Having problems with your Whirlpool GU2400XTP Built-in Dishwasher ?

Quiet partner II is stuck in cancel/drain mode...

\015 We have a Whirlpool Quiet partner II, about 4 yrs. old..\015\012When I push the start button the cancel/drain cycle begins...will run in this mode for about 5 minutes then shuts off...try to start it again, same thing happens,,,cancel/drain mode begins.\015\012 tryed to get any of the other modes to work, will not accept the cycle which I select, goes back to the cancel/drain mode again...\015\012please help !! frustrated in Ma.,,,dishes are piling up quick.\015

Answers :

You need a new cycle selector ...or "timer "....
Repair Help & Product Troubleshooting for Whirlpool GU2400XTP Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Our Quiet Partner I dishwasher is stuck on clean mode.


... Whirlpool Dishwashers

Quiet partner II is stuck in cancel/drain mode...


You need a new cycle selector ...or "timer ".... ... Whirlpool GU2400XTP Built-in Dishwasher

I have a Whirlpool Quiet Partner II dishwasher and it is stuck in the clean mode the light continuous blinks


THat means that something is wrong with the water temp. It is either not hot enough when it fills or the heating element that increases the temp it bad. To start the Service Diagnostics Cycle, press thefollowing keys, in order, in less than 6 se ... Dishwashers

My DISWASHER, a Whirlpool Quiet Partner Plus, is stuck in the "glass express" mode. This light keeps flashing and will not go out. I threw the circuit breaker. Did not do a thing. Suggestions?


Hi,Unfortunately the flashing light you see is an indication of a failed user interface/keypad control. If the electronics under that button fail the LED that is controlled by that button will flash indicating a 'stuck key'. I ... Whirlpool Dishwashers

I have a Whirlpool Quiet Partner II dishwasher and it is stuck in the clean mode the light continuous blinks


Duplicate\\ ... Dishwashers

Maytag dishwasher quiet series 400 stuck in lock mode


... Dishwashers

Whirlpool Quiet Partner I gets stuck in the rinse cycle


... Whirlpool GU2400XTP Built-in Dishwasher

My Maytag quiet series 400 is stuck in lock mode. What do I do?


... Maytag MDB7100AWB Dishwasher

My dishwasher Whirlpool Gold Quiet Partner IV seems stuck. 2 of its buttons "rinse only" and "soak/scour" are blinking and it'snot doing anything else. Please help! Thanks.


... Whirlpool Dishwashers

My Whirlpool Quiet Partner iii is stuck on 44 minutes. It just gets hotter and hotter.


... Whirlpool GU2400XTP Built-in Dishwasher

Our Whirlpool Quiet Partner III has the "Soak and Scour" light on and blinking, we can't get the dishwasher to run, seems to be stuck.


... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

I have a Whirlpool Quiet Partner 3 GU2200XTSB3 dishwasher that starts but wont complete a full wash cycle. I went to diag mode and the follow light sequence appeared: Normal light and washing light came on, then switched to Rinse only and drying then back to normal light washing this sequence repeated 3 times then no lights then Light and heated dry followed by the normal light flashing repeatedly for an long period of time then switched to Light and heated dry then all lights went out I was t


... Whirlpool GU2200XTSB GU2200XTSQ 24 in Builtin Dishwasher

My quiet partner 2 dishwasher is stuck in the lock position it's older and I do not know the combination is there a solution


... Dishwashers

We have a Whirlpool Gold Quiet Partner IV model#GU1500XTKQ0,the normal wash cycle starts buts just goes into hang mode @ 76min remaining and just continues to wash, is it the control panel or the timer circuit board, all lights seem to work on the control panel


I replaced the heater element on mine and that fixed the problem. ... Whirlpool 24 in. GU1500XTLS Stainless Steel Built-in Dishwasher

Whirkpool quiet partner 3 dishwasher status stuck on clean. If I press cancel it goes into a 2 minute drain cycle, but there is no water in it. It will no reset or start....just blinks clean.


