Having problems with your Whirlpool DP1040XTX Portable Dishwasher ?

Mod DP1040XTXQ6 clean light does not come on

\015 Runs all the time. Does not shut off.\015

Answers :

If your Dishwasher is stuck in a cycle check the following

Float Switch

The float switch may be hung up and this can cause the dishwasher to be stuck in a cycle.

Timer / Control

If your dishwasher gets stuck in a cycle first try shutting off the breaker for at least 5 minutes if this does not correct the problem you will need to replace timer/electronic control board
God bless you use the VOM..
84136fce-3582-44ec-a9dc-7b2ddc5c8356.gif
Repair Help & Product Troubleshooting for Whirlpool DP1040XTX Portable Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Mod DP1040XTXQ6 clean light does not come on


If your Dishwasher is stuck in a cycle check the followingFloat SwitchThe float switch may be hung up and this can cause the dishwasher to be stuck in a cycle. Timer / ControlIf your dishwas ... Whirlpool DP1040XTX Portable Dishwasher

After a power outage, that occured while the dishwasher was running, the lights come on and there is a high pitched noise. Then all the lights go off and the motor sounds like it is starting. However there is no water and the heating elemant comes on. The lights on the front; china/crystal, normal wash, clean and heated dry, all come on as if the computer is confused and trying to run them all simultaneously.


Sounds like the board was fried from a power surge ... GE Tritonr XL GSD6260JCC Dishwasher

Clean light Our diswasher runs fine and the clean light comes on, but will not go back off after the door is opened and closed. No buttons will work and the clean light will not go back off.


You have an issue with the door latch assy, something inside it snapped, and its not recognizing you opening the door.. it still thinks the door is shut and is waitin g for you to open it, a swtich must of gone bad, the console will reove with a few ... Frigidaire 24 in. FDB1050RE Built-in Dishwasher

Rinse only light is on and all of the wash rinse sanitize clean buttons come on and flash when you try to start it, if you change the setting to normal or heavy duty the wash light comes on then the rinse only light comes on and all above mentioned buttons flash until the tub is drained.


Hi\015\012 \015\012Try and reset the dishwasher by unplugging it for 5-10 minutes. Now check if you are still getting the same error you can try and press the following buttons to reset it-- \015\012Saini Rinse, He ... Dishwashers

It appears to finish it's cycle, as far as the dishes are clean - however there is clean water that has pooled on the bottom. you can hear the water fresh coming in - the pump comes on for a few minutes, drains some of the water and shuts off - the pump comes on again - drains some of the water and turns off. I turned the water going into the dishwater off - the pump ran for a few minutes - drained some of the water and then just sits there with the red power light on - there is still the same


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. Dishwasher not draining properly or not draining at all issues\015\012can arise due to different reasons ... Bosch 23 in. SHU3302UC Built-in Dishwasher

First 2 weeks ago i put an electric control module into the upper section. what comes on is the green flashing light for clean. in checking connections i found the paper for trouble shouting. i did what they said to do. they said hit the time saver - high temp - time saver - high temp. from there all the lights went on & the wash cycle started and ran. then it just stopped & the green light for clean just flashes. the water is still in the bottom & won't drain.


The error indicates that the machine has taken too long to drain the water. Do the following.\015\012 \015\012\015\012Switch off the machine, unplug or disconnect the ma ... Kenmore 16874 Built-in Dishwasher

My Bosch dishwasher SGS46E26GB/90 makes a knocking noise when started. the timer does not advance and the check water light comes on.There is water in the bottom (up to the bottom of the door) . If I reset the DW the water drains ok. If I mess with the buttons E3 shows on the display the 'quick' light stays on and the eco light flashes. I've checked the filter where the water hose is fastens to the rear. I've cleaned the filters at the bottom of the DW and cleaned out the pump area under them.


... Dishwashers

I have a Whirlpool dishwasher mod. number GU2400XTP6 the clean light flashes then stoppes when the start button is pushed. the light on the start button flashes three times and stoppes then the clean light starts flashing again the machine dosen't start. I've checked the micro switches in the handle release and they are working fine. will I have to replace the main computer module? If so were do I get it and how much dose it cost?Thanks


... Whirlpool Dishwashers

My Frigidaire Dishwasher FDB1050RES2 gets stuck in a rinse cycle. The light on the front will be lit "clean" but the bottom of the washer is full of water. Opening the door does not turn off the "clean" light. For me to get it to run, I have to unplug it, plug it back in, push the start button until the ?washing? light comes on. I then push the start button once more and the dishwasher will begin to drain. I open the door as soon as I hear the water stop draining into the sink drain. This


By the descrition you are giving you will need to replace the main control board.Part number 154568401.you may also need to check the float switch.The part will run about 110.00 dollars from a local parts store ... Frigidaire 24 in. FDB1050RE Built-in Dishwasher

Kenmore dishwasher Clean light flashes after reset goes through cycle but motor does not run then clean light comes on again.


