Having problems with your Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher ?

Whirlpool dishwasher spinny thing is rattling

\015 Dishwasher ran fine yesterday. Today it rattles during cycle. It seems like the spinney thing on the bottom is loose but it is not. the bolt seems tight enough. Have even removed the spinny thing (wish i knew its name) and checked to make sure nothing was stuck. Screwed it back in place.\015

Answers :

Hi,\015\012I suggest u to check these :\015\012\015\012
    \015\012
  1. Check the spray arm for damage and obstructions
  2. \015\012
  3. Check the inlet filter screens
  4. \015\012
  5. Test the water inlet valve
  6. \015\012
  7. Check the motor and mounts
  8. \015\012
  9. Check the fan motor and blade
  10. \015\012
  11. Check the drain for obstructions
Repair Help & Product Troubleshooting for Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Whirlpool dishwasher spinny thing is rattling


Hi,\015\012I suggest u to check these :\015\012\015\012\015\012Check the spray arm for damage and obstructions\015\012Check the inlet filter screens\015\012 ... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

My Whirlpool dishwasher stutters loudly during wash cycle. It's an intermittent thing, in the sense that sometimes when i run the dishwasher it doesn't do it at all. But also in the sense that when it does do it, it's for like a couple of seconds, then fine for a bit, then stutters again for a few seconds, fine for a minute etc etc. Sound is coming from inside, kind of like the power is turning on and off rapidly. It's a Whirlpool ADP-8540 Stainless Steel (Made in Germany)


A symptom like this is commonly caused by a failing wash pump motor. If you are having this problem and the dishes are not getting as clean as they used to, the motor is most likely the problem. ... Dishwashers

Dishwasher flood I have a whirlpool "Queit Partner I" type dishwasher. When I used it for the first time it flooded my kitchen floor. I had to stop in the middle of everything. What do I do from here. Not sure if I put in the correct detergent or if I put too much in. Never had one of these things before. I was always the dishwasher...help...I can be reached at [email protected] Thanks for your help.


... Dishwashers

Whirlpool Undercounter Dishwasher DU8900XY1, My dishwasher is dead. It stopped in the middle of the wash cycle and has not operated since. I checked the power at the junction box and power was confirmed. I could not see or smell any burnt wires. I don't know the next thing to trouble shoot to fix the problem. Please help


Take off the kick panel and open up the j-box at the dishwasher only. Just make sure there is no burned wire nut or loose one\012\012Thanks ... Whirlpool Dishwashers

I have a whirlpool dishwasher model adp 5550 condenser. The dishes do not get clean. I have had a repair man out twice and he replaced the soap dispenser on Friday but it still doesn't work. I went to the store today and bought every cleaning things I could find for dishwashers and also started to investigate online myself. I took the arms off and cleaned them, I took the filter out and cleaned it, and then I noticed that the plastic bar that runs from the top, along the back and into the bottom


... Dishwashers

Bathtubs was not listed in the "pick an expert" list, so choose dishwashers as closest thing to a bathtub. I have a whirlpool bath tub (don't know the make, but it is only 4 years old) It works fine but have a question - near the top of the bathtub there is a screaw in cap type of thing. It is a disk with a threaded bit on the back. The disk is about 1-1/4 inches in diameter and the threaded bit on the back is about 1/2 inch diameter and 1 inch long. Is this for allowing extra air into the syste


This would be a plumming issue. i do not know the answer you are looking for ... Dishwashers

I have a whirlpool dishwasher that is not working properly. It is less han 3 years old. It is not cleaning the dishes properly and leaving a heavy film on the dishes which only came off by handwashing with vinegar. We have followed all manufacture recommendations for cleaning the dishwasher itself and tried using less soap and it is doing the sdame thing


The problem is hard water. There is a new product out called the dishwasher filtration system. It filters the water before it enters your dishwasher. It works amazing and has a money back guarantee. You will love the ... Whirlpool 24 in. DU850SW - Multiple Color Free-standing Dishwasher

I just bought a Whirlpool quiet partner II and it's leaking. It appears to be coming from a dome shaped thing at the front of the basin. It only leaks when the dishwasher stops and there is water in the basin. It appears to be a valve of some sort but i can't tell. Nothing in the manual even mentions what this thing is. Any ideas?


I think what your looking at is the fill switch float there should be a switch located under it on the bottom of the tub it might have came loses or not hitting it properly ... Dishwashers

Dishwasher 6 ADP 5540 WH Whirlpool goes through a cycle then flashes three times, after reset does same thing. Solution to repair?


... Dishwashers

Can someone please help, my start light has just started flashing on my whirlpool adp 951 dishwasher has never done it before, have cleaned all the arms and filters but is still doing the same thing. please please anyone with any info would be great.


OK I SOLVED MY PROBLEM. I HAVE TAKEN IT TO THE TIP. THERE IS ABSOLUTELY NOTHING I COULD DO TO FIX THE PROBLEM. WHIRLPOOL WERE ABSOLUTELY HOPELESS, SO HAVE DECIDED NOT TO BUY ANOTHER ONE FROM THEM AGAIN. HAVE NOW BOUGHT AN LG - SO THAT WILL BE ARR ... Dishwashers

I have a whirlpool dishwasher Quiet partner 2. I am using cascade detergent, my dishes coming out spotty. I have tried running with a very light load and the same thing happens. I notice that there is a white film around where the water comes out during a wash. I am running a normal cycle with heated dry.


