Having problems with your Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher ?

Unit was purchased in 07, is it still under warranty?. unit is making noise, that was not there before. should I call service tech? thank you


Answers :

Repair Help & Product Troubleshooting for Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Unit was purchased in 07, is it still under warranty?. unit is making noise, that was not there before. should I call service tech? thank you


... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

My dishwasher will not turn on and the Start/Resume light will not stop blinking. Is there any thing you can suggest to fix this without my calling and paying for a service call? We have stopped, restarted and reset the unit as well as cleaned out the soap tray. We have also switched off the electric to the washer as well to no avail. Really cannot afford another service call again so please help us out. Thanks. Chris


Reset the control again. Then change out your heating element.\012\012That should fix it good.\012\012Have a great day! ... KitchenAid 24 in. KUDP02CR Built-in Dishwasher

We have a 100% failure rate on multiple parts on two Maytag dishwasher units and no longer can get replacement parts from anyone. Any ideas of what to do? Here is the latest summary we sent to Maytag: Thank you for the help last fall. As a follow-up, we are still having very bad results with your product. You authorized replacement of the unit which was done. After one dishwashing, THE NEW UNIT SHOWED THE SAME PROBLEM (WOULD NOT TURN ON). I called in and you referred us to a senior te


Well iam sorry to here of you major problems.if the control board has been replaced several times and no luck fixing it there may be a problem with the main power supplied to the unit,as well as having a problem with the wiring harness.usually a manu ... Maytag 24 in. MDBH940AW Built-in Dishwasher

The clean light is flashing and the instruction manuel says, that the unit has malfunctioned and to call a service tech to check the Heater circuit. I have unplugged the unit and it did not help


... KitchenAid 24 in. KUDP01DLBS Free-standing Dishwasher

Overfilling fault I have an Asko D3530 reporting an overfilling fault. I checked the outlet hose and found a blockage. I cleared the blockage and the unit pumped the water clear. The unit however continues to opperate the pump with the message "Overfilling" diplayed. The manual indicates "call for service" Does anyone have any idear how to clear the fault? Thanks Steve


I believe the washer has had a flood type situation.there is normally a flood switch in the very bottom of the dishwasher right at the very floor,if water get into the bottom tray it floats a piece polystyrene foam wich triggers a little micro switch ... Asko 24 in. D3530FI Built-in Dishwasher

Dishwasher does not start, on any cycle selection. the only button that works is the cancel button which tells me the unit has power. this has happened before and a service tech was called and it "magically" started after he pushed the cancel button, not so this time??


Make sure the floor is dry where you are standing. \015\012 \015\012Push the cancel button twice in quick succession to attempt to turn the washer off.\015\012 \015\012Open the door all the way and look over t ... Whirlpool 24 in. GU1500XTLS Stainless Steel Built-in Dishwasher

Lost Power We always run the unit before bed on the delay timer. I heard it kick on last night. When we woke up this morning I first noticed that the clean light wasn't on. Then I noticed that the dishes were still very damp. Lastly it has about a inch of water laying in the bottom of it. It appears that it just lost power during the cycle. What are some areas I may trouble shoot before calling in a repair person. Thanks


Replace the thermal fuse inside the control panel.\015\012Part #3376359 ... Whirlpool DU960PW Dishwasher

I have an LG dishwasher. Model LDF7811BB. It is giving me a TE error code. I had previously used ya'll for help and ya'll emailed a tech sheet saying to replace the thermister. I called to order the part and the supplier said they can't find a thermister on this unit. Can you tell me what part number it is? Thanks, Greg.


Hi \015\012 \015\012Either the inlet water temp too high over 140 degrees or your thermister went open, or you have a bad control board. This type of error code will require using an ohmmeter to chec ... Dishwashers

ONCE AGAIN MY DISHWASHER IS DONE DO NOT WANT TO CALL A SERVICE TECH AGAIN HOW DO I RESET THE DISHWASHER FRONT PANEL TO GET RID OF ERROR CODES SERVICE TECH DID IT AND I WAS NOT WATCHING


... Samsung DMT300RFW Builtin Dishwasher

I have a karcher K3.98 pressure washer. The unit surges when I put the wand on and then it stops working. I tried cleaning the wand (didn't make any difference) I then tried another wand from my son's unit (still didn't work)I am wondering if the unit is worn out or can you suggest what is wrong? Thanks [email protected]


Dear davedulmage,\015\012To see if the unit is OK....first you must switch it on without water and without high pressure hose and gun. If machinr works smoothly, try by attaching a water supply. Now run the pump with water coming out of the o ... Karcher Pressure Washers

I have been negligent in not cleaning out the filters and after the unit more or less stopped, I pulled the two filters finding them full of what looked like soap scum. I cleaned them best I could (but noticed the inner filter still had most of the small holes blocked) Started the unit and it cleaned alright for a couple of days. Last night after running a load all the water did not empty from the bottom of the tub? Any suggestion on what wrong? Bought the unit on 1/19/05. Thanks


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. Dishwasher not draining properly or not draining at all issues\015\012can arise due to different reasons ... Bosch 24 in. SHX46A02 / SHX46A06 Built-in Dishwasher

Starts but won't stay running, i clean carburator and still have same problem, unit has been used very little, still look new, Thanks,


Have you checked your oil? You need pump oil half way up in reservoir. Open plug on top of pump and check oil. Pump takes SAE 20 or 30Next, open oil plug below engine and check your oil level. It should come up 1/2 way on dip stick. Engi ... Honda 2500 PSI Gas Pressure Washer

