Having problems with your Whirlpool GU2400XTP Built-in Dishwasher ?

Whirlpool Quiet Partner Doesn't finish cycle

\015 My machine GU2455GTSQ0 doesnt complete it cycles. When you put it on the normal or light cycle with the heated dry the machine will continuously run until you turn it off manually. On the regular cycle mine gets stuck on 44 min and on the light cycle at 39 min. I have figured out that if you wash only it will get past that time and when you get close the end of the cycle you can push the dry button and it will go on to dry the dishes. The machine appears to be washing properly just will not switch over from wash cycle to rinse and then dry. We had a repairman look at it and he could not figure out the problem.\015\012\015\012Update as of 7/30 I now cannot get it to complete the wash cycle at all and now it is making very loud noise while washing. I have ordered a new electronic control and am hoping that solves the problem. Any suggestions would be appreciated.\015

Answers :

FIX YA IS A JOKE I WOULD LIKE TO BURY THE ************** WHO CREATED IT!
My Quiet Partner II is less than a year old. When It was new it ran the wash cycle for a long long time AND the bottom was filled with dirty water when it was finished. I unscrewed the washer from counter top and shook 3 or 4 times untill it finally started operating properly.. that did the trick. Now its making a light but loud grinding noise when it washes.
Repair Help & Product Troubleshooting for Whirlpool GU2400XTP Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Whirlpool Quiet Partner Doesn't finish cycle


FIX YA IS A JOKE I WOULD LIKE TO BURY THE ************** WHO CREATED IT! ... Whirlpool GU2400XTP Built-in Dishwasher

My whirlpool quiet partner 1 does not dry my dishes , it washes them fine and when the unit gets finished with cycle it isnt any hot inside.


Hi,Check your heating element.. \012A bad heating element causes many problems in dishwashers…Dishwasher Problems The ... Dishwashers

My whirlpool quiet partner 2 dishwasher the clean button keeps flashing even though the dishes are not clean. Will not reset and I don't think it finished its cycle.


Same with mine. ... Dishwashers

My whirlpool quiet partner II is not quiet at all. When I start the cycle it starts humming and a little vibrating and I open it up and no water. I close it and wait it out every 10 minutes I open it back up and no water. The heating element is hot and stinky since there's no water. But once the wash cycle is over the rinse cycle works and theres water. What's the issue?


... Whirlpool GU2400XTP Built-in Dishwasher

I have the Whirlpool Quiet Partner 1 the wash cycle starts and about 20 Min.'s into it the clean light starts flashing or the the start light, one or the other each time and it wont dry the dish's anymore we have already replaced the panel once and it has always popped when it is filling with water or changing cycles. HELP!!!! I hate washing dish's and I am beginning to hate all Whirlpool Appliances.


If the clean light blinks 7 times thats you heating circuit. Test the heater with an ohm meeting to see if it has open. If so order the heater kit and it comes with the control board. ... Whirlpool GU2400XTP Built-in Dishwasher

Whirlpool Quiet Partner II dead mid-cycle; no lights; nothing


... Dishwashers

Whirlpool Gold Quiet Partner IV Dishwasher, Model GU1500XTKT0, Serial number FL4104935, Type 575-0, during a Rinse Only cycle suddenly the cycle light began constantly blinking, which could not canceled or stopped nor placed into diagnostic cycle or other wash cycle. The repairman checked everything and decided problem was Electronic Control Module, which he replaced; blinking Rinse Only went off, but Normal Wash is now constantly blinking and repairman seemed confused and is wanting to repla


... Whirlpool Dishwashers

I have a Whirlpool Gold Quiet Partner III (Model GU1200XTKB0). I have used it previously on "Normal" cycle and I always keep it on Air Dry. Last night I used the "Pots and Pans" cycle and it seemed to work fine. But this morning the Air Dry light is flashing and if I press a cycle key the Rinse Only light starts to flash as well. Nothing works. I have made sure that the console is not locked. Any suggestions? I do not have a Heated Dry button, only Air Dry. Thank you.


... Dishwashers

I have a Whirlpool quiet partner III dishwasher that began to make a loud scratchy noise when the cycle started. This went on for a few months but it was still cleaning the dishes. Last weekend we tried it and it just kind of stopped---there is a kind of buzzing at the point when the cycle should start and then it does nothing. It does still drain of the cancel cycle. What does this sound like


There could be some debris obstructing the spray arm assembly from turning freely, puting extra working load on the motor and it now started to cut off(thats why you get the buzzing noise) since the motor also activates the water pump(reversible) it ... Whirlpool Dishwashers

Our GU2500XTPQ6 Gold quiet partner III begins a cleaning cycle but then different numbers appear on the minute countdown and the cycle never finishes. Once it gets to this point, you can only get it to drain. You cannot reset the cycle. We were once given a series of buttons to push to reset the control panel but don't know where it is. Can you help?


Yes call the manufacturer and ask for the code again ... Whirlpool 24 in. GU2500 XTP Built-in Dishwasher

My Whirlpool Gold,quiet partner 3,model GU2400XTPT6 dishwasher runs the pre-rinse cycle & drains then just hums and doesn't run the wash cycle. Any help?


On a "normal wash cycle" \015\012turn all the spray arms at the 12 o'clock position.\015\012Please answer the folling questions.\015\012Will water enter the unit?\015\012After water has stopped entering the unit can you hear t ... Whirlpool GU2400XTP Built-in Dishwasher

Whirlpool Gold Quiet Partner Model # GU980SCGQ2 The dishwasher normal light flashes on and off continually. The dishwasher won't stop cycling now, everything seems to work normally other than it won't stop cycling. I've attempted turning off the breaker- no luck. Attempted resetting the dishwasher- no luck. Any assistance would be appreciated. Is this a problem with the control module? The thermal fuse?


... Whirlpool 24 in. GU980SCG Built-in Dishwasher

We have a whirlpool quiet partner iii. It was working fine and was opened mid cycle. Then it wouldnt drain. Then all the lights started blinking. At some point it drained the water out. We flipped the breaker and now just the normal cycle light is flashing. Flipped breaker again that didnt work. Tried the reset code hi temp wash and heated dry. Normal light still blinking. Help please?


See this causes and fix it. God bles you\012 \012 \012 \012 \012 Check Fault Codes\012 \012 \012 \012 \012 \012 \012 \012 \012 ... Dishwashers

Whirlpool gold quiet partner iii was making humming noise. I took apart and found a couple of rubber and a plastic straw. Thinking I had it fixed, I ran a cycle. It started fine, however it stops using water. Same with rinse cycle. Sometimes it works, sometimes it doesn't.


... Whirlpool Dishwashers

I have Whirlpool Quiet Partner III dishwasher, Model number GU2400XTPS3, Serial number FS1820245. I recently had the thermal fuse replaced by an authorized service repair person. My problem is that the dishwasher stops mid-cycle. I noticed that when I try to clean it in the normal cycle, the dishwasher stops with about 46 or 47 minutes remaining, and the green light flashes continuously. I have pressed the Normal and Heated Dry buttons, as well as the Sani Dry and HEated dry buttons to res


... Whirlpool 24 in. ADG7540 Built-in Dishwasher

I have Whirlpool Quiet Partner III dishwasher, Model number GU2400XTPS3, Serial number FS1820245. I recently had the thermal fuse replaced by an authorized service repair person. My problem is that the dishwasher stops mid-cycle. I noticed that when I try to clean it in the normal cycle, the dishwasher stops with about 46 or 47 minutes remaining, and the green light flashes continuously. I have pressed the Normal and Heated Dry buttons, as well as the Sani Dry and HEated dry buttons to reset the


... Whirlpool GU2400XTP Built-in Dishwasher

My Whirlpool Gold Quiet Partner III was DOA when I went to use it today. I unplugged/plugged it back in, at which time the "China Crystal" LED flashed a sequence of 3 flashes, then 3 more flashes, pause, 3 + 3 more, pause, 3+3 more, pause, etc., etc. And it would not run on any other cycle, but it did seem to run thru that one OK. Upon completion of the cycle, it was DOA again. Did the "Normal/Air Dry/Normal" button sequence, and now the Rinse Only button is steadily flashing. Any suggestions? I


When the rinse light is flashing steadily then the reset procedure for your model is pressing the "Normal/Air Dry/Normal" buttons.\015\012\015\012If it did not reset your dishwasher the control board must have fa ... Whirlpool GU2400XTP Built-in Dishwasher

Help! My Whirlpool Quiet Partner II isn't working at all. Water was standing in bottom at end of last 2 cycles, but on the last cycle, I came home to clean looking dishes, standing water, and a machine that won't turn on at all- no lights on any buttons- nothing works. I've tried the reset codes published here and elsewhere, but there are no lights on any buttons at all. The circuit breaker is fine. I have 3 young kids and can't function long without my dishwasher!


There is a fuse in the control panel what your model# i can get you the part number its easy to replace it. ... Dishwashers

Whirlpool Quiet Partner II not washing or sensing.


I have a whirlpool quiet partner II and for some reason it does not drain the water out any more and I cannot figure out why....people say that it is the filter but that is unbelievably hard to get to and I cannot find any instructions online or pape ... Whirlpool GU2400XTP Built-in Dishwasher

Whirlpool Quiet Partner I gets stuck in the rinse cycle


... Whirlpool GU2400XTP Built-in Dishwasher

Whirlpool quiet partner 1 stops during wash cycle and cancels and drains


... Whirlpool Dishwashers

Whirlpool gold quiet partner iii quit during a cycle. none of the lights on the control panel work. there is power going to the unit from the breaker box.


... Whirlpool Gold GU2275XTVy Dishwasher

Why did my quiet partner II whirlpool dishwash just stop mid cycle?


See this possible causes:Water-heating cycleheat, wash, and rinse has the 3 cicle, principal pro ... Whirlpool Dishwashers

Whirlpool gold quiet partner accuwash sensor dishwasher...... only heavy cycle works,and dishes do not come out clean. What are possible problems/solutions? Thank You!!


... Whirlpool Dishwashers

I have a whirlpool quiet partner dishwasher that is not getting even light food residue off the dishes. Cycles seem to be running and progressing normally, tho I do not think the water is spraying from the arms with adequate force.


Hello,Welcome to fixya,You said, you have a whirlpool quiet partner dishwasher that is not getting even\015\012light food residue off the dishes. Cycles seem to be running and\015\012progressing normally, tho you do not think the wa ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1102 seconds