Having problems with your Whirlpool GU2400XTP Built-in Dishwasher ?

Problems with Whirlpool dishwasher model GU1500XTKB0

\015 Dishwasher began not working with soak and scour light blinking. Dishwasher was primarily used in the quickwash cycle. \015\012Dealer replaced electronic control board twice as well as checked fuse and checked continuity of the heating coil. The door latches were also checked. Dishwasher still doesn't work. \015\012When you close the door, the soak and scour light comes on and after 15 seconds starts to blink. If you open and reclose the door, the soak and scour light blinks once and then after 15 seconds starts blinking. \015\012When dishwasher stopped working there was a -- line in the time display window at the center of the control panel. Each time after service was done we were able to wash one load of dishes then during the second use, the soak and scour light comes on and the dishwasher stops it's cycle, and stops working. \015\012We have tried shutting off power to the dishwasher at the circut breaker box twice to see if the control panel would reset but no success. \015\012Have tried using the rapid advance service feature and diagnostics cycle but have not been succesful.\015

Answers :

Will these units (silo and jtrip) start back on their own? if so, it is likely they are heating the water.
otherwise it sounds like a logic board, unless there is a defective door switch or sensor issue.
electronics seem to be a recurring problem with whirlpool.
i would ask whirlpool (electorlux) to either buy it back or fix it.
good luck
mark
Repair Help & Product Troubleshooting for Whirlpool GU2400XTP Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Problems with Whirlpool dishwasher model GU1500XTKB0


Have they checked the thernals on the bottom of the tub ... Whirlpool GU2400XTP Built-in Dishwasher

Problems with Whirlpool dishwasher model GU1500XTKB0


Will these units (silo and jtrip) start back on their own? if so, it is likely they are heating the water.otherwise it sounds like a logic board, unless there is a defective door switch or sensor issue.electronics seem to be a recurring p ... Whirlpool GU2400XTP Built-in Dishwasher

Whirlpool dishwasher I have a whirlpool dishwasher model # 665.16519202, and the clean light flashes 7 times then pauses. I was having a problem with the machine working properly right befor the fault code came up and froze it. Can you give me any guidance as to the problem of this washer? Thanks in advance.


If the dishwasher doesn't sense a water temperature increase, it will stop working and lock the functions (clean light flashes 7 times, all buttons are non responsive).To resolve this you will have to reset the console. Do this by closing ... Whirlpool GU2400XTP Built-in Dishwasher

Whirlpool dishwasher I have a whirlpool dishwasher model # 665.16519202, and the clean light flashes 7 times then pauses. I was having a problem with the machine working properly right befor the fault code came up and froze it. Can you give me any guidance as to the problem of this washer? Thanks in advance.


Do a "key dance" between normal and heated dry , going bak and forth six times. this will rester the heater fault. That is the clean light flashing code. Now you have to find the cause. Most likely is that there were suds in the last cycle or the do ... Dishwashers

Model: Whirlpool ADP 4501/5 (4 years old) Problem: Dishwasher won't start wash cycle. Green light flashes 11 times. After adding a bucket of water to the dishwasher it runs normally. Checked the inlet valve and it appears to be fine. Filled the salt container and it solved the problem for a while but having the same problem again. Any suggestions would be appreciated.


... Dishwashers

Have the same problem as other with the maytag quiet series 300 model MDBS561AWB dishwasher. Two of the buttons on the front light up, but dishwasher will not start. Don't know if CBoard or the buttons or the ribbon cable is the problem. Took the door apart and couldn't find any condensation....Looks like maytag has done it again......could use some help with the cost of replacing all those parts. Will help me decide if better to buy new dishwasher.....preferrably not a maytag or whirlpool, or a


... Dishwashers

Dishwasher We are having a problem with our Whirlpool ADP5540 dishwasher. We have just moved into a new house with this model dishwasher and have tried running it on a number of cycles. It always seems to stop part way through and the start button then flashes three times. Any ideas what the problem is or how to fix it?


