Having problems with your Whirlpool Dishwashers ?

Normal Light flashing continuously

\015 GU2500XPB6 model, light flashes continuously, machine will not run\015

Answers :

Repair Help & Product Troubleshooting for Whirlpool Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a whirlpool quiet partner II dishwasher model # DU1055XTVB5 and the normal light is steady flashing I have did the sequence to reset HEATED DRY NORMAL HEATED DRY NORMAL and the normal light continues to flash and if I push the cancel/drain button then it starts a steady flash


... Whirlpool 24 in. DU1055XTP Built-in Dishwasher

I own a kitchenaid dishwasher model KUDPO2FRSSO. The normal and cancel lights are flashing. I have tried shutting off the breaker for 20 min. Plus only to have the cancel light stop flashing but the normal light continues to flash. An


... KitchenAid 24 in. KUDS01FLBL Built-in Dishwasher

Kitchen Aid KUDIO1ILBS5... Normal Light keeps flashing green and wont start. When I press the cancel button, it flashes too. If I hold down the cancel button fashing light goes away on cancel button, but not the normal button... It continues to flash.


Hi,\015\012\015\012Close the door and to cancel that just press high temp and hetaer dry,then again high temp and heater dry and all the lights is going to light up, it getting into test mode.After that press cancel.\015\012 ... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

Three year old Amanda dishwasher won't run. Normal wash light flashes continually Turn off power and cancel light flashes five seconds machine tries to run five seconds then back to flashing light.


... Dishwashers

Pots/pans and normal cycle lights flash alternatly...soak/scour light on continuously. dishwasher does not work at all. did disconnect power for 12 hour. lights come back on flashing, still no function.


... Whirlpool DU1055XT 24 in Builtin Dishwasher

Whirlpool Quiet II (DU110XTPB1)... Two problems (maybe it's one)... Start/resume light flashing and won't stop. I have tried on the different button combinations from this website and other websites and none of them seem to make a difference. The flashing continues. That's problem number one. Problem number two is that it seems to go into some sort of washing cycle in completely random intervals. When it's in one of the random washing cycles the following lights are on; Normal Soak and scour


Hope it's under warranty, maybe logic board, poor motor design causes main PCB failure ... Dishwashers

We have a kenmore elite dishwasher model number 665.13249k900. The normal wash green light is flashing but none of the buttons will work . If I press the cancel drain button it will come on too but it will not do anything. I turned a power off for a short w hile but the light continues to flash


... Kenmore Dishwashers

Normal Light flashing continuously


... Whirlpool Dishwashers

Whirlpool Gold Quiet Partner Model # GU980SCGQ2 The dishwasher normal light flashes on and off continually. The dishwasher won't stop cycling now, everything seems to work normally other than it won't stop cycling. I've attempted turning off the breaker- no luck. Attempted resetting the dishwasher- no luck. Any assistance would be appreciated. Is this a problem with the control module? The thermal fuse?


... Whirlpool 24 in. GU980SCG Built-in Dishwasher

The normal wash light is flashing continuously and the 1hr. ,start resume, quick rinse, and cancel drain lights are very dimly lit. The dishwasher will not accept and inputs.


Hi... you need a new control board ... seen this lots of times ... Dishwashers

Our Kenmore Elite Ultrawash model 665.7697 has one green light continuously flashing (Smart Wash), If you try to push any other buttons then the Normal Wash also flashes. Dishwasher will not do anything. Anything we can try?


... Dishwashers

GE MODEL 5900N10BB. TWO LIGHTS ON FRONT ARE BLINKING-THE HOT START AND NORMAL WASH- DOOR IS OPEN, BLINKING LIGHTS AND PERIODIC SINGLE BEEP. WHEN I CLOSE DOOR, FLASHING CONTINUES, THERE IS A SOUND BUT NO WATER - NOTHING HAPPENING


Hi. I am actually having the exact same problem. Anyones help would be greatly appreciated.\015\012Thank You ... GE GLD5900NWW / GLD5900NBB / GLD5900NCC Dishwasher

I have Whirlpool Quiet Partner III dishwasher, Model number GU2400XTPS3, Serial number FS1820245. I recently had the thermal fuse replaced by an authorized service repair person. My problem is that the dishwasher stops mid-cycle. I noticed that when I try to clean it in the normal cycle, the dishwasher stops with about 46 or 47 minutes remaining, and the green light flashes continuously. I have pressed the Normal and Heated Dry buttons, as well as the Sani Dry and HEated dry buttons to reset the


