotpoint 24 in. HDA3400G Built-in Dishwasher

I have a Whirlpool Dishwasher, I had a problem with the garbage disposal, so it was replaced, I hurt myself at the time and my wife had someone install the Garbage Disposal and now you run the dishwasher and no water is brought in to the dishwasher. It does drain, because I put water in and ran that part of the cycle and drained, it does turn on, it does dry but not bring in water is there something basic the guy forgot to do? Any suggestions, thank you.


He turned the hot water faucet under the sink for the dishwasher ... Whirlpool 24 in. DU1100XTP Built-in Dishwasher

Whirlpool dishwasher The dishwasher works off and on. Every few days it stops going on altogether...only the cancel button goes on and the the dishwasher's timer says 2 minutes. Sometimes the air dry button works,but none of the other buttons work. The problem has been when the repair person comes out, it all of a sudden starts to work and so he can't diagnose the problem. I spoke with someone who said it sounds like with the touch pad or computer control board is bad. You don't seem to list my


Hi there,\015\012\015\012your problem is intermittent and before you start replacing parts, i would recommend that you do these checks:\015\012\015\012unplug the dishwasher from the wall\015\012check the connection betwe ... Dishwashers

Have the same problem as other with the maytag quiet series 300 model MDBS561AWB dishwasher. Two of the buttons on the front light up, but dishwasher will not start. Don't know if CBoard or the buttons or the ribbon cable is the problem. Took the door apart and couldn't find any condensation....Looks like maytag has done it again......could use some help with the cost of replacing all those parts. Will help me decide if better to buy new dishwasher.....preferrably not a maytag or whirlpool, or a


... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1886 seconds