Having problems with your Whirlpool GU2400XTP Built-in Dishwasher ?

Whirlpool Quiet Partner III will not drain

\015 Just stopped draining. What should I look for?\015\012\015

Answers :

The drain pump motor is in line with the outlet pipe. First check if the outlet pipe is not blocked or obstructed. The motor can be tested by removing the 2 electrical push on connectors and connecting mains supply to the 2 terminals. If the motor spinns it indicates that the motor is OK and that the fault is then with the electronic switching circuit (not normaly a home repair). If the motor does not spin it indicates that the motor is open circuit and needs replacing. (easy job). You can also spin the motor small cooling fan by hand just to determine if it runs freely like it should and is not obstructed by dirt inside the water channel of the pump.
Repair Help & Product Troubleshooting for Whirlpool GU2400XTP Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Whirlpool Quiet Partner III Will not drain at the


Hi,It sounds like the control unit has gone bad and you will have to replace it...the replacement is not very hard, just make sure to mark the wires so you get them back were they belong on the new unit.\015\012How to Buy ... Whirlpool GU2400XTP Built-in Dishwasher

I recently replaced the chopper in my whirlpool quiet partner III. now it won't drain. I can push the cancel drain button and hear the pump running, but nothing happens. I tried reversing the wires to see if I had switched them around when I was trying to figure out why it wasn't cleaning the dishes and that didn't work either. I checked the hose for cloggs and nothing. I am left scratching my head. model # gu1200xtkt0


It sounds like you've done a lot to try and fix your dishwasher. Make sure your air gap is not plugged up and double check the drain hose. If those are clear change out your drain hose. Part#8270145 the elbow connector sometimes have a bad chec ... Whirlpool GU2400XTP Built-in Dishwasher

We have a whirlpool quiet partner iii. It was working fine and was opened mid cycle. Then it wouldnt drain. Then all the lights started blinking. At some point it drained the water out. We flipped the breaker and now just the normal cycle light is flashing. Flipped breaker again that didnt work. Tried the reset code hi temp wash and heated dry. Normal light still blinking. Help please?


See this causes and fix it. God bles you\012 \012 \012 \012 \012 Check Fault Codes\012 \012 \012 \012 \012 \012 \012 \012 \012 ... Dishwashers

My Whirlpool Gold Quiet Partner III will not drain. How do I clean the drain or unclog it?


... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

Whirlpool Quiet Partner III will not drain


The drain pump motor is in line with the outlet pipe. First check if the outlet pipe is not blocked or obstructed. The motor can be tested by removing the 2 electrical push on connectors and connecting mains supply to the 2 terminals. If the motor sp ... Whirlpool GU2400XTP Built-in Dishwasher

Whirlpool Quiet Partner III will not drain


Hi,Here is a tip that I wrote that will help you with your problem...Dishwasher ... Whirlpool GU2400XTP Built-in Dishwasher

GU2400 whirlpool gold quiet partner iii. Won't clean dishes. Dishes don't get wet. Water seems to accumulate at the bottom but no spraying sound during cycle. Cancel causes the system to drain completely. Possibly plastic utensil under the filter screen at bottom. Can't figure out how to remove it or the filter screen. Might be preventing impeller blades from rotating.


... Whirlpool GU2400XTP Built-in Dishwasher

Whirlpool Gold Quiet partner III Mod GU3200XTPQ3 Will not drain? Thank you


Hello,\012Everyone\012expects their dishwasher will work correctly. They can become\012nonchalant about it until one day it does not function. Sometimes the\012dishwasher doesn't drain as expected. Most people immediately call the\012p ... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

I have a Whirlpool quiet partner III dishwasher that began to make a loud scratchy noise when the cycle started. This went on for a few months but it was still cleaning the dishes. Last weekend we tried it and it just kind of stopped---there is a kind of buzzing at the point when the cycle should start and then it does nothing. It does still drain of the cancel cycle. What does this sound like


There could be some debris obstructing the spray arm assembly from turning freely, puting extra working load on the motor and it now started to cut off(thats why you get the buzzing noise) since the motor also activates the water pump(reversible) it ... Whirlpool Dishwashers

I have a whirlpool gold quiet partner III. The cancel drain button works but nothing else. If you press any of the button for a period of time the normal button flashes; nothing happens though. Any thoughts????


Try to reset the dishwasher by using this sequence of keys within 6-8 secs.\015\012\015\012HiTemp/ heat Dry/ Hi Temp/ heat Dry/ Hi Temp / Heat dry.\015\012\015\012If it works all lights should turn on. Press Cancel to exit. ... Whirlpool GU2400XTP Built-in Dishwasher

Whirlpool Gold Quiet Partner III... soak/scour light won't go off


... Whirlpool 24 in. GU2500XTPS Stainless Steel Built-in Dishwasher

Whirlpool quiet partner III. Clean light keeps flashing clean.


Had the same problem. Press the sani-rinse and heated dry button back and forth and it should reset. ... KitchenAid 24 in. KUDI02IR Built-in Dishwasher

See below This is a post that I just copied to this space "I have a whirlpool Quiet Partner II, Model GU2400XTB1, that just suddenly will not start, as if the power was cut. Circuit breaker is fine. from the little Internet research I've done it looks as thou it could be a thermal fuse problem. How easy are these to replace, assuming that's what it is?" Mine is quiet partner III ... there is power to the connection box at the dishwasher it self (checked w/ light tester) ... but there is no power


Have you tryed leaving the power cord out of the socket for an hour or so sometimes they don't lose the memory until they have been left disconnected for a while ... Whirlpool GU2400XTP Built-in Dishwasher

The drain cycle does not drain completely. You need to restart it 6 or 7 times before it drains completely. When it first starts you can hear it draining but it only lasts for 5 seconds and then appears to stop draining. This is a Whirlpool Quiet Partner II Model DUL200PKT1


HiThanks for using FixYa. To start with try to leave the unit unplugged for 10-15 minutes and while its unplugged check for clogs in the drain hose. Usually, these issues are related to kinked hoses, ... Dishwashers

I have a whirlpool Quiet Partner I. HELP Drain light flashing


This may or may not help in your situation, but the following link explains how you can clear the blinking clean light problem:\015\012\015\012 ... Whirlpool DU1055XTS Built-in Dishwasher

Suds and water staying in Whirlpool Quiet Partner III


I believe you may be over sudsing, Try a few cycles with vinegar and no soap. Do not use dishwashing soap at any time ever. See if the vinegar trick helps...helijm ... Dishwashers

Suds are still in the bottom of My Whirlpool Quiet Partner III


... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

Cannot unscrew cap on rinse aid compartment in door of Whirlpool Gold Quiet Partner III


The cap doesn't come off, you just have to open the door all the way. then, when you pour the rinse aid into the dial area, it will get sucked into the dispenser. but if the door isn't open all the way it won't go anywhere and will overflow on you. ... Dishwashers

Whirlpool gold Quiet Partner III is really loud.


Now you'll be able too hear under the tub if motor bearing was the noise.put a long tool to the motor and close to you ear,see if that gives you a clue[i don't want you to give up on it if its not the motor]if was to buy that motor wholesale it would ... Whirlpool GU2400XTP Built-in Dishwasher

Whirlpool Quiet Partner III has no power to control panel


... Dishwashers

The soak and scour light on my whirlpool gold quiet partner III is blinking and will not work


... Whirlpool Dishwashers

I have a whirlpool quiet partner 2. It seems the whole washer is draining out of the air gap. This has never happened before and as you can imagine, makes a huge mess. The washer fills normally and runs normally, but is draining out the air gap an d all over the floor. Help!


Your air gap connect to the garbage disposal. The hose that makes that connection may be cloged. It is also possible the the plug that is in the disposal was not knock out. Check for a hole inside disposal were the air gap connects. If the plug was n ... Dishwashers

I have a Whirlpool quiet partner ii that won't fully drain. The bottom is fully filled with water. I've taken apart the inner drain portion and screen to get to the impeller. Everything is completely unclogged. The hose is clear. So I assume that it is the pump or valve. How do I get to them to check?


... Whirlpool Dishwashers

We have a Whirlpool Gold Quiet Partner GU980SCGZ0 model. When rinse cycle is over the water only trickles out when draining. We checked the drain and it is not plugged. Water remains sitting in bottom of dishwasher


I took the check valve assembly off the bottom of the pump assembly and there was a big chunk of string balled up in the line which created a plug against the screen when trying to drain.Works great now! ... Whirlpool Dishwashers

Dishwasher: Whirlpool Gold Quiet Partner. Has worked fine until had a house plumbing blockage which made water pool in the bottom of the dishwasher as well as kitchen sink. Tried to get it to drain at first using keypad. Drain light clicked on and then off because there was nowhere for water to do. Manually emptied most of the water, then "Cancel/Drain" worked if I held it down quite a while. House plumbing is now fixed. However the keypad only works sporadically now. Some buttons do so


\015\012Ok so your dishwasher won't do anything... it justs sits there and "Hums" you can't make it respond to any controls, and the ONLY way to Stop it. is to unplug the unit, replugging back in it simply "Hums" again and will do nothing. ... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1105 seconds