If\015\012this is a blinking "clean light", this is a common problem with some\015\012of the Kenmore\015\012and Whirlpool models. I believe the problem is attributed to water supply\015\012temperatures being too low when filling. Apparently, th ... Dishwashers

Whirlpool dishwasher model# DU915PWSS0 S/N# DE3960705 reset procedure? The problem: dishwasher will not start the only buttons that will light up when I push them are heavy, rinse only, and heated dry. I have reset the dishwasher once before about a year ago, I can't remember how I did it. Please help. Thank you.


\015\012\015\012\015\012\015\012Turn off the dishwasher and unplug it from the power supply. Wait 10 minutes and restore power.\015\0123\015\012\015\012\015\012Select a "Hi Temp" w ... Whirlpool Dishwashers

Whirlpool Gold Quiet Partner Model # GU980SCGQ2 The dishwasher normal light flashes on and off continually. The dishwasher won't stop cycling now, everything seems to work normally other than it won't stop cycling. I've attempted turning off the breaker- no luck. Attempted resetting the dishwasher- no luck. Any assistance would be appreciated. Is this a problem with the control module? The thermal fuse?


... Whirlpool 24 in. GU980SCG Built-in Dishwasher

I turned on my Whirlpool dishwasher last night before I went to bed. It is a model number DU915PwP82. Sometime shortly after that, a water line broke in my neighborhood. The water was off and caused some sort of problem with my dishwasher. There is some water in the bottom of the dishwasher. It won't drain or start washing. Do I need to call a repair man or is there a reset button of some sort. Thanks for your help. Rina


Hi.\015\012Often there is a lot of grit in the water supply after a pipe has been repaired, and this may have clogged one or more of the valves in your line, or the gauze filter in the inlet port on your machine. I would first turn off the wate ... Whirlpool Dishwashers

I have Whirlpool Quiet Partner III dishwasher, Model number GU2400XTPS3, Serial number FS1820245. I recently had the thermal fuse replaced by an authorized service repair person. My problem is that the dishwasher stops mid-cycle. I noticed that when I try to clean it in the normal cycle, the dishwasher stops with about 46 or 47 minutes remaining, and the green light flashes continuously. I have pressed the Normal and Heated Dry buttons, as well as the Sani Dry and HEated dry buttons to res


... Whirlpool 24 in. ADG7540 Built-in Dishwasher

I have Whirlpool Quiet Partner III dishwasher, Model number GU2400XTPS3, Serial number FS1820245. I recently had the thermal fuse replaced by an authorized service repair person. My problem is that the dishwasher stops mid-cycle. I noticed that when I try to clean it in the normal cycle, the dishwasher stops with about 46 or 47 minutes remaining, and the green light flashes continuously. I have pressed the Normal and Heated Dry buttons, as well as the Sani Dry and HEated dry buttons to reset the


... Whirlpool GU2400XTP Built-in Dishwasher

Dub750x leaks My Whirlpool Quiet Wash Plus Series Model DUB750XB-0 dishwasher produces a small puddle of water on tile floor in front of unit, but it doesn't seem to be coming from underneath it as tile/grout right in front of it aren't wet. This happens hours after the dishwasher has been run, usually at night, whether on Air Dry or Heat Dry setting. This began occurring recently after years of use without the problem. Sometimes it occurs more than once after washing/unloading. Coul


... Whirlpool Dishwashers

Dishwasher (Whirlpool Model DU930PWQ0) won't pump out. Problem occurred after door was opened during a cycle. Then the pump-out function ceased to work. Washer fills and pumps correctly during the wash cycle. Any suggestions? My guess is that the electronic control may be faulty and it is not opening the solenoid valve for the drain cycle. The other option I have thought of is that the solenoid valve may be faulty and is not responding to the signal from the controller. The dishwasher is n


... Whirlpool DU930 Built-in Dishwasher

Hi, I have a Whirlpool dishwasher, model DU980QPDQ6. The problem is it won't turn on. We bought it in 3/98 and had no problems with it in the past. The lights go on, I can hear two clicks, or relays, and it would start after the second click. Well it does'nt do anything! Help me please! Thank you!


