Having problems with your Whirlpool DU1055XTSQ Built-in Dishwasher ?

The dishwasher is practically new. But after it

\015 The dishwasher is practically new. But after it has gone through the clean cycle and I open it up, it is moist inside. Although drying is part of the cycle\015

Answers :

Main support number1-800-253-1301
\015\012Email supporthttp://www.whirlpool.com/custserv/email_...
Repair Help & Product Troubleshooting for Whirlpool DU1055XTSQ Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My Frigidaire Dishwasher keeps going to 99 min even though im just trying to run the quick clean. The dishes that are in the dishwasher are practically clean any way . . . how do i stop this?


... Frigidaire Dishwashers

My dishes have a film and sometimes have mould on them after they've been run through the wash cycle. All my dishes are practically clean when the dishwasher is run and we open the door as soon as the cycle is done. Anyone have any solutions? Is it safe to run an empty wash cycle with bleach instead of dishwasher detergent?


Try using some orange tang drink crystals...sounds odd but works really well.. your dish washer will look like new inside ... Bosch 24 in. SHX33A02 / SHX33A06 Free-standing Dishwasher

My Bosch dishwasher has had a problem since we had it installed. It smells like garbage after sitting for a few hours. This problem is there whether it has been run or not. Water is always standing in the large drain tube under the "filter" and it doesn't look clean. I contacted Bosch by phone as soon as this was discovered - in a matter of days after purchase - and was told by a rather haughty service person to leave the dishwasher door open. Not a practical suggestion even if it didn't sm


Was the drain tube that hooks into the sink drain passed over the partition between the sink area and washer area or through a low-level hole. If through a low-level hole, try rerouting the tube over the partition. This forms a 'trap area' to isolate ... Bosch 24 in. SHU43 Built-in Dishwasher

The dishwasher is practically new. But after it


Main support number1-800-253-1301\015\012Email supporthttp://www.whirlpool.com/custserv/email_... ... Whirlpool DU1055XTSQ Built-in Dishwasher

Is our dishwasher no good? We have hard H20 and practically rinse clean our dishes, untensils & glasses before we load it. We never use it for pots & pans. There's a sort of soap scum on the clear glasses. The utensils are spotty & streaky. The stuff is not clean looking. It's a 10 yr. old Maytag.


If you have hard water, glasses can look spotted and cloudy even after cleaning. Sometimes changing the dishwasher detergent can help. The easiest solution to clearing up glasses that start to look cloudy is to add some vinegar to the bo ... Maytag Dishwasher

Kitchen aid dishwasher not cleaning dishes well. especially the top rack. practically taken the whole thing apart can't find any clogs.


Sounds like you have a broken chopper. have you checked the chopper how far have you taken it apart? if the unit is put back together point all wash arms in the same direction turn the dishwasher on after it has started washing give it about 2-3 minu ... KitchenAid 24 in. KUDP01DLBS Free-standing Dishwasher

Dishwasher door When you open the door it practically falls to the floor, it almost like there is no spring in the door


Hello Jodi, welcome to Fixya.Based on your description what you`ve likey experienced is a broken door closer/link kit.It is a fairly minor procedure to replace it/them. Slide the entire unit out from the cabinet a couple or th ... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

We have a 2year old GE Adora dishwasher model# ghda670n20bb. It fails to runs completely or finish its cycle. now really nothing at all. iy appears that when i press hard on the door it will run but that is not practical. perhaps it is some kind of sensor or contact in the door/


... GE Dishwashers

Maytag Quiet Series 300 dishwasher, dishes come out dirty


A water softner will not make the dishes any cleaner, it just makes it so they don't have water spots on them.If the dishes are dirty, it is most likely that the nozzles (holes) in arms may be plugged.Also check to make sure you are gett ... Maytag 24 in. MDB5601AWS Stainless Steel Built-in Dishwasher

Kenmore dishwasher leaves fine debris in cups.


... Dishwashers

Dishwasher not draining, drying cycle error Electrolux ESF 4120


You didn't say what model you have, most dishwashers have a float switch inside to prevent over filling and subsequent flooding. If this switch is stuck, the dishwasher won't start. \015\012\015\012Open the door and look inside the unit ... Dishwashers

Dishwasher does not clean dishes


Okay check all your jets carefully where the water sprays out. make sure nothing . is clogging these up.and you say it's very loud could be the pump could be now. but also could be your filter on the bottomc of dishwasher. sounds like your pump is st ... Frigidaire 24 in. FDB635RF Built-in Dishwasher

Dishwasher Normally, after the dishwasher cleans the load, it displays green light next to clean. Once the door is opened, the light goes off an dishwasher is ready for next load. But from few days, after opening the dishwasher door, the clean light does not go off, it remains lit. Dishwasher doe snot reset for next cycle. So, I have to go in the basement and trip the main power to dishwasher. That resets the dishwasher. This needs to be done before each cycle. Not sure how to resolve the issue.