Your problem is hard water. the minerals dry on your glassware causing a white film or residue. go to www.dishwasherfilter.com. they have an awesome product designed for yo ... Whirlpool 24 in. DU1100XTP Built-in Dishwasher

Need a new sink- now THE SINK has 4 holes to accomodate hot cold water faucet and an air gap thing that is hooked under the sink to dishwasher and garbage disposal- can we not rehook that air gap kit and just get a sink with three holes for faucet only?? a quiet wash whirlpool model DU7800XS_3 -need info. linda


Yes you just need to run the hose to the top of the counter hieght to create a high loop. Basically does the same thing as an air gap. Here is a video showing this\015\012 ... Whirlpool GU2400XTP Built-in Dishwasher

My Whirlpool Gold dishwasher has been wonderful until recently. In the last 2-3 weeks, the top rack of dishes does NOT get clean - AT ALL. It appears that the spray arm is not moving, or at least not moving much. What can I do myself to check this out and possibly take things apart to see if something is clogged?


Take a tork #20 screwdriver and remove the screen go all the way to the choper and make sure its not broken on clogged. ... Dishwashers

Have whirlpool dishwasher model DU1055XTSS2 and the top rack water wheel does not spin. Operated the washer with door opened and it gets water but doesn't spin. There are no restrictions to the jets on wheel and the wheel turns feeely. The only thing i can figure is inadequate water pressure....


... Dishwashers

I have a Whirlpool dishwasher model #DU920PFGQ4. The controls locked light is flashing, and when I press the air dry key for 5 seconds it won't unlock, however the cancel/drain light starts flashing. When I press the cancel key the controls lock light will stop flashing, but will resume as soon as I release the cancel key. I have tried disconnecting power for 24 hours, but as soon as I plug it back up it does the same thing. Nothing else on the control panel will work.


... Whirlpool Dishwashers

My Whirlpool ADP 553 dishwasher starts and time switch goes through normally but nothing happens. The only thing is it does try and drain previous water. I suspect the inlet valve to be faulty thereby not letting water in. Could this be the fault


... Whirlpool 18 in. ADP530 Free-standing Dishwasher

I have a whirlpool dishwasher that won't start even though there is power going to it. I was told by someone at Lowes ro shut the breakers off for 15 minutes and that would no doubt fix the problem. it did not change a thing ,can you help? the model number is DU1145XTPBA the machine was purchased in 2007.


Hi,\015\012 Check there is no water in the tray under the machine.\015\012There will be a switch that turns off everything if there is a possible leak - so may be that. Just blot up any water and try again.\015\012If there is a sli ... Whirlpool 24 in. DU1100XTP Built-in Dishwasher

Whirlpool dishwasher model 280 has pump rattle, can this be replaced


... Whirlpool Dishwashers

My whirlpool dishwasher makes a rattling or grinding noise during one of the cycles.


... Dishwashers

My Whirlpool dishwasher will wash fine, but when it drains, it's a slow trickle. I've snaked the line from the sink to the washer, but I can't find a clog. If I try to blow into the drain pipe all I accomplish is almost passing out. I can't blow all the way through it. When I hit the drain button, I hear the solenoid kick on with a rattle, then just a hum. Like I said, I just get a trickle, and the basin never drains completely. It's driving me crazy! Help? Thanks.


In the bottom of the dishwasher, there is a screen. Remove it and clean it and the drain underneath it. Make sure the POWER IS OFF before you start. ... Dishwashers

I have a whirlpool dishwasher thats a quiet partner 2. the cancel drain light keeps blinking and nothing else is happening. i try to unlock it and then the normal light starts blinking also and still nothing happens. i called a local repair shop and they said i need to change the control board so i did and its still does the same thing. can you give me an idea of where i need to start to fix my problem?


Can you here the pump running or check to make sure there is no water in the base... ... Dishwashers

My Whirlpool dishwasher will wash fine, but when it drains, it's a slow trickle. I've snaked the line from the sink to the washer, but I can't find a clog. If I try to blow into the drain pipe all I accomplish is almost passing out. I can't blow all the way through it. When I hit the drain button, I hear the solenoid kick on with a rattle, then just a hum. Like I said, I just get a trickle, and the basin never drains completely. It's driving me crazy! Help? Thanks.


Ok, don't fret too bad, help maybe just reading.Disconnect the drain hose from the sink/garbage disposal, get a big bucket, stick hose in bucket, making sure that end of drain hose does not get lower then the bottom of dishwasher. Turn di ... Whirlpool 24 in. DU1055XTPS Stainless Steel Built-in Dishwasher

Kenmore QuietGuard I'm not exactly sure how it happened but somehow the piece that keeps the round spinny thing in place broke off. The dishwasher still works but it doesn't clean or rinse as well as it did. Do I need to call Sears and have them come out to replace the bolt or is there something that I can rig up from the local hardware store.


If u can get orginal bolt cheak locak store applices see if they have any in back room then u could if u cant get right bolt have them get u one ok thx for using fix ya ... Kenmore 24 in. 15142 Built-in Dishwasher

I have a Whirlpool gold dishwasher GU2275xtvy0. It will stop during the middle of a cycle, all the lights will go out after a while the lights come back on with the startresume light blinking. It wil start back after pushing startresume only to do the same thing 10 or so min. later. Any idea what could be wrong or what to check?


... Dishwashers

My whirlpool dishwasher is acting up. The control panel lights keeps blinking, I was told by a repain man, that charge me $60.00 to look at it, he said the electronic board was the problem, I order and replace it myself, but it still is doing the same thing, Help Joey


If its the "clean light" then its probably the heater element. You can Ohm out the heater with a meter to check if its got continuity. They had an issue with this where if it wasn't the board it was the heater. ... Whirlpool GU2400XTP Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1343 seconds