If you have a heated dry option and normal wash option push those buttons back and forth three times all the lights will come on reseting the board..\015\012push cans. and your done\015\012if this happens again that means you have a bad h ... Whirlpool Dishwashers

Whirlpool Gold Quiet Partner III... soak/scour light won't go off


... Whirlpool 24 in. GU2500XTPS Stainless Steel Built-in Dishwasher

My Whirlpool quiet partner dishwasher seems to run


Try a large cresent wrenck,or channel lock plier.ps.might place towel over plastic nut,to protect from wrench damage. ... Dishwashers

I have a bosch dishwasher SHE43C06UC22 (non-LED version). It's stuck in the drain cycle and continues to run even when opening the door (it should stop, but it doesn't). As a test, I poured a large glass of water in the bottom of the dishwasher and it drained it into the sink as it should, but it continues to run in the drain mode with no water in it. I've heard I either have a float stuck or an emergency drain switch or leak somewhere causing the dishwasher to continue in the drain mode. Ho


Hello,\015\012\015\012Welcome to FixYa.\015\012\015\012This can be caused by either faulty door switch or indeed the float you mentioned.\015\012\015\012This is where to look for the switch and test it ... Dishwashers

See below This is a post that I just copied to this space "I have a whirlpool Quiet Partner II, Model GU2400XTB1, that just suddenly will not start, as if the power was cut. Circuit breaker is fine. from the little Internet research I've done it looks as thou it could be a thermal fuse problem. How easy are these to replace, assuming that's what it is?" Mine is quiet partner III ... there is power to the connection box at the dishwasher it self (checked w/ light tester) ... but there is no power


Have you tryed leaving the power cord out of the socket for an hour or so sometimes they don't lose the memory until they have been left disconnected for a while ... Whirlpool GU2400XTP Built-in Dishwasher

Bosch SHU4302 WITH REPAIRED PC BOARD has been working fine for several years now seems stuck in rinse/drain mode and is not quite pumping cabinet dry. I have removed the screens and located the small impeller at bottom below cover. The impeller rotates as though it has multiple spring loaded stop positions. When I turn on the unit and open the door water is trickling from the sprayer arms at low pressure. It seems stuck in rinse mode and will not advance cycles or reset when shut off.


... Bosch Dishwashers

My dishwasher Bosch shx43c05uc/40 seems to be stuck in drain mode and if I turn power off (or disconnect electric plug) and turn on again, it still stuck in drain mode.


... Bosch Integra 300 Series SHX43C0xUC Built-in Dishwasher

Problem with whirlpool dishwasher ADP6000IX stuck on drain mode has err4 on it which means water inlet problem has sencer that changers to pump mode now is stuck on pump


Hi I had the same problem with a whirlpool adp6000ix. Although it looked fine from the inside, the base was full of water. I managed to fix the problem by pulling the dishwasher out and then tilting it gently to the side. All of the hidden water in t ... Dishwashers

My Whirlpool quiet wash plus 940 series is stuck on "lock out"


Same problem and I was about to call for service. Opened the dishwasher to get the model number and noticed a sticker stating to hold down the Heated Dry button for 5 seconds to clear the lock light. Worked for me! ... Whirlpool 24 in. DU1050SS Built-in Dishwasher

My Bosh dishwasher now runs well past the 105 minutes as stated in the manual, over three hours before I intervene. It gets stuck on the wash mode, it wont drain or rinse, just runs and runs in the wash mode (I know it's in the wash mode because when I open it up, theres suds inside). It will do the wash mode until I reset the wash mode to "Rinse & Hold". I appreciate whatever information you could provide.


Hello, welcome to Fixya.\015\012\015\012The problem you're describing is unfortunately a common one with B/S/H/ built dishwasher's. That includes Bosch, Thermador, Siemens, and Gaggenau. ... Bosch 24 in. SHX33A02 / SHX33A06 Free-standing Dishwasher

Quiet Partner lll won't start


I have the same problem. turns out my main motor is toast due to the front bearing going out. ... Whirlpool GU2400XTP Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0613 seconds