Having problems with your Whirlpool GU2400XTP Built-in Dishwasher ?

Whirlpool dishwasher float 'assembly' model-DU810SWPQ2

\015 The connector nut attached to the float dropped back down into the long tube at the bottom of the dishwasher when I was trying to see why the water wouldn't drain. The small tip at the bottom of the float looked a tiny bit 'chewed up' so I ordered a new float and it looks exactly like the old one. Obviously the float is not the problem. When I pull out the dishwasher to retrieve the part(connector nut?) that fell---what exactly am I looking for? How does the rest of the assembly attach to the bottom of the float? The whirlpool customer service seemed clueless when I ordered the part the first time.\015

Answers :

Enter your model number into a site like partselect.com to get a parts diagram for your dishwasher so that you can see what the part looks like. The float just extends through the base to close a micro switch so the dishwasher shuts off the inlet water valve.
http://tclaundryrepair.com/
Repair Help & Product Troubleshooting for Whirlpool GU2400XTP Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Whirlpool dishwasher float 'assembly' model-DU810SWPQ2


... Dishwashers

Whirlpool dishwasher float 'assembly' model-DU810SWPQ2


Enter your model number into a site like partselect.com to get a parts diagram for your dishwasher so that you can see what the part looks like. The float just extends through the base to close a micro switch so the dishwasher shuts off the inlet wat ... Whirlpool GU2400XTP Built-in Dishwasher

Whirlpool float assembly - Whirlpool Dishwasher Float Assembly - 3376397


... Whirlpool Dishwasher Float Assembly - 3376397

Whirlpool Dishwasher detergent door not operating properly. Main wash door opens immediately after starting dishwasher. No pre wash cycle. Loud humming noise coming from bi-metal switch or wax motor attached to the detergent cup assembly. I just replaced detergent cup assembly including the wax motor and I still get a loud vibrating humm from the actuator. model number du1055xtp3


Pdemaio,ngafm at your serviceI believe the loud humming you describe is an electronic problem. And is not worth changing parts randomly and spending unnecessary funds in this fashion!my advice is a hands on experi ... Whirlpool Dishwashers

Sears kenmore dishwasher; model: 665.13763K600 (made by Whirlpool). Dishes have debris after washing in all cycles. Arms spin, water is running, dishwasher drains, and I removed the sump assembly to clean the chopper inlet. How do I diagnose it. I put it into diagnostics cycle and am unable to identify the issue.


... Kenmore 24 in. 16012 Built-in Dishwasher

I have a Kenmore model 15165 dishwasher. It suddenly stopped filling with water--no water comes into the machine at all. No exterior valves that could have gotten turned off. Is the problem with the float assembly?


... Kenmore 24 in. 15164 Built-in Dishwasher

I have a Whirlpool Model DU943PWKQ0 dishwasher. Several of the controls on the front panel no longer work, ie normal wash, cnacel and drain, etc. Others like heavy duty wash work perfectly. It appears the most used are what is not functioning. My question is should I replace the Microcomputer assembly part number 8530929 or the Console (with overlay) part number 8274732. Can you help as I cannot really afford both!


... Dishwashers

Whirlpool Dishwasher Model Du850SWPB3 Changed out Water valve, float switch, Still doesn't fill with water. D/w runs in all cycles , just NO WATER.


Hello,What ya need to check is for power coming into the water valve from the control board by using a mulitmeter set to measure ac volts and when the dishwasher is running...during the times the unit is supposed to fill their should be p ... Whirlpool Dishwashers

I have a model du1055xtsq2 Whirlpool dishwasher. When running, it leaks at the bottom of the door opening. This was recently installed by myself,Is this a door adjustment or is there a float that may be malfuntioning?


Hi,\012Check the float\012 \012 \012Here is a tip that I wrote about dishwashers and them leaking. ... Whirlpool DU1055XTSQ Built-in Dishwasher

I just bought a whirlpool model DU1014XTXQ dishwasher from Lowes. I got half unpacked from the box before I noticed their was no sound insulating blanket. To help me decide weather to return it before I install it I have 2 questions; how quiet is this dishwasher without a blanket? (subjective...i know. Also can I install the blanket from the old dishwasher over this new model without adverse consequences? I tried to get these answers from Whirlpool but all they could tell me was that it doesn't


... Dishwashers

Hello,I hope you can answer the question below for me. My dishwasher is a Hotpoint model BFI680 - integrated. I want to replace the old interlocking assembly with a new one as the spring has broken and I can not close the dishwasher door. I have trouble removing the old interlocking assembly though. I can not see any screws that keep it into place as with other models. Instead, it looks like that it is "clipped" to the dishwasher door via the two inner side round holes at the bottom. Tried to re


... Hotpoint 23 in. BFI68 Built-in Dishwasher

I just bought a whirlpool model DU1014XTXQ dishwasher from Lowes. I got half unpacked from the box before I noticed their was no sound insulating blanket. To help me decide weather to return it before I install it, I have 2 questions; How quiet is this dishwasher without a blanket? (subjective...I know. Also can I install the blanket from the old dishwasher over this new model without adverse consequences? I tried to get these answers from Whirlpool but all they could tell me was that it doe


Hello. I have been installing dishwashers for 35 years. Whenever the new one lacks a blanket I take the blanket off of the old unit and apply it being careful to trim it if necessary. I always use a good quality duct tape to make sure the blanket ... Whirlpool Dishwashers

I have a kitchenaid model KUDS01JBT dishwasher. The Chopper Assembly keeps pluging up causing the dishwasher not to wash properly. Can I remove the chopper Assembly and run the dishwasher without causing any further problems to the dishwasher or will it cause other problems with the pump etcetera? Thank you for your assistance. Sincerely, Pat


\015\012\015\012Check the water temperature. Should be 125 to 140 F. \015\012\015\012Check pump re-circulation., Listen, see if it sounds like it is spraying the water around with enough pressure. ... Dishwashers

In replacing the float that senses water level on a Hobart AM 14 dishwasher, I see that the whole assembly is free to rotate after the c-clip is reinstalled. Past experience is that sometimes this plastic float will be found upside-down, on top of the probe which houses the reed switch & thermistor temperature sensor. What's to keep the float from rotating like this? Nothing appears to be broken or missing on the assembly from what I can see. THANKS!!!.......Lee


... Hobart AM14-253 Free-standing Dishwasher

Whirlpool dishwasher I have a whirlpool dishwasher model # 665.16519202, and the clean light flashes 7 times then pauses. I was having a problem with the machine working properly right befor the fault code came up and froze it. Can you give me any guidance as to the problem of this washer? Thanks in advance.


Do a "key dance" between normal and heated dry , going bak and forth six times. this will rester the heater fault. That is the clean light flashing code. Now you have to find the cause. Most likely is that there were suds in the last cycle or the do ... Dishwashers

Whirlpool dishwasher I have a whirlpool dishwasher model # 665.16519202, and the clean light flashes 7 times then pauses. I was having a problem with the machine working properly right befor the fault code came up and froze it. Can you give me any guidance as to the problem of this washer? Thanks in advance.


If the dishwasher doesn't sense a water temperature increase, it will stop working and lock the functions (clean light flashes 7 times, all buttons are non responsive).To resolve this you will have to reset the console. Do this by closing ... Whirlpool GU2400XTP Built-in Dishwasher

Im wanting to purchase a whirlpool dishwasher from a friend and i need to know the measurements of model #du8700xt whirlpool dishwasher


... Dishwashers

Model #DU948PWKQ1 Whirlpool Dishwasher - Whirlpool Dishwashers


... Whirlpool Dishwashers

Fix whirlpool dishwasher model wdf510 - Whirlpool Dishwashers


... Whirlpool Dishwashers

Electrolux Dishwasher 24 " not enough water new fill valve new float hot water Water lines clear. water too low float never rises amd the dishwasher runs water barly covers the top of the filter straner Model FDBB2455FS0


If i was at your home as a repairman this is what i would do.if your water pressure was good at the kitchen sink,i would turn water off to dishwasher undo water connection at the fill valve,and place water line in a bucket and turn on wa ... Electrolux Frigidaire Professional Series 24 in. Built-In Dishwasher Dishwasher

I want to replace the spray arm assembly #WD22X154 on my GE dishwasher. How do I remove the existing spray arm assembly? The Dishwasher is Model# GSD2600G02BB. Thaks, Bill


Grasp the base of the spray arm and twist it to unscrew. May need large pliers. ... Dishwashers

I need the steps to change the hose assembly on my Whirlpool portable dishwasher. When I got it someone had cut the sink connections off so my son connected it to the water and drain with my washing machine which was in the kitchen. However, I have moved and want to use it as portable. I purchased the new hose assembly for the sink faucet, I just need instructions on how to take the dishwasher apart and connect the new hoses.....HELP PLEASE!


... Whirlpool 24 in. Portable Dishwasher Dishwasher

Whirlpool dishwasher Dishwasher is showing F4 and not working. Whirlpool 6th sense ADP7966 its about 2years old.Also can not find this model anyway.


We had same problem with our ADP 5966. An engineer over the phone said he thought it was related to machine being unable to drain. I checked the drainage pipe connection to u-bend under sink, and sure enough, there was a major blockage. Cleared that& ... Whirlpool 24 in. ADP5966 Free-standing Dishwasher

Whirlpool DU1055XTSS dishwasher is totally dead as if it were unplugged. No response from front lights. Only 3 years old. Another post for an different Whirlpool model says it's the thermal fuse, but I cant find that part for this model.


Hi,If you have power going to the dishwasher, meaning the breaker, switches, wiring and fuses in the home are okay, the most common cause for your symptoms is the thermal fuse. The thermal fuse is a small disk shaped device th ... Whirlpool DU1055XTS Built-in Dishwasher

Whirlpool dishwasher We do not have a manual for a whirlpool dishwasher, model WJU34002.


... Whirlpool 24 in. ADG7540 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2076 seconds