Having problems with your Whirlpool DU943PWK - Multiple Color Built-in Dishwasher ?

Own a DU943 Dishwasher. It will not turn on at all. Control panel DEAD... Power to washer is good no house fuse blown. door locks fine.


Answers :

Repair Help & Product Troubleshooting for Whirlpool DU943PWK - Multiple Color Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Own a DU943 Dishwasher. It will not turn on at all. Control panel DEAD... Power to washer is good no house fuse blown. door locks fine.


... Whirlpool DU943PWK - Multiple Color Built-in Dishwasher

The dishwasher stop during the wash cycle. It did finish draining the water from the tub. The machine is not showing a power signs, I check the circuit breaker and the fuse is not tripped. I open and closed the door and the door latch seems to be working fine. There is just no power to the washer. Usually when a machine breaks down, there still is power or buttons that light up on the front of the machine. I looked on the internet and many say that the fuse could be tripped. No where can I find


... Whirlpool DU912 Dishwasher

My Kitchenaid dishwasher KUDIO1FLSS1 stopped during the wash cycle. No lights and no power. I checked the power to the washer and the fuse inside the door panel. Both fine.


... KitchenAid Dishwashers

I started working with the Karcher KB4040 pressure washer and all was well for 1-2mins, then it sputered a bit and all power died. All hoses were still attached properly, it hadn't blown a fuse in my house and the fuse in the plug of the washer is working fine.When I switch it on I get nothing. Do you think the motor has packed in? I borrowed the machine from my neighbour who's away on holiday, so don't know much about age of the machine. Any advice much appreciated.


If the water is in anyway impeded, like kink in hose the unit turns off and goes into protection mode. That it it shuts down for a pewriod of time depending on how hot it may have got.\015\012When its rested try it again ensuring you definitely ... Karcher 1750 psi Electric Pressure Washer

Kudl03fvsso dishwasher Was working fine, now dead no lights ,nothing. Has power, checked thermo fuse in door and door switch both ok seems like this is a common problem. any suggestions?


... KitchenAid Dishwashers

Electrolux ESL 63010 dishwasher. This worked fine until the door catch broke. I replaced the catch but could not remember which way round the two electrical leads went (red and black). I tried both ways with the same result. The lights come on the control panel and I can change the programme, but on closing the door the house fuses blow. I have checked the earth cable is fine. Any ideas?


Red - is active powerblack - ground or neutral ... Electrolux Dishwashers

Power is on, lock symbol appears in display panel of both upper & lower draws. On pressing lock button on either draw you hear a click however their is nothing else showing in the display panels & there is no response when pressing the power buttons or any of the other buttons. Every thing is completely dead. Is their a fuse or overload button?


Hi \015\012If the key/ lock symbol is showing in the display, then it is possible you have the child lock on. Disable it by pressing the key/ lock button on the panel. Press and hold the "Lock" icon again until o ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

I have a karcher pressure washer 1800 psi i bought from walmart it was running good until i had a power surge with the plug in. what can i do can i change the fuse in the plug or do i have to open the pressure washer up and replace a fuse.... thanks


You will have to take the cover off & look for melted wires or a fuse.\015\012if there is no fuse the capacitor may have been cooked.\015\012it should be a white cylinder.if it has been damaged it will have burn marks and may be swollen. ... Karcher PSI Electric Pressure Washer

When on/off button de-selected large flash from top of door. Main consumer unit tripped and fuse in plug found ruptured. Fuse replaced cb reset but dishwasher has no power. Fuse rechecked found to be good.


Dishwasher stripped down and found MAIN WIRING HARNESS chaffed agains door during opening and closing. New loom in region of £100 so repared old loom. ... Dishwashers

OUr ASEA Cylinda dishwasher doesn't seem to have any power. The manual suggests the fuse might be blown. THe circuit breaker is fine. Is there a fuse on the machine that can be replaced?


You need to trace the power cord into the machine to confirm this case. It will lead you into the circuit and if power is not present to the controller section there can be a fuse before the circuit.Remove power to the machine and remove panel to ... Dishwashers

Bosch DW model SHU53A05UC/17 was working fine until yesterday evening. Went to turn it on and now get nothing. No lights, no power zip. It's on its own 20amp circuit. Checked the fuse and it's not blown. Flip the breaker on/off a few times anyway to make sure. I was installing a floor and used my miter saw on the sump pump circuit (diff from the DW circuit). It blew the fuse a few times. Any chance, on a diff circuit, it spiked and damaged a board in the DW? What part (part #) would


... Dishwashers

Kitchen circut was accidently turned off. Now whirlpool gold disher will not work(unit was not running and the door was not closed all the way when circuit was turned off, All circuit breakers are on) There are no lights on display when door is closed completely, and it appears to have no power. Worked fine prior, what could it be? The unit has not been removed from under the counter yet. Is there a fuse or circuit breaker on the unit? If so where is it located? Other troubleshooting ideas


Hello- Turn power off. Remove kick panel and cover for power wires. Check connections. If these are ok, most likely suspect is a fuse at the control. This is a little harder to get to. Remove inside door panel screws. Unplug wires and remove panel. F ... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

I have Miele g665 dish washer and there is no power when you turn it on. I have checked the power point and it is on. The door is closed. The manual is saying the circuit is blown. Does anyone know how to replace one.


