Having problems with your Whirlpool GU2400XTP Built-in Dishwasher ?

Where does the bumper part go on the rack for the whirlpool quiet wash plus, du8600xb-1 I am replacing the upper spray arm and for the life of me I can not figure out where the bumper goes...it is a small clip, probably 1 by 3 inches


Answers :

Repair Help & Product Troubleshooting for Whirlpool GU2400XTP Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Where does the bumper part go on the rack for the whirlpool quiet wash plus, du8600xb-1 I am replacing the upper spray arm and for the life of me I can not figure out where the bumper goes...it is a small clip, probably 1 by 3 inches


... Whirlpool GU2400XTP Built-in Dishwasher

There was a plastic dishwasher part lying loose in the bottom of my dishwasher this morning. Can't figure out where it belongs. probably inch and 1/2 round , 1/2 inch high. Top of spray tower maybe?


Probably the holder for the bottome rotating spray arm. Mine just broke off this morning too. Trying to locate parts supplier that isn't in the states and has a picture of the part. Don't want to replace the whole assembly which would be costly. ... GE Dishwashers

BOSCH DISHWASHER,MODEL# SHV99A13UC19, I HAVE NO PROBLEM REMOVING THE EXISTING DISPENSER, HOWEVER INSTALLING THE NEW MUST REQUIRE A TOOL TO PULL IN THE NEW DISPENSER COMPRESSING THE GASKET SO THE CLIPS HOLD INTO PLASE. I NEED ANOTHER 1/16 OF AN INCH FOR THE LATCH ON THE CLIPS.


Put the new one in a cup of hot water for two minutes to soften up the gasket then quickly install it while it is still flexible. ... Dishwashers

Kitchenaid dishwasher - small pieces of food are left on otherwise clean dishes. Water level comes to about 1 inch below heater coil. I ran it without dishes (or soap) and added about a quart of water so that level came to about 1/4 inch below heater and that's when I noticed food pieces on drain surfaces (nylon filter under bottom spray arm unit and circular plastic "trap" surrounding it). Spray arms holes are clear and water is hot.


It sounds as if you figured the solution out. The holes in the spray arm(s) get plugged by small debris, (tooth picks, seeds, bits of plastic like candy wrappers, etc) and the water does not reach the dishes to wash and rinse effective ... Dishwashers

How to replace or position top rack clips? Someone removed the top rack, clips and metalsliders, and I can't figure out how to reassemble them properly.


... Maytag 24 in. DWB1000 Built-in Dishwasher

GE Dishwasher GSD4030: I had to take the top rack out. Now I can't get it back in. Can you tell me how to reinstall the top rack and where to attach the small rack clips?


... Dishwashers

Brand new dishwasher, installed last week. When it is done there is quite a lot of water standing in the bottom of the tub. It has only been run 2 times since installed and both times several inches of water were left standing. Is this something we could check or do I need to have the installer come back, which will probably take a week at least. Oh-KitchenAid #KUDC031VWH


First was a new garbage disposal also installed? There is a knockout on the garbage disposal where the drain hose connects to.\015\012If that is not the problem make sure it has the correct high loop or also called air gap. If that is not right ... KitchenAid KUDC03IVWH Builtin Dishwasher

My dishwasher won't stop running. It has even run for a full day until I cut it off. Is this something I can fix myself? My dishwasher is a built-in Frigidaire. The manual says 2000 series, but I do not have any specifics. It is probably a 24 inch.


... Frigidaire Dishwashers

The upper rinse arm has come apart from the ''nozzles'' located on the back wall of the interior. I have the main rotating rinse arm and a small ''u'' shaped clip that appears to be intended as a retainer of some sort, perhaps snapping to a pin? How do I reconnect this arm?


Can you please tell me the make and model so I can look up these parts for you? i believe one of the parts is broken and therefore not staying where it is supposed to be. not all dishwashers are built the same so having this info will help me to get ... Bosch Dishwashers

Jackson jp-24b purchased this machine used, cant figure out how to work it. I flip the auto cycle on, and then the power switch. The fill light turns green and i assume water is filling up in the machine. In the meantime there are two small red external hoses that hot water comes and i currently just have those hanging in the sink. At the same time, nothing is happening during the wash cycle, the wash gauge doesnt even move only the rinse gauge. Also when i try to drain it nothing happends (begi


It needs a new drain relay box 120 volt the drain is stuck open the jp 24 were not very good machines the red lines are drain lines if you plug up the drian lines at fillup the machine will wash but now it will never drain a new drain box is not c ... Jackson JP-24B Built-in Dishwasher

Upper spray arm and tube assembly. This part fell off the back wall. Can not figure out how to get it to stay on again. Looks like it should clip in, but nothing to snap it in place. The part does not look brocken when compared to the part would order to replace. No info in the manual and their service department was no help, How do I fix this.


Hi,\012Those p[arts wear and even though the parts do not look broken they are not up to the specs. of a new part...\012That is not that hard to fix and you can easily buy the parts yourself online... ... Bosch 23 in. SHU 8805 Built-in Dishwasher

Whirlpool DU927QWDG1 Hi, The problem I'm having with my dishwasher pertains to the door cover for the area I place the soap. There is a small spring which helps the door pop open to release the soap when washing. I cant figure out how to place the spring so that the pops open.....right now when I run the unit the door stays latched and the soap doesn't get dispensed. Any ideas on how to repair this or where I could maybe get a parts manual??? Your expertise will be greatly appreciated!!!!


... Whirlpool GU2400XTP Built-in Dishwasher

No power Our 3-yr-old dishwasher (Whirlpool 24-inch ) stopped in mid-cycle. A small amount standing water in the bottom of the washer. None of the control panel buttons were lit up and none of them will work. NO POWER


Hi lushman001\015\012\015\012I'm Harvey the Master Plunber.\015\012\015\012Your question is: your 3-yr-old dishwasher (Whirlpool 24-inch ) stopped in mid-cycle. A small amount standing water in the bottom of the washer. None o ... Whirlpool 24 in. DU1100XTP Built-in Dishwasher

Dishwasher sounds like it is running normally, (no grinding sounds or anything)but there doesn't appear to be any water coming into the machine. we checked to see if there was a kink in the line or if perhaps it was a plumbing problem but that does not seem to be the case. I know the circular disk in the front of the machine needs to be down and it is, so can you figure out without seeing for yourself what could be the problem and if so is it worth fixing since I can probably replace it for und


Hi there,\012Well first of all you can check out the following -Water-inlet valve - The water-inlet valve lets water enter the machine. If this valve is defective, you need to completely replace it. It's usua ... Dishwashers

Cycle counter goes to 1, but continues to agitate, does not pump the water out, nor does it go to zero. The counter will stay on 1 indefinetly, if I use the pump button, there is soap residue in the bottom of the machine. I called the Sears repairman, he was here about 10 minutes, unplugged the machine from the wall and said that probably I had a power surge and that would solve my problem. It did not. I live in a very small town, I will have to take my dishwasher to Las Cruces (101 miles awa


Hello, welcome to Fixya.\015\012\015\012I`ll start by saying how unfortunate it is to have too many so called "pro`s" trying to diagnose appliances who have no business doing so if that is how the repair-person you spoke of e ... Bosch Dishwashers

The upper spray arm on our dishwasher has become detached from the back of the machine, and there is no obvious means of reattaching it. Are there some clips perhaps that have snapped on the part which attaches to the back wall of the d/washer (part number PP-TD20 - it's a 4 by 1 1/2 inch long rectangular shape with rounded ends) or does this piece somehow need to be taken apart (how - i can't see how i might do this?) and the transparent 2nd layer underneath get attached first? Thanks, Sarah.


What exactly the brand / model of your unit.?Let me know.Thanks ... Dishwashers

I have a Bosch dishwasher and the upper arm that spins and dispenses water has come off. There is a bracket on the back wall with 2 protruding pieces and an open whole in the middle which seems like the water comes out of it. There are 2 metal "clips" on the side of this braket which seems like the plate part of the spining arm should be able to attach to it.. I cannot figure out how..Any helo would be apprecated..


On Bosh dishwasher you just slide the upper arm vertically until it snaps in place. The arm attachment will snap automatically into the clips, onto upper dishrack, unless the upper arm is damaged ... Dishwashers

Hi, I'm having trouble with my maytag jetclean eq. I've removed everything down to what I think is the drain impeller and can't figure out how to remove what seems to be this last piece. Fwiw, the trouble is dishes are dirty/cloudy, soap dispenser is still half full, and there is an inch or two of water in the bottom, like it never fully drains.


The problem is not your dishwasher but your water actually. hard water is the reason for the cloudiness. www.dishwasherfilter.com makes a filter just for this problem. it f ... Dishwashers

A small cap fell down into the drain area on my Kitchenaid dishwasher. I removed the lower washer arm trying to get to the drain area. I could not figure out how to get to it, but now I have another problem. I can't get the washer arm back on!


Grab the center nut with pliers and pull up on it while spinning the spray arm. ... Dishwashers

I can't reatach top( glasses) rack I can't figure out where the clips go into.


The clips attach to the upper tray assembly...you clip the little roller assemblies (all one piece) onto the bottom of the tray...along the lowest part of the tray...when clipped in place...(I'm not sure but there will be an even # on both sides) you ... GE Nautilus 24" Built-in Dishwasher

My dishwasher started to fill with water, probably close to 2 inches, then it stopped altogether. Now the motor makes a humming noise...it won't do anything else. Help!


That is the model number ... Dishwashers

G.E. GSD5130 When the dishwasher is pumping out the water a small amount comes in the rotating sprayer head. At the end of the cycle the dishwasher still has water in the bottom. The amount of water varies from just a little to over an inch. I replaced the spring loaded check valve a couple of months earlier and everything worked fine until now. What should I check? Thankyou.


Mike, I just ran into the same problem. I found a second check valve located in the outlet hose of the ELECTRIC drain motor. This motor is located at the right rear underside of d/w and is used only for backflush of the filter. When the unit goes th ... GE GSD5130 Dishwasher

I followed 'Mindcell's' advice on fixing my Kenmore QuietGuard 4 dishwasher, and I managed to clear out all the food particles that have accumulated. I suspect that is probably why the middle spray arm has not been very effective. However, in my repair, as I was screwing in the star screw that holds the cover of the foodscreen (the lower most star screw), I managed to overturn it and break it. Thus, the food screen is only held by a plastic clip, and from what I can gather, pressure from a


Hello Lily - You could use the machine this way, afterall all that could happen is for the cover to come loose and end up in the bottom of the machine.\015\012\015\012That said, why not remove that broken screw with a small pair of vise g ... Kenmore 24 in. 15689 Built-in Dishwasher

Dishwasher does not turn on at all - no lights when power button is pressed. There is an inch of water in the bottom - the last cycle probably didn't finish but we did not notice when we unloaded it.


... Bosch SHU5315UC Dishwasher

I have a small drip coming from somewhere other than the water supply or drain pipes. It is on the right side of the unit and drips down the outside of the terminal box. The puddle size at the end of a cycle is maybe 3-4 inches in diameter.


... KitchenAid KUDS30IVBL Builtin Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0596 seconds