Having problems with your Whirlpool GU2400XTP Built-in Dishwasher ?

Whirlpool from ikea DWF415

\015 The programme is only lasting for about 20 minutes instead of 2 hours.\015\012The start indicator light flashes on and off\015\012It is not cleaning properly. Filter clean\015

Answers :

Hazman, depending on your serial number, this model has a bunch of service issues. Everything from the motor rework to the heating element. Sounds like your issue has to do with the heating element. If the dishwasher does not detect a 4 degrees temp. rise in the water in will go into this fault. They have redesigned the board to bypass this fault in later models. Since I don't have a serial number I can't tell if you have one of the affected models, but I assume so. I would call Whirlpool and inquire about any service flashes they have on this dishwasher, you may be covered. Otherwise you would have to do some tests to determine the cause, starting with the heating element. I believe you can clear the fault by pressing these keys in this order: high temp-air dry-high temp-air dry. four key presses...this should put it in the automatic test mode. Let it do it's thing and the fault should clear. For more info on your dishwasher there should be a tech sheet behind the bottom toe panel....Catriver..post back.
I have model GU3200 series that the clean light was blinking suggesting a problem in the heating cycle and this solution worked to stop the light from blinking.
Repair Help & Product Troubleshooting for Whirlpool GU2400XTP Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Ikea whirlpool dwf415 will not take in water and green light flashes on and off...help


MINE DID THE SAME IT WAS DUE TO A SPLIT PIPE ON THE OUTLET OF THE PUMP. THIS CAUSED A SMALL PUDDLE UNDER THE MACHINE THAT TRIPPED THE BUILT IN ANTI FLOOD SWITCH SO CUTTING OF THE POWER TO THE WATER SOLENOID. TO FIND THE LEAK BRIDGE THE ANTI FLOOD SWI ... Whirlpool Dishwashers

DWF415 Whirlpool for Ikea Dishwasher - Indicator flashing


... Whirlpool GU2400XTP Built-in Dishwasher

Whirlpool from ikea DWF415


Hazman, depending on your serial number, this model has a bunch of service issues. Everything from the motor rework to the heating element. Sounds like your issue has to do with the heating element. If the dishwasher does not detect a 4 degrees temp. ... Whirlpool GU2400XTP Built-in Dishwasher

Ikea whirlpool dishwasher+DWF B00w manuall - Whirlpool GU2400XTP Built-in Dishwasher


... Whirlpool GU2400XTP Built-in Dishwasher

Ikea Whirlpool integrated dishwasher door front


How do i take door off to fix handle back on dishwasher ... AEG 23 in. Favorit 50750Vi Built-in Dishwasher

Zanussi whirlpool intergrated Ikea dishwaser, keeps beeping


... Zanussi 18 in. DA4342 Free-standing Dishwasher

DWF 415 Ikea Whirlpool Dishwasher as constant


DWF 415 Ikea Whirlpool Dishwasher has constant green blinking light. Drain pump works ok (as it will pump out a jug of water if I tip it into it!) but no water comes in. Cycle stops about 30 seconds after thre is no more water to pump. Any idea ... Whirlpool GU2400XTP Built-in Dishwasher

Whirlpool DWF 407 IKEA Dishwasher serious problem.


A worn film capacitor on the circuit board is the cause of the problem which often manifests itself after several years using the dwf 407. Replacing the film capacitor on the circuit board is the solution! Such a capacitor costs about GBP 2. The remo ... Dishwashers

Whirlpool ikea dwf 417 the two lights on the right hand side are


... Hotpoint 24 in. DWF34 Built-in Dishwasher

Whirlpool DWH B10 - under IKEA


Hello Shazzastu,\015\012I think there is on manual online for the product you need,\015\012However i advise you to click ... Dishwashers

Hi I am in an emergency situation with an ikea whirlpool dishwasher. I have no idea what model it is since it's built in and I can't find the manual in my rental apartment. The machine works normally until the part where it's supposed to pump the water out after rinsing. At this point it starts to beep, once, and then 3 times. On and on and on. If I open it, there is water stagnated there. If I try to turn it off and back in, it will go through a whole new program and then I get the same problem


Can you feel the pump operate during the last wash cycles? if not either theres a bad pump motor or lack of power to the pump during that cycle,if this is ok,then remove the drain hose to the main drain to see if this is plugged up with food debris ... Whirlpool GU2400XTP Built-in Dishwasher

No manual for my DWN 610 its a Ikea Whirlpool dishwasher.