... Whirlpool 24 in. GU980SCG Built-in Dishwasher

I have a whirlpool model number du810swpq3 dishwasher. It began to emit smoke during the washing cycle. I immediately began to suspect a belt problem but this model does not have a belt. Any suggestions? John


You have to check the water pump.Solenoid valves. Check whether any electrical part getting over heated!Switch of the machine after a short 5 mins run and check ... Dishwashers

Whirlpool dishwasher, model DU1050XTPQ1, type 575-0; problem: showing no sign of power to unit and bottom of dishwasher is full of water---it apparently stopped during cycle. Is there a reset button? I have tried depressing the front panel "lock" button for five to ten seconds to unlock the system with no luck. The washer is hard wired to the home electrical system. What should be my next course of action? Thanks


... Whirlpool 24 in. DU1050SS Built-in Dishwasher

Whirlpool dishwasher model GU2-400-XTB7 Problem started with display cycling through delay times. (1 hr, 2hr, 3 hr and so on.) Was able to cancel that for short periods and then it would repeat the cycle. Was able to run dishwasher by pressing different buttons. Then it would start a cycle but did not run full cycle. Now control panel doesn't work at all. When buttons are pushed, lights do not light up and nothing happens. Is stuck in lock mode.


... Whirlpool GU2400XTP Built-in Dishwasher

Whirlpool quiet wash plus dishwasher, (DU915QWDB1) not sure if the model number is correct. Basically my dishwasher will not drain completely (smells bad) and spills water during a wash. I don't know what it is, if there is something easy to adjust inside the washer? Or If there are general troubleshooting tips that I need to run through in order to diagnose the problem? Help!?


... Dishwashers

I have a Whirlpool dishwasher, model DU943 that's under 7 years old. I went to use it last night and it won't power on. I tried selecting all of the cycles, but the dishwasher never came on. I looked through the troubleshooting tips in my manual (like checking the circuit breaker for a tripped fuse, which was fine) and I still have a problem. what else can I try? thanks.


Hello- This unit has a thermal fuse inside the door panel on the control. This part is replaceable. If it is bad, replace.- and would suggest not using heated dry as this is most common cause of fuse failure. Let me know if this info helps- have more ... Whirlpool Dishwashers

I have a Whirlpool dishwasher model number DU1055XTPQ4 that is not cleaning the dishes. When the dishwasher is working, the bottem arm is turning and water comes out the holes. The middle arm has some water coming out, but does not turn. The top arm does nothing. It appears I have a pressure problem. I took out all the arms and cleaned them, along with the plastic tube that feeds them water. They had some build up on them but not much. I have the same result as before. I took off the


... Whirlpool Dishwashers

Problem with top spray arm not turning in whirlpool dishwasher model #DU1055XTss3


... Whirlpool Dishwashers

My (approx) 25 yr old whirlpool dishwasher, model DU8100XT, will not start. It had been working fine, no problems for 6 years since we moved in. I have reset the circuit breaker though it was not trip


... Whirlpool Dishwashers

Whirlpool dishwasher model ADG 7460 - the problem is that the Machine fills with water and then immediately pumps water out and ends cycle.


... Whirlpool Dishwashers

I have a whirlpool in counter dishwasher model # DU915PWPQ0 serial #FS2536586. The problem i have is the light cycle, green light is constantly blinking. When another button is pressed the heavy and normal cycle lights start blinking and the light cycle, light is illumanated constantly. I have left the power off for 24hrs and when turned on the light blinks again. it will not start any cycles.


Hi Mike...As I said..it flashes 4 times (not 5) 4 times then stops and starts flahung 4 times again. Also, the float is free moving in the tub,\015\012\015\012Any other suggstions??\015\012\015\012Thanks\015\012Dave ... Whirlpool 24 in. ADP5962 Free-standing Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2043 seconds