Call Miele Technical Support at 800.999.1360. They can help you resolve your problem. ... Dishwashers

Good day after the power is turned on to my brand new kudc03fvss dishwasher, nothing happens. have made sure that the power supply is ok and that the door is properly closed. there is 115 volts at the circuit board inside but nothing happens. no lights, no response to switch etc. just dead. need some advice


You said your getting 115 volts and that is across the power wire and its neutral not a power and ground.. i had a case like this last week and when i got there the unit had power if tested from black to ground but not from black and the white neutra ... Dishwashers

Hi, I have a Dishlex Global 300 which has just stopped powering. The power supply is fine ( I plugged in other appliances and they work) but the machine is just dead, no lights, no sounds, nothing. The door closes OK. There have been no leaks, burning smells or any other problems with it. What to do? Please help! Thank you in anticipation.


Hello it,ll will be the on/off switch easy to replace and costs about 10-15 bucks youll probally see a char mark on the connector, where it over heated and shorted out. ... Electrolux Dishwashers

Dead dishwasher? I have an Prima LXP600 dishwasher that doesn't work - no power light, no beeps, no anything. I've changed the fuse and used different power sockets. Is there anything that I can investigate, or alternatively is it likely to worth calling an engineer? The machine looks almost unused (was in a repossessed house that I bought, so no history), so I'd like to think that it's got some life left in it!


Please find some help from the link below;\012\012\012http://www.repairclinic.com/Dishwasher-Repair-Help ... Dishwashers

My kenmore dishwasher model #665.1359 just stopped working mid cycle. checked fuses in house door is closed all the way and still no power to the door. what do i do?


... Kenmore Dishwashers

The lock button light will not turn off and can not turn washer on or off. Door lock is working fine


... Kenmore 24 in. 16019 Built-in Dishwasher

Kenmore dishwasher... filled up with water and its lights went off.. no buttons work acts like no power. check the house fuse box - ok ... check the 2 door switch - ok .. checked the thermal fuse - ok ... so, i picked up a new board and changed it out. still wouldn't run.


Did you check power to the unit? Double check the common and grounds. When servicing I will disconect(unplug from wall) power to the unit. Is it pluged in? Use another outlet(the outlet under the sink may be wired thru a switch for a disposer)even ... Kenmore 24 in. 16032 Built-in Dishwasher

I have a kitchenaid dishwasher mod KUDK01TKBL1. It was running fine, opened the door and now the unit is dead,no lights nothing. It has 119 volts to it, the circuit board has line voltage and the door switch seems okay. I could not find any thermal fuse in this unit


... KitchenAid Dishwashers

No power unit went dead checked power to base of unit ok also shut off breaker for 10 minutes to see if it will reset, no luck. Also removed inner door panel to reveal circut board to look for a reset or small fuse, none evident.


... General Electric GLD5960NSS Stainless Steel Built-in Dishwasher

The power went out and we cant use the reset button to get the alarm to go off. The error says 8. When the power went off it was not washing dishes and the door was not locked. Dish washer Model KDS-17A Thanks, Todd


I would try unplugging it for 30 minutes .. ... KitchenAid Dishwashers

Power washer works perfect for 10- 15 minutes then blows fuse. Put in new fuse straight away and works fine again for another 10-15 minutes.


These machines can have issues such as you have explained if they are run off from an extension cord or if they are really far from the breaker box. They have this issue because the amount of amps that are going to the machine aren't enough for the m ... Karcher 1750 psi Electric Pressure Washer

Kudc10fxss4 I have a KitchenAid KUDC10FXSS4 w/o any power. Circuit breaker is on, and it's getting power. But there are no lights on the display. I called a parts place to see if I could order a thermal cut off fuse. But the representative stated there is no fuse listed for this model. Any ideas on what would be causing a loss of power? Seems odd/wrong to me that there wouldn't be a fuse. If there is a fuse, would it be located in the door (the control is built into the door, such


... KitchenAid Dishwashers

Model 665.15919001 Kenmore Elite dish washer suffered blown fuse last week, and after running two more loads, it appears to have the same problem-no power. The unit is plugged in and the breaker to the circuit is on.


... Kenmore Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1466 seconds