... Whirlpool Dishwashers

Hello all, We have an Ikea Whirlpool DWF 416 that is a couple of years old and has never caused any problems. From today the door has stopped shutting properly. The electronics and internal mechanisms seem to be working fine, since when you turn it on the cycle starts - but only if you hold the door shut. Has maybe a catch gone? Any ideas for fixing a door-shutting problem like this? Thanks in advance! Dave


The catch is no longer working. Contact IKEA for the replacement part. I'm sure it's available through EBAY or something, but probably not guaranteed or as reliable. ... Dishwashers

Whirlpool / IKEA Dishawasher DWH B10 - castor wheel


Make sure there aren't any screws through tabs at the top front of the washer that fastened it to the counter top. ... Dishwashers

I have a whirlpool for Ikea dishwasher that is built in and I put it on the normal 30 minute cycle before I went to bed and 8 hours later it was still going. I opened the door and machine was full of suds. It is like it gets stuck and can't move on to the next part of the cycle. I have checked the filter in the bottom of the machine and checked the salt and rinse aid levels.


It could be waiting for the temperature to reach the required level.\012\012Sounds like the heater element has died. ... Whirlpool Dishwashers

Hi. IKEA Whirlpool DWFA10 dishwasher.Firstly, when switching on the machine to befin the programme the machine does not pump residual water away.It then begins its cycle (in this case the pre-rinse cycle).After 12 or so minutes,when the cycle finishes and the water should be pumped away,the machine stops and the green warning light keeps flashing 4 times intermitantly.


... Dishwashers

Our Ikea Nutid Whirlpool dishwasher locked up recently. It started when someone was wiping off the top of the door where the control buttons are located. The dishwasher was locked on the china setting. Holding the cancel button, shutting off the breaker did not seem to clear it. Is there a way to reset the dishwasher? There was flashing on buttons but I cannot remember how many flashes or what one was flashing.


... Whirlpool GU2400XTP Built-in Dishwasher

IKEA Whirlpool DWF 407


... Dishwashers

Ikea Whirlpool dishwasher not properly starting


... Whirlpool 24 in. GU3200XTP Built-in Dishwasher

IKEA Whirlpool DWF 403 W Dishwasher buzzing


When it's buzzing, you have to let it buzz until it stops. Then you pressed stop then start. Et voilà!\012\012"S" means salt, but you can use any salt you want. ... Whirlpool 24 in. GU3200XTP Built-in Dishwasher

Ikea Whirlpool DWF 417 does not start program. Runs for about 20 seconds and then beeps, water gets let in for about 1 second then beeps again. Stays in this loop until you turn it off. Reset does not fix


... Dishwashers

The water enters the machine as normal, as soon as water stops filling, the machine pumps it out again strait away, then bleeps. the whole thing over in two mins. The machine smell awful!. It is a Ikea, whirlpool. Thanks


Change control ... Dishwashers

DWF415 WHIRLPOOL DISHWASHER NOT FILLING UP MAKING SOUNDS S BEND THIN PIPE THAT RUNS DOWN AND ATTACHES AT THE BOTTOM OF MACHINE KEEPS COMING LOOSE WITH THE WATER PRESSURE WHAT CAN I DO?


... Whirlpool Dishwashers

I have a slimline dishwasher from Ikea. The model is Whirlpool DWH C10 W manual. Everything worked fine up until the other day when I switched the machine on and it made a noise as if it was working but nothing happens. No water comes into the washer although inlet pip looks fine. I have poured water in and it is drained okay but the dishwasher is not cleaning dishes. After checking through numerous forum and reading about a flood prevention switch which can be sorted by tipping the d


Ok so slow down and lets look at the d/w problem and don't take the kitchen apart.. in the tank there is a float in the front corner. lift the float and listen for the click that would be the float sw . if no click th ... Dishwashers

We have a IKEA Whirlpool DWF 407 dishwasher that suddenly stopped pumping in water. It's just stuck in a loop where it sounds like the water pump is dryheaving and soon after it starts smelling a bit burnt and smells a bit like a battery. I've checked the overflooding breaker and there's no water down there and I can hear the switch turning on if I move the floater upwards. Also checked so that the water hose up on top of the machine is securely fixed. Any ideas?


... Whirlpool 24 in. ADG6340 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0343 seconds