Make sure that you do not open the door during the wash cycle. Wait until all the cycles \015\012are complete before opening the door. Especially don't open the door \015\012during the drying cycle. ... Dishwashers

On off switch won't stay depressed on AEG dishwasher


Just remove the 3 screws along the top of the door (on the "inside") and the first screw down each side. Door kinda falls apart at this point!Unclip the switch circuit board plastic holder, then unclip the wires...take a photo first so you can get th ... AEG 24 in. Favorit 40850 Free-standing Dishwasher

Dishwasher drains at the top of the sink? Is this


You mean its draining into the kitchen sink waste pipe. if so this is perfectly correct. ... GE Nautilus 24" Built-in Dishwasher

GE 24in GSD980X Dishwasher water leak in pump &motor area


I had the same problem. There is no way of replacing seal/joint between pump and motor. It can't be taken apart w/o destroying parts, it only comes as an assembly. Costs around 130$ for pump/motor assy, so it might not be worth it. ... GE 24 in. GSD980X Built-in Dishwasher

I set my dishwasher to wash last night (delay 2 hrs.) and I checked it this morning and it never washed. Yesterday, I had to turn off the dishwasher at the breaker box because it wouldn't reset. Now, the normal wash and heated dry lights are on, but it won't start. Also, it usually beeps when I close the dishwasher door, and now it won't even do that. We bought the dishwasher about a week ago. It a GE Profile dishwasher. Thanks, Chris


\015\012\015\012\015\012First off all try to close the door tightly with your hand till you hear a beep.dont force very much.\015\012as you mentioned that unit normally gives a beep when door is closed.but not it is not giving that beep w ... GE Dishwashers

Dishwashing liquid ( Cascade Liquid- gel- with Dawn) seems to be crytalizing is dishwashing reservoir on the door. After running the dishwasher the small door holding the liquid is open but still has some residual dishwashing liquid in and it seems to harden right away into a crytal like substance. Just started doing this. Is it the product or dishwasher? The dishes come out clean. This product doen't seem to clean as good as the first cascade. Thank you


Tide is having a problem with it freezing during shipping. Call for a free replacement. Or...to thaw it she said to put it in hot water in a sink for one hour, then do it again (not boiling...have lid on tight). ... Whirlpool Dishwashers

I'm installing an electrolux dishwasher, the first thing I'm going to do is the electric wire. I know I have to attach the black white and green (ground wire).I've done this before with my Maytag and it was a breeze. When I open the elec. box on the electrolux dishwasher the black white and green wires go into the box from the Dishwasher and then THROUGH THE BOX AND THEN BACK INTO THE DISHWASHER>>>>>THERE IS NO END........... In the Maytag I just opened the box on the dishwasher and the ends of


There should be a complete wire connection already there ready to be plugged in. If not, typically at the back of the unit there should be a black plastic box that when opened will indicate 3 terminals. live - neutral - and earth. Looks to m ... Electrolux Dishwashers

Nasty dishwasher there is nasty wet grunge at the bottom of the door, around the place the heating unit in the bottom of the dishwasher. half the time the dishes are clean in the bottom of the dishwasher. half the heating element is melted..for some reason...what do i do. the dishwasher still works, if we make sure the dishes are clean before they go in. using more for a sanitation thing than a dishwasher. can ya'll help me?


Sounds like your heating element is broken and you should replace it to prevent a possible fire hazard. \015\012You can replace the element easily for not alot of cash. You'll need to pick up a new one at an appliance parts store, just bring them the ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

Re: Bosch Dishwasher Model SHX46B06UC/14 (year 2003) Good afternoon, I have water dripping into my dishwasher when it is not in use, approximately up to 1/2 inch over a few hours. The water collects at the bottom inside the dishwasher. I have to shut off the dishwasher water supply so that it does not overflow. Other than that, the dishwasher works perfect! Any idea as to what has to be replaced? Can I do it myself or do I have to call a technician. Thanks very much for your help.


HI. This type of issue will be the result of mechanical failure. This failure will be within the inlet assembly. Debris may be keeping the solenoid valve from closing correctly, thus, producing the steady drip a ... Dishwashers

Whirlpool dishwasher This dishwasher quit in the middle of a wash cycle,we had to empty it and wash by hand. I thought that maybe the breaker to the dishwasher popped but when checked it had not .I then noticed that there are no lights on the electronic key board .Even when not in use there should be one red LED that is lit. It almost seems as if there is no power to the dishwasher. Is there some type of backup safety switch or breaker on the dishwasher itself that I could reset?


Fuse on control board. ... Dishwashers

Bosch Dishwasher I currently own a Bosch dishwasher. One of the selling points, if I'm remembering right, of the dishwasher was it was supposed to super heat the hot water that is coming in from the tap. I have 3 problems. We have to rinse the dishes by hand before putting them in the dishwasher, Otherwise they won't come out clean. The dishwasher will run for four hours sometimes longer. It doesn't seem like it is heating the water any hotter than what comes out of the tap.


Your control board is bad. ... Bosch 24 in. SHU43 Built-in Dishwasher

I have a Zanussi dishwasher model IT 5614. When I turn the dishwasher on, the indicator light is already stuck at "BIO 50" and won't move, and the dishwasher won't start when the door is closed. This just happened today. The indicator light for dishwasher salt was also on, so I added dishwasher salt and that light went off, but the machine is still stuck. The instruction book says that when this happens, technical assistance is needed. What exactly is the problem, and is it anything I can


It has been suggested to switch the machine on/off a couple of times and the flashing light will not reappear. Until this light goes off the dishwasher will not start. All the filters should be cleaned free of any leftover food particles. What i mean ... Dishwashers

I was replacing my sink faucet today and in the process turned the water off to the dishwasher. Subsequently my girlfriend ran the dishwasher without the water on! Now when I go to run the dishwasher no water comes out (meanwhile I've turned the water to the dishwasher back on). Is there some kind of reset? I accidently touched the coil in the bottom of the dishwasher just after trying to run it and it was hot. What do you recommend? Thanks. Mark


Hi,You need to investigate the following :-\015\012\015\012\015\012\015\012\015\012Drain line/air gap\015\012\015\012A\015\012clog in the drain line or air gap (if there is one) is the usual reason\015\012that a dishwas ... Kenmore Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1578 seconds