... Kenmore 16602 / 16604 / 16609 Built-in Dishwasher

Inlet/drain light on. i know it drains OK because if i pour water into bottom and close door and turn on i can hear it draining water out. it wont fill. i have cleaned everything and taken base off and cleaned and checked float and all ok. i have tried every combination of holding buttons down and trying to reset but machine just makes low humming noise and after about 5 seconds the red light comes on again.


... Miele 24 in. G646SC Plus Free-Standing Dishwasher

Bosch SGS44E12EU dishwasher check water light comes on, cleaned filtersetc, worked for a while and light came on again. Tap water pressure not a problem. Water hose clean.


Check drain hose for kinks,blockages including the drain pipes at the sink. Allan ... Bosch Dishwashers

Maytag mbd6601aws after cleaning clean lights do not come on only 9 and rinse light


... Maytag Dishwashers

I have a Maytag MDB8951bws and I have noticed that the dishes at the end of the cycle do not feel hot but mildly warm and not completely dry. I also noticed that when I select the ''Sanitize'' option the light that tells you the dishes have completed being sanitized does not come on after the cycles are completely finished (the ''clean'' light does come on). One last note I will throw in is that the high temp wash seems to work quite well as a lot of steam is expelled when the door is opened dur


... Maytag MDB8951BW Dishwasher

Hi, I have a Miele dishwasher G2150 that after 7-10 minutes on any cycle the rinse, dry, and end lights flash amber. I called the 800 number and they walked me through the diagnostic sequence and they said it was an error code 12 something to do with water restriction. I removed and checked the bottom "L" filter(clean), the wheel (moves freely, not dirty), and the grey in line filter screen on the intake hose,( clean also). I can feel the water coming through the intake hose, water comes in thro


... Miele G2150SC Dishwasher

Green clean light wont stop blinking unable to use dishwasher . It is an energy saver. the drain button works ..and when you push start the light comes on but will not run for cleaning


HiThanks for using FixYa. If the clean light flashes, pauses, and then repeats. When the dishwasher doesn't sense a water temperature increase, it stops working and locks the functions (clean light fla ... Kenmore 16602 / 16604 / 16609 Built-in Dishwasher

Low oil pressure while car is in idle..check gauge light comes on. I had the oil pump replaced and the sludge cleaned up. The check guage light still comes on when car is in idle and epecially when the car is hot.


Sounds like your oil pump replacement was left too late.sounds like a worn engine due to oil starvation with the previous low oil pressure and sludge problem.to verify the oil pressure you need to fit an oil pressure guage. to ... Mi T M Pump Oil

I'm working with a kitchenaid D/W model N0. KUDS01FKSS1: I repired a broken wire that shorted out near the main board, after repairing the wire the cycle selector board "light wash cycle" was not working, after the customer used the D/W the "clean light starting flashing 7 times then pauses repeately, after instaling the selector board, I entered the diagnoptics code all lights came on and then I cancelled, the D/W started working, when the cycle finish the light will come back and D/W will no


... KitchenAid Dishwashers

I have a Bosch SHE6AP05UC dishwasher. All of a sudden when I turned it on to wash a load the clean light and the quick wash light came on and when you push the wash button nothing happens. When you turn it off and on those 2 lights come on solid and you can't wash. How can I reset or what can I do to troubleshoot this?


... Bosch SHE6AP05UC 24 in Builtin Dishwasher

Bosch Ascenta SHE4AM1 Start any cycle. Active light is on. Spraying starts, but only lasts 5-10 sec., the active light goes out, clean light comes on and dishwasher sits doing nothing more.


I have the same problems..Did somebody tell you what to do to solve it? ... Dishwashers

In the last month I have noticed that my dishes aren't getting clean. My dishwasher is less than a year old and has done a great job so far. I tried adjusting the amount of rinse aid and the amount of soap but nothing works. the dishes come out "clean" without food residue on them, but they are so cloudy that I don't want to use them. I will go back to handwashing and sell the dishwasher is this is the way it is going to be cleaning. (The repair guy said nothing is wrong with it.) It is mod


First I would run the hot water until hot. Then start the dishwasher on the longest setting with the dispenser door closed( no detergent). Then after about 10-15 minutes open the door and check to see if the dispenser door opened, it should have. The ... LG Dishwashers

Water does not drain from Bosch Model SHX33A05 dishwasher. When trying to initiate Cancel/Drain (pushing simultaneously the 2 outer buttons) the 2 lights do not light up simultaneously - instead, Rinse&Hold and Clean lights come up.


I pulled the unit out and it turned out that the contractor pinched the drain hose between the back of the unit and the wall. Before, I was erroneously informed that the unit went through a complete washing cycle OK after the installation, so I did n ... Bosch Dishwashers

Miele dishwasher G818scv1plus intake/drain light comes on. i cleaned the drain line ,cleaned the tripple filter in the cabinet, checked the pump it moves freely, cleaned the water inlet filter.


... Miele Dishwashers

Lost manual - what is recommeneded cleaning procedure? Clean light has come on. What do you recommend to clean with and any special instructions.


... KitchenAid 24 in. KUDP01IL Stainless Steel Free-standing Dishwasher

Cycle stops early and clean light comes on


... Bosch Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0945 seconds