I have a electrolux EIDW6105 dishwasher,since new,after a load of dishes are done,by the end of the day,the inside of the dishwasher smells so bad,like rotting food,it is almost unbearable to smell.I had a service tech come and check it out,he said the washer was not installed correctly,was not level,I made the change,same problem,then he said I would need to use DISHWASHER MAGIC once a week,same resault,then he called electrolux tech support and they told him that it was nomal and I should run


... Electrolux 23 in. ESI602X Built-in Dishwasher

BOSCH dishwasher SHX43 leaves a very thick film on everything. Have tried all kinds of different soaps and spot removers. I tried running unit with no soap and no dishes and noticed a lot of soapy water during washing cycle and still leaving film on stainless steel tub. Have cleaned all filters. Does this unit have trouble codes and how do I access them? Thanks Joeot


Hi,Check your heating element.. A bad heating element causes many problems in dishwashers…Dishwasher Problems The Heating Element not Working ... Dishwashers

Sounds like there is a piece of broken glass in motor section upon start of cycle and any other time water enters. Just started happening. Noise coming from bottom of unit. Do we need to have unit serviced? Thank you, lauri


... Miele 24 in. G653 SCVi Plus Built-In Dishwasher

Describe your whirlpool du948pwpq Problem: I have a whirlpool du948pwpq dishwasher in a tenant's unit. They said the delay start button is no longer working. Also, they cannot "de-select" the heated dry option. It seems to be an issue with the electronics of the control panel. I've already tried to "unlock" the buttons - no change. I also powered off the unit in hopes of re-setting - no change. Does anyone have any other suggestions? I am hesitant to call a service person (it's out of warrant


... Whirlpool 24 in. DU948PWPQ Built-in Dishwasher

Whirlpool - Quit Partner I - DU1048XTP: Start at the beginning - Dishwasher would go through most of it's wash cycle and stop and the 'Start/Resume' LED would start flashing. Would press 'Start/Resume' and wash cycle would start again and run non-stop. Would have to hit 'Cancel/Drain' to stop. Called local service tech and he said board would need to be replaced. First board he brought failed right away, second board was installed. Tech also replaced latch handle assembly because it was missing


Have you asked the technician if the water temperature is OK.\015\012\015\012Run it again and after 30 minutes cancel and see if water temperature is warm or not. If not warm enough, then likely causes are heater is faulty or if you are u ... Whirlpool Dishwashers

My Whirlpool Dishwasher's clean light is blinking and it won't start. Is this a common problem? My book's troubleshooting guide says when this happens to contact a service tech to check the heat element. Is that a difficult repair best left to a tech? Thanks, Brian


... Dishwashers

The slide on the upper basket keeps falling out. It's been fixed twice but doesn't hold. The second repair man who put the slide back in the rollers said he couldn't see anything wrong with it, but it still didn't hold, so he called your tech dept. who said they had roller and slide kits at a total cost of $66 for this model. The slide kit had a new part number but the tech department didn't tell the repair man why they'd changed the part. The roller kit was one for dishwashers the sides o


One option is installing stainless steel washers on the rack supports that screw into the side of the tub. The rack falls down because there is too much "slop" with the rack...a couple small washers to space them tighter normally does the trick. ... Frigidaire 24 in. PLD2850 Built-in Dishwasher

Hi I have a bosch diswahser smu 7000. No power when I push button. Manual says its could either be fuse or circuit breaker. Checked breaker its ok. My manual does not say anything about location fuse. Called bosch. And they said they cant tell me. I nee to have a service call. Any help. Thanks.


... Dishwashers

I have a bosch millennium series SHU9905UC. There is still water at the bottom of the dishwasher from the last time it was run. I think it may not have completed the cycle as a few bowls were still dirty. Now when I try to put the washer on and press a cycle, no light is coming on at all. It seems dead. Is there anything I can try before calling in service people?


... Dishwashers

White Residue Yes...we have the same problem as well with the residue as was mentioned by several others. I guess our dishwasher is still under warranty since it is only 11 months old. It can be serviced if it is a defect or part malfunction but otherwise I may end up with a service bill. That would add to the ongoing frustrations we have with this appliance. Right now we call it our dish dirtier! We put fairy clean rinsed dishes in and....voila....out comes dirty dishes covered in white gr


Most likely it is your detergent. palmolive eco is notorious for leaving a white chalky residue on dishes. try this out before calling a service tech: put unclean glasses in the dishwasher and in your soap dish and rinse cycle cup put 1/2 cup of dist ... Frigidaire 24 in. FDB510LC Free-standing Dishwasher

Machine does not heat up. The water remains cold and the cycle takes hours irrespective of the setting temp. Heater seems to be OK and a tech guy repleced the sensor today as he thought that was the problem after everything else seemed to checkout ok but still no go. It has already cost us 200 dollars and I dont want to keep spending money having tech guys guessing the problem. Any suggestions? Thanks


Depending on the model, I have had loads of Bosch dishwashers fail because they have blown the heater relay solder joint on the main control board. Usually just requires control board to be opened up, and the faulty solder joint re-soldered. Occasion ... Bosch Dishwashers

How can you clean the drain receptacle ? I have a piece of broken glass. When you run it it never stops at the last minute and run forever after reaching that point. Can you tell me what to do, we call service man and is to busy to service it, no washer since. Last Saturday. Thank you


Hello, welcome to FixYa. \015\012\015\012**What I`m about to share applies to All B/S/H/ dishwashers. That includes Bosch, Thermador, Gaggenau and Siemens.**I know what the problem is, though yo ... Gaggenau Dishwashers

Appliance had been working fine now all of a sudden no water is running in the dishwasher.The machine appears to run through all of its cycles but without water. The water pressure in the ajoining sink appears a little low though the water pressure in the rest of my home is fine. I see no water leakage anywhere. Do I need to call an appliance tech or should I call a plumber? Thank you.


... GE GSD1000 Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1002 seconds