... Whirlpool GU2400XTP Built-in Dishwasher

I have Whirlpool Quiet Partner III dishwasher, Model number GU2400XTPS3, Serial number FS1820245. I recently had the thermal fuse replaced by an authorized service repair person. My problem is that the dishwasher stops mid-cycle. I noticed that when I try to clean it in the normal cycle, the dishwasher stops with about 46 or 47 minutes remaining, and the green light flashes continuously. I have pressed the Normal and Heated Dry buttons, as well as the Sani Dry and HEated dry buttons to res


... Whirlpool 24 in. ADG7540 Built-in Dishwasher

Miele g1040i wash drying and end lights flashing. Appliance will start pumps out for 3 seconds and then the lights flash.Appliance will continue to pump out for 2 minutes approx.I have checked pump and overflow micro switch both of them are working normally and outlet is clear.


... Dishwashers

The three lights for Pots & Pans, Normal Wash, Econo Wash are all flashing. When I hold the start button down for four seconds, just the Normal light is on. However, once I close the door, all three lights are on again, and the dishwasher does not start. We have tried unpugging it and then plugging it in again. It worked once then went back to all three light flashing. Before this, only the Normal Wash and Econo Wash lights were flashing.


Hello,\015\012\015\012Welcome to FixYa.\015\012\015\012I can't seem to access any previous post dialog that may have taken place but I'd like to help if you can fill me in on whats taken place to this point.\015\012\015\012The scenario you describe i ... Viking DFB450 Dishwasher

Kenwood Elite Dishwasher Mod#665.13779 K600 "Normal Wash " light blinks continuously with NO washer action. No other wash modes light up when pressed. Washer does not do anything. However, a couple of times I got it to make a noise as if it was draining, but then nothing happens. Push "Cancel" and it blinks in unison with Normal Wash light. Open door and close it, "Cancel" light goes out and Normal Wash light continues to blink. Have tried various combination of buttons to try to "Reset"


... Kenmore Dishwashers

Normal light flashing on and off. Pressed cancel, now both normal light and cancel light are flashing. Dishwasher won't start. Can't shut lights off. Tried disconnecting power. Lights still flashing.


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for using FixYa. To resolve this you will have to\015\012reset the console. Do this by closing the door and press t ... Dishwashers

My Smeg dishwasher when turned on, the 'normal wash light' is flashing (rather that just staying on). It then beeps through the cycle and goes for about 2 and half hours. Even when I open the door and reclose it continues to beep through the cycle. Any ideas?????


... Smeg Dishwashers

Normal light on the Kitchenaid KUDSO1IL continues to flash


... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

Whirlpool quiet partner 2 DU1345XTVB2 Normal and Cancel lights flash continuously


WP has great on line trouble shooting, have you tried their own onsite trouble shooting listing the exact problem and model? ... Whirlpool Dishwashers

Kitchenaid kudl02ir stainless steel built-in dishwasher: normal light flashes continuously; will not cancel, will not start; button sequence solution did not work.


... KitchenAid Dishwashers

My GE GLD5500 dishwasher has the Normal and Heated Dry lights flashing and the pump continues to run , but no water. I have tried the reset and turned the breaker off and no change in status.


You need to open up the machines control panel and start checking grounds,then you may also need to check for corrosion on all inner door,and lower motor/pump unit connections.,any high-resistance or corroded connections in the lower unit,grounds are ... GE Profile PDW8400J Built-in Dishwasher

Green light which indicates all cycles are complete and glows constant is normal. What causes it to flash continuously after all cycles are finished? What can be done to correct situation?


... Whirlpool 24 in. ADG6552 Built-in Dishwasher

I have a Kenmore elite ultrawash HE dishwasher Model 665.13129K700 , serial # FU3801153 , Stock # 13129K , Type 586-0. My normal wash red light flashed constantly and will not allow me to reset the control panel. I disconnect power for 1 hour then it allowed me to run 1 cycle. Upon completion the normal wash red light started flashing again. I tried to toggle between high temp wash and heated dry but no other button will work since normal wash is flashing. I again disconnected power but this tim


Hi,Push push thishi temp wash / heated dry hi temp wash / heated dry hi temp wash / heated dryIf this does not reset the control then you will need to replace the control board.Let me know,if needed fur ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0808 seconds