Having problems with your Whirlpool GU2400XTP Built-in Dishwasher ?

Fuse The fuse keeps blowing. Sears replaced the fuse but is has since blown again. Sears said all power was within specs. Any suggestions?


Answers :

Are you referring to the thermal fuse in the control compartment? There's a kit that does a small modification to the wiring. Make sure that was done. Part # is 8193762 should run around $20
Which fuse, and what amperage/voltage?
fuse issues should not be ignored.
sounds like you have an intermittent problem.
i suspect sears missed the boat on this one.
there is clearly something wrong.
ask them to put into writing that its ok for the fuse to blow.
that ought to get them back out.
worse case scenario is that you are supplying undersized wire to the unit. that could account for various problems. a long run can cause a normal wire to be too small for the job. for instance, if you put a dishwasher in an outdoor kitchen and run hundreds of feet of #12 wire to it, it will not be the right size, at some point you would need to go to a #10 or larger wire for a long run.
if you have very old wiring or a long run, i suspect the issue is in the machine wiring and boards.
again, get sears back.
good luck
mark
good luck
mark
Repair Help & Product Troubleshooting for Whirlpool GU2400XTP Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Fuse The fuse keeps blowing. Sears replaced the fuse but is has since blown again. Sears said all power was within specs. Any suggestions?


Are you referring to the thermal fuse in the control compartment? There's a kit that does a small modification to the wiring. Make sure that was done. Part # is 8193762 should run around $20 ... Whirlpool GU2400XTP Built-in Dishwasher

OUr ASEA Cylinda dishwasher doesn't seem to have any power. The manual suggests the fuse might be blown. THe circuit breaker is fine. Is there a fuse on the machine that can be replaced?


You need to trace the power cord into the machine to confirm this case. It will lead you into the circuit and if power is not present to the controller section there can be a fuse before the circuit.Remove power to the machine and remove panel to ... Dishwashers

Whirlpool Dishwasher No Power: GU1200XT dishwasher thermal fuse in power up circuit blew & was replaced about two months ago. It has blown again. Both times it was after wash was finished but water was left in tub. Would appreciate suggestions on what may be causing the hi temp condition and how to verify.


I have a similar problem with my whirpool diswashre GU2500XTPB1. I check thermal fuse (on the board. It is OK (continuty). Right door switch _ OK, Left door switch _ weaker a bit). It still not work) I do not know what to check? ... Whirlpool 24 in. GU1200XT Built-in Dishwasher

My Samsung DMR77LHS dishwasher has lost power completely near the end of a cycle. About an inch of water remains. I have power to the unit. I checked the 15 amp fuse in the unit - it had blown. I replaced it, but still no luck. The fuse is not blowing, but there is no power to panel. Nothing happens when you hit the power button - no lights or anything. Unit acts as if ther is no power at all. I have seen similar posts. Any thoughts?


Hi, whenever a fuse of that magnitude, or any fuse really, Blows, you should never just replace it, as to have any device, blow a fuse, trip a breaker, requires a major fault, they do NOT blow spontaneously ever. So you have had a major short circu ... Samsung DMR77LHS Tall Tub Dishwasher

No Power Hey everyone, I have power at the wall, but no power at the dishwasher. the garbage disposal is on the same circuit and it is working. I pulled the fuse behind the control panel after cussing several times seeing that I broke the ribbon cable for the buttons in the process. I do not know how to visually tell if the fuse is blown. Thanks,


If it is a Kitchenaid KUDS25 series, there is a thermal fuse located on the upper portion of the electronic control panel. You will need a continuity meter to test it with the power OFF. In addition, check that the door latch switch closes properly ... KitchenAid 24 in. KUDS25 Built-in Dishwasher

My du943 dishwasher will not power on....it looks like it lost power after the dishes were washed and before the water drained. The fuse is not blown, the power box underneath the unit appears ok, and I checked the thermal fuse after reading other posts with the same problem. What to do from here?


... Whirlpool 24 in. DU930PWP Built-in Dishwasher

We have a kitchen aid dishwasher model # kudso1msso -- quit working and the control panel button lights are out so i assume there is no power to control panel. we have power at the plug every else looks ok. . could the internal fuse at the control panel be blown or the circuit board blown.


Sounds to me like a 'breaker' must be thrown; ... KitchenAid Dishwashers

Hi I have a whirlpool diswasher which is about 7 uears old which has blown the fuse (and the mains trip) half way through a cycle. Replaceing the fuse has resulted not resulted in the restoring of power to the unit. Is there anything simple I could check (in line fuses etc.)? Cheers


Some whirlpool models do have a thermal fuse in the consloe mounted to the main control board housing, might looke to see if it has one and if it is good ... Dishwashers

Siemens SE25M851 randomly looses power. power to the unit is fine ie fuses ok and constant power. if i give the unit a bit of a jiggle it some times comes back to life. any suggestions?


It could be the lid switch. See if "jiggling" the door handle pin points the problem. The door switch normally sits behind the door handle.\015\012\015\012If so, it is either a faulty door switch, or more likely a brocken piece of plastic ... Siemens Dishwashers

Fuses blown & controller card fried


Take this from a 4 board and 9 fuse owner.I believe the ceramic thermal fuse does not blow quick enough and during voltage spikes,or under a load cause overheating of the control board.All my boards had burnt marks on the back of the board(apposite w ... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

I have a candy futura cdf322-80 dishwasher,done a load as normal then i put it on the next day and there was nothing no lights came on nothing, i checked the fuses and the socket they were fine,so i had an engineer out who said there was power going to the machine so he said it was the contol panel which is situated behind the temperature and programme buttons so i bought this part and replaced it but still there is nothing.


I would check for myself if there was power going to the machine. If it acts the ways your does, then either the control panel or the power supply is at fault. Slight possibility a wire that runs between the two may be faulty, but not as common ... Dishwashers

Blown fuse? no power to dishwasher. getting power at the plug.


... Whirlpool 24 in. GU3600XTRY Stainless Steel Built-in Dishwasher

Hi, I have a bosch SGI 57. Started wash cycle and stopped some time later. Noticed there is now no power coming to front panel. Fuse fine, power to machine fine. Any suggestion please? Thank you


... Bosch 24 in. SGI43A75 Built-in Dishwasher

Our unit is not power on. It's plugged in and was previously working. The fuse is okay at the breaker. Any ideas? Is there a fuse within the unit that I can check? It looks like the screws to get into the lid are not standard. Thanks


... Bosch SRV53C03UC Built-in Dishwasher

Bosch Dishwasher SHE66C06UC is DEAD. Push Power Button and nothing happens? We did have a power outage just before this happened. I cannot find a fuse. Any suggestions?


Hello, ... Bosch 24 in. SHU66C02 / SHU66C06 Built-in Dishwasher

I have a GE Quiet Power 2 and the face plate (buttons) stopped working (i.e no lights, sound, action). Is there a fuse for this or something I can dismantle and replace? The dishwasher shares power and the shared sources are still working and the breaker is not tripped. Any suggestions?


Look for a bad fuse on the control board. Soldered in near the power connection. You may see a burn mark from under the fuse. ... GE 24 in. GLD5860LSS Stainless Still Built-in Dishwasher

I purchased a used Dishwasher KUDE70FVSS but it will not power on. I have checked the power up to the control panel. An earlier posting said to replace the thermal fuse. I don't have a wiring diagram so I don't know where to locate it or what it looks like. Thanks David


HI. This is true. There is a thermal fuse that will burn out under adverse conditions. This could be a power surge or element failure. This fuse is mounted in close proximity to the main board. Both parts are housed within the control panel. The actu ... KitchenAid Dishwashers

I have a Kenmore Elite Dishwasher Model 665.13773K600. It seems to have no power to the touch pad (top) control panel. I have already checked the circuit breaker and the power to the dishwasher. A friend said that it may perhaps be the thermo fuse cut out that needs to be replaced. 1) Is this true? 2) How can I remove the 1" thick control panel touch pad after removing the six screws- it seems to be stuck, and I don't want to break the plastic touchpad.


... Kenmore Dishwashers

Hi I have a bosch diswahser smu 7000. No power when I push button. Manual says its could either be fuse or circuit breaker. Checked breaker its ok. My manual does not say anything about location fuse. Called bosch. And they said they cant tell me. I nee to have a service call. Any help. Thanks.


... Dishwashers

My 1 yr old GE dishwasher model # GLD4900P00WW lost power during the drying cycle & blew the rest of the circuit. An electrician has fixed the rest of the circuit & rewired the dishwasher to it's own switch in the breaker box. The dishwasher still has no power. Is there a fuse somewhere in the dishwasher that could've blown? If so, how do I locate it?


... GE Dishwashers

I started working with the Karcher KB4040 pressure washer and all was well for 1-2mins, then it sputered a bit and all power died. All hoses were still attached properly, it hadn't blown a fuse in my house and the fuse in the plug of the washer is working fine.When I switch it on I get nothing. Do you think the motor has packed in? I borrowed the machine from my neighbour who's away on holiday, so don't know much about age of the machine. Any advice much appreciated.


If the water is in anyway impeded, like kink in hose the unit turns off and goes into protection mode. That it it shuts down for a pewriod of time depending on how hot it may have got.\015\012When its rested try it again ensuring you definitely ... Karcher 1750 psi Electric Pressure Washer

House circuits OK, power to unit. No power within dishwasher as if it was not pluged in. Is there a circuit breaker or fuse inside? the modle number is WP920?WDB4. (The Question mark is unlegible)


Did you check the door switch for continuity? That will kill all control power. Just a thought.\012 GOOD LUCK ! ... Whirlpool DP920PF Dishwasher

My Diplomat HJA 8630 dishwasher has stopped working. Put cycle on machine filled with water then no power and can not drain dishwasher. Fuse checked and changed, so not mains power supply. Any suggestions??


... Dishwashers

The electronic panel on the top of the door doesnt light up anymore and is unresponsive, when the power is turned on, the machine makes a sound like its running or draining or something, but nothing is happening. This all started after a potential electrical disruption following a power outage. Perhaps there is a fuse or some relatively easy way to fix this? or am I screwed and should just call a repair man. Thanks for your suggestions, Brodie


... Bosch 24 in. SHX56B05 Stainless Steel Built-in Dishwasher

Bosch DW model SHU53A05UC/17 was working fine until yesterday evening. Went to turn it on and now get nothing. No lights, no power zip. It's on its own 20amp circuit. Checked the fuse and it's not blown. Flip the breaker on/off a few times anyway to make sure. I was installing a floor and used my miter saw on the sump pump circuit (diff from the DW circuit). It blew the fuse a few times. Any chance, on a diff circuit, it spiked and damaged a board in the DW? What part (part #) would


